O. A. Aref’eva
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
O. A. Aref’eva has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Lyubov N. Olshanskaya
Yuri Gagarin State Technical University of Saratov
4 shared publications - Elena A. Tatarintseva
Yuri Gagarin State Technical University of Saratov
3 shared publications Yuri Gagarin State Technical University of Saratov
3 shared publications- E. N. Lazareva
Yuri Gagarin State Tech Univ Saratov, 77 Politekhn Skaya St, Saratov 410054, Russia
2 shared publications - Elena V. Yakovleva
Yuri Gagarin State Tech Univ Saratov, 77 Politekhn Skaya St, Saratov 410054, Russia
2 shared publications R.Sh. Valiev
2 shared publications
Latest Publications
- 26 June 2023
- Published by O-Kratkoe Ltd in Theoretical and Applied Ecology
- No. 2,p. 89-95
Galvanic sludge is a source of secondary material resources in the production of filler pigments for paints and varnishes
Galvanic production occupies one of the first places according to the degree of negative impact on the environment due to the content of heavy metal ions which have toxic, carcinogenic and mutagenic properties. Finding an effective method of recycling and utilization of galvanic sludge will solve the problem of the steady growth of the cost of metals and minimize the negative impact on the environment, which is an important environmental task of great scientific and practical significance. This paper presents the results of studies on the extraction of iron oxide(III) Fe2O3 from ironcontaining galvanic sludge to use it as a filler pigment in the manufacture of paint (red iron oxide). At the initial stage, the original galvanic sludge was dissolved in distilled water to a creamy consistency, and then, sulfuric acid was gradually added until the pH value gradually decreased (pH 6.0–1.5), metal sulfates were obtained. Iron hydroxide(III) Fe(OH)3 was precipitated from filtered sulfate solutions with 40% NaOH alkali solution at pH 1.5–4.1. After preliminary drying at a temperature of ≈ 150 оС, heat treatment was carried out at 600±2 оС for 5–6 h, obtaining iron oxide(III) Fe2O3, which met the requirements of GOST 10503-71 “Oil paints, ready to use. Technical Conditions in terms of particle size, oil capacity, particle density and pH of aqueous extracts. The iron minium paint made on its basis also met the requirements of this GOST on parameters: viscosity, hiding power, drying time, etc. A schematic diagram is proposed for obtaining a filler pigment used for the production of paints and varnishes. The scheme uses a set and layout of equipment widely used in industry (conveyor, batchers, screw feeders, acid and alkali treatment baths, centrifuge, drying and roasting oven).
- 26 June 2023
- Published by O-Kratkoe Ltd in Theoretical and Applied Ecology
- No. 2,p. 89-95
Galvanic sludge is a source of secondary material resources in the production of filler pigments for paints and varnishes
Galvanic production occupies one of the first places according to the degree of negative impact on the environment due to the content of heavy metal ions which have toxic, carcinogenic and mutagenic properties. Finding an effective method of recycling and utilization of galvanic sludge will solve the problem of the steady growth of the cost of metals and minimize the negative impact on the environment, which is an important environmental task of great scientific and practical significance. This paper presents the results of studies on the extraction of iron oxide(III) Fe2O3 from ironcontaining galvanic sludge to use it as a filler pigment in the manufacture of paint (red iron oxide). At the initial stage, the original galvanic sludge was dissolved in distilled water to a creamy consistency, and then, sulfuric acid was gradually added until the pH value gradually decreased (pH 6.0–1.5), metal sulfates were obtained. Iron hydroxide(III) Fe(OH)3 was precipitated from filtered sulfate solutions with 40% NaOH alkali solution at pH 1.5–4.1. After preliminary drying at a temperature of ≈ 150 оС, heat treatment was carried out at 600±2 оС for 5–6 h, obtaining iron oxide(III) Fe2O3, which met the requirements of GOST 10503-71 “Oil paints, ready to use. Technical Conditions in terms of particle size, oil capacity, particle density and pH of aqueous extracts. The iron minium paint made on its basis also met the requirements of this GOST on parameters: viscosity, hiding power, drying time, etc. A schematic diagram is proposed for obtaining a filler pigment used for the production of paints and varnishes. The scheme uses a set and layout of equipment widely used in industry (conveyor, batchers, screw feeders, acid and alkali treatment baths, centrifuge, drying and roasting oven).
