Derese Wodajo Bekele
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Derese Wodajo Bekele has a total of 5 co-authors. Here are the top co-authors by number of shared publications:
Shimelis Admassu
Addis Ababa Institute of Technology
2 shared publicationsShimelis Admassu Emire
School of Chemical and Bioengineering, Addis Ababa Institute of Technology, Addis Ababa, Ethiopia
2 shared publications- Shimelis Admassu Emire
Addis Ababa University
2 shared publications - Misikir Milkias
School of Chemical and Bio-Engineering, Addis Ababa Institute of Technology, King George VI Street, Addis Ababa, Ethiopia
1 shared publication - Workineh Abebe
Department of Agriculture and Forestry Engineering, Food Technology, College of Agricultural and Forestry Engineering, University of Valladolid, 47002 Valladolid, Spain
1 shared publication
Latest Publications
- Open Access
- 1 January 2026
- Published by Wiley in Journal of Food Processing and Preservation
- Vol. 2026 (1)
Moisture Sorption Isotherm and Rheological Characteristics of Ethiopian Potato ( Plectranthus edulis ) Starch and Flour
This study examines the moisture sorption isotherms and rheological properties of indigenous Ethiopian potato (EP) starch and flour to address knowledge gaps. Moisture sorption isotherms were determined at 20°C using saturated salt solutions, with equilibrium moisture content (EMC) plotted against a w . Five models (Guggenheim–Anderson–de Boer [GAB], Modified GAB, BET, Oswin, and Peleg) were applied, with BET and modified GAB best describing the sorption behavior. Rheological properties were analyzed using Bingham plastic, power‐law, Herschel–Bulkley, Robertson–Stiff, and Prandtl–Eyring models. The power‐law model best fit starch, while Prandtl–Eyring was optimal for flour. Both exhibited pseudoplastic behavior, with flow index ( n ) values below 1. Dynamic frequency sweep tests showed that storage modulus ( G ′) exceeded loss modulus ( G ″), indicating elasticity. The complex viscosity ( ƞ ∗ ) decreased with angular frequency and was lower in starch (289.92 Pa.s) than flour (346.24 Pa.s). Tan δ values (0.13 for starch, 0.18 for flour) suggested stronger elastic behavior. This study demonstrates that EP starch and flour exhibit good moisture stability and favorable rheological properties, supporting their use in food processing like thickening, gelling, and gluten‐free food products.
- 1 January 2026
- Published by Wiley in Journal of Food Processing and Preservation
- Vol. 2026 (1)
Open AccessMoisture Sorption Isotherm and Rheological Characteristics of Ethiopian Potato ( Plectranthus edulis ) Starch and Flour
This study examines the moisture sorption isotherms and rheological properties of indigenous Ethiopian potato (EP) starch and flour to address knowledge gaps. Moisture sorption isotherms were determined at 20°C using saturated salt solutions, with equilibrium moisture content (EMC) plotted against a w . Five models (Guggenheim–Anderson–de Boer [GAB], Modified GAB, BET, Oswin, and Peleg) were applied, with BET and modified GAB best describing the sorption behavior. Rheological properties were analyzed using Bingham plastic, power‐law, Herschel–Bulkley, Robertson–Stiff, and Prandtl–Eyring models. The power‐law model best fit starch, while Prandtl–Eyring was optimal for flour. Both exhibited pseudoplastic behavior, with flow index ( n ) values below 1. Dynamic frequency sweep tests showed that storage modulus ( G ′) exceeded loss modulus ( G ″), indicating elasticity. The complex viscosity ( ƞ ∗ ) decreased with angular frequency and was lower in starch (289.92 Pa.s) than flour (346.24 Pa.s). Tan δ values (0.13 for starch, 0.18 for flour) suggested stronger elastic behavior. This study demonstrates that EP starch and flour exhibit good moisture stability and favorable rheological properties, supporting their use in food processing like thickening, gelling, and gluten‐free food products.
- Open Access
- 31 March 2023
- Published by Taylor & Francis in International Journal of Food Properties
- Vol. 26 (1) , 963-973
Pasting, thermal and structural properties of haricot beans flour ( Phaseolus vulgaris , L.) as affected by variety and germination
This research aimed to verify how the germination method affects the pasting, thermal and structural properties of haricot bean flours to expand their potential for application in various food products. The pasting properties of flours showed considerable variation due to variety, germination, and interaction between variety and germination. Onset, peak and end of gelatinization temperature and enthalpy of haricot bean flours ranged with germination from 65.4 to 67.9, 70.6 to 73.3, 77.0 to 79.4 C, and 3.5 to 4.9 J/g, respectively. The Crystallinity index of 632 G flour was higher than that of 119 G and 125 G flour. The data revealed that the soaked and germinated haricot bean flour showed major diffraction peak values of the 2θ at 18.25°,18.40°,18.25°, 17.68°, 18.74°, and 18.34°, respectively for 119S, 119 G, 632S, 632 G,125S, and 125 G. FT-IR spectroscopy of four samples did not show any variations in spectra, but a change in the intensity of bands was observed. The SEM images reveal that starch granules were surrounded by a protein matrix.
- 31 March 2023
- Published by Taylor & Francis in International Journal of Food Properties
- Vol. 26 (1) , 963-973
Open AccessPasting, thermal and structural properties of haricot beans flour ( Phaseolus vulgaris , L.) as affected by variety and germination
This research aimed to verify how the germination method affects the pasting, thermal and structural properties of haricot bean flours to expand their potential for application in various food products. The pasting properties of flours showed considerable variation due to variety, germination, and interaction between variety and germination. Onset, peak and end of gelatinization temperature and enthalpy of haricot bean flours ranged with germination from 65.4 to 67.9, 70.6 to 73.3, 77.0 to 79.4 C, and 3.5 to 4.9 J/g, respectively. The Crystallinity index of 632 G flour was higher than that of 119 G and 125 G flour. The data revealed that the soaked and germinated haricot bean flour showed major diffraction peak values of the 2θ at 18.25°,18.40°,18.25°, 17.68°, 18.74°, and 18.34°, respectively for 119S, 119 G, 632S, 632 G,125S, and 125 G. FT-IR spectroscopy of four samples did not show any variations in spectra, but a change in the intensity of bands was observed. The SEM images reveal that starch granules were surrounded by a protein matrix.
- Open Access
- 19 October 2022
- Published by Taylor & Francis in International Journal of Food Properties
- Vol. 25 (1) , 2409-2424
Pumpkin flour qualities as affected by ultrasound and microwave pre-drying treatment
The aim of this study was to assess the impact of innovative pre-drying treatments (ultrasound and microwave) on the physical, chemical, and functional properties pumpkin flour in comparison to untreated and freeze-dried (optimal control) flours. The impact was primarily related to the improvement of the flour’s nutritional, phytochemical, and functional properties. The pretreated flours were superior to untreated flour and were nearer in quality to freeze-dried flour. The moisture, ash, crude fat, crude protein, crude fiber, and carbohydrate contents of flours ranged from 7.57 to 8.23%, 5.73 to 6.57%, 1.17 to 1.85%, 8.72 to 11.32%, 10.92 to 13.11%, and 61.47 to 64.23%, respectively. Among the pre-drying treatment, 20UM depicts the highest color change and retention of the bioactive component in pumpkin flour. The results also showed that the 30UM pry-dried flour had higher water solubilities index (11.83%), water absorption (9.75 g/g), and oil absorption capacities (2.28 mL/g).
- 19 October 2022
- Published by Taylor & Francis in International Journal of Food Properties
- Vol. 25 (1) , 2409-2424
Open AccessPumpkin flour qualities as affected by ultrasound and microwave pre-drying treatment
The aim of this study was to assess the impact of innovative pre-drying treatments (ultrasound and microwave) on the physical, chemical, and functional properties pumpkin flour in comparison to untreated and freeze-dried (optimal control) flours. The impact was primarily related to the improvement of the flour’s nutritional, phytochemical, and functional properties. The pretreated flours were superior to untreated flour and were nearer in quality to freeze-dried flour. The moisture, ash, crude fat, crude protein, crude fiber, and carbohydrate contents of flours ranged from 7.57 to 8.23%, 5.73 to 6.57%, 1.17 to 1.85%, 8.72 to 11.32%, 10.92 to 13.11%, and 61.47 to 64.23%, respectively. Among the pre-drying treatment, 20UM depicts the highest color change and retention of the bioactive component in pumpkin flour. The results also showed that the 30UM pry-dried flour had higher water solubilities index (11.83%), water absorption (9.75 g/g), and oil absorption capacities (2.28 mL/g).
- Open Access
- 15 May 2022
- Published by Taylor & Francis in International Journal of Food Properties
- Vol. 25 (1) , 1186-1202
Haricot beans ( Phaseolus vulgaris L.) flour: Effect of varieties and processing methods to favor the utilization of underconsumed common beans
Four improved varieties of haricot bean flour prepared by soaking, autoclaving, germination, and germination followed by autoclaving were investigated. The objective was to obtain information on the effect of varieties, processing methods and their interactions on flour quality. The moisture, crude protein, crude fat, crude fiber, ash, and carbohydrate contents of flours were from 8.05 to 9.72%, 23.11 to 27.96%, 1.33 to 2.87%, 3.82 to 5.97%, 3.45 to 5.52%, and 51.79 to 57.14%, respectively. The flour produced through germination followed by the autoclaving method showed a significant reduction in tannin, phytate, and oxalate contents with less acceptability by the consumer while the one that produced through germination increased in total flavonoids (2.79 to 3.69 mg QE/g), total phenol content (0.72 to 1.04 mg GAE/g) and DPPH scavenging activities (EC50). Germination showed increased foaming and emulsifying capacity; however, autoclaving and germination followed by autoclaving noticeably reduced foaming capacities.
- 15 May 2022
- Published by Taylor & Francis in International Journal of Food Properties
- Vol. 25 (1) , 1186-1202
Open AccessHaricot beans ( Phaseolus vulgaris L.) flour: Effect of varieties and processing methods to favor the utilization of underconsumed common beans
Four improved varieties of haricot bean flour prepared by soaking, autoclaving, germination, and germination followed by autoclaving were investigated. The objective was to obtain information on the effect of varieties, processing methods and their interactions on flour quality. The moisture, crude protein, crude fat, crude fiber, ash, and carbohydrate contents of flours were from 8.05 to 9.72%, 23.11 to 27.96%, 1.33 to 2.87%, 3.82 to 5.97%, 3.45 to 5.52%, and 51.79 to 57.14%, respectively. The flour produced through germination followed by the autoclaving method showed a significant reduction in tannin, phytate, and oxalate contents with less acceptability by the consumer while the one that produced through germination increased in total flavonoids (2.79 to 3.69 mg QE/g), total phenol content (0.72 to 1.04 mg GAE/g) and DPPH scavenging activities (EC50). Germination showed increased foaming and emulsifying capacity; however, autoclaving and germination followed by autoclaving noticeably reduced foaming capacities.