Juliana Cristina Tristão
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Juliana Cristina Tristão has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
- Leandro José dos Santos
Universidade Federal de Viçosa
3 shared publications - Vívian Helene Diniz Araújo
Universidade Federal de Viçosa – Campus Florestal, UFV, Rodovia LMG 818, km 06, s/n, Campus Universitário, Florestal, MG, Brazil
3 shared publications - Ana Flavia Nogueira
Institute of Chemistry
2 shared publications - Matheus Henrique Pimentel Araújo
Universidade Federal de Viçosa – Campus Florestal – UFV, Rodovia LMG 818, km 06, s/n, Campus Universitário, Florestal, MG, 35690-000, Brazil
2 shared publications - Alisson Carlos Krohling
Centro de Desenvolvimento da Tecnologia Nuclear – CDTN/CNEN, campus da Universidade Federal de Minas Gerais, Avenida Presidente Antônio Carlos, No 6627, Rua Mário Werneck, S/N – Pampulha, Belo Horizonte, MG, Brazil
1 shared publication - Emerson Fonseca Silva
Universidade Federal de Viçosa
1 shared publication
Latest Publications
- Open Access
- 1 January 2026
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Advances
- Vol. 5 (8) , 2014-2025
Phosphate removal from water using zinc ferrite-based materials prepared via different methods: insights into adsorption performance and reusability
Zinc ferrite-based materials were synthesized via different methods and applied for efficient phosphate removal from water, showing enhanced adsorption performance and reusability.
- 1 January 2026
- Published by Royal Society of Chemistry (RSC) in Environmental Science: Advances
- Vol. 5 (8) , 2014-2025
Open AccessPhosphate removal from water using zinc ferrite-based materials prepared via different methods: insights into adsorption performance and reusability
Zinc ferrite-based materials were synthesized via different methods and applied for efficient phosphate removal from water, showing enhanced adsorption performance and reusability.
- Open Access
- 22 August 2025
- Published by Royal Society of Chemistry (RSC) in RSC Sustainability
- Vol. 3 (10) , 4314-4335
Advances in lead-free perovskite solar cell design via SCAPS-1D simulations
Perovskite solar cells (PSCs) have attracted significant attention over the past decade due to their high performance. However, challenges such as moisture sensitivity and the toxicity of certain constituents remain barriers to their commercialization. Tin, germanium, and other elements with optoelectronic properties similar to those of lead have emerged as promising substitutes for the B-site metal in PSCs. Theoretical studies have played a crucial role in elucidating how specific material and structural parameters influence photovoltaic behavior. Among the most prominent tools for simulating thin-film solar cells in recent years, open-source SCAPS-1D software stands out as a valuable resource. Therefore, this article presents a comprehensive review of 54 simulation studies, using SCAPS-1D, published between 2016 and 2025, focusing on lead-free PSCs. In total, 26 studies on Sn-based PSCs and 28 on perovskites with alternative B-site metals were analyzed to evaluate how simulations have contributed to understanding device performance with lead substitutes. This review also provides an overview of the current research landscape and highlights promising directions for advancing environmentally benign, lead-free PSCs through SCAPS modeling. The studies discussed in this review show a prevailing tendency to simulate PSCs in regular rather than inverted configuration. In many cases, the defect density assumed for the absorber layer is set at ideal values or even below 1013 cm−3, which potentially limits the accuracy of predictions. Among the strategies adopted to improve performance, composition engineering emerged as the most prominent.
