Peter A. Hegarty
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Peter A. Hegarty has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Lukas M. Eng
Institute of Applied Physics, TUD Dresden University of Technology, Dresden, Germany
5 shared publications - Michael Rüsing
Paderborn University
5 shared publications - Julius Ratzenberger
Institut für Angewandte Physik, Technische Universität Dresden 1 , 01062 Dresden, Germany
3 shared publications - Zeeshan H. Amber
Institut für Angewandte Physik, Technische Universität Dresden 1 , 01062 Dresden, Germany
3 shared publications - Boris Koppitz
Institut für Angewandte Physik Technische Universität Dresden 01062 Dresden Germany
2 shared publications - Elke Beyreuther
Institut für Angewandte Physik Technische Universität Dresden 01062 Dresden Germany
2 shared publications
Latest Publications
- Open Access
- 9 September 2024
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 136 (10)
Toward the reproducible fabrication of conductive ferroelectric domain walls into lithium niobate bulk single crystals
Ferroelectric domain walls (DWs) are promising structures for assembling future nano-electronic circuit elements on a larger scale since reporting domain wall currents of up to 1 mA per single DW. One key requirement hereto is their reproducible manufacturing by gaining preparative control over domain size and domain wall conductivity (DWC). To date, most works on DWC have focused on exploring the fundamental electrical properties of individual DWs within single-shot experiments, with an emphasis on quantifying the origins of DWC. Very few reports exist when it comes to comparing the DWC properties between two separate DWs, and literally nothing exists where issues of reproducibility in DWC devices have been addressed. To fill this gap while facing the challenge of finding guidelines for achieving predictable DWC performance, we report on a procedure that allows us to reproducibly prepare single hexagonal domains of a predefined diameter into uniaxial ferroelectric lithium niobate single crystals of 200 and 300 μm thickness, respectively. We show that the domain diameter can be controlled with an uncertainty of a few percent. As-grown DWs are then subjected to a standard procedure of current-limited high-voltage DWC enhancement, and they repetitively reach a DWC increase of six orders of magnitude. While all resulting DWs show significantly enhanced DWC values, their individual current–voltage (I–V) characteristics exhibit different shapes, which can be explained by variations in their 3D real structure reflecting local heterogeneities by defects, DW pinning, and surface-near DW inclination.
- 9 September 2024
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 136 (10)
Open AccessToward the reproducible fabrication of conductive ferroelectric domain walls into lithium niobate bulk single crystals
Ferroelectric domain walls (DWs) are promising structures for assembling future nano-electronic circuit elements on a larger scale since reporting domain wall currents of up to 1 mA per single DW. One key requirement hereto is their reproducible manufacturing by gaining preparative control over domain size and domain wall conductivity (DWC). To date, most works on DWC have focused on exploring the fundamental electrical properties of individual DWs within single-shot experiments, with an emphasis on quantifying the origins of DWC. Very few reports exist when it comes to comparing the DWC properties between two separate DWs, and literally nothing exists where issues of reproducibility in DWC devices have been addressed. To fill this gap while facing the challenge of finding guidelines for achieving predictable DWC performance, we report on a procedure that allows us to reproducibly prepare single hexagonal domains of a predefined diameter into uniaxial ferroelectric lithium niobate single crystals of 200 and 300 μm thickness, respectively. We show that the domain diameter can be controlled with an uncertainty of a few percent. As-grown DWs are then subjected to a standard procedure of current-limited high-voltage DWC enhancement, and they repetitively reach a DWC increase of six orders of magnitude. While all resulting DWs show significantly enhanced DWC values, their individual current–voltage (I–V) characteristics exhibit different shapes, which can be explained by variations in their 3D real structure reflecting local heterogeneities by defects, DW pinning, and surface-near DW inclination.
- Open Access
Towards the reproducible fabrication of conductive ferroelectric domain walls into lithium niobate bulk single crystals
Ferroelectric domain walls (DWs) are promising structures for assembling future nano-electronic circuit elements on a larger scale, since reporting domain wall currents of up to 1 mA per single DW. One key requirement hereto is their reproducible manufacturing by gaining preparative control over domain size and domain wall conductivity (DWC). To date, most works on DWC have focused on exploring the fundamental electrical properties of individual DWs within single shot experiments, with emphasis on quantifying the origins for DWC. Very few reports exist when it comes to compare the DWC properties between two separate DWs, and literally nothing exists where issues of reproducibility in DWC devices have been addressed. To fill this gap while facing the challenge of finding guidelines achieving predictable DWC performance, we report on a procedure that allows us to reproducibly prepare single hexagonal domains of a predefined diameter into uniaxial ferroelectric (FE) lithium niobate (LN) single crystals of 200 and 300 micrometers thickness, respectively. We show that the domain diameter can be controlled with an error of a few percent. As-grown DWs are then subjected to a standard procedure of current-controlled high-voltage DWC enhancement, repetitively reaching a DWC increase of 6 orders of magnitude. While all resulting DWs show significantly enhanced DWC values, subtle features in their individual current-voltage (I-V) characteristics hint towards different 3D shapes into the bulk, with variations probably reflecting local heterogeneities by defects, DW pinning, and surface-near DW inclination, which seem to have a larger impact than expected.
