Khaled Fahmi Fawy
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Khaled Fahmi Fawy has a total of 25 co-authors. Here are the top co-authors by number of shared publications:
- Ajaz Hussain
Institute of Chemical Sciences, Bahauddin Zakariya University, Multan, Pakistan
4 shared publications - Khurshid Ayub
Department of Chemistry, COMSATS University, Abbottabad Campus, Abbottabad, 22060, Pakistan
4 shared publications - Riaz Hussain
Department of Chemistry, University of Okara, Okara 56300, Pakistan
4 shared publications - Jabir Hussain
Institute of Chemistry, the Islamia University of Bahawalpur, Bahawalpur, Pakistan
3 shared publications - Mohamed Saad Hamdy
Higher Institute of Engineering
3 shared publications - Muhammad Durair Sajjad Haider
School of Molecular Sciences, Arizona State University, Tempe, USA
3 shared publications
Latest Publications
- 4 June 2026
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 58 (8) , 328
Molecular modeling of [15]anen5 based alkaline earthides to explore their electronic and nonlinear optical properties
- 4 June 2026
- Published by Springer Nature in Optical and Quantum Electronics
- Vol. 58 (8) , 328
Molecular modeling of [15]anen5 based alkaline earthides to explore their electronic and nonlinear optical properties
- 22 October 2025
- Published by Springer Nature in Structural Chemistry
- Vol. 37 (3) , 1503-1519
Thermodynamic and Electronic Stability of Alkalides Based on Tetraza-18-Crown-6 Ether Complexes for Enhanced Nonlinear Optical Performance
- 22 October 2025
- Published by Springer Nature in Structural Chemistry
- Vol. 37 (3) , 1503-1519
Thermodynamic and Electronic Stability of Alkalides Based on Tetraza-18-Crown-6 Ether Complexes for Enhanced Nonlinear Optical Performance
- 1 June 2025
- Published by Springer Nature in Structural Chemistry
- Vol. 37 (1) , 209-226
DFT-based evaluation of C3N2 nanosheet as sensor against industrial gaseous effluents: NH3, NCl3, NF3, COCl2, and SOCl2
- 1 June 2025
- Published by Springer Nature in Structural Chemistry
- Vol. 37 (1) , 209-226
DFT-based evaluation of C3N2 nanosheet as sensor against industrial gaseous effluents: NH3, NCl3, NF3, COCl2, and SOCl2
- Open Access
Effect of Different Zeolite Supports on the Catalytic Behavior of Platinum Nanoparticles in Cyclohexene Hydrogenation Reaction
In this study, 1 wt% platinum (Pt) nanoparticles were incorporated into five types of zeolites (HY, Beta, mordenite, ZSM-5, and ferrierite) with an impregnation technique. The synthesis strategy included the use of water as a solvent for the applied Pt source. Moreover, the incorporation process was performed at ambient conditions followed by calcination at 450 °C. The five prepared materials were characterized by different physical and chemical characterization techniques and the obtained results confirmed the formation of Pt nanoparticles with an average size of 5–10 nm. The catalytic performance of the prepared materials was evaluated in the hydrogenation of cyclohexene under a solvent-free system at room temperature. Pt nanoparticles supported on ZSM-5 zeolite exhibited the best catalytic performance. Moreover, the optimization of operational conditions such as temperature, pressure, and catalyst amount was investigated and the obtained results showed the possibility to convert 100% of cyclohexene within 35 min over Pt-ZSM-5. Finally, the reusability of the Pt-ZSM-5 catalyst was investigated in four consecutive runs without treatment and the obtained results showed a negligible activity loss.
Open AccessEffect of Different Zeolite Supports on the Catalytic Behavior of Platinum Nanoparticles in Cyclohexene Hydrogenation Reaction
In this study, 1 wt% platinum (Pt) nanoparticles were incorporated into five types of zeolites (HY, Beta, mordenite, ZSM-5, and ferrierite) with an impregnation technique. The synthesis strategy included the use of water as a solvent for the applied Pt source. Moreover, the incorporation process was performed at ambient conditions followed by calcination at 450 °C. The five prepared materials were characterized by different physical and chemical characterization techniques and the obtained results confirmed the formation of Pt nanoparticles with an average size of 5–10 nm. The catalytic performance of the prepared materials was evaluated in the hydrogenation of cyclohexene under a solvent-free system at room temperature. Pt nanoparticles supported on ZSM-5 zeolite exhibited the best catalytic performance. Moreover, the optimization of operational conditions such as temperature, pressure, and catalyst amount was investigated and the obtained results showed the possibility to convert 100% of cyclohexene within 35 min over Pt-ZSM-5. Finally, the reusability of the Pt-ZSM-5 catalyst was investigated in four consecutive runs without treatment and the obtained results showed a negligible activity loss.
- Open Access
Cytotoxic Potential of Bio-Silica Conjugate with Different Sizes of Silver Nanoparticles for Cancer Cell Death
Well-defined silver nanoparticles were doped into bio-based amorphous silica (Ag-b-SiO2) with different silver contents (from 2 to 20 wt%) by a solvent-free procedure. The four as-synthetized samples were hydrogenated at 300 °C to ensure the formation of zero-valent Ag nanoparticles. The prepared samples were characterized by X-ray powder diffraction (XRD), elemental analysis, N2 sorption measurements, scanning electron microscopy (SEM), X-ray photoelectron spectroscopy (XPS), and high-resolution transmission electron microscopy (HR-TEM). The characterization data confirmed the formation of well-defined zero-valent silver nanoparticles in the range of 3–10 nm in the low-loading samples, while in high-loading samples, bulky particles of silver in the range of 200–500 nm were formed. The in vitro cytotoxic activities of the Ag-b-SiO2 samples were tested against the tumor cell lines of breast (MCF-7), liver (HepG2), and colon (HCT 116) over a concentration range of 0.01 to 1000 g. The prepared samples exhibited a wide range of cytotoxic activities against cancer cells. An inverse relationship was observed between the silver nanoