Ayane Taki
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Ayane Taki has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Hiroaki Minamisawa
Department of Basic Science, College of Industrial Technology, Nihon University, 2-11-1 Shin-ei, Narashino 275-8576, Chiba, Japan
2 shared publications - Hiromichi Asamoto
Department of Basic Science, College of Industrial Technology, Nihon University, 2-11-1 Shin-ei, Narashino 275-8576, Chiba, Japan
2 shared publications - Kazunori Yamada
Department of Applied Molecular Chemistry, College of Industrial Technology, Nihon University, 1-2-1 Izumi-cho, Narashino 275-8575, Chiba, Japan
2 shared publications - Anzu Nishino
Major of Applied Molecular Chemistry, Graduate School of Industrial Technology, Nihon University, 1-2-1 Izumi-cho, Narashino, Chiba 275-8575, Japan
1 shared publication - Keiko Noguchi
Major of Applied Molecular Chemistry, Graduate School of Industrial Technology, Nihon University, 1-2-1 Izumi-cho, Narashino 275-8575, Chiba, Japan
1 shared publication - Kouta Morioka
Major of Applied Molecular Chemistry, Graduate School of Industrial Technology, Nihon University, 1-2-1 Izumi-cho, Narashino 275-8575, Chiba, Japan
1 shared publication
Latest Publications
- Open Access
Grafting of Polyethyleneimines on Porous Silica Beads and Their Use for Adsorptive Removal of Cr(VI) from Aqueous Medium
Porous silica-based adsorbents for hexavalent chromium (Cr(VI)) ion removal were prepared by the combined use of functionalization with (3-glycidyloxypropyl)trimethoxysilane and the grafting of branched and linear polyethyleneimine (BPEI and LPEI). LPEI was prepared from polyethyloxazolin by hydrolysis with HCl. The preparation of LPEI was identified by NMR measurements and the grafting of BPEI and LPEI on the silica beads was confirmed by an XPS analysis. The Cr(VI) ion adsorption of the obtained BPEI-grafted silica beads (BPEI–silica beads) was investigated as a function of the pH value, the content of amino groups, the temperature, the Cr(VI) ion concentration, and the molecular mass of the grafted BPEI chains. The Cr(VI) ion adsorption at pH 3.0 increased with an increase in the content of amino groups, and the maximum adsorption capacity of 1.06 mmol/g was obtained when the content of amino groups was at 2.17 mmol/g. This value corresponds to 589 mg/g−1.8KPEI, and the adsorption ratio of about 0.5 is a noteworthy result. The data fit to the pseudo-second-order kinetic model, and the suitability of this fitting was supported by the results that the adsorption capacity and initial rate of adsorption increased with the temperature. In addition, the equilibrium data followed the Langmuir isotherm model. These results clearly demonstrate that the Cr(VI) adsorption occurred chemically, or through the electrostatic interaction of protonated amino groups on the grafted BPEI chains with hydrochromate () ions. A higher adsorption capacity was obtained for the silica beads grafted with shorter BPEI chains, and the adsorption capacity of BPEI–silica beads is a little higher than that of linear PEI-grafted silica beads, suggesting that the Cr(VI) ion adsorption is affected by the chain isomerism of PEI (linear and branched) as well as the molecular mass of the grafted PEI chains, in addition to the content of amino groups. The experimental and analytical results derived from this study emphasize that the BPEI–silica beads can be used as an adsorbent for the removal of Cr(VI) ions from an aqueous medium.Open AccessGrafting of Polyethyleneimines on Porous Silica Beads and Their Use for Adsorptive Removal of Cr(VI) from Aqueous Medium
Porous silica-based adsorbents for hexavalent chromium (Cr(VI)) ion removal were prepared by the combined use of functionalization with (3-glycidyloxypropyl)trimethoxysilane and the grafting of branched and linear polyethyleneimine (BPEI and LPEI). LPEI was prepared from polyethyloxazolin by hydrolysis with HCl. The preparation of LPEI was identified by NMR measurements and the grafting of BPEI and LPEI on the silica beads was confirmed by an XPS analysis. The Cr(VI) ion adsorption of the obtained BPEI-grafted silica beads (BPEI–silica beads) was investigated as a function of the pH value, the content of amino groups, the temperature, the Cr(VI) ion concentration, and the molecular mass of the grafted BPEI chains. The Cr(VI) ion adsorption at pH 3.0 increased with an increase in the content of amino groups, and the maximum adsorption capacity of 1.06 mmol/g was obtained when the content of amino