Sara El Mattar
Research Subjects
Sara El Mattar has a total of 8 co-authors. Here are the top co-authors by number of shared publications:
- Abdennaceur Baghdad
Hassan II University of Casablanca
4 shared publications Abdennaceur Baghdad
Universite Hassan II Casablanca Faculte des Sciences Techniques Mohammedia
3 shared publications- Abdennaceur Baghdad
Hassan II University, Casablanca
2 shared publications - Elhadi Baghaz
Aix Marseille Univ, Université de Toulon, CNRS, LIS
2 shared publications - Sara Said
EHEI
2 shared publications Abdelhakim Ballouk
Hassan II University, FstMohammedia-Casablanca
1 shared publication
Latest Publications
- 30 January 2025
- Published by Wiley in Transactions on Emerging Telecommunications Technologies
- Vol. 36 (2)
Beyond Traditional RFID: Unveiling the Potential of Wi‐Fi, 5G, Bluetooth, and Zigbee for Backscatter Systems
Traditional RFID systems rely on dedicated readers, often expensive and bulky, hindering their widespread deployment. This paper proposes an alternative RFID system that leverages ubiquitous radio sources—Wi‐Fi, 5G, Bluetooth, and Zigbee—to replace dedicated readers. Our system employs backscatter communication, where RFID tags modulate reflected signals from these readily available sources to transmit data. We investigate the feasibility and performance of this approach through Matlab simulator. Our results show that 802.11ax at 2.45 GHz exhibits the best symbol error rate, followed by 802.11n at the same frequency. However, 5G, Bluetooth, and Zigbee signals demonstrate lower performance even at high signal‐to‐noise ratios. To address this, we introduce error correction coding techniques (BCH and RS) that significantly improve communication reliability. Utilizing these codes, our system achieves a communication range of up to 1 m. This finding highlights the potential of ubiquitous radio sources as a viable alternative to dedicated RFID readers, opening doors for various applications.
- 30 January 2025
- Published by Wiley in Transactions on Emerging Telecommunications Technologies
- Vol. 36 (2)
Beyond Traditional RFID: Unveiling the Potential of Wi‐Fi, 5G, Bluetooth, and Zigbee for Backscatter Systems
Traditional RFID systems rely on dedicated readers, often expensive and bulky, hindering their widespread deployment. This paper proposes an alternative RFID system that leverages ubiquitous radio sources—Wi‐Fi, 5G, Bluetooth, and Zigbee—to replace dedicated readers. Our system employs backscatter communication, where RFID tags modulate reflected signals from these readily available sources to transmit data. We investigate the feasibility and performance of this approach through Matlab simulator. Our results show that 802.11ax at 2.45 GHz exhibits the best symbol error rate, followed by 802.11n at the same frequency. However, 5G, Bluetooth, and Zigbee signals demonstrate lower performance even at high signal‐to‐noise ratios. To address this, we introduce error correction coding techniques (BCH and RS) that significantly improve communication reliability. Utilizing these codes, our system achieves a communication range of up to 1 m. This finding highlights the potential of ubiquitous radio sources as a viable alternative to dedicated RFID readers, opening doors for various applications.
- Open Access
- 15 October 2024
- Published by Wiley
Beyond Traditional RFID: Unveiling the Potential of Wi-Fi, 5G, Bluetooth, and Zigbee for Backscatter Systems
Traditional RFID systems rely on dedicated readers, often expensive and bulky, hindering their widespread deployment. This paper proposes an alternative RFID system that leverages ubiquitous radio sources – Wi-Fi, 5G, Bluetooth, and Zigbee – to replace dedicated readers. Our system employs backscatter communication, where RFID tags modulate reflected signals from these readily available sources to transmit data. We investigate the feasibility and performance of this approach through Matlab simulator. Our results show that 802.11ax at 2.45 GHz exhibits the best Symbol Error Rate (SER), followed by 802.11n at the same frequency. However, 5G, Bluetooth, and Zigbee signals demonstrate lower performance even at high Signal-to-Noise Ratios (SNRs). To address this, we introduce error correction coding techniques (BCH and RS) that significantly improve communication reliability. Utilizing these codes, our system achieves a communication range of up to 1 meter. This finding highlights the potential of ubiquitous radio sources as a viable alternative to dedicated RFID readers, opening doors for various applications.
