M. Ady
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
M. Ady has a total of 1000 co-authors. Here are the top co-authors by number of shared publications:
- Carsten Peter Welsch
The University of Liverpool
5 shared publications R. Veness
European Organization for Nuclear Research
4 shared publications- Roberto Kersevan
European Organization for Nuclear Research
4 shared publications - Stefano Mazzoni
European Organization for Nuclear Research
4 shared publications - A. D'AVanzo
INFN Sezione di Napoli
3 shared publications - A. T. Watson
University of Birmingham
3 shared publications
Latest Publications
- Open Access
- 21 July 2026
- Published by Springer Nature in The European Physical Journal C
- Vol. 86 (7)
Erratum to: Future Circular Collider Feasibility Study Report
- 21 July 2026
- Published by Springer Nature in The European Physical Journal C
- Vol. 86 (7)
Open AccessErratum to: Future Circular Collider Feasibility Study Report
- Top Cited PapersOpen Access
- 24 December 2025
- Published by Springer Nature in The European Physical Journal C
- Vol. 85 (12)
Future Circular Collider Feasibility Study Report
Volume 1 of the FCC Feasibility Report presents an overview of the physics case, experimental programme, and detector concepts for the Future Circular Collider (FCC). This volume outlines how FCC would address some of the most profound open questions in particle physics, from precision studies of the Higgs and EW bosons and of the top quark, to the exploration of physics beyond the Standard Model. The report reviews the experimental opportunities offered by the staged implementation of FCC, beginning with an electron-positron collider (FCC-ee), operating at several centre-of-mass energies, followed by a hadron collider (FCC-hh). Benchmark examples are given of the expected physics performance, in terms of precision and sensitivity to new phenomena, of each collider stage. Detector requirements and conceptual designs for FCC-ee experiments are discussed, as are the specific demands that the physics programme imposes on the accelerator in the domains of the calibration of the collision energy, and the interface region between the accelerator and the detector. The report also highlights advances in detector, software and computing technologies, as well as the theoretical tools/reconstruction techniques that will enable the precision measurements and discovery potential of the FCC experimental programme. The content and structure of this report are guided by the scope and priorities defined in the mandate of the FCC Feasibility Study. It is therefore not intended to serve as an exhaustive review of the full physics potential of FCC. Several topics, already covered in earlier reports such as the FCC CDR, are not reiterated here or are addressed only briefly, in alignment with the study’s focus. This volume reflects the outcome of a global collaborative effort involving hundreds of scientists and institutions, aided by a dedicated community-building coordination, and provides a targeted assessment of the scientific opportunities and experimental foundations of the FCC programme.
- 24 December 2025
- Published by Springer Nature in The European Physical Journal C
- Vol. 85 (12)
Top Cited PapersOpen AccessFuture Circular Collider Feasibility Study Report
Volume 1 of the FCC Feasibility Report presents an overview of the physics case, experimental programme, and detector concepts for the Future Circular Collider (FCC). This volume outlines how FCC would address some of the most profound open questions in particle physics, from precision studies of the Higgs and EW bosons and of the top quark, to the exploration of physics beyond the Standard Model. The report reviews the experimental opportunities offered by the staged implementation of FCC, beginning with an electron-positron collider (FCC-ee), operating at several centre-of-mass energies, followed by a hadron collider (FCC-hh). Benchmark examples are given of the expected physics performance, in terms of precision and sensitivity to new phenomena, of each collider stage. Detector requirements and conceptual designs for FCC-ee experiments are discussed, as are the specific demands that the physics programme imposes on the accelerator in the domains of the calibration of the collision energy, and the interface region between the accelerator and the detector. The report also highlights advances in detector, software and computing technologies, as well as the theoretical tools/reconstruction techniques that will enable the precision measurements and discovery potential of the FCC experimental programme. The content and structure of this report are guided by the scope and priorities defined in the mandate of the FCC Feasibility Study. It is therefore not intended to serve as an exhaustive review of the full physics potential of FCC. Several topics, already covered in earlier reports such as the FCC CDR, are not reiterated here or are addressed only briefly, in alignment with the study’s focus. This volume reflects the outcome of a global collaborative effort involving hundreds of scientists and institutions, aided by a dedicated community-building coordination, and provides a targeted assessment of the scientific opportunities and experimental foundations of the FCC programme.
