Sergey I. Sidorenko
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Sergey I. Sidorenko has a total of 154 co-authors. Here are the top co-authors by number of shared publications:
- Igor A. Vladymyrskyi
Natl Tech Univ Ukraine, Igor Sikorsky Kyiv Polytech Inst, Prospect Beresteiskyi 37, UA-03056 Kyiv, Ukraine
18 shared publications S. M. Voloshko
13 shared publications- Gabor L. Katona
University of Debrecen
10 shared publications S.M. Voloshko
9 shared publications- I. O. Kruhlov
National Technical University of Ukraine ‘Igor Sikorsky Kyiv Polytechnic Institute’, Prospect Beresteiskyi 37, Kyiv 03056, Ukraine
7 shared publications M. O. Vasylyev
6 shared publications
Latest Publications
- 1 May 2025
- Published by AIP Publishing in Low Temperature Physics
- Vol. 51 (5) , 533-542
Black silicon: Formation in the trampoline mode of ion flow, surface properties, and performance perspectives
By irradiating the (111) surface of single-crystalline silicon wafers with Ar+ ions in the trampoline mode (high-density flows of low-energy ions) and with the assistance of metal initiator atoms, a transition of those wafers into the “black silicon” optical state was stimulated. This state is characterized by low values of light reflectance (less than 2%) from the irradiated wafer side in a spectral interval from 400 to 1000 nm. Scanning electron microscopy studies showed that this is a result of the emergence of a hierarchical submicron/nanoscale structure at the treated surface of the wafers. This transition can be performed only with the assistance of metal initiator atoms simultaneously evaporated from an auxiliary target in the operating chamber. At the same time, the application of metals initiators affects the effective lifetime of the minority charge carriers in the black state silicon, which is crucial for the efficiency of black silicon application in solar cells. Among the examined metals initiators (Al, Cr, Fe, Ni, Mo, and Cu), only the application of copper made it possible to preserve or even increase the value of this parameter. The electrostatic interaction between free electric charges and dipoles (playing the role of excitons in this case) near the interface in a two-layer system was considered theoretically. It was shown how the system parameters affect the preferable location of excitons and their orientation, which can be applied, e.g., to govern the solar cell efficiency. The formation of black silicon in the trampoline mode is environmentally friendly at all production stages.
- 1 May 2025
- Published by AIP Publishing in Low Temperature Physics
- Vol. 51 (5) , 533-542
Black silicon: Formation in the trampoline mode of ion flow, surface properties, and performance perspectives
By irradiating the (111) surface of single-crystalline silicon wafers with Ar+ ions in the trampoline mode (high-density flows of low-energy ions) and with the assistance of metal initiator atoms, a transition of those wafers into the “black silicon” optical state was stimulated. This state is characterized by low values of light reflectance (less than 2%) from the irradiated wafer side in a spectral interval from 400 to 1000 nm. Scanning electron microscopy studies showed that this is a result of the emergence of a hierarchical submicron/nanoscale structure at the treated surface of the wafers. This transition can be performed only with the assistance of metal initiator atoms simultaneously evaporated from an auxiliary target in the operating chamber. At the same time, the application of metals initiators affects the effective lifetime of the minority charge carriers in the black state silicon, which is crucial for the efficiency of black silicon application in solar cells. Among the examined metals initiators (Al, Cr, Fe, Ni, Mo, and Cu), only the application of copper made it possible to preserve or even increase the value of this parameter. The electrostatic interaction between free electric charges and dipoles (playing the role of excitons in this case) near the interface in a two-layer system was considered theoretically. It was shown how the system parameters affect the preferable location of excitons and their orientation, which can be applied, e.g., to govern the solar cell efficiency. The formation of black silicon in the trampoline mode is environmentally friendly at all production stages.
- Open Access
- 1 December 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (12) , 126431
Oxidation and reduction processes in Ni/Cu/Cr/Si(100) thin films under low-energy ion irradiation
- 1 December 2019
- Published by IOP Publishing in Materials Research Express
- Vol. 6 (12) , 126431
Open AccessOxidation and reduction processes in Ni/Cu/Cr/Si(100) thin films under low-energy ion irradiation
- 26 April 2019
- Published by IOP Publishing in Journal of Physics: Condensed Matter
- Vol. 31 (28) , 285401
Phase transformations in Pt/Fe bilayers during post annealing probed by resistometry
X-ray diffraction (XRD), secondary neutral mass spectrometry (SNMS) depth profiling, and electrical resistivity measurements were used to follow the phase transformations in Pt/Fe bi-layered thin films during annealing. Initially, the electrical resistivity increases linearly with temperature up to 150 °C due to the contribution of phonon scattering of the metallic Pt and Fe bilayer. Further increase of the annealing temperature leads to a steeper linear increase, which is associated with the initial formation of the chemically disordered A 1-phase followed by the formation of the chemically ordered L 1 0 -FePt phase, as confirmed by XRD and SNMS studies. Finally, at about 620 °C the single L 1 0 -FePt phase has formed throughout the film. Moreover, the electrical resistivity contains also the magnetic contribution to the total resistivity. In this case, the loss in magnetic order is indicated by a change in temperature dependence of the resistivity at about 310 °C, representing the Curie temperature of the initially formed A 1-FePt alloy, while the finally formed L 1 0 -FePt alloy reveals a higher magnetic transition temperature of about 410 °C. In this study, it has been demonstrated that resistometry in combination with structural and chemical analysis provides valuable information on diffusion processes, structural phase formations and its stability range, as well as on the magnetic transition temperature.
