Zhen-Hua Zhao
Research Subjects
Zhen-Hua Zhao has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Hai-Feng Zhang
College of Electronic and Optical Engineering & College of Flexible Electronics (Future Technology), Nanjing University of Posts and Telecommunications (NJUPT) 1 , Nanjing 210023
3 shared publications Lin Han
Shandong Provincial Geo‐mineral Engineering Exploration Institute Jinan China
2 shared publicationsLiting Xing
Shandong Provincial Geo‐mineral Engineering Exploration Institute Jinan China
2 shared publicationsQuanlin Feng
Shandong Provincial Geo‐mineral Engineering Exploration Institute Jinan China
2 shared publications- Guobiao Liu
Department of Materials Science, Sichuan Engineering Technical College, Deyang 618000, China
1 shared publication - Hao Pan
College of Electronic and Optical Engineering & College of Flexible Electronics (Future Technology), Nanjing University of Posts and Telecommunications, Nanjing, 210023, China
1 shared publication
Latest Publications
- 24 April 2022
- Published by Wiley in Luminescence
- Vol. 37 (6) , 995-1000
A novel colorimetric fluorescent probe for detecting hydrazine in living cells and zebrafish
Hydrazine (NH2NH2) is a highly toxic organic substance that poses a threat to human health. Monitoring hydrazine with high sensitivity and selectivity is very important. Here, a simple colorimetric fluorescent probe for hydrazine detection, which is a seminaphthorhodafluor derivative containing thiophene‐2‐carboxylic acid ester reaction site, was rationally constructed. The probe itself exhibits weak fluorescence. The fluorescence is significantly enhanced when hydrazine is added. The probe exhibited a broad linear range (0–1 mM) with satisfactory selectivity and sensitivity (limit of detection 36.4 μM), which turned out to be an excellent fluorescent probe for monitoring hydrazine. Additionally, the probe was used to track hydrazine in living cells and zebrafish with great success, and the detection performance was satisfying. These results proved that this type of fluorescent probe with the thiophene‐2‐carboxylic acid ester structure can detect hydrazine with higher selectivity and sensitivity.
- 24 April 2022
- Published by Wiley in Luminescence
- Vol. 37 (6) , 995-1000
A novel colorimetric fluorescent probe for detecting hydrazine in living cells and zebrafish
Hydrazine (NH2NH2) is a highly toxic organic substance that poses a threat to human health. Monitoring hydrazine with high sensitivity and selectivity is very important. Here, a simple colorimetric fluorescent probe for hydrazine detection, which is a seminaphthorhodafluor derivative containing thiophene‐2‐carboxylic acid ester reaction site, was rationally constructed. The probe itself exhibits weak fluorescence. The fluorescence is significantly enhanced when hydrazine is added. The probe exhibited a broad linear range (0–1 mM) with satisfactory selectivity and sensitivity (limit of detection 36.4 μM), which turned out to be an excellent fluorescent probe for monitoring hydrazine. Additionally, the probe was used to track hydrazine in living cells and zebrafish with great success, and the detection performance was satisfying. These results proved that this type of fluorescent probe with the thiophene‐2‐carboxylic acid ester structure can detect hydrazine with higher selectivity and sensitivity.
- 8 April 2022
- Published by Wiley in ChemistrySelect
- Vol. 7 (14)
A Novel Levulinate‐Based Highly Specific Colorimetric Fluorescent Probe for Bisulfite Detection in Live Cells and Zebrafish
Bisulfite (HSO 3 − ) is associated with many physiological processes in living systems. High concentration of HSO 3 − may lead to many diseases. Herein, a simple levulinate‐based colorimetric fluorescent probe for HSO 3 − detection was designed and synthesized. The probe showed high selectivity for HSO 3 − detection with color changes from light pink to deep pink. Under the optimal test conditions, there is a good linear relationship between fluorescence intensity and concentrations of HSO 3 − in the range of 0–50 μM with detection limit of 1.04 nM. In addition, the probe was successfully applied to monitor HSO 3 − in living cells and zebrafish, which proved that the probe can be used to detect HSO 3 − in living systems.