- 15 October 2024
- Published by Wiley
Open AccessBeyond Traditional RFID: Unveiling the Potential of Wi-Fi, 5G, Bluetooth, and Zigbee for Backscatter Systems
Traditional RFID systems rely on dedicated readers, often expensive and bulky, hindering their widespread deployment. This paper proposes an alternative RFID system that leverages ubiquitous radio sources – Wi-Fi, 5G, Bluetooth, and Zigbee – to replace dedicated readers. Our system employs backscatter communication, where RFID tags modulate reflected signals from these readily available sources to transmit data. We investigate the feasibility and performance of this approach through Matlab simulator. Our results show that 802.11ax at 2.45 GHz exhibits the best Symbol Error Rate (SER), followed by 802.11n at the same frequency. However, 5G, Bluetooth, and Zigbee signals demonstrate lower performance even at high Signal-to-Noise Ratios (SNRs). To address this, we introduce error correction coding techniques (BCH and RS) that significantly improve communication reliability. Utilizing these codes, our system achieves a communication range of up to 1 meter. This finding highlights the potential of ubiquitous radio sources as a viable alternative to dedicated RFID readers, opening doors for various applications.
- Open Access
- 13 February 2024
- Published by Qeios Ltd
Review of: "Investigations on Input Impedance and Radiation Pattern of a UWB Antenna for Microwave Imaging"
* It's worth noting that despite the mention of microwave imaging in the title, the research does not explore this application in the presented results. * I recommend against describing each paper in the related work section and including figures o...
- 13 February 2024
- Published by Qeios Ltd
Open AccessReview of: "Investigations on Input Impedance and Radiation Pattern of a UWB Antenna for Microwave Imaging"
* It's worth noting that despite the mention of microwave imaging in the title, the research does not explore this application in the presented results. * I recommend against describing each paper in the related work section and including figures o...
- Open Access
- 1 January 2024
- Published by KEAI Publishing in International Journal of Intelligent Networks
- Vol. 5, 1-9
Introducing a high-throughput energy-efficient anti-collision (HT-EEAC) protocol for RFID systems
- 1 January 2024
- Published by KEAI Publishing in International Journal of Intelligent Networks
- Vol. 5, 1-9
Open AccessIntroducing a high-throughput energy-efficient anti-collision (HT-EEAC) protocol for RFID systems
- Open Access
- 1 December 2023
- Published by Universitas Ahmad Dahlan in TELKOMNIKA (Telecommunication Computing Electronics and Control)
- Vol. 21 (6) , 1178-1184
Patch antenna design based on 1D-EBG structures for high gain applications
Patch antenna design based on 1D-EBG structures for high gain applications
- 1 December 2023
- Published by Universitas Ahmad Dahlan in TELKOMNIKA (Telecommunication Computing Electronics and Control)
- Vol. 21 (6) , 1178-1184
Open AccessPatch antenna design based on 1D-EBG structures for high gain applications
Patch antenna design based on 1D-EBG structures for high gain applications
- Open Access
- 1 August 2023
- Published by Universitas Ahmad Dahlan in TELKOMNIKA (Telecommunication Computing Electronics and Control)
- Vol. 21 (4) , 909-916
Dickson voltage multiplier with 1 to 6 stages for dual-band rectifiers (2.45/5.8 GHz) with low input power
Dickson voltage multiplier with 1 to 6 stages for dual-band rectifiers (2.45/5.8 GHz) with low input power
- 1 August 2023
- Published by Universitas Ahmad Dahlan in TELKOMNIKA (Telecommunication Computing Electronics and Control)
- Vol. 21 (4) , 909-916
Open AccessDickson voltage multiplier with 1 to 6 stages for dual-band rectifiers (2.45/5.8 GHz) with low input power
Dickson voltage multiplier with 1 to 6 stages for dual-band rectifiers (2.45/5.8 GHz) with low input power
- Open Access
- 1 June 2023
- Published by Institute of Advanced Engineering and Science in International Journal of Electrical and Computer Engineering (IJECE)
- Vol. 13 (3) , 2419-2427
High-efficiency 2.45 and 5.8 GHz dual-band rectifier design with modulated input signals and a wide input power range
This paper presents a new rectifier design for radio frequency (RF) energy harvesting by adopting a particular circuit topology to achieve two objectives at the same time. First, work with modulated input signal sources instead of only continuous waveform (CW) signals. Second, operate with a wide input power range using the Wilkinson power divider (WPD) and two different rectifier diodes (HSMS2852 and SMS7630) instead of using active components. According to the comparison with dual-band rectifiers presented in the literature, the designed rectifier is a high-efficiency rectifier for wide RF power input ranges. A peak of 67.041% and 49.089% was reached for 2.45 and 5.8 GHz, respectively, for CW as the input signal. An efficiency of 72.325% and 45.935% is obtained with a 16 QAM modulated input signal for the operating frequencies, respectively, 69.979% and 54.579% for 8PSK. The results obtained demonstrate that energy recovery systems can use modulated signals. Therefore, the use of a modulated signal over a CW signal may have additional benefits.