Open AccessTowards the reproducible fabrication of conductive ferroelectric domain walls into lithium niobate bulk single crystals
Ferroelectric domain walls (DWs) are promising structures for assembling future nano-electronic circuit elements on a larger scale, since reporting domain wall currents of up to 1 mA per single DW. One key requirement hereto is their reproducible manufacturing by gaining preparative control over domain size and domain wall conductivity (DWC). To date, most works on DWC have focused on exploring the fundamental electrical properties of individual DWs within single shot experiments, with emphasis on quantifying the origins for DWC. Very few reports exist when it comes to compare the DWC properties between two separate DWs, and literally nothing exists where issues of reproducibility in DWC devices have been addressed. To fill this gap while facing the challenge of finding guidelines achieving predictable DWC performance, we report on a procedure that allows us to reproducibly prepare single hexagonal domains of a predefined diameter into uniaxial ferroelectric (FE) lithium niobate (LN) single crystals of 200 and 300 micrometers thickness, respectively. We show that the domain diameter can be controlled with an error of a few percent. As-grown DWs are then subjected to a standard procedure of current-controlled high-voltage DWC enhancement, repetitively reaching a DWC increase of 6 orders of magnitude. While all resulting DWs show significantly enhanced DWC values, subtle features in their individual current-voltage (I-V) characteristics hint towards different 3D shapes into the bulk, with variations probably reflecting local heterogeneities by defects, DW pinning, and surface-near DW inclination, which seem to have a larger impact than expected.
- Open Access
- 1 December 2022
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 132 (21) , 214102
Tuning the Čerenkov second harmonic contrast from ferroelectric domain walls via anomalous dispersion
Second harmonic (SH) microscopy represents a powerful tool for the investigation of crystalline systems, such as ferroelectrics and their domain walls (DWs). Under the condition of normal dispersion, i.e., the refractive index at the SH wavelength is larger as compared to the refractive index at the fundamental wavelength, , bulk crystals will generate no SH signal. Should the bulk, however, contain DWs, an appreciable SH signal will still be detectable at the location of DWs stemming from the Čerenkov mechanism. In this work, we demonstrate both how SH signals are generated in bulk media and how the Čerenkov mechanism can be inhibited by using anomalous dispersion, i.e., . This allows us to quantitatively estimate the relative strength of the Čerenkov compared to other SH contrast mechanisms in DWs, such as the interference contrast. The results are in agreement with previous experiments based on the geometric separation of the signals. Due to the observed, strong Čerenkov contrast, such signal contributions may not be neglected in polarimetry studies of ferroelectric DWs in the future.- 1 December 2022
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 132 (21) , 214102
Open AccessTuning the Čerenkov second harmonic contrast from ferroelectric domain walls via anomalous dispersion
Second harmonic (SH) microscopy represents a powerful tool for the investigation of crystalline systems, such as ferroelectrics and their domain walls (DWs). Under the condition of normal dispersion, i.e., the refractive index at the SH wavelength is larger as compared to the refractive index at the fundamental wavelength, , bulk crystals will generate no SH signal. Should the bulk, however, contain DWs, an appreciable SH signal will still be detectable at the location of DWs stemming from the Čerenkov mechanism. In this work, we demonstrate both how SH signals are generated in bulk media and how the Čerenkov mechanism can be inhibited by using anomalous dispersion, i.e., . This allows us to quantitatively estimate the relative strength of the Čerenkov compared to other SH contrast mechanisms in DWs, such as the interference contrast. The results are in agreement with previous experiments based on the geometric separation of the signals. Due to the observed, strong Čerenkov contrast, such signal contributions may not be neglected in polarimetry studies of ferroelectric DWs in the future. - Open Access
- 24 June 2022
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 131 (24) , 244102
Turn all the lights off: Bright- and dark-field second-harmonic microscopy to select contrast mechanisms for ferroelectric domain walls
Recent analyses by polarization resolved second-harmonic (SH) microscopy have demonstrated that ferroelectric (FE) domain walls (DWs) can possess non-Ising wall characteristics and topological nature. These analyses rely on locally analyzing the properties, directionality, and magnitude of the second-order nonlinear tensor. However, when inspecting FE DWs with SH microscopy, a manifold of different effects may contribute to the observed signal difference between domains and DWs, i.e., far-field interference, Čerenkov-type phase-matching (CSHG), and changes in the aforementioned local nonlinear optical properties. They all might be present at the same time and, therefore, require careful interpretation and separation. In this work, we demonstrate how the particularly strong Čerenkov-type contrast can selectively be blocked using dark- and bright-field SH microscopy. Based on this approach, we show that other contrast mechanisms emerge that were previously overlayed by CSHG but can now be readily selected through the appropriate experimental geometry. Using the methods presented, we show that the strength of the CSHG contrast compared to the other mechanisms is approximately 22 times higher. This work lays the foundation for the in-depth analysis of FE DW topologies by SH microscopy.