- Open Access
- 10 November 2025
- Published by American Physical Society (APS) in Physical Review Research
- Vol. 7 (4) , 043144
Full-cycle, noninvasive emittance monitoring with the beam gas curtain monitor at the LHC
The large energy range and high intensity of current hadron accelerators, such as the Large Hadron Collider (LHC) and its planned high-luminosity upgrade, pose great challenges to beam measurements. The Beam Gas Curtain presents an accurate, minimally invasive profile monitor with a large energy range for high-intensity beams, by exploiting fluorescence from a supersonic gas jet interacting with the accelerator particle beam. In this paper, we report for the first time the proton and lead ion beam transverse profile and emittance continuously measured throughout the whole LHC energy range.
- 10 November 2025
- Published by American Physical Society (APS) in Physical Review Research
- Vol. 7 (4) , 043144
Open AccessFull-cycle, noninvasive emittance monitoring with the beam gas curtain monitor at the LHC
The large energy range and high intensity of current hadron accelerators, such as the Large Hadron Collider (LHC) and its planned high-luminosity upgrade, pose great challenges to beam measurements. The Beam Gas Curtain presents an accurate, minimally invasive profile monitor with a large energy range for high-intensity beams, by exploiting fluorescence from a supersonic gas jet interacting with the accelerator particle beam. In this paper, we report for the first time the proton and lead ion beam transverse profile and emittance continuously measured throughout the whole LHC energy range.
- Open Access
- 1 June 2024
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 19 (06) , P06014
Beam-induced backgrounds measured in the ATLAS detector during local gas injection into the LHC beam vacuum
Inelastic beam-gas collisions at the Large Hadron Collider (LHC), within a few hundred metres of the ATLAS experiment, are known to give the dominant contribution to beam backgrounds. These are monitored by ATLAS with a dedicated Beam Conditions Monitor (BCM) and with the rate of fake jets in the calorimeters. These two methods are complementary since the BCM probes backgrounds just around the beam pipe while fake jets are observed at radii of up to several metres. In order to quantify the correlation between the residual gas density in the LHC beam vacuum and the experimental backgrounds recorded by ATLAS, several dedicated tests were performed during LHC Run 2. Local pressure bumps, with a gas density several orders of magnitude higher than during normal operation, were introduced at different locations. The changes of beam-related backgrounds, seen in ATLAS, are correlated with the local pressure variation. In addition the rates of beam-gas events are estimated from the pressure measurements and pressure bump profiles obtained from calculations. Using these rates, the efficiency of the ATLAS beam background monitors to detect beam-gas events is derived as a function of distance from the interaction point. These efficiencies and characteristic distributions of fake jets from the beam backgrounds are found to be in good agreement with results of beam-gas simulations performed with the Fluka Monte Carlo programme.
- 1 June 2024
- Published by IOP Publishing in Journal of Instrumentation
- Vol. 19 (06) , P06014
Open AccessBeam-induced backgrounds measured in the ATLAS detector during local gas injection into the LHC beam vacuum
Inelastic beam-gas collisions at the Large Hadron Collider (LHC), within a few hundred metres of the ATLAS experiment, are known to give the dominant contribution to beam backgrounds. These are monitored by ATLAS with a dedicated Beam Conditions Monitor (BCM) and with the rate of fake jets in the calorimeters. These two methods are complementary since the BCM probes backgrounds just around the beam pipe while fake jets are observed at radii of up to several metres. In order to quantify the correlation between the residual gas density in the LHC beam vacuum and the experimental backgrounds recorded by ATLAS, several dedicated tests were performed during LHC Run 2. Local pressure bumps, with a gas density several orders of magnitude higher than during normal operation, were introduced at different locations. The changes of beam-related backgrounds, seen in ATLAS, are correlated with the local pressure variation. In addition the rates of beam-gas events are estimated from the pressure measurements and pressure bump profiles obtained from calculations. Using these rates, the efficiency of the ATLAS beam background monitors to detect beam-gas events is derived as a function of distance from the interaction point. These efficiencies and characteristic distributions of fake jets from the beam backgrounds are found to be in good agreement with results of beam-gas simulations performed with the Fluka Monte Carlo programme.
