Dongmei Wu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Dongmei Wu has a total of 2 co-authors. Here are the top co-authors by number of shared publications:
- Jie Gao
State Key Laboratory for Fine Exploration and Intelligent Development of Coal Resources, School of Mines, University of Mining and Technology, Xuzhou 221116, China
1 shared publication - Ke Lu
CCTEG Chongqing Research Institute, Chongqing 400037, China
1 shared publication
Latest Publications
- Open Access
Dust Control Technology in Dry Directional Drilling in Soft and Broken Coal Seams
High rate of dust generation and serious dust diffusion in dry directional drilling in soft and broken coal seams (SBCS) have long been critical problems in the mining process. To solve these problems, in this study, a dust hood was designed and applied to realize non-contact dust control in drilling holes. The optimal performance of the dust hood was achieved when different technical parameters, including the gap width between the dust hood and the drill pipe, the air-slot width of the sealing device, the slag discharge pressure, and the air curtain pressure were controlled at 2 mm, 0.2 mm, 0.3 MPa, and 0.5 MPa, respectively. As a result, the dust concentration was reduced from 540 mg/m3 to 15 mg/m3, with dust control efficiency reaching 97.2%. The in situ test results confirmed good dust control effects, as the dust control efficiency reached 98.3% after using the dust hood.
Open AccessDust Control Technology in Dry Directional Drilling in Soft and Broken Coal Seams
High rate of dust generation and serious dust diffusion in dry directional drilling in soft and broken coal seams (SBCS) have long been critical problems in the mining process. To solve these problems, in this study, a dust hood was designed and applied to realize non-contact dust control in drilling holes. The optimal performance of the dust hood was achieved when different technical parameters, including the gap width between the dust hood and the drill pipe, the air-slot width of the sealing device, the slag discharge pressure, and the air curtain pressure were controlled at 2 mm, 0.2 mm, 0.3 MPa, and 0.5 MPa, respectively. As a result, the dust concentration was reduced from 540 mg/m3 to 15 mg/m3, with dust control efficiency reaching 97.2%. The in situ test results confirmed good dust control effects, as the dust control efficiency reached 98.3% after using the dust hood.