groups was at 2.17 mmol/g. This value corresponds to 589 mg/g−1.8KPEI, and the adsorption ratio of about 0.5 is a noteworthy result. The data fit to the pseudo-second-order kinetic model, and the suitability of this fitting was supported by the results that the adsorption capacity and initial rate of adsorption increased with the temperature. In addition, the equilibrium data followed the Langmuir isotherm model. These results clearly demonstrate that the Cr(VI) adsorption occurred chemically, or through the electrostatic interaction of protonated amino groups on the grafted BPEI chains with hydrochromate () ions. A higher adsorption capacity was obtained for the silica beads grafted with shorter BPEI chains, and the adsorption capacity of BPEI–silica beads is a little higher than that of linear PEI-grafted silica beads, suggesting that the Cr(VI) ion adsorption is affected by the chain isomerism of PEI (linear and branched) as well as the molecular mass of the grafted PEI chains, in addition to the content of amino groups. The experimental and analytical results derived from this study emphasize that the BPEI–silica beads can be used as an adsorbent for the removal of Cr(VI) ions from an aqueous medium. - Open Access
Kinetic, Isotherm, and Equilibrium Investigation of Cr(VI) Ion Adsorption on Amine-Functionalized Porous Silica Beads
The hexavalent chromium (Cr(VI)) ion adsorption properties were conferred to porous silica beads by introducing alkylamine chains through functionalization with an aminosilane coupling agent, [3-(2-aminoethylamino)propyl]triethoxysilane (AEAPTES), or with an epoxysilane coupling agent, (3-glycidyloxypropyl)triethoxysilane (GOPTES), and polyfunctional amine compounds or poly-ethylenimines (PEIs). The presence of amino groups on the silica beads was confirmed by XPS and the amount of amino groups increased to 0.270 mmol/g by increasing the AEAPTES concentration and/or reaction time. The adsorption capacity of the silica beads functionalized with AEAPTES was the maximum at the initial pH value of 3.0 and the initial adsorption rate increased with an increase in the temperature. The adsorption capacity increased with an increase in the amount of amino groups at pH 3.0 and 30 °C. The adsorption behavior obeyed the pseudo-second order kinetic model and was well expressed by the Langmuir isotherm. These results support that Cr(VI) ion adsorption is accomplished through the electrostatic interaction between protonated amino groups and HCrO4− ions. In addition, the adsorption capacity further increased to 0.192–0.320 mmol/g by treating the GOPTES-treated silica beads with triethylenetetramine, pentaethylenehexamine, or PEI. These empirical, equilibria, and kinetic aspects obtained in this study support that the porous silica-based adsorbents prepared in this study can be applied to the removal of Cr(VI) ions.
Open AccessKinetic, Isotherm, and Equilibrium Investigation of Cr(VI) Ion Adsorption on Amine-Functionalized Porous Silica Beads
The hexavalent chromium (Cr(VI)) ion adsorption properties were conferred to porous silica beads by introducing alkylamine chains through functionalization with an aminosilane coupling agent, [3-(2-aminoethylamino)propyl]triethoxysilane (AEAPTES), or with an epoxysilane coupling agent, (3-glycidyloxypropyl)triethoxysilane (GOPTES), and polyfunctional amine compounds or poly-ethylenimines (PEIs). The presence of amino groups on the silica beads was confirmed by XPS and the amount of amino groups increased to 0.270 mmol/g by increasing the AEAPTES concentration and/or reaction time. The adsorption capacity of the silica beads functionalized with AEAPTES was the maximum at the initial pH value of 3.0 and the initial adsorption rate increased with an increase in the temperature. The adsorption capacity increased with an increase in the amount of amino groups at pH 3.0 and 30 °C. The adsorption behavior obeyed the pseudo-second order kinetic model and was well expressed by the Langmuir isotherm. These results support that Cr(VI) ion adsorption is accomplished through the electrostatic interaction between protonated amino groups and HCrO4− ions. In addition, the adsorption capacity further increased to 0.192–0.320 mmol/g by treating the GOPTES-treated silica beads with triethylenetetramine, pentaethylenehexamine, or PEI. These empirical, equilibria, and kinetic aspects obtained in this study support that the porous silica-based adsorbents prepared in this study can be applied to the removal of Cr(VI) ions.