Ken Miyauchi has a total of 78 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Improvement in Random Noise for Pixel-Parallel Single-Slope ADC with Consideration of Flicker Noise Effect

    by Masayuki Uno, Kwuang-Han Chang, Tsung-Hsun Tsai, Junichi Nakamura, Rimon Ikeno, Kazuya Mori, Ken Miyauchi, Toshiyuki Isozaki, Yi-Hsuan Lin, Sheng-Yeh Lai, et al.

    We propose and demonstrate a low-random-noise (RN) design for pixel-parallel single-slope ADCs (SS-ADCs), achieving 2.2 e-rms in a 3.24 µm pixel. In this paper, we discuss AC-based RN estimation with respect to the comparator bias current and a bandwidth-limiting capacitor in digital-pixel sensors (DPSs). RN is composed of thermal noise (TN) and flicker noise (FN), where FN can be a major contributor in DPSs because of its area limitation. We express the concise equation to estimate the FN/TN ratio, in which the FN characteristic is modulated by the correlated double sampling (CDS) operation. We also study the effective RN bandwidth, which increases due to the ramp slope transient effect and introduces a noise bandwidth (NBW) coefficient, to estimate the effective NBW. This study provides insights into the area arrangement of the small-pixel DPS design. A high-gain single-ended comparator is introduced to realize an area-efficient DPS without digital CDS (D-CDS). Noise analysis of its pixel design shows that FN becomes the main contributor, and further RN improvement by limiting NBW or D-CDS is not promising under these conditions.

  • Open Access

    An Area-Efficient Readout Circuit for a High-SNR Triple-Gain LOFIC CMOS Image Sensor

    by Ai Otani, Hiroaki Ogawa, Ken Miyauchi, Yuki Morikawa, Hideki Owada, Isao Takayanagi, Shunsuke Okura

    A lateral overflow integration capacitor (LOFIC) CMOS image sensor (CIS) can achieve high-dynamic-range (HDR) imaging by combining a low-conversion-gain (LCG) signal with a high-conversion-gain (HCG) signal. However, the signal-to-noise ratio (SNR) drops at the switching point from HCG signal to LCG signal due to the significant pixel noise in the LCG signal. To address this issue, a triple-gain LOFIC CIS with a middle-conversion-gain (MCG) signal has been introduced. In this work, we propose an area-efficient readout circuit for the triple-gain LOFIC CIS, using amplifier and capacitor sharing techniques to process the HCG, MCG, and LCG signals. A test chip of the proposed readout circuit was fabricated using the 0.18μm CMOS process. The area overhead was only 7.6%, and the SNR drop was improved by 8.05 dB compared to the readout circuit for a dual-gain LOFIC CIS.


  • Open Access

    A 3.96-μm, 124-dB Dynamic-Range, Digital-Pixel Sensor With Triple- and Single-Quantization Operations for Monochrome and Near-Infrared Dual-Channel Global Shutter Operation

    by Ken Miyauchi, Masayuki Uno, Toshiyuki Isozaki, Hideyuki Fukuhara, Kazuya Mori, Hirofumi Abe, Masato Nagamatsu, Rimon Ikeno, Isao Takayanagi, Hsin-Li Chen, et al.

    This article presents a 3.96- $\mu $ m, $640 \times 640$ pixel stacked digital pixel sensor capable of capturing co-located monochrome (MONO) and near-infrared (NIR) frames simultaneously in a dual-channel global shutter (GS) operation. A super-pixel structure is proposed with diagonally arranged $2 \times 2$ MONO and NIR sub-pixels. To enhance visible light sensitivity, large and small non-uniform micro-lenses are formed on the MONO and NIR sub-pixels, respectively. Each floating diffusion (FD) shared super-pixel is connected to an in-pixel analog-to-digital converter and two banks of 10-bit static random access memories (SRAMs) to enable the dual-channel GS operation. To achieve high dynamic range (DR) in the MONO channel, a triple-quantization (3Q) operation is performed. Furthermore, a single-channel digital-correlated double sampling (D-CDS) 3Q operation is implemented. The fabricated sensor achieved 6.2-mW low power consumption at 30 frames/s with dual-channel capture. The MONO channel achieved 124-dB DR in the 3Q operation and 60 dB for the NIR channel. The sensor fits the stringent form-factor requirement of an augmented reality headset by consolidating MONO and NIR imaging capabilities.


