Jae Hwan Jeong
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Jae Hwan Jeong has a total of 24 co-authors. Here are the top co-authors by number of shared publications:
- Gwan-Hyoung Lee
Seoul National University
4 shared publications - Kenji Watanabe
National Institute for Materials Science
2 shared publications - Alejandro Díez-Martínez
Department of Condensed Matter Physics and IFIMAC, Universidad Autónoma de Madrid, Madrid, Spain
1 shared publication Byeong Chan Kim
Department of Materials Science and Engineering, Seoul National University, Seoul 08826, Republic of Korea
1 shared publicationChul‐Ho Lee
KU‐KIST Graduate School of Converging Science and Technology Korea University Seoul 02841 Korea
1 shared publication- Diego Alonso Aldave
Shenzhen University
1 shared publication
Latest Publications
- Open Access
- 30 July 2025
- Published by Elsevier in Materials & Design
- Vol. 257
Probing the structural resilience of tobacco mosaic virus under thermal stress
- 30 July 2025
- Published by Elsevier in Materials & Design
- Vol. 257
Open AccessProbing the structural resilience of tobacco mosaic virus under thermal stress
- 4 May 2024
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 18 (20) , 13098-13105
Van der Waals Epitaxially Grown Molecular Crystal Dielectric Sb2O3 for 2D Electronics
Two-dimensional (2D) semiconducting materials have attracted significant interest as promising candidates for channel materials owing to their high mobility and gate tunability at atomic-layer thickness. However, the development of 2D electronics is impeded due to the difficulty in formation of high-quality dielectrics with a clean and nondestructive interface. Here, we report the direct van der Waals epitaxial growth of a molecular crystal dielectric, Sb2O3, on 2D materials by physical vapor deposition. The grown Sb2O3 nanosheets showed epitaxial relations of 0 and 180° with the 2D template, maintaining high crystallinity and an ultrasharp vdW interface with the 2D materials. As a result, the Sb2O3 nanosheets exhibited a high breakdown field of 18.6 MV/cm for 2L Sb2O3 with a thickness of 1.3 nm and a very low leakage current of 2.47 × 10-7 A/cm2 for 3L Sb2O3 with a thickness of 1.96 nm. We also observed two types of grain boundaries (GBs) with misorientation angles of 0 and 60°. The 0°-GB with a well-stitched boundary showed higher electrical and thermal stabilities than those of the 60°-GB with a disordered boundary. Our work demonstrates a method to epitaxially grow molecular crystal dielectrics on 2D materials without causing any damage, a requirement for high-performance 2D electronics.
- 4 May 2024
- Published by American Chemical Society (ACS) in ACS Nano
- Vol. 18 (20) , 13098-13105
Van der Waals Epitaxially Grown Molecular Crystal Dielectric Sb2O3 for 2D Electronics
Two-dimensional (2D) semiconducting materials have attracted significant interest as promising candidates for channel materials owing to their high mobility and gate tunability at atomic-layer thickness. However, the development of 2D electronics is impeded due to the difficulty in formation of high-quality dielectrics with a clean and nondestructive interface. Here, we report the direct van der Waals epitaxial growth of a molecular crystal dielectric, Sb2O3, on 2D materials by physical vapor deposition. The grown Sb2O3 nanosheets showed epitaxial relations of 0 and 180° with the 2D template, maintaining high crystallinity and an ultrasharp vdW interface with the 2D materials. As a result, the Sb2O3 nanosheets exhibited a high breakdown field of 18.6 MV/cm for 2L Sb2O3 with a thickness of 1.3 nm and a very low leakage current of 2.47 × 10-7 A/cm2 for 3L Sb2O3 with a thickness of 1.96 nm. We also observed two types of grain boundaries (GBs) with misorientation angles of 0 and 60°. The 0°-GB with a well-stitched boundary showed higher electrical and thermal stabilities than those of the 60°-GB with a disordered boundary. Our work demonstrates a method to epitaxially grow molecular crystal dielectrics on 2D materials without causing any damage, a requirement for high-performance 2D electronics.
- 13 February 2023
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 23 (7) , 3085-3089
Gate-Tunable Electrostatic Friction of Grain Boundary in Chemical-Vapor-Deposited MoS2
Two-dimensional (2D) semiconducting materials, such as MoS2, are widely studied owing to their great potential in advanced electronic devices. However, MoS2 films grown using chemical vapor deposition (CVD) exhibit lower-than-expected properties owing to numerous defects. Among them, grain boundary (GB) is a critical parameter that determines electrical and mechanical properties of MoS2. Herein, we report the gate-tunable electrostatic friction of GBs in CVD-grown MoS2. Using atomic force microscopy (AFM), we found that electrostatic friction of MoS2 is generated by the Coulomb interaction between tip and carriers of MoS2, which is associated with the local band structure of GBs. Therefore, electrostatic friction is enhanced by localized charge carrier distribution at GB, which is linearly related to the loading force of the tip. Our study shows a strong correlation between electrostatic friction and localized band structure in MoS2 GB, providing a novel method for identifying and characterizing GBs of polycrystalline 2D materials.
