Robson Pacífico Guimarães Lima
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Robson Pacífico Guimarães Lima has a total of 4 co-authors. Here are the top co-authors by number of shared publications:
- Heber Pimentel Gomes
UFPB
2 shared publications - Juan Moises Mauricio Villanueva
Renewable and Alternatives Energies Center (CEAR), Electrical Engineering Department (DEE), Campus I, Federal University of Paraiba (UFPB), Joao Pessoa 58051-900, Brazil
2 shared publications - Thommas Kevin Sales Flores
PPgEEC-UFRN, Federal University of Rio Grande do Norte, Natal, Brazil
2 shared publications - Anne Louise Matos Barão Oliveira
Programa de Pós-Graduação em Engenharia Mecânica, Universidade Federal da Paraíba, João Pessoa
1 shared publication
Latest Publications
- Open Access
- 18 October 2023
- Published by SWGE Sistemas Ltda in Anais Do Vi Simpósio Brasileiro de Sistemas Elétricos
- Vol. 1 (2)
Estudo experimental de robustez de um controlador PID adaptativo por modelo de referência (PID-MRAC) com entradas do tipo caóticas
The present work describes the methodologies used to evaluate the robustness of an adaptive controller used to promote pressure management in a water supply system when the system is subjected to chaotic inputs. Pressure is one of the most important quantities in supply systems and it directly impacts other associated variables such as flow for example. The standardization of pressure in the supply network, through control adjustment, can reduce the frequency of pipe ruptures, pressure-induced excessive water consumption and volume lost in leaks. To this end, the control technique used in this work was adaptive control. The analyzed controller, based on the technique, can change its gains from the dynamic changes that occur in the system over time, without necessarily having a previous data collection for the controller modeling. Tests were performed emulating chaotic inputs, such as spurious outliers and gaussian noises, likely to occur in water supply systems, to verify the controller's robustness to these inputs. The results obtained and analyzed proved the robustness of the controller, allowing a window of applicability in real supply systems.
- 18 October 2023
- Published by SWGE Sistemas Ltda in Anais Do Vi Simpósio Brasileiro de Sistemas Elétricos
- Vol. 1 (2)
Open AccessEstudo experimental de robustez de um controlador PID adaptativo por modelo de referência (PID-MRAC) com entradas do tipo caóticas
The present work describes the methodologies used to evaluate the robustness of an adaptive controller used to promote pressure management in a water supply system when the system is subjected to chaotic inputs. Pressure is one of the most important quantities in supply systems and it directly impacts other associated variables such as flow for example. The standardization of pressure in the supply network, through control adjustment, can reduce the frequency of pipe ruptures, pressure-induced excessive water consumption and volume lost in leaks. To this end, the control technique used in this work was adaptive control. The analyzed controller, based on the technique, can change its gains from the dynamic changes that occur in the system over time, without necessarily having a previous data collection for the controller modeling. Tests were performed emulating chaotic inputs, such as spurious outliers and gaussian noises, likely to occur in water supply systems, to verify the controller's robustness to these inputs. The results obtained and analyzed proved the robustness of the controller, allowing a window of applicability in real supply systems.
- Open Access
Development of a Soft Sensor for Flow Estimation in Water Supply Systems Using Artificial Neural Networks
A water supply system is considered an essential service to the population as it is about providing an essential good for life. This system typically consists of several sensors, transducers, pumps, etc., and some of these elements have high costs and/or complex installation. The indirect measurement of a quantity can be used to obtain a desired variable, dispensing with the use of a specific sensor in the plant. Among the contributions of this technique is the design of the pressure controller using the adaptive control, as well as the use of an artificial neural network for the construction of nonlinear models using inherent system parameters such as pressure, engine rotation frequency and control valve angle, with the purpose of estimating the flow. Among the various contributions of the research, we can highlight the suppression in the acquisition of physical flow meters, the elimination of physical installation and others. The validation was carried out through tests in an experimental bench located in the Laboratory of Energy and Hydraulic Efficiency in Sanitation of the Federal University of Paraiba. The results of the soft sensor were compared with those of an electromagnetic flux sensor, obtaining a maximum error of 10%.
Open AccessDevelopment of a Soft Sensor for Flow Estimation in Water Supply Systems Using Artificial Neural Networks
A water supply system is considered an essential service to the population as it is about providing an essential good for life. This system typically consists of several sensors, transducers, pumps, etc., and some of these elements have high costs and/or complex installation. The indirect measurement of a quantity can be used to obtain a desired variable, dispensing with the use of a specific sensor in the plant. Among the contributions of this technique is the design of the pressure controller using the adaptive control, as well as the use of an artificial neural network for the construction of nonlinear models using inherent system parameters such as pressure, engine rotation frequency and control valve angle, with the purpose of estimating the flow. Among the various contributions of the research, we can highlight the suppression in the acquisition of physical flow meters, the elimination of physical installation and others. The validation was carried out through tests in an experimental bench located in the Laboratory of Energy and Hydraulic Efficiency in Sanitation of the Federal University of Paraiba. The results of the soft sensor were compared with those of an electromagnetic flux sensor, obtaining a maximum error of 10%.