Adam Lagin
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Adam Lagin has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
- Cesare Franchini
University of Vienna
2 shared publications - Gareth Steven Parkinson
Institute of Applied Physics, Vienna University of Technology, Wiedner Hauptstraße 8-10/134, 1040 Vienna, Austria
2 shared publications Lena Puntscher
Institute of Applied Physics, TU Wien, 1040 Vienna, Austria
2 shared publications- Matthias Meier
Faculty of Physics and Center for Computational Materials Science, University of Vienna, Vienna, AT 1090, Austria
2 shared publications - Michael Schmid
Institute of Applied Physics, TU Wien, Vienna, Austria
2 shared publications - Ulrike Diebold
Institute of Applied Physics, TU Wien, Vienna, Austria
2 shared publications
Latest Publications
- Open Access
- 22 May 2026
- Published by Royal Society of Chemistry (RSC) in Faraday Discussions
- Vol. 267, 172-195
CO on a Rh/Fe 3 O 4 single-atom catalyst: high-resolution infrared spectroscopy and near-ambient-pressure scanning tunnelling microscopy
A model Rh/Fe 3 O 4 (001) single-atom catalyst enables site-resolved assignment of CO stretching frequencies.
- 22 May 2026
- Published by Royal Society of Chemistry (RSC) in Faraday Discussions
- Vol. 267, 172-195
Open AccessCO on a Rh/Fe 3 O 4 single-atom catalyst: high-resolution infrared spectroscopy and near-ambient-pressure scanning tunnelling microscopy
A model Rh/Fe 3 O 4 (001) single-atom catalyst enables site-resolved assignment of CO stretching frequencies.
- Open Access
- 11 September 2023
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 127 (37) , 18378-18388
A Multitechnique Study of C2H4 Adsorption on Fe3O4(001)
The adsorption/desorption of ethene (C2H4), also commonly known as ethylene, on Fe3O4(001) was studied under ultrahigh vacuum conditions using temperature-programmed desorption (TPD), scanning tunneling microscopy, X-ray photoelectron spectroscopy, and density functional theory (DFT)-based computations. To interpret the TPD data, we have employed a new analysis method based on equilibrium thermodynamics. C2H4 adsorbs intact at all coverages and interacts most strongly with surface defects such as antiphase domain boundaries and Fe adatoms. On the regular surface, C2H4 binds atop surface Fe sites up to a coverage of 2 molecules per (√2 × √2)R45° unit cell, with every second Fe occupied. A desorption energy of 0.36 eV is determined by analysis of the TPD spectra at this coverage, which is approximately 0.1-0.2 eV lower than the value calculated by DFT + U with van der Waals corrections. Additional molecules are accommodated in between the Fe rows. These are stabilized by attractive interactions with the molecules adsorbed at Fe sites. The total capacity of the surface for C2H4 adsorption is found to be close to 4 molecules per (√2 × √2)R45° unit cell.
- 11 September 2023
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 127 (37) , 18378-18388
Open AccessA Multitechnique Study of C2H4 Adsorption on Fe3O4(001)
The adsorption/desorption of ethene (C2H4), also commonly known as ethylene, on Fe3O4(001) was studied under ultrahigh vacuum conditions using temperature-programmed desorption (TPD), scanning tunneling microscopy, X-ray photoelectron spectroscopy, and density functional theory (DFT)-based computations. To interpret the TPD data, we have employed a new analysis method based on equilibrium thermodynamics. C2H4 adsorbs intact at all coverages and interacts most strongly with surface defects such as antiphase domain boundaries and Fe adatoms. On the regular surface, C2H4 binds atop surface Fe sites up to a coverage of 2 molecules per (√2 × √2)R45° unit cell, with every second Fe occupied. A desorption energy of 0.36 eV is determined by analysis of the TPD spectra at this coverage, which is approximately 0.1-0.2 eV lower than the value calculated by DFT + U with van der Waals corrections. Additional molecules are accommodated in between the Fe rows. These are stabilized by attractive interactions with the molecules adsorbed at Fe sites. The total capacity of the surface for C2H4 adsorption is found to be close to 4 molecules per (√2 × √2)R45° unit cell.
- Open Access
- 1 April 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 71 (00189456) , 1-12
Sample Holders for Sub-THz Electron Spin Resonance Spectroscopy
Electron spin resonance (ESR) is a powerful spectroscopic technique used to investigate samples with unpaired electrons in a broad range of scientific fields. High-frequency ESR (HF-ESR) spectrometers operating at sub-THz frequencies are mostly custom-made with non-standard solutions. This article presents a set of six different exchangeable sample holders with a fast-loading flange for a sub-THz ESR spectrometer operating at high magnetic fields up to 16 T and temperature ranges of 4–400 K. Here, we report on the concept, design, and illustrative measurements of non-resonant ESR sample holders for the measurements of samples in a liquid solution, polycrystalline-compressed powders, oriented single crystals, electrical devices under sub-THz irradiation, as well as for samples transferred from the ultrahigh vacuum (UHV) systems without air contamination. Our solution expands the usage possibilities for HF-ESR spectroscopy, showing that one spectrometer with the presented concept of sample holders enables a wide range of applications.
- 1 April 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Instrumentation and Measurement
- Vol. 71 (00189456) , 1-12
Open AccessSample Holders for Sub-THz Electron Spin Resonance Spectroscopy
Electron spin resonance (ESR) is a powerful spectroscopic technique used to investigate samples with unpaired electrons in a broad range of scientific fields. High-frequency ESR (HF-ESR) spectrometers operating at sub-THz frequencies are mostly custom-made with non-standard solutions. This article presents a set of six different exchangeable sample holders with a fast-loading flange for a sub-THz ESR spectrometer operating at high magnetic fields up to 16 T and temperature ranges of 4–400 K. Here, we report on the concept, design, and illustrative measurements of non-resonant ESR sample holders for the measurements of samples in a liquid solution, polycrystalline-compressed powders, oriented single crystals, electrical devices under sub-THz irradiation, as well as for samples transferred from the ultrahigh vacuum (UHV) systems without air contamination. Our solution expands the usage possibilities for HF-ESR spectroscopy, showing that one spectrometer with the presented concept of sample holders enables a wide range of applications.