- 22 August 2025
- Published by Royal Society of Chemistry (RSC) in RSC Sustainability
- Vol. 3 (10) , 4314-4335
Open AccessAdvances in lead-free perovskite solar cell design via SCAPS-1D simulations
Perovskite solar cells (PSCs) have attracted significant attention over the past decade due to their high performance. However, challenges such as moisture sensitivity and the toxicity of certain constituents remain barriers to their commercialization. Tin, germanium, and other elements with optoelectronic properties similar to those of lead have emerged as promising substitutes for the B-site metal in PSCs. Theoretical studies have played a crucial role in elucidating how specific material and structural parameters influence photovoltaic behavior. Among the most prominent tools for simulating thin-film solar cells in recent years, open-source SCAPS-1D software stands out as a valuable resource. Therefore, this article presents a comprehensive review of 54 simulation studies, using SCAPS-1D, published between 2016 and 2025, focusing on lead-free PSCs. In total, 26 studies on Sn-based PSCs and 28 on perovskites with alternative B-site metals were analyzed to evaluate how simulations have contributed to understanding device performance with lead substitutes. This review also provides an overview of the current research landscape and highlights promising directions for advancing environmentally benign, lead-free PSCs through SCAPS modeling. The studies discussed in this review show a prevailing tendency to simulate PSCs in regular rather than inverted configuration. In many cases, the defect density assumed for the absorber layer is set at ideal values or even below 1013 cm−3, which potentially limits the accuracy of predictions. Among the strategies adopted to improve performance, composition engineering emerged as the most prominent.
- Open Access
- 3 April 2024
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 14 (16) , 10930-10941
Fullerene-C60 and PCBM as interlayers in regular and inverted lead-free PSCs using CH3NH3SnI3: an analysis of device performance and defect density dependence by SCAPS-1D
The use of fullerene-C60 and PCBM as interlayers in lead-free PSCs can positively impact the optimized parameters of these solar cells. The simulation program SCAPS-1D was used to simulate inverted and regular PSCs using interlayers in MASI PSCs.
- 3 April 2024
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 14 (16) , 10930-10941
Open AccessFullerene-C60 and PCBM as interlayers in regular and inverted lead-free PSCs using CH3NH3SnI3: an analysis of device performance and defect density dependence by SCAPS-1D
The use of fullerene-C60 and PCBM as interlayers in lead-free PSCs can positively impact the optimized parameters of these solar cells. The simulation program SCAPS-1D was used to simulate inverted and regular PSCs using interlayers in MASI PSCs.
- Open Access
- 3 January 2024
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 14 (3) , 1612-1624
Calcium ferrites for phosphate adsorption and recovery from wastewater
In this study, calcium ferrites with different Ca : Fe atomic ratios (1 : 1, 1 : 2, 1 : 3 and 2 : 1) were prepared from Ca and Fe nitrates treated at 300, 700 and 900 °C and evaluated for phosphate adsorption and recovery from wastewater. TG, XRD, Mössbauer spectroscopy, SEM, VSM magnetic measurements, and BET analyses showed the formation of two different calcium ferrite phases, i.e., CaFe2O4 and Ca2Fe2O5 at 700 and 900 °C. The adsorption results indicated that the formation of calcium ferrite structure is critical for phosphate adsorption/recovery. Evaluation of the pH, initial phosphate concentration, contact time, coexisting ions and desorption conditions showed remarkable adsorption capacities of 62–75 mg g−1 for CaFe1:2-700 and 28–43 mg g−1 for CaFe1:2-900. The phosphate adsorption on the Ca ferrite surfaces is so strong that the recovery/desorption showed limited efficiencies, e.g., 15–39%.
- 3 January 2024
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 14 (3) , 1612-1624
Open AccessCalcium ferrites for phosphate adsorption and recovery from wastewater
In this study, calcium ferrites with different Ca : Fe atomic ratios (1 : 1, 1 : 2, 1 : 3 and 2 : 1) were prepared from Ca and Fe nitrates treated at 300, 700 and 900 °C and evaluated for phosphate adsorption and recovery from wastewater. TG, XRD, Mössbauer spectroscopy, SEM, VSM magnetic measurements, and BET analyses showed the formation of two different calcium ferrite phases, i.e., CaFe2O4 and Ca2Fe2O5 at 700 and 900 °C. The adsorption results indicated that the formation of calcium ferrite structure is critical for phosphate adsorption/recovery. Evaluation of the pH, initial phosphate concentration, contact time, coexisting ions and desorption conditions showed remarkable adsorption capacities of 62–75 mg g−1 for CaFe1:2-700 and 28–43 mg g−1 for CaFe1:2-900. The phosphate adsorption on the Ca ferrite surfaces is so strong that the recovery/desorption showed limited efficiencies, e.g., 15–39%.