- 8 April 2022
- Published by Wiley in ChemistrySelect
- Vol. 7 (14)
A Novel Levulinate‐Based Highly Specific Colorimetric Fluorescent Probe for Bisulfite Detection in Live Cells and Zebrafish
Bisulfite (HSO 3 − ) is associated with many physiological processes in living systems. High concentration of HSO 3 − may lead to many diseases. Herein, a simple levulinate‐based colorimetric fluorescent probe for HSO 3 − detection was designed and synthesized. The probe showed high selectivity for HSO 3 − detection with color changes from light pink to deep pink. Under the optimal test conditions, there is a good linear relationship between fluorescence intensity and concentrations of HSO 3 − in the range of 0–50 μM with detection limit of 1.04 nM. In addition, the probe was successfully applied to monitor HSO 3 − in living cells and zebrafish, which proved that the probe can be used to detect HSO 3 − in living systems.
- 12 December 2021
- Published by Taylor & Francis in Journal of Electromagnetic Waves and Applications
- Vol. 36 (9) , 1244-1256
A circularly polarized antenna array with sequential-phase feed network
In this paper, a simple broadband circularly polarized (CP) patch antenna design is proposed. The antenna uses a 2 × 2 array fed by a sequential-phase feed network to improve the axial ratio (AR) bandwidth and gain, and an L-shaped slot is used to remove the coupling between the feed network and the radiation patches. Similarly, to reduce coupling, the height between two substrates is discussed as an important parameter. The proposed antenna is fabricated to verify the simulated results. Measured results show that the impedance bandwidth is 65.2% (1.68–3.31 GHz), the AR bandwidth obtained at the same time is 61.6% (1.86–3.39 GHz), and the effective relative bandwidth is 58% (1.86–3.31 GHz), and the peak gain is about 7.13 dBi at 2.7 GHz.
- 12 December 2021
- Published by Taylor & Francis in Journal of Electromagnetic Waves and Applications
- Vol. 36 (9) , 1244-1256
A circularly polarized antenna array with sequential-phase feed network
In this paper, a simple broadband circularly polarized (CP) patch antenna design is proposed. The antenna uses a 2 × 2 array fed by a sequential-phase feed network to improve the axial ratio (AR) bandwidth and gain, and an L-shaped slot is used to remove the coupling between the feed network and the radiation patches. Similarly, to reduce coupling, the height between two substrates is discussed as an important parameter. The proposed antenna is fabricated to verify the simulated results. Measured results show that the impedance bandwidth is 65.2% (1.68–3.31 GHz), the AR bandwidth obtained at the same time is 61.6% (1.86–3.39 GHz), and the effective relative bandwidth is 58% (1.86–3.31 GHz), and the peak gain is about 7.13 dBi at 2.7 GHz.
- 1 December 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 2040-2044
A Tunable Device for Switching between Abosrber and Frequency Selective Surface Tailored by Gravity Field
We present a novel type of tunable gravity tailored metamaterial absorber which can obtain absorption in GHz region and can become a frequency selective surface by rotating it 180°. The original sandwich structure was modified in this structure. By digging grooves in dielectric substrate which owns surface metal resonance units, EGaIn is placed in the grooves for replacement of the metal plane. Due to the fluidity of liquid metal (eutectic gallium-indium), EGaIn would flow into different part of this unique designed structure when it was rotated, this instrument can achieve a 99.17% absorption at 6.87 GHz. This instrument will change into a FSS which can manage a stopband from 7.95 to 9.5 GHz. Importantly, compared with the most of current tailoring approaches of the absobers, the proposed method is more convenient.
- 1 December 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 2040-2044
A Tunable Device for Switching between Abosrber and Frequency Selective Surface Tailored by Gravity Field
We present a novel type of tunable gravity tailored metamaterial absorber which can obtain absorption in GHz region and can become a frequency selective surface by rotating it 180°. The original sandwich structure was modified in this structure. By digging grooves in dielectric substrate which owns surface metal resonance units, EGaIn is placed in the grooves for replacement of the metal plane. Due to the fluidity of liquid metal (eutectic gallium-indium), EGaIn would flow into different part of this unique designed structure when it was rotated, this instrument can achieve a 99.17% absorption at 6.87 GHz. This instrument will change into a FSS which can manage a stopband from 7.95 to 9.5 GHz. Importantly, compared with the most of current tailoring approaches of the absobers, the proposed method is more convenient.
- Open Access
- 9 August 2019
- Published by Wiley in International Journal of RF and Microwave Computer-Aided Engineering
- Vol. 29 (11) , e21926
A strain sensor realized by a multilayer dielectric antenna
- 9 August 2019
- Published by Wiley in International Journal of RF and Microwave Computer-Aided Engineering
- Vol. 29 (11) , e21926
Open AccessA strain sensor realized by a multilayer dielectric antenna