MXMing Xu

Ming Xu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Ming Xu has a total of 36 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Large-scale data-driven inverse EM design based on metacircuit-embedded surface

    by Ming Xu, Song Zha, Mingtuan Lin, Hanqing Liu, Jihong Zhang, Yanlin Xu, Huan Jiang, Qiang Cheng, Peiguo Liu

    General-purpose electromagnetic model is central to intelligent electromagnetic applications. However, its development is limited by severe scarcity of training data, arising from the high computational cost of full-wave simulations and reliance on specialized topologies that yield single EM function. To overcome this challenge, we introduce a metacircuit-embedded surface (MCES) framework, consisting of a fixed structural topology and flexible metacircuits that can be realized through lumped components. By shifting design focus from full-wave simulation to circuit-level modeling, over six million samples can be easily generated with laptop computation resources. Subsequently, an MCES-based forward and inverse AI design method was developed, providing rich design capability in frequency, amplitude, phase and polarization domains. Finally, three kinds of classical metasurfaces were designed and fabricated, showing superior performance compared to reported advanced designs. Overall, the proposed MCES-based framework greatly raises the design efficiency and training scale, paving the way for future general-purpose electromagnetic model.

  • Proposal of a HIRF Prevention Cassegrain Antenna Employing Energy High-Pass Selective Subreflector

    by Song Zha, Zhengwei Liu, Jihong Zhang, Zhuang Qu, Honglin Zhang, Ming Xu, Peiguo Liu

    A X-band Cassegrain antenna was proposed for high-intensity radiation fields (HIRF) prevention in this paper. The sub-reflector of the Cassegrain antenna was made of a reconfigurable metasurface that named as energy high-pass selective surface (EHPSS). The EHPSS was firstly proposed and verified, which could adaptively switch between status of low-loss mirror reflection for low-intensity incident waves and high-effectiveness transmission for high-intensity incident waves, respectively. Through mathematical modeling and unit-cell design, an EHPSS prototype featuring the rotating hyperboloid geometry of Cassegrain sub-reflectors was manufactured. After simulation and measurement, the Cassegrain antenna employing the EHPSS sub-reflector can dynamically control the radiation gain in response to the incident wave intensity. In the low-intensity condition, the insertion loss compared with the conventional antenna was less than 1 dB in the band from 10.0 GHz to 10.5 GHz; while in the high-intensity condition, the proposed antenna was measured an over 20 dB gain reduction at 10.0 GHz. These results have demonstrated that the proposed Cassegrain antenna was capable of adaptively switch between working and HIRF preventing, rendering it a promising candidate for modern electronic systems requiring HIRF resilience.


  • Open Access

    A Cassegrain Antenna With Field-Controlled Reconfigurable Subreflector for HIRF Protection

    by Zhuang Qu, Song Zha, Jihong Zhang, Ming Xu, Zhengwei Liu, Peiguo Liu

    This paper proposed a Cassegrain antenna with a field-controlled reconfigurable subreflector for high-intensity radiation fields (HIRF) protection. By replacing the rotating hyperboloid subreflector with a field-controlled reconfigurable metasurface, the antenna can adaptively change its gain based on the incident electromagnetic field intensity. The proposed reconfigurable metasurface consists of 97 unit cells, each unit cell with a thickness of 4 mm and equipped with four diodes. The simulation and measurement have demonstrated that under low-intensity fields, the gain of the proposed antenna reaches 27.4 dBi at 9.3 GHz, which is only 0.3 dB less than the normal hyperboloid subreflector antenna. In HIRF, the gain of the proposed antenna decreases to 8.9 dBi, below the level of the feed.


  • An Energy-Selective Substrate-Integrated Waveguide Slotted Antenna for HIRFs Protection

    by Honglin Zhang, Huan Jiang, Song Zha, Jihong Zhang, Peiguo Liu, Ming Xu

    This letter presents an energy-selective substrate-integrated waveguide (SIW) slotted antenna with nonlinear component loading for high-intensity radiation fields (HIRFs) protection. The proposed design integrates PIN diodes and lumped inductors across the slots to achieve adaptive admittance modulation. Through equivalent circuit parameter extraction, the nonlinear network deliberately detunes slot admittance under HIRFs exposure, disrupting original resonance via field-induced admittance transforming. The alteration changes the antenna's radiation pattern, reducing the realized gain over 23 dB after measured, and thus providing HIRFs preventing. The proposed antenna demonstrates enhanced electromagnetic protection in HIRFs environments and stable radiation characteristics in normal operation.


  • Open Access

    Design of a Folded Transmitarray Antenna With Field-Controlled Gain for HIRF Protection

    by Zhuang Qu, Song Zha, Jihong Zhang, Ming Xu, Zhengwei Liu, Peiguo Liu

    This paper proposed a folded transmitarray antenna for high-intensity radiation fields (HIRF) protection, which can adaptively change gain based on the intensity of the incident electromagnetic field. When the field intensity is low, the antenna has a phase compensation function to achieve high-gain characteristics of the antenna and receives electromagnetic waves with low loss. In HIRF, the antenna removes its phase compensation and reflects the incident electromagnetic wave, which reduces the receiving efficiency of electromagnetic waves and achieves protection for HIRF. After simulation and measurement, with a low-intensity incident wave, the antenna’s gain is over 20 dBi in the central frequency. In HIRF, the antenna can remove the gain of transmitarray, causing the antenna’s gain to decrease to the level of the antenna feed about 7 dBi. This paper provides a new perspective on antenna design by integrating electromagnetic protection mechanisms into the antenna structure, and proposes an antenna that can adapt to HIRF and protect backend electronic devices.