- 1 January 2024
- Published by Revista Brasileira de Gestao Ambiental e Sustentabilidade in Revista Brasileira de Gestão Ambiental e Sustentabilidade
- Vol. 11 (29) , 1191-1204
Panorama atual e perspectivas futuras do uso da biomassa da macaúba Acrocomia aculeata (Jack.) Lood. ex Mart. (Arecaceae): uma revisão sistemática da literatura
A macaúba Acrocomia aculeata (Jack.) Lood. ex Mart. (Arecaceae) é uma palmeira oleaginosa amplamente distribuída pelo território brasileiro. Recentemente muita atenção tem sido dada a esta espécie, em função do alto teor de óleo proveniente de seu fruto, utilizado na produção de biodiesel e outros combustíveis derivados. No processamento de seu fruto há iminente geração de resíduos, que pode causar inúmeros passivos ambientais. Este trabalho busca, através de uma revisão sistemática da literatura, utilizando a metodologia de PRISMA, entender quais produtos tem sido gerado a partir dos resíduos da palmeira (casca, polpa, amêndoa, endocarpo e folhas) na atualidade. Para isso, foram utilizadas as bases de dados e portais acadêmicos Google Scholar, Periódicos CAPES e Scopus. Foram selecionados, a partir de uma série de critérios, 33 artigos para leitura total do texto e avaliação da elegibilidade, dos quais 14 foram selecionados para compor a revisão. Observou-se que a maior parte dos trabalhos busca produzir biocombustíveis e carvão ativado a partir de diferentes processos e técnicas. Ademais, este trabalho aponta algumas perspectivas e oportunidades futuras de pesquisa científica com os res#237;duos gerados a partir do processo de beneficiamento da macaúba, visando a obter produtos com alto valor agregado, mitigando poss#237;veis impactos e otimizando a cadeia produtiva da esp#233;cie.
- 1 January 2024
- Published by Revista Brasileira de Gestao Ambiental e Sustentabilidade in Revista Brasileira de Gestão Ambiental e Sustentabilidade
- Vol. 11 (29) , 1191-1204
Panorama atual e perspectivas futuras do uso da biomassa da macaúba Acrocomia aculeata (Jack.) Lood. ex Mart. (Arecaceae): uma revisão sistemática da literatura
A macaúba Acrocomia aculeata (Jack.) Lood. ex Mart. (Arecaceae) é uma palmeira oleaginosa amplamente distribuída pelo território brasileiro. Recentemente muita atenção tem sido dada a esta espécie, em função do alto teor de óleo proveniente de seu fruto, utilizado na produção de biodiesel e outros combustíveis derivados. No processamento de seu fruto há iminente geração de resíduos, que pode causar inúmeros passivos ambientais. Este trabalho busca, através de uma revisão sistemática da literatura, utilizando a metodologia de PRISMA, entender quais produtos tem sido gerado a partir dos resíduos da palmeira (casca, polpa, amêndoa, endocarpo e folhas) na atualidade. Para isso, foram utilizadas as bases de dados e portais acadêmicos Google Scholar, Periódicos CAPES e Scopus. Foram selecionados, a partir de uma série de critérios, 33 artigos para leitura total do texto e avaliação da elegibilidade, dos quais 14 foram selecionados para compor a revisão. Observou-se que a maior parte dos trabalhos busca produzir biocombustíveis e carvão ativado a partir de diferentes processos e técnicas. Ademais, este trabalho aponta algumas perspectivas e oportunidades futuras de pesquisa científica com os res#237;duos gerados a partir do processo de beneficiamento da macaúba, visando a obter produtos com alto valor agregado, mitigando poss#237;veis impactos e otimizando a cadeia produtiva da esp#233;cie.
- 1 January 2022
- Published by Sociedade Brasileira de Quimica (SBQ) in Revista Virtual de Química
- Vol. 14 (3) , 427-442
Recent Advances in the Use of Fullerene-C60 and Its Derivatives as Additives and Interlayers in Perovskite Solar Cells
- 1 January 2022
- Published by Sociedade Brasileira de Quimica (SBQ) in Revista Virtual de Química
- Vol. 14 (3) , 427-442
Recent Advances in the Use of Fullerene-C60 and Its Derivatives as Additives and Interlayers in Perovskite Solar Cells