- 1 June 2023
- Published by Institute of Advanced Engineering and Science in International Journal of Electrical and Computer Engineering (IJECE)
- Vol. 13 (3) , 2419-2427
Open AccessHigh-efficiency 2.45 and 5.8 GHz dual-band rectifier design with modulated input signals and a wide input power range
This paper presents a new rectifier design for radio frequency (RF) energy harvesting by adopting a particular circuit topology to achieve two objectives at the same time. First, work with modulated input signal sources instead of only continuous waveform (CW) signals. Second, operate with a wide input power range using the Wilkinson power divider (WPD) and two different rectifier diodes (HSMS2852 and SMS7630) instead of using active components. According to the comparison with dual-band rectifiers presented in the literature, the designed rectifier is a high-efficiency rectifier for wide RF power input ranges. A peak of 67.041% and 49.089% was reached for 2.45 and 5.8 GHz, respectively, for CW as the input signal. An efficiency of 72.325% and 45.935% is obtained with a 16 QAM modulated input signal for the operating frequencies, respectively, 69.979% and 54.579% for 8PSK. The results obtained demonstrate that energy recovery systems can use modulated signals. Therefore, the use of a modulated signal over a CW signal may have additional benefits.
- Open Access
- 1 October 2022
- Published by Institute of Advanced Engineering and Science in International Journal of Electrical and Computer Engineering (IJECE)
- Vol. 12 (5) , 5114-5122
Design and optimization of a rectangular microstrip patch antenna for dual-band 2.45 GHz/ 5.8 GHz RFID application
This paper introduces a new rectangular slot antenna structure based on a simple rectangular shape with two symmetrical rectangular slots on the radiated element. The aim of this work is to design an antenna and enhance it to function in the band (2.45 GHz and 5.8 GHz). We formulated the dimensions of the antenna using the transmission line model of the analytical methods and then we optimized these parameters using the CST Microwave Studio simulator. We made changes to two important parameters in our design: the position and width of the slots when the other parameters are kept constant. The resulting antenna provides good adaptation, high gain that achieves 5.96 dBi at 2.45 GHz and 6.491 dBi at 5.8 GHz, good return loss values of -49.859 dB and -34.303 dB for the lower and upper operating frequencies respectively. For radio frequency identification (RFID) implementations, the proposed antenna is ideal, and its main advantage is that it has high gain and is simple to design and fabricate.
- 1 October 2022
- Published by Institute of Advanced Engineering and Science in International Journal of Electrical and Computer Engineering (IJECE)
- Vol. 12 (5) , 5114-5122
Open AccessDesign and optimization of a rectangular microstrip patch antenna for dual-band 2.45 GHz/ 5.8 GHz RFID application
This paper introduces a new rectangular slot antenna structure based on a simple rectangular shape with two symmetrical rectangular slots on the radiated element. The aim of this work is to design an antenna and enhance it to function in the band (2.45 GHz and 5.8 GHz). We formulated the dimensions of the antenna using the transmission line model of the analytical methods and then we optimized these parameters using the CST Microwave Studio simulator. We made changes to two important parameters in our design: the position and width of the slots when the other parameters are kept constant. The resulting antenna provides good adaptation, high gain that achieves 5.96 dBi at 2.45 GHz and 6.491 dBi at 5.8 GHz, good return loss values of -49.859 dB and -34.303 dB for the lower and upper operating frequencies respectively. For radio frequency identification (RFID) implementations, the proposed antenna is ideal, and its main advantage is that it has high gain and is simple to design and fabricate.
- Open Access
- 2 May 2022
- Published by Elsevier in Scientific African
- Vol. 16
An improved RFID anti-collision protocol (IMRAP) with low energy consumption and high throughput
- 2 May 2022
- Published by Elsevier in Scientific African
- Vol. 16
Open AccessAn improved RFID anti-collision protocol (IMRAP) with low energy consumption and high throughput
- 22 July 2021
- Published by Springer Nature
- p. 943-948
A Novel Two-Branch Dual-Band Rectifier for 2.45 GHz 5.8 GHz RFID Systems
- 22 July 2021
- Published by Springer Nature
- p. 943-948
A Novel Two-Branch Dual-Band Rectifier for 2.45 GHz 5.8 GHz RFID Systems