Boris Lehmann
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Boris Lehmann has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Ali Hassan Khan
Department of Computer Systems, Tallinn University of Technology, Tallinn, Estonia
1 shared publication - Andreas Buttinger-Kreuzhuber
VRVis Zentrum für Virtual Reality und Visualisierung Forschungs‐GmbH Vienna Austria
1 shared publication Carsten Thorenz
1 shared publication- Gert Toming
Tallinn University of Technology, Tallinn, Estonia
1 shared publication - Jeffrey Andrew Tuhtan
Department of Computer Systems, Tallinn University of Technology, Tallinn, Estonia
1 shared publication Jeffrey Tuhtan
1 shared publication
Latest Publications
- Open Access
- 10 April 2026
- Published by Elsevier in Advances in Water Resources
- Vol. 212
Comparison of CFD and autonomous sensor measurements during weir passage for over- and undershot conditions
- 10 April 2026
- Published by Elsevier in Advances in Water Resources
- Vol. 212
Open AccessComparison of CFD and autonomous sensor measurements during weir passage for over- and undershot conditions
- Open Access
- 4 December 2025
- Published by Elsevier in Journal of Hydrology
- Vol. 665
Methodological approaches for numerical integration of culverts in 2D surface models in urban flood analysis
- 4 December 2025
- Published by Elsevier in Journal of Hydrology
- Vol. 665
Open AccessMethodological approaches for numerical integration of culverts in 2D surface models in urban flood analysis
- Open Access
- 1 January 2025
- Published by IOP Publishing in Environmental Research Communications
- Vol. 7 (1) , 015024
Application of low-cost hydrokinetic technology for accelerating electricity access to rural areas in developing economies: field experiment in Kenya
This article presents the design, construction and field test of an experimental prototype of a low-cost hydrokinetic turbine technology made of local materials and e-waste components. The aim of this study is to investigate the performance of the turbine when subjected to field conditions in low flow velocity rivers. The research and development (R&D) involve the use of e-waste boat motor and locally available materials to develop a modular hydrokinetic turbine for generation of electricity using kinetic energy of rivers. A decommissioned boat motor with a 0.24 m diameter rotor is operated as a turbine. A shroud for flow acceleration was developed from 1.5 mm thick stainless-steel plates and a support structure constructed using angle lines. The field test results of the prototype generated about 11.543 ± 0.021 W and 37.129 ± 0.021 W or (equivalent of 0.011543 kWh and 0.037129 kWh) when operated at an approach flow velocity of 0.8 m s−1 and 1.2 m s−1 respectively. The wire to water ratio was determined instead of the Cp and the turbine achieved an overall wire to water efficiency of 0.99 and 0.95 respectively. This prototype technology can sustainably provide 24 h energy, sufficient to charge batteries in the rural areas and also provide opportunities within the community such as mobile charging points. An upscaled version of this low-cost technology can be adaptable in rural off-grid communities to enhance the access to electricity in developing countries.
- 1 January 2025
- Published by IOP Publishing in Environmental Research Communications
- Vol. 7 (1) , 015024
Open AccessApplication of low-cost hydrokinetic technology for accelerating electricity access to rural areas in developing economies: field experiment in Kenya
This article presents the design, construction and field test of an experimental prototype of a low-cost hydrokinetic turbine technology made of local materials and e-waste components. The aim of this study is to investigate the performance of the turbine when subjected to field conditions in low flow velocity rivers. The research and development (R&D) involve the use of e-waste boat motor and locally available materials to develop a modular hydrokinetic turbine for generation of electricity using kinetic energy of rivers. A decommissioned boat motor with a 0.24 m diameter rotor is operated as a turbine. A shroud for flow acceleration was developed from 1.5 mm thick stainless-steel plates and a support structure constructed using angle lines. The field test results of the prototype generated about 11.543 ± 0.021 W and 37.129 ± 0.021 W or (equivalent of 0.011543 kWh and 0.037129 kWh) when operated at an approach flow velocity of 0.8 m s−1 and 1.2 m s−1 respectively. The wire to water ratio was determined instead of the Cp and the turbine achieved an overall wire to water efficiency of 0.99 and 0.95 respectively. This prototype technology can sustainably provide 24 h energy, sufficient to charge batteries in the rural areas and also provide opportunities within the community such as mobile charging points. An upscaled version of this low-cost technology can be adaptable in rural off-grid communities to enhance the access to electricity in developing countries.
- Open Access
- 3 May 2022
- Published by Springer Nature in Aquatic Sciences
- Vol. 84 (3) , 1-14
Fish body geometry reduces the upstream velocity profile in subcritical flowing waters
Fish body geometry is highly variable across species, affecting the fluid-body interactions fish rely on for habitat choice, feeding, predator avoidance and spawning. We hypothesize that fish body geometry may substantially influence the velocity experienced by fish swimming. To test this hypothesis, we built nine full-scale physical prototypes of common freshwater fish species. The prototypes were placed in a large laboratory flume and upstream time-averaged velocity profiles were measured with increasing distance from the anterior-most location of each body. The measurements revealed that the body geometry can have a significant influence on the velocity profile, reducing the flow field at a distance of one body length upstream of the fish. Furthermore, it was found that the upstream velocity profiles from the nine fish species investigated in this study can be normalized to a single fit curve based on the freestream velocity and fish body length under subcritical flow conditions. These findings are significant, because they show that conventional point velocity measurements overlook the reducing effect of the fish body on the upstream flow field, creating a systematically biased representation of the velocity experienced by fish in subcritical flowing waters. This bias is illustrated by velocity field maps created with and without the presence of the physical models for three different fish species. Finally, we provide an example of how point velocity measurements can be recalculated to provide upstream velocity field maps closer to “the fish’s perspective”.
- 3 May 2022
- Published by Springer Nature in Aquatic Sciences
- Vol. 84 (3) , 1-14
Open AccessFish body geometry reduces the upstream velocity profile in subcritical flowing waters
Fish body geometry is highly variable across species, affecting the fluid-body interactions fish rely on for habitat choice, feeding, predator avoidance and spawning. We hypothesize that fish body geometry may substantially influence the velocity experienced by fish swimming. To test this hypothesis, we built nine full-scale physical prototypes of common freshwater fish species. The prototypes were placed in a large laboratory flume and upstream time-averaged velocity profiles were measured with increasing distance from the anterior-most location of each body. The measurements revealed that the body geometry can have a significant influence on the velocity profile, reducing the flow field at a distance of one body length upstream of the fish. Furthermore, it was found that the upstream velocity profiles from the nine fish species investigated in this study can be normalized to a single fit curve based on the freestream velocity and fish body length under subcritical flow conditions. These findings are significant, because they show that conventional point velocity measurements overlook the reducing effect of the fish body on the upstream flow field, creating a systematically biased representation of the velocity experienced by fish in subcritical flowing waters. This bias is illustrated by velocity field maps created with and without the presence of the physical models for three different fish species. Finally, we provide an example of how point velocity measurements can be recalculated to provide upstream velocity field maps closer to “the fish’s perspective”.