  • Open Access

    Analysis of Light Intensity and Charge Holding Time Dependence of Pinned Photodiode Full Well Capacity

    by Ken Miyauchi, Toshiyuki Isozaki, Rimon Ikeno, Junichi Nakamura

    In this paper, the light intensity and charge holding time dependence of pinned photodiode (PD) full well capacity (FWC) are studied for our pixel structure with a buried overflow path under the transfer gate. The formulae for PDFWC derived from a simple analytical model show that the relation between light intensity and PDFWC is logarithmic because PDFWC is determined by the balance between the photo-generated current and overflow current under the bright condition. Furthermore, with using pulsed light before a charge holding operation in PD, the accumulated charges in PD decrease with the holding time due to the overflow current, and finally, it reaches equilibrium PDFWC. The analytical model has been successfully validated by the technology computer-aided design (TCAD) device simulation and actual device measurement.


  • Open Access

    An Area-Efficient up/down Double-Sampling Circuit for a LOFIC CMOS Image Sensor

    by Ai Otani, Hiroaki Ogawa, Ken Miyauchi, Sangman Han, Hideki Owada, Isao Takayanagi, Shunsuke Okura

    A lateral overflow integration capacitor (LOFIC) complementary metal oxide semiconductor (CMOS) image sensor can realize high-dynamic-range (HDR) imaging with combination of a low-conversion-gain (LCG) signal for large maximum signal electrons and a high-conversion-gain (HCG) signal for electron-referred noise floor. However, LOFIC-CMOS image sensor requires a two-channel read-out chain for LCG and HCG signals whose polarities are inverted. In order to provide an area-efficient LOFIC-CMOS image sensor, a one-channel read-out chain that can process both HCG and LCG signals is presented in this paper. An up/down double-sampling circuit composed of an inverting amplifier for HCG signals and a non-inverting attenuator for LCG signals can reduce the area of the read-out chain by half compared to the conventional two-channel read-out chain. A test chip is fabricated in a 0.18 μm CMOS process with a metal–insulator–metal (MIM) capacitor, achieving a readout noise of 130 μVrms for the HCG signal and 1.19 V for the LCG input window. The performance is equivalent to 103 dB of the dynamic range with our previous LOFIC pixel in which HCG and LCG conversion gains are, respectively, 160 μV/e− and 10 μV/e−.


  • Open Access

    A 4.0 μm Stacked Digital Pixel Sensor Operating in a Dual Quantization Mode for High Dynamic Range

    by Kazuya Mori, Naoto Yasuda, Ken Miyauchi, Toshiyuki Isozaki, Isao Takayanagi, Junichi Nakamura, Ho-Ching Chien, Ken Fu, Shou-Gwo Wuu, Andrew Berkovich, et al.

    It is anticipated that ubiquitous computer vision (CV) and artificial intelligence (AI) applications used on mobile devices will grow significantly. Such applications require battery-powered, always-on mobile devices to support indoor/outdoor, day/night usages. A global shutter (GS), stacked digital pixel sensor (DPS) is a promising candidate to meet such requirements because of its potential for ultralow-power, ultrahigh dynamic range (HDR), and a small form factor. This article presents a prototype 4.0- ${\mu } \text{m}$ stacked DPS operating in its dual quantization (2Q) to realize HDR. The 4.0- ${\mu }\text{m}$ DPS pixel is formed with two layers, a backside illuminated pinned photodiode (PD) pixel on the top layer and an in-pixel analog-to-digital conversion (ADC) circuit with 9-bit static random access memory (SRAM) on the bottom layer. A Cu-to-Cu hybrid bonding (HB) technology is used to connect the two layers via pixel-level interconnect. In the 2Q scheme, a time-stamp (TS) quantization and a linear ADC are performed sequentially in the same frame, which extends the dynamic range (DR) with a small number of ADC bits of 9. The DPS with a 1024 $\times$ 832 pixel array has achieved a single-exposure ultra HDR of 107 dB in a single frame. The nonlinear conversion characteristic of the TS mode provides an equivalent full well capacity (FWC) of 2000ke−, while the noise floor in the linear ADC mode is 8.3e−.


  • A 4.6-μm, 127-dB Dynamic Range, Ultra-Low Power Stacked Digital Pixel Sensor With Overlapped Triple Quantization

    by Rimon Ikeno, Kazuya Mori, Masayuki Uno, Ken Miyauchi, Toshiyuki Isozaki, Isao Takayanagi, Junichi Nakamura, Shou-Gwo Wuu, Lyle Bainbridge, Andrew Berkovich, et al.

