Petr Mácha
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Petr Mácha has a total of 132 co-authors. Here are the top co-authors by number of shared publications:
- Jakub Seidl
Institute of Plasma Physics of the CAS
3 shared publications - Jaroslav Krbec
Institute of Plasma Physics Czech Academy of Sciences
3 shared publications - Jiri Adamek
Institute of Plasma Physics of the CAS, Za Slovankou 3, 182 00 Prague 8, Czech Republic
3 shared publications - David Tskhakaya
Institute of Plasma Physics of the Czech Academy of Sciences, U Slovanky 2525/1a, 18200 Prague, Czech Republic
2 shared publications - Jan Horacek
Institute of Plasma Physics Czech Academy of Sciences
2 shared publications - Jordan Cavalier
Institute of Plasma Physics, Czech Academy of Sciences - Institute of Plasma Physics, Prague, CZECH REPUBLIC
2 shared publications
Latest Publications
- Open Access
- 25 June 2026
- Published by IOP Publishing in Nuclear Fusion
- Vol. 66 (8) , 086038
Validation of the GBS code against COMPASS experimental data
This work presents the first full-size turbulence simulation of the COMPASS tokamak edge with the three-dimensional, self-consistent, flux-driven, two-fluid GBS code. The simulation is validated against experimental data from a standard L-mode COMPASS discharge, covering the SOL from the outer midplane to the divertor region. The dataset combines four diagnostic systems and provides 43 observable profiles, including electron temperature and plasma potential measurements that enable the first direct comparison of their fluctuations and higher-order statistics in COMPASS. The validation results show good agreement between simulation and experiment in profile shape, magnitude, and fluctuation levels for most outer midplane observables. The parallel heat-flux fall-off length is also reproduced. In the divertor, the mean profiles agree reasonably well in magnitude, but the simulated fluctuation levels remain significantly underestimated. Advanced blob analysis shows that both simulation and experiment lie mainly in the sheath-connected regime, with partial presence in the connected ideal-interchange regime. The remaining discrepancies in the COMPASS simulation are probably a consequence of simplified parameters and boundary conditions, reflecting limitations that are common to fluid turbulence models. Overall, the validation demonstrates that GBS captures the dominant upstream SOL turbulence dynamics, while identifying divertor physics as the main target for further improvement.
- 25 June 2026
- Published by IOP Publishing in Nuclear Fusion
- Vol. 66 (8) , 086038
Open AccessValidation of the GBS code against COMPASS experimental data
This work presents the first full-size turbulence simulation of the COMPASS tokamak edge with the three-dimensional, self-consistent, flux-driven, two-fluid GBS code. The simulation is validated against experimental data from a standard L-mode COMPASS discharge, covering the SOL from the outer midplane to the divertor region. The dataset combines four diagnostic systems and provides 43 observable profiles, including electron temperature and plasma potential measurements that enable the first direct comparison of their fluctuations and higher-order statistics in COMPASS. The validation results show good agreement between simulation and experiment in profile shape, magnitude, and fluctuation levels for most outer midplane observables. The parallel heat-flux fall-off length is also reproduced. In the divertor, the mean profiles agree reasonably well in magnitude, but the simulated fluctuation levels remain significantly underestimated. Advanced blob analysis shows that both simulation and experiment lie mainly in the sheath-connected regime, with partial presence in the connected ideal-interchange regime. The remaining discrepancies in the COMPASS simulation are probably a consequence of simplified parameters and boundary conditions, reflecting limitations that are common to fluid turbulence models. Overall, the validation demonstrates that GBS captures the dominant upstream SOL turbulence dynamics, while identifying divertor physics as the main target for further improvement.
- Open Access
- 4 September 2023
- Published by IOP Publishing in Nuclear Fusion
- Vol. 63 (10) , 104003
Spontaneous formation of a transport barrier in helium plasma in a tokamak with circular configuration
We report on the first experimental observation of a spontaneously formed transport barrier in the tokamak with a circular configuration in helium plasmas. There was no external polarization of the plasma by electric field or other technique to form the barrier as it is typically used in tokamaks with circular plasma. In general, the transport barriers play an important role in plasma confinement especially in tokamaks with divertor configuration. In our experiments, we clearly observe distinct characteristics of a transport barrier, including a steep gradient of the electron temperature and an enhanced radial electric field along with the change in the plasma potential, floating potential, and electron temperature fluctuation. The electron temperature and the plasma potential are obtained by a combination of the ball-pen and Langmuir probe measurements with high temporal resolution on a shot-to-shot basis. This first experimental observation of the spontaneously formed transport barrier might bring new possibilities to obtain a fusion-relevant study of the edge plasma parameters and transport in helium plasmas even on small tokamaks.
