ASAndrés Sepúlveda

Andrés Sepúlveda

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Andrés Sepúlveda has a total of 40 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Enhancing the stability of silicon anodes using polymer binders based on host-guest and hydrogen-bonding interactions: Do small changes in guest tether length matter?

    by Rudy Martín-Trasancos, Ana L. Montero-Alejo, Mariela G. Ortiz, Andrés Sepúlveda, Guadalupe Pizarro, Claudio García Herrera, Sebastian Andrés Toro, Juan Escrig, Cristhian Berríos, Yamilé Bernardo-Otero

  • Electronic stopping cross sections of rhodium for protons and determination of the mean excitation energy

    by Paulina Valdivia, Pedro Miranda, Tabatha Rodríguez, Andrés Sepúlveda, Raimundo Fernández, Norberto Catarino, Rui Coelho Da Silva, Erick Burgos

  • High-resolution electron-induced Ge L X-ray spectrum: diagram lines and satellite structures

    by Andrés Sepúlveda, Tabatha Rodríguez, Alejo Carreras, Gustavo Castellano, Jorge Trincavelli

    The L X-ray spectrum induced by electron impact upon a solid germanium target was measured with high spectral resolution and analyzed using the POEMA fitting software. Characteristic transition energies, natural linewidths, and relative radiative transition probabilities were determined for the main diagram lines. In addition, a comprehensive identification of satellite decays was achieved, including features previously unreported; the corresponding energy shifts were found to agree with literature values. New satellite structures in the and Lη regions were also observed, with the large linewidths found suggesting contributions from multiple unresolved transitions. The intensity-ratio analysis reveals a significant role of multivacancy states, with the Lβ1 transition exhibiting an unusually high satellite-to-main intensity ratio close to unity, evidenced by the careful spectral treatment carried out. To accurately reproduce this region, we applied the self-absorbed Voigt profile previously developed for L-emission spectra, which incorporates an energy-dependent absorption term to account for the variation of the absorption coefficient across the neighbouring L3 edge. This approach successfully reproduces the low-energy asymmetry of the Lβ1 peak and its effect on the relative intensities of the main and satellite components. The results obtained aim to complete the database available at present for Ge L X-ray parameters, providing methodological advances applicable to the spectroscopic study of other elements.

  • LIATAN, a new laboratory for applied research at the Universidad Tecnológica Metropolitana

    by Andrés Sepúlveda, Tabatha Rodríguez, Pedro Miranda, Eugenio Miranda, Javier Wachter, Nicolas Bravo, Rafael Correa


  • Experimental determination of Sn L -shell atomic parameters

    by F. Fernandez, A. Sepúlveda, S. Limandri, J. Trincavelli, G. Castellano

    A careful inspection on the tin L x-ray spectrum induced by electron impact was carried out, with the aim of obtaining fundamental atomic properties related to core ionizations and subsequent emissions. A bulk tin standard was irradiated, the resulting spectrum being recorded with a commercial wavelength dispersive spectrometer, and processed by means of a parameter optimization method previously developed. Characteristic energies, relative transition probabilities and natural linewidths were therefore experimentally determined for this element, and compared with data from the literature, when available. Satellite and radiative Auger effect structures were also investigated, for which the corresponding energy shifts and relative intensities were obtained. A number of these parameters were determined, even in overlapping peaks and weak transitions, which evidences the robustness of the spectral processing method used.


  • Experimental determination of total M shell and subshell X-ray production cross sections for uranium by proton impact

    by Mariano Bonifacio, Sergio Gabriel Suárez, Tabatha Pamela Rodríguez Cabello, Andrés Sepúlveda Peñaloza, Jorge Carlos Trincavelli, Pablo Daniel Pérez

    X-ray production cross sections for total and subshell M uranium by proton impact are measured and compared with other studies.