    This article presents a global shutter (GS), stacked digital pixel sensor (DPS) to meet the ultra-low power, ultra high dynamic range (HDR) requirements for battery-powered, always-on mobile computer vision (CV) applications. The $4.6~\mu \text{m}$ DPS pixel is partitioned into two layers; a dual conversion gain (CG) pixel with a backside-illuminated photodiode (PD) on the top layer and an in-pixel ADC circuit with 10 bit SRAM on the bottom layer. A Cu-to-Cu hybrid-bonding (HB) technology is used to connect the two layers via pixel-level interconnect. The sensor features an overlapped triple quantization (3Q) scheme that performs a time-to-saturation (TTS) quantization and the dual-CG linear ADC mode sequentially in the same frame and extends the dynamic range (DR) with a small number of ADC bits. The DPS with a $512\times512$ pixel array has achieved an ultra-HDR of 127 dB and low power consumption of 5.75 mW at 30 frames per second. The nonlinear conversion characteristics of the TTS mode provide an equivalent full well capacity (FWC) of 9000 ke−, while the high CG linear ADC mode realizes a low noise floor of 4.2 e−.


  • [Paper] 4.0 μm Stacked Voltage Mode Global Shutter Pixels with Single Exposure High Dynamic Range and Phase Detection Auto Focus Capability

    by Ken Miyauchi, Kazuya Mori, Toshiyuki Isozaki, Yusuke Sawai, Naoto Yasuda, Ho-Ching Chien, Ken Wen-Chien Fu, Isao Takayanagi, Junichi Nakamura

    In this paper, two types of 4.0 μm back side illuminated stacked voltage mode global shutter pixels implemented in a prototype CMOS image sensor are reported. One is a pixel with a lateral overflow integration capacitor (LOFIC) to expand the sensor dynamic range and the other is a pixel having dual photodiodes and dual conversion gains which enables the phase detection auto focus capability with single exposure high dynamic range (SEHDR). Thanks to the LOFIC and the dual conversion gain technologies, SEHDR of 90 dB and 77 dB has been achieved in the global shutter mode.


  • Open Access

    A Stacked Back Side-Illuminated Voltage Domain Global Shutter CMOS Image Sensor with a 4.0 μm Multiple Gain Readout Pixel

    by Ken Miyauchi, Kazuya Mori, Toshinori Otaka, Toshiyuki Isozaki, Naoto Yasuda, Alex Tsai, Yusuke Sawai, Hideki Owada, Isao Takayanagi, Junichi Nakamura

    A backside-illuminated complementary metal-oxide-semiconductor (CMOS) image sensor with 4.0 μm voltage domain global shutter (GS) pixels has been fabricated in a 45 nm/65 nm stacked CMOS process as a proof-of-concept vehicle. The pixel components for the photon-to-voltage conversion are formed on the top substrate (the first layer). Each voltage signal from the first layer pixel is stored in the sample-and-hold capacitors on the bottom substrate (the second layer) via micro-bump interconnection to achieve a voltage domain GS function. The two sets of voltage domain storage capacitor per pixel enable a multiple gain readout to realize single exposure high dynamic range (SEHDR) in the GS operation. As a result, an 80dB SEHDR GS operation without rolling shutter distortions and motion artifacts has been achieved. Additionally, less than −140dB parasitic light sensitivity, small noise floor, high sensitivity and good angular response have been achieved.


  • Open Access

    A 120-ke− Full-Well Capacity 160-µV/e− Conversion Gain 2.8-µm Backside-Illuminated Pixel with a Lateral Overflow Integration Capacitor

    by Isao Takayanagi, Ken Miyauchi, Shunsuke Okura, Kazuya Mori, Junichi Nakamura, Shigetoshi Sugawa

    In this paper, a prototype complementary metal-oxide-semiconductor (CMOS) image sensor with a 2.8-μm backside-illuminated (BSI) pixel with a lateral overflow integration capacitor (LOFIC) architecture is presented. The pixel was capable of a high conversion gain readout with 160 μV/e− for low light signals while a large full-well capacity of 120 ke− was obtained for high light signals. The combination of LOFIC and the BSI technology allowed for high optical performance without degradation caused by extra devices for the LOFIC structure. The sensor realized a 70% peak quantum efficiency with a normal (no anti-reflection coating) cover glass and a 91% angular response at ±20° incident light. This 2.8-μm pixel is potentially capable of higher than 100 dB dynamic range imaging in a pure single exposure operation.