- 26 April 2019
- Published by IOP Publishing in Journal of Physics: Condensed Matter
- Vol. 31 (28) , 285401
Phase transformations in Pt/Fe bilayers during post annealing probed by resistometry
X-ray diffraction (XRD), secondary neutral mass spectrometry (SNMS) depth profiling, and electrical resistivity measurements were used to follow the phase transformations in Pt/Fe bi-layered thin films during annealing. Initially, the electrical resistivity increases linearly with temperature up to 150 °C due to the contribution of phonon scattering of the metallic Pt and Fe bilayer. Further increase of the annealing temperature leads to a steeper linear increase, which is associated with the initial formation of the chemically disordered A 1-phase followed by the formation of the chemically ordered L 1 0 -FePt phase, as confirmed by XRD and SNMS studies. Finally, at about 620 °C the single L 1 0 -FePt phase has formed throughout the film. Moreover, the electrical resistivity contains also the magnetic contribution to the total resistivity. In this case, the loss in magnetic order is indicated by a change in temperature dependence of the resistivity at about 310 °C, representing the Curie temperature of the initially formed A 1-FePt alloy, while the finally formed L 1 0 -FePt alloy reveals a higher magnetic transition temperature of about 410 °C. In this study, it has been demonstrated that resistometry in combination with structural and chemical analysis provides valuable information on diffusion processes, structural phase formations and its stability range, as well as on the magnetic transition temperature.
- 1 April 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 278-281
Formation of Hard Magnetic FePt Based Films on Amorphous Silicon Oxide and Sapphire Substrates by RTA
Ordering and structural transformations as well as the magnetic properties of the ordered tetragonal FePt phase formed by rapid thermal annealing (RTA) of the Pt/Fe layered stacks on amorphous silicon oxide and sapphire substrates were investigated. It is shown that a higher level of compressive stresses in the Pt/Fe layered films on the silicon oxide substrate promotes the ordering process, improves magnetic properties of the films and leads to a higher number of grains oriented in the [001] direction perpendicular to the film plane.
- 1 April 2019
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 278-281
Formation of Hard Magnetic FePt Based Films on Amorphous Silicon Oxide and Sapphire Substrates by RTA
Ordering and structural transformations as well as the magnetic properties of the ordered tetragonal FePt phase formed by rapid thermal annealing (RTA) of the Pt/Fe layered stacks on amorphous silicon oxide and sapphire substrates were investigated. It is shown that a higher level of compressive stresses in the Pt/Fe layered films on the silicon oxide substrate promotes the ordering process, improves magnetic properties of the films and leads to a higher number of grains oriented in the [001] direction perpendicular to the film plane.
- 1 March 2019
- Published by Elsevier in Surface and Coatings Technology
- Vol. 361, 413-424
Characterization of ZrN coating low-temperature deposited on the preliminary Ar+ ions treated 2024 Al-alloy
- 1 March 2019
- Published by Elsevier in Surface and Coatings Technology
- Vol. 361, 413-424
Characterization of ZrN coating low-temperature deposited on the preliminary Ar+ ions treated 2024 Al-alloy
- 13 February 2019
- Published by National Academy of Sciences of Ukraine (Co. LTD Ukrinformnauka) (Publications) in Metallofizika i Noveishie Tekhnologii
- Vol. 41 (1) , 1-11
Structural and Phase Transformations in Nanoscale Cu/Cr System under Heat and Ion Actions
- 13 February 2019
- Published by National Academy of Sciences of Ukraine (Co. LTD Ukrinformnauka) (Publications) in Metallofizika i Noveishie Tekhnologii
- Vol. 41 (1) , 1-11
Structural and Phase Transformations in Nanoscale Cu/Cr System under Heat and Ion Actions
- 20 December 2018
- Published by National Academy of Sciences of Ukraine (Co. LTD Ukrinformnauka) (Publications) in Metallofizika i Noveishie Tekhnologii
- Vol. 40 (11) , 1521-1537
Enhancement of Heat Resistance of Ti6Al4V Titanium Alloy by Formation of Oxide Composite Layers Using Ultrasonic Impact Treatment
- 20 December 2018
- Published by National Academy of Sciences of Ukraine (Co. LTD Ukrinformnauka) (Publications) in Metallofizika i Noveishie Tekhnologii
- Vol. 40 (11) , 1521-1537
Enhancement of Heat Resistance of Ti6Al4V Titanium Alloy by Formation of Oxide Composite Layers Using Ultrasonic Impact Treatment
- 4 December 2018
- Published by National Academy of Sciences of Ukraine (Co. LTD Ukrinformnauka) (Publications) in Metallofizika i Noveishie Tekhnologii
- Vol. 40 (7) , 919-930
Plasmon Spectroscopy of a Surface of the Transition Metal Films after Low-Energy Ion Action
- 4 December 2018
- Published by National Academy of Sciences of Ukraine (Co. LTD Ukrinformnauka) (Publications) in Metallofizika i Noveishie Tekhnologii
- Vol. 40 (7) , 919-930
Plasmon Spectroscopy of a Surface of the Transition Metal Films after Low-Energy Ion Action
- Open Access
- 1 December 2018
- Published by National Academy of Sciences of Ukraine (Co. LTD Ukrinformnauka) in Uspehi Fiziki Metallov
- Vol. 19 (4) , 418-441
The Secondary-Ion Emission: Matrix Effect
- 1 December 2018
- Published by National Academy of Sciences of Ukraine (Co. LTD Ukrinformnauka) in Uspehi Fiziki Metallov
- Vol. 19 (4) , 418-441
Open AccessThe Secondary-Ion Emission: Matrix Effect