- Open Access
- 12 April 2024
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 27 (4) , 043201
Beam gas curtain monitor: Vacuum studies for LHC integration and operation
A beam gas curtain (BGC) monitor has been designed to obtain information about the relative position between the LHC proton beam and the hollow electron lens electron beam through a minimally invasive process. Its working principle relies on intersecting the path of both beams with a supersonic gas curtain, introduced transversely into the LHC beamline, to produce a fluorescence signal. As an intermediate project stage (phase II), a preliminary version of the BGC monitor has been installed into the LHC beamline. To ensure the successful integration of the monitor and subsequent operation under LHC ultrahigh vacuum conditions, a series of vacuum studies have been performed. These can be classified as follows: An off-line laboratory test campaign, to assess BGC behavior during pump down and gas injections; simulations and analytical calculations, to evaluate BGC behavior and estimate the impact of its installation and operation in the LHC. This document will briefly present the off-line tests campaign, followed by a more extensive description of the simulations performed. Published by the American Physical Society 2024
- 12 April 2024
- Published by American Physical Society (APS) in Physical Review Accelerators and Beams
- Vol. 27 (4) , 043201
Open AccessBeam gas curtain monitor: Vacuum studies for LHC integration and operation
A beam gas curtain (BGC) monitor has been designed to obtain information about the relative position between the LHC proton beam and the hollow electron lens electron beam through a minimally invasive process. Its working principle relies on intersecting the path of both beams with a supersonic gas curtain, introduced transversely into the LHC beamline, to produce a fluorescence signal. As an intermediate project stage (phase II), a preliminary version of the BGC monitor has been installed into the LHC beamline. To ensure the successful integration of the monitor and subsequent operation under LHC ultrahigh vacuum conditions, a series of vacuum studies have been performed. These can be classified as follows: An off-line laboratory test campaign, to assess BGC behavior during pump down and gas injections; simulations and analytical calculations, to evaluate BGC behavior and estimate the impact of its installation and operation in the LHC. This document will briefly present the off-line tests campaign, followed by a more extensive description of the simulations performed. Published by the American Physical Society 2024
- Open Access
- 25 April 2022
- Published by AIP Publishing in Applied Physics Letters
- Vol. 120 (17) , 174101
A gas curtain beam profile monitor using beam induced fluorescence for high intensity charged particle beams
A minimally invasive transverse beam profile monitor based on supersonic gas curtain technology and beam-induced fluorescence has been developed and demonstrated. The concept presented can be used to measure both the profile of the proton beam in the Large Hadron Collider (LHC) and the concentricity of the electron and the proton beams in the LHC hollow electron lens. In this Letter, the performance of such a monitor for a low energy electron beam is discussed, which paves the way for its wider implementation.
- 25 April 2022
- Published by AIP Publishing in Applied Physics Letters
- Vol. 120 (17) , 174101
Open AccessA gas curtain beam profile monitor using beam induced fluorescence for high intensity charged particle beams
A minimally invasive transverse beam profile monitor based on supersonic gas curtain technology and beam-induced fluorescence has been developed and demonstrated. The concept presented can be used to measure both the profile of the proton beam in the Large Hadron Collider (LHC) and the concentricity of the electron and the proton beams in the LHC hollow electron lens. In this Letter, the performance of such a monitor for a low energy electron beam is discussed, which paves the way for its wider implementation.