SPS. Pavithra

S. Pavithra

*This is an algorithmically generated author record based on publicly available information.

S. Pavithra has a total of 20 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Engineered CoS/Ni3S2 Heterointerface Catalysts Grown Directly on Carbon Paper as an Efficient Electrocatalyst for Urea Oxidation

    by Saba A. Aladeemy, Prabhakarn Arunachalam, Abdullah M. Al-Mayouf, P. N. Sudha, A. Rekha, A. Vidhya, J. Hemapriya, Srinivasan Latha, P. Supriya Prasad, S. Pavithra, et al.

    Developing highly efficient and stable electrocatalysts for urea electro-oxidation reactions (UORs) will improve wastewater treatment and energy conversion. A low-cost cobalt sulfide-anchored nickel sulfide electrode (CoS/Ni3S2@CP) was synthesized by electrodeposition in DMSO solutions and found to be highly effective and long-lasting. The morphology and composition of catalyst surfaces were examined using comprehensive physicochemical and electrochemical characterization. Specifically, CoS/Ni3S2@CP electrodes require a potential of 1.52 volts for a 50 mA/cm2 current, confirming CoS in the heterointerface CoS/Ni3S2@CP catalyst. Further, the optimized CoS/Ni3S2@CP catalyst shows a decrease of 100 mV in the onset potential (1.32 VRHE) for UORs compared to bare Ni3S2@CP catalysts (1.42 VRHE), demonstrating much greater performance of UORs. As compared to Ni3S2@CP, CoS/Ni3S2@CP exhibits twofold greater UOR efficiency as a result of a larger electroactive surface area. The results obtained indicate that the synthetic CoS/Ni3S2@CP catalyst may be a favorable electrode material for managing urea-rich wastewater and generating H2.


  • Open Access

    Removal of Copper(II) Ion using Nanochitosan/Carboxymethyl Cellulose/Grapheme Oxide Composite Biosorbent

    by S. Sugashini, T. Gomathi, S. Pavithra, P.N. Sudha, J. Annie Kamala Florence, A. Mubashirunnisa

    The present study aimed to prepare a novel biosorbent of nanochitosan (NCS)/carboxymethyl cellulose (CMC)/graphene oxide (GO) and used to remove Cu(II) ion from wastewater system. The prepared nanocomposite was characterized using FTIR, XRD and SEM analysis. The FTIR and XRD results revealed the formation of novel NCS/CMC/GO nanocomposite. Rough surface morphology of nanocomposite was confirmed from the SEM analysis results. The removal efficiency of Cu(II) ion was evaluated through batch mode by varying pH, adsorbent dose, contact time and initial metal ion concentration. The maximum removal of Cu(II) ion was 80.1% at pH 4, 92.4% at 360 min contact time and about 89.2% for 3 g adsorbent dose. Theoretical models such as Langmuir isotherm, Freundlich isotherm, and kinetics models were used to evaluate the experimental results. After examining, the results revealed that the adsorption follows Freundlich isotherm and pseudo-second-order models. The adsorption capacity of the prepared nanocomposite was 145.22 mg/g.


  • Open Access

    Degradation of refractory organics in chemical industry wastewater using iron (II) Schiff base complex as homogeneous catalyst in Fenton-like oxidation

    by S. Pavithra, A. Madonna, S. Swarnalatha, K. Mohan Das, A.B. Mandal, G. Sekaran

    Degradation of biorefractory compounds in wastewater generated from a chemical industry using iron (II) Schiff base complex as homogeneous catalyst. The complex of iron (II) Schiff base was derived from o-vanillin and allyl thio urea. The ligand and the complex were characterized using FT-IR, UV–Visible, fluorescence spectroscopy, SEM–EDX, and elemental composition. The optimized conditions for degradation were carried out with different time, pH, temperature, dosage of the complex, and H2O2. The chemical oxygen demand was reduced from 3,360 to 1,200 mg/L (64.3% reduction) at the optimized conditions such as pH, temperature, iron (II) Schiff base complex, and H2O2. The degradation of chemicals in wastewater was confirmed with the 13C-NMR, 1H-NMR, high performance liquid chromatography (HPLC), and fluorescence spectroscopy.