  • Experimental determination of the Ag L -subshell x-ray-production cross sections by electron impact through two bulk target methods

    by Tabatha P. Rodríguez, Andrés H. Sepúlveda, Pablo D. Pérez, Jorge C. Trincavelli, Gustavo Castellano

    The experimental determination of x-ray-production cross sections by electron impact on thick samples is faced in this work, especially focusing on the L subshells of Ag. The integrodifferential method used by An et al. is compared with a recently implemented approach involving the ionization distribution function. The first method has shown good results under suitable conditions, namely, when multiple scattering, bremsstrahlung enhancement, and other secondary effects are negligible. Monte Carlo simulations were performed in order to analyze the influence of these conditions and therefore to extend the validity range of the method by adding a correction factor. The second approach uses the ionization distribution function ϕ(ρz) to predict the intensity of the emitted photons; this magnitude is assessed by the poema software, previously developed, and it is used to determine correction factors to the cross sections included in the software database. Both approaches were tested by fitting several L-shell spectra measured in a wide interval of incident electron energies, ranging from 4.0 to 25 keV, with an electron microprobe equipped with a wavelength-dispersive spectrometer. The x-ray-production cross sections obtained for each L subshell and the total L x-ray-production cross section were compared with theoretical predictions based on the distorted-wave approach theory and with experimental determinations when available.


  • Open Access

    Modelo geoestadístico de la distribución espacial de arsénico y plomo en la superficie de depósitos de relaves abandonados en la comuna de Andacollo, región de Coquimbo – Chile

    by Keyla Manuela Alencar da Silva Allves, Maria Carolina Parodi Dávila, Andrés Sepúlveda Peñaloza, Erik Zimmermann, Jessica Chacón

    La comuna de Andacollo se localiza en la región de Coquimbo al norte de Chile. Posee una superficie de 310 km2, y una demografía de 11.044 habitantes. De acuerdo con el Catastro Nacional de Relaves de 2020 del Servicio Nacional de Geología y Minería, existen en Chile un total de 743 depósitos de relave, de los cuales 105 están ubicados en Andacollo. De acuerdo con lo mencionado anteriormente, según el Ministerio de Minería se definen como un residuo, mezcla de mineral molido con agua y otros compuestos, que quedan como resultado de la extracción de minerales sulfurados en el proceso de flotación. En los relaves visitados durante las campañas a terreno realizadas en 2019 y 2020, se realizaron colectas de muestras de sedimentos, y se pudo evidenciar a través de mediciones realizadas con un equipo XRF portátil, que varias de las muestras colectadas contenían concentraciones de metales pesados sobre la normativa de la Agencia de Protección Ambiental de Estados Unidos. Las fuentes de contaminación, es decir los depósitos de relaves abandonados, se encuentran expuestos a la propagación en el medio ambiente a través de la dinámica de diversos factores físicos. Dada la relevancia de estos fenómenos, es imprescindible contar con un conocimiento preciso de la concentración y distribución de elementos potencialmente perjudiciales para la salud de la población. Por lo anteriormente expuesto, en este estudio se presenta un modelo geoestadístico de la distribución espacial de arsénico y plomo en la superficie de los depósitos de relaves abandonados en Andacollo.Palabras-claves: geoestadística, contaminación, XRF, minería, relaves. Geostatistical model of the spatial distribution of arsenic and lead on the surface of abandoned tailings in the Andacollo city, Coquimbo region - Chile A B S T R A C TThe commune of Andacollo is located in the Coquimbo region in northern Chile. It has an area of 310 km2 and a population of 11,044 inhabitants. According to the National Tailings Cadastre 2020 of the National Geology and Mining Service, there are a total of 743 tailings in Chile, of which 105 are located in Andacollo. As mentioned above, according to the Ministry of Mining, tailings are defined as a residue, a mixture of ground ore with water and other compounds, left over from the extraction of sulfide minerals in the flotation process. In the tailings visited during the field campaigns conducted in 2019 and 2020, sediment samples were collected, and it was evident through measurements made with portable XRF equipment, that several of the samples collected contained concentrations of heavy metals above the United States Environmental Protection Agency regulations. The sources of contamination, that is abandoned tailings deposits, are exposed to propagation in the environment through the dynamics of various physical factors. Given the relevance of these phenomena, it is essential to have a precise knowledge of the concentration and distribution of elements potentially harmful to the health of the population. Therefore, this study presents a geostatistical model of the spatial distribution of arsenic and lead on the surface of abandoned tailings deposits in Andacollo.Keywords: geostatistics, contamination, XRF, mining, tailings