- 13 February 2023
- Published by American Chemical Society (ACS) in Nano Letters
- Vol. 23 (7) , 3085-3089
Gate-Tunable Electrostatic Friction of Grain Boundary in Chemical-Vapor-Deposited MoS2
Two-dimensional (2D) semiconducting materials, such as MoS2, are widely studied owing to their great potential in advanced electronic devices. However, MoS2 films grown using chemical vapor deposition (CVD) exhibit lower-than-expected properties owing to numerous defects. Among them, grain boundary (GB) is a critical parameter that determines electrical and mechanical properties of MoS2. Herein, we report the gate-tunable electrostatic friction of GBs in CVD-grown MoS2. Using atomic force microscopy (AFM), we found that electrostatic friction of MoS2 is generated by the Coulomb interaction between tip and carriers of MoS2, which is associated with the local band structure of GBs. Therefore, electrostatic friction is enhanced by localized charge carrier distribution at GB, which is linearly related to the loading force of the tip. Our study shows a strong correlation between electrostatic friction and localized band structure in MoS2 GB, providing a novel method for identifying and characterizing GBs of polycrystalline 2D materials.
Laser‐Induced Phase Transition and Patterning of hBN‐Encapsulated MoTe2
Transition metal dichalcogenides exhibit phase transitions through atomic migration when triggered by various stimuli, such as strain, doping, and annealing. However, since atomically thin 2D materials are easily damaged and evaporated from these strategies, studies on the crystal structure and composition of transformed 2D phases are limited. Here, the phase and composition change behavior of laser‐irradiated molybdenum ditelluride (MoTe2) in various stacked geometry are investigated, and the stable laser‐induced phase patterning in hexagonal boron nitride (hBN)‐encapsulated MoTe2 is demonstrated. When air‐exposed or single‐side passivated 2H‐MoTe2 are irradiated by a laser, MoTe2 is transformed into Te or Mo3Te4 due to the highly accumulated heat and atomic evaporation. Conversely, hBN‐encapsulated 2H‐MoTe2 transformed into a 1T′ phase without evaporation or structural degradation, enabling stable phase transitions in desired regions. The laser‐induced phase transition shows layer number dependence; thinner MoTe2 has a higher phase transition temperature. From the stable phase patterning method, the low contact resistivity of 1.13 kΩ µm in 2H‐MoTe2 field‐effect transistors with 1T′ contacts from the seamless heterophase junction geometry is achieved. This study paves an effective way to fabricate monolithic 2D electronic devices with laterally stitched phases and provides insights into phase and compositional changes in 2D materials.
Laser‐Induced Phase Transition and Patterning of hBN‐Encapsulated MoTe2
Transition metal dichalcogenides exhibit phase transitions through atomic migration when triggered by various stimuli, such as strain, doping, and annealing. However, since atomically thin 2D materials are easily damaged and evaporated from these strategies, studies on the crystal structure and composition of transformed 2D phases are limited. Here, the phase and composition change behavior of laser‐irradiated molybdenum ditelluride (MoTe2) in various stacked geometry are investigated, and the stable laser‐induced phase patterning in hexagonal boron nitride (hBN)‐encapsulated MoTe2 is demonstrated. When air‐exposed or single‐side passivated 2H‐MoTe2 are irradiated by a laser, MoTe2 is transformed into Te or Mo3Te4 due to the highly accumulated heat and atomic evaporation. Conversely, hBN‐encapsulated 2H‐MoTe2 transformed into a 1T′ phase without evaporation or structural degradation, enabling stable phase transitions in desired regions. The laser‐induced phase transition shows layer number dependence; thinner MoTe2 has a higher phase transition temperature. From the stable phase patterning method, the low contact resistivity of 1.13 kΩ µm in 2H‐MoTe2 field‐effect transistors with 1T′ contacts from the seamless heterophase junction geometry is achieved. This study paves an effective way to fabricate monolithic 2D electronic devices with laterally stitched phases and provides insights into phase and compositional changes in 2D materials.
- 20 April 2022
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 24 (18) , 10684-10711
Recent trends in covalent functionalization of 2D materials
Covalent functionalization of the surface is crucial in 2D materials because of their atomic thinness, large surface-to-volume ratio, and uniform surface chemical potential.
- 20 April 2022
- Published by Royal Society of Chemistry (RSC) in Physical Chemistry Chemical Physics
- Vol. 24 (18) , 10684-10711
Recent trends in covalent functionalization of 2D materials
Covalent functionalization of the surface is crucial in 2D materials because of their atomic thinness, large surface-to-volume ratio, and uniform surface chemical potential.