  • Top Cited Papers

    Design of Ultrawideband Energy-Selective Surface Based on Triple-Layer Structure and Semiconductor for HIRF Prevention

    by Jihong Zhang, Fule Kang, Zhengwei Liu, Zhuang Qu, Ming Xu, Song Zha, Peiguo Liu

    An ultrawideband energy selective surface (ESS) for adaptive prevention of high-intensity radiation fields (HIRF) is proposed in this paper. With a triple-layer structure loaded with PIN diodes, the ultrawideband transmission property from C- to X-band was achieved in both the OFF- and ON-state of the diode. Without active biasing, the state of the loaded diodes was directly controlled by the intensity of the incident waves. Unlike the low insertion loss (IL) realized in OFF-state, the shielding effectiveness (SE) in ON-state was high to prevent the incident waves. Therefore, the proposed ESS could adaptively respond to the HIRF’s illumination and simultaneously switch its transmission property. After full-wave simulations and waveguide measurements, the bandwidth of IL below 1 dB and SE over 20 dB were achieved from 6.30 GHz to 12.20 GHz, demonstrating a 64% fractional bandwidth for HIRF prevention.


  • Low Profile Dynamic Patch Antenna Array With High-Intensity Radiation Fields (HIRF) Protection

    by Ming Xu, Jibin Liu, Shaopeng Pan, Bowen Deng, Jihong Zhang, Zhaofeng Wu, Peiguo Liu, Mingtuan Lin

    A 1-bit low-profile patch antenna array integrating beam scanning and adaptive high-intensity radiation fields (HIRF) protection is proposed in this paper. Each antenna element consists of two dielectric layers, two radiation patches, a ground plane, and a feeding network. By electronically controlling a pair of coding diodes in the same direction, the antenna element can achieve 180 $^\circ$ phase difference, producing two logical states, namely “0” and “1”. It has good beam scanning capability in the range of −60 $^\circ$ to 60 $^\circ$ . When the proposed antenna is exposed to HIRF, the protective diodes mounted over the grounded coplanar waveguide (GCPW) transmission line are triggered, dramatically reducing the overall gain of the antenna array. By optimizing design, the element possesses a bandwidth of 8.8 $\sim$ 9.3 GHz. The grating lobe of the antenna array is suppressed by 17.5 dB thanks to the adoption of the non-uniform feed. The simulation results indicate that the proposed antenna element and array have a high isolation degree of 22.4 dB and 23.2 dB when exposed to HIRF, respectively. Finally, a prototype of the antenna is fabricated, and the validity of the proposed design is experimentally verified. The experimental results are in good agreement with the simulation results, demonstrating the validity of the proposed design.


  • Open Access

    Analyses of Grating Lobe and Beam Fixation Problems of Low-Profile Dynamic Antenna

    by Jibin Liu, Ming Xu, Mingtuan Lin, Yangfei Li, Bowen Deng, Yuanxin Lee, Jihong Zhang, Peiguo Liu

    Dynamic metasurface antennas (DMAs) and dynamic antenna arrays (DAAs) are emerging concepts in low-profile antenna design, providing alternative structures with lower circuit complexity and power requirements for radar and communication systems. However, dynamic antennas are prone to significant grating lobe and beam fixation problems due to their discrete amplitude and phase control. The reasons behind these issues are explored through mathematical and simulation analysis of three specific cases, and solutions are subsequently proposed and partially experimentally verified.

  • Top Cited Papers

    A Low-Profile Programmable Beam Scanning Holographic Array Antenna Without Phase Shifters

    by Shaopeng Pan, Mingtuan Lin, Ming Xu, Shichao Zhu, Li-An Bian, Gaosheng Li

    Beam scanning antenna brings new opportunities to reduce the data collision of multinode communication in the Internet of Things (IoT). This article proposes a new type antenna design scheme that can be used for IoT relay communication. A programmable beam scanning antenna without phase shifters operating in the X-band is designed to evaluate the feasibility of this scheme. The integrated design of excitation source and phase-modulated structure greatly reduces the profile of the antenna and improves the integrated degrees of freedom with other equipment. By switching the state of the PIN diode loaded on each element, different radiators can be selected and the direction of current polarization on elements can be adjusted to change the radiation phase. Furthermore, the diode states are encoded by the holographic antenna theory and controlled by the FPGA controller to realize programmable beam scanning. One-element, two-element, and 1-D array containing 32 elements are fabricated and measured. The experimental results are in good agreement with the simulation data. The operating bandwidth is 7.5% at 10 GHz while the beam scanning range of the array is $- 60{^\circ }$ –60°, with a good scanning accuracy and stability. The proposed low-profile beam scanning antenna can provide stable communication services to multiple users and smart devices as a new type of beam scanning array antenna solution for the IoT application, which is beneficial to this field.