- 4 September 2023
- Published by IOP Publishing in Nuclear Fusion
- Vol. 63 (10) , 104003
Open AccessSpontaneous formation of a transport barrier in helium plasma in a tokamak with circular configuration
We report on the first experimental observation of a spontaneously formed transport barrier in the tokamak with a circular configuration in helium plasmas. There was no external polarization of the plasma by electric field or other technique to form the barrier as it is typically used in tokamaks with circular plasma. In general, the transport barriers play an important role in plasma confinement especially in tokamaks with divertor configuration. In our experiments, we clearly observe distinct characteristics of a transport barrier, including a steep gradient of the electron temperature and an enhanced radial electric field along with the change in the plasma potential, floating potential, and electron temperature fluctuation. The electron temperature and the plasma potential are obtained by a combination of the ball-pen and Langmuir probe measurements with high temporal resolution on a shot-to-shot basis. This first experimental observation of the spontaneously formed transport barrier might bring new possibilities to obtain a fusion-relevant study of the edge plasma parameters and transport in helium plasmas even on small tokamaks.
- Open Access
- 1 April 2022
- Published by IOP Publishing in Nuclear Fusion
- Vol. 62 (4) , 042021
Overview of the COMPASS results *
COMPASS addressed several physical processes that may explain the behaviour of important phenomena. This paper presents results related to the main fields of COMPASS research obtained in the recent two years, including studies of turbulence, L–H transition, plasma material interaction, runaway electron, and disruption physics: Tomographic reconstruction of the edge/SOL turbulence observed by a fast visible camera allowed to visualize turbulent structures without perturbing the plasma. Dependence of the power threshold on the X-point height was studied and related role of radial electric field in the edge/SOL plasma was identified. The effect of high-field-side error fields on the L–H transition was investigated in order to assess the influence of the central solenoid misalignment and the possibility to compensate these error fields by low-field-side coils. Results of fast measurements of electron temperature during ELMs show the ELM peak values at the divertor are around 80% of the initial temperature at the pedestal. Liquid metals were used for the first time as plasma facing material in ELMy H-mode in the tokamak divertor. Good power handling capability was observed for heat fluxes up to 12 MW m−2 and no direct droplet ejection was observed. Partial detachment regime was achieved by impurity seeding in the divertor. The evolution of the heat flux footprint at the outer target was studied. Runaway electrons were studied using new unique systems—impact calorimetry, carbon pellet injection technique, wide variety of magnetic perturbations. Radial feedback control was imposed on the beam. Forces during plasma disruptions were monitored by a number of new diagnostics for vacuum vessel (VV) motion in order to contribute to the scaling laws of sideways disruption forces for ITER. Current flows towards the divertor tiles, incl. possible short-circuiting through PFCs, were investigated during the VDE experiments. The results support ATEC model and improve understanding of disruption loads.
- 1 April 2022
- Published by IOP Publishing in Nuclear Fusion
- Vol. 62 (4) , 042021
Open AccessOverview of the COMPASS results *
COMPASS addressed several physical processes that may explain the behaviour of important phenomena. This paper presents results related to the main fields of COMPASS research obtained in the recent two years, including studies of turbulence, L–H transition, plasma material interaction, runaway electron, and disruption physics: Tomographic reconstruction of the edge/SOL turbulence observed by a fast visible camera allowed to visualize turbulent structures without perturbing the plasma. Dependence of the power threshold on the X-point height was studied and related role of radial electric field in the edge/SOL plasma was identified. The effect of high-field-side error fields on the L–H transition was investigated in order to assess the influence of the central solenoid misalignment and the possibility to compensate these error fields by low-field-side coils. Results of fast measurements of electron temperature during ELMs show the ELM peak values at the divertor are around 80% of the initial temperature at the pedestal. Liquid metals were used for the first time as plasma facing material in ELMy H-mode in the tokamak divertor. Good power handling capability was observed for heat fluxes up to 12 MW m−2 and no direct droplet ejection was observed. Partial detachment regime was achieved by impurity seeding in the divertor. The evolution of the heat flux footprint at the outer target was studied. Runaway electrons were studied using new unique systems—impact calorimetry, carbon pellet injection technique, wide variety of magnetic perturbations. Radial feedback control was imposed on the beam. Forces during plasma disruptions were monitored by a number of new diagnostics for vacuum vessel (VV) motion in order to contribute to the scaling laws of sideways disruption forces for ITER. Current flows towards the divertor tiles, incl. possible short-circuiting through PFCs, were investigated during the VDE experiments. The results support ATEC model and improve understanding of disruption loads.