- 24 June 2022
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 131 (24) , 244102
Open AccessTurn all the lights off: Bright- and dark-field second-harmonic microscopy to select contrast mechanisms for ferroelectric domain walls
Recent analyses by polarization resolved second-harmonic (SH) microscopy have demonstrated that ferroelectric (FE) domain walls (DWs) can possess non-Ising wall characteristics and topological nature. These analyses rely on locally analyzing the properties, directionality, and magnitude of the second-order nonlinear tensor. However, when inspecting FE DWs with SH microscopy, a manifold of different effects may contribute to the observed signal difference between domains and DWs, i.e., far-field interference, Čerenkov-type phase-matching (CSHG), and changes in the aforementioned local nonlinear optical properties. They all might be present at the same time and, therefore, require careful interpretation and separation. In this work, we demonstrate how the particularly strong Čerenkov-type contrast can selectively be blocked using dark- and bright-field SH microscopy. Based on this approach, we show that other contrast mechanisms emerge that were previously overlayed by CSHG but can now be readily selected through the appropriate experimental geometry. Using the methods presented, we show that the strength of the CSHG contrast compared to the other mechanisms is approximately 22 times higher. This work lays the foundation for the in-depth analysis of FE DW topologies by SH microscopy.
- Open Access
- 18 April 2022
- Published by AIP Publishing in Applied Physics Letters
- Vol. 120 (16) , 162901
High-speed hyperspectral imaging of ferroelectric domain walls using broadband coherent anti-Stokes Raman scattering
Spontaneous Raman spectroscopy (SR) is a versatile method for analysis and visualization of ferroelectric crystal structures, including domain walls. Nevertheless, the necessary acquisition time makes SR impractical for in situ analysis and large scale imaging. In this work, we introduce broadband coherent anti-Stokes Raman spectroscopy (B-CARS) as a high-speed alternative to conventional Raman techniques and demonstrate its benefits for ferroelectric domain wall analysis. Using the example of poled lithium niobate, we compare the spectral output of both techniques in terms of domain wall signatures and imaging capabilities. We extract the Raman-like resonant part of the coherent anti-Stokes signal via a Kramers–Kronig-based phase retrieval algorithm and compare the raw and phase-retrieved signals to SR characteristics. Finally, we propose a mechanism for the observed domain wall signal strength that resembles a Čerenkov-like behavior, in close analogy to domain wall signatures obtained by second-harmonic generation imaging. We, thus, lay here the foundations for future investigations on other poled ferroelectric crystals using B-CARS.
- 18 April 2022
- Published by AIP Publishing in Applied Physics Letters
- Vol. 120 (16) , 162901
Open AccessHigh-speed hyperspectral imaging of ferroelectric domain walls using broadband coherent anti-Stokes Raman scattering
Spontaneous Raman spectroscopy (SR) is a versatile method for analysis and visualization of ferroelectric crystal structures, including domain walls. Nevertheless, the necessary acquisition time makes SR impractical for in situ analysis and large scale imaging. In this work, we introduce broadband coherent anti-Stokes Raman spectroscopy (B-CARS) as a high-speed alternative to conventional Raman techniques and demonstrate its benefits for ferroelectric domain wall analysis. Using the example of poled lithium niobate, we compare the spectral output of both techniques in terms of domain wall signatures and imaging capabilities. We extract the Raman-like resonant part of the coherent anti-Stokes signal via a Kramers–Kronig-based phase retrieval algorithm and compare the raw and phase-retrieved signals to SR characteristics. Finally, we propose a mechanism for the observed domain wall signal strength that resembles a Čerenkov-like behavior, in close analogy to domain wall signatures obtained by second-harmonic generation imaging. We, thus, lay here the foundations for future investigations on other poled ferroelectric crystals using B-CARS.