- 1 January 2023
- Published by O-Kratkoe Ltd in Theoretical and Applied Ecology
- No. 1,p. 148-153
Extraction of copper and zinc ions from wastewater by a sorbent based on chitosan
- 1 January 2023
- Published by O-Kratkoe Ltd in Theoretical and Applied Ecology
- No. 1,p. 148-153
Extraction of copper and zinc ions from wastewater by a sorbent based on chitosan
- 1 January 2021
- Published by O-Kratkoe Ltd in Theoretical and Applied Ecology
- No. 4,p. 167-173
Energy and resource-saving technologies for utilization of metal-containing galvanic sludges
The environmental problems of the formation and accumulation of various types of wastes, in particular, galvanic sludge (GS), which are pollutants of biosphere complexes, are considered. By polluting air, soil, surface and underground waters, they pose a serious ecological hazard to the environment and public health. Along with this, galvanic sludge often contains very valuable components - ferrous and non-ferrous metals, which can be used to obtain products and goods that are of great importance for national economic. The paper presents the results on the utilization of galvanic sludge into materials for the creation of magneto sorbents (MS) when removing various oil contaminants from waste and surface waters. A method for ferritization of iron-containing galvanic waste is proposed, in which, due to the presence of iron, the material acquires magnetic properties and can be used as a magnetic component of composite MS, which greatly simplifies the process of cleaning the water surface from a film of oil and oil products using magnetic separation. During ferritization, films of mixed oxides of ions of heavy metals and iron - ferrites with the general formula MeOFe2O3 are formed on the surface of metal hydroxide particles. Investigation of the process of ferritization of iron-containing GS by the thermal method has been carried out. The main parameters of the ferritization process have been empirically established: t = 1000 degrees C and tau = 1.5 h. Received powdery ferritized galvanic sludge (FGSt) has well-pronounced magnetic properties, the saturation induction determined using a vibration magnetometer was 0.02 T. This allows it to be used as a component in the preparation of composite MS. For hydrophobization of FGSt and obtaining granular oil sorbents, paraffin was used in a ratio of components 1 : 2 by weight. It was found that the buoyancy of the obtained composite magneto sorbents (CMS) for 96 h was 98-100%, respectively, the water absorption did not exceed 0.2 g water/g. The wettability of the materials was evaluated by measuring the contact angles of a sitting drop formed on the surface of the compacted layer of the material. The contact angle is 140 degrees, which indicates good hydrophobicity of the materials. Technological solutions have been developed, environmentally friendly methods of manufacturing composite sorption materials for purification of waste and surface waters from various types of oil and oil products have been proposed. It is shown that with the disposal and rational use of galvanic sludge waste in the production of composite MS for the purification of water bodies from oil and oil products, ecological, economic and social benefits can be obtained.
- 1 January 2021
- Published by O-Kratkoe Ltd in Theoretical and Applied Ecology
- No. 4,p. 167-173
Energy and resource-saving technologies for utilization of metal-containing galvanic sludges
The environmental problems of the formation and accumulation of various types of wastes, in particular, galvanic sludge (GS), which are pollutants of biosphere complexes, are considered. By polluting air, soil, surface and underground waters, they pose a serious ecological hazard to the environment and public health. Along with this, galvanic sludge often contains very valuable components - ferrous and non-ferrous metals, which can be used to obtain products and goods that are of great importance for national economic. The paper presents the results on the utilization of galvanic sludge into materials for the creation of magneto sorbents (MS) when removing various oil contaminants from waste and surface waters. A method for ferritization of iron-containing galvanic waste is proposed, in which, due to the presence of iron, the material acquires magnetic properties and can be used as a magnetic component of composite MS, which greatly simplifies the process of cleaning the water surface from a film of oil and oil products using magnetic separation. During ferritization, films of mixed oxides of ions of heavy metals and iron - ferrites with the general formula MeOFe2O3 are formed on the surface of metal hydroxide particles. Investigation of the process of ferritization of iron-containing GS by the thermal method has been carried out. The main parameters of the ferritization process have been empirically established: t = 1000 degrees C and tau = 1.5 h. Received powdery ferritized galvanic sludge (FGSt) has well-pronounced magnetic properties, the saturation induction determined using a vibration magnetometer was 0.02 T. This allows it to be used as a component in the preparation of composite MS. For hydrophobization of FGSt and obtaining granular oil sorbents, paraffin was used in a ratio of components 1 : 2 by weight. It was found that the buoyancy of the obtained composite magneto sorbents (CMS) for 96 h was 98-100%, respectively, the water absorption did not exceed 0.2 g water/g. The wettability of the materials was evaluated by measuring the contact angles of a sitting drop formed on the surface of the compacted layer of the material. The contact angle is 140 degrees, which indicates good hydrophobicity of the materials. Technological solutions have been developed, environmentally friendly methods of manufacturing composite sorption materials for purification of waste and surface waters from various types of oil and oil products have been proposed. It is shown that with the disposal and rational use of galvanic sludge waste in the production of composite MS for the purification of water bodies from oil and oil products, ecological, economic and social benefits can be obtained.
- 1 January 2021
- Published by Penza State University in University proceedings. Volga region. Natural sciences
- No. 2
A study of water environment purification efficiency by little duckweed Lemna minor L. from heavy metal salts using the energy of electromagnetic radiation and phytoremediant regeneration
Article 8221. Пензенский государственный университет
- 1 January 2021
- Published by Penza State University in University proceedings. Volga region. Natural sciences
- No. 2
A study of water environment purification efficiency by little duckweed Lemna minor L. from heavy metal salts using the energy of electromagnetic radiation and phytoremediant regeneration
Article 8221. Пензенский государственный университет
- 1 January 2021
- Published by Penza State University in University proceedings. Volga region. Natural sciences
- No. 1
Cultivation of Chlorella sorokiniana in natural open air conditions of the Volga region and in a laboratory experiment under the effect of a constant magnetic field
Article 7121. Пензенский государственный университет
- 1 January 2021
- Published by Penza State University in University proceedings. Volga region. Natural sciences
- No. 1
Cultivation of Chlorella sorokiniana in natural open air conditions of the Volga region and in a laboratory experiment under the effect of a constant magnetic field
Article 7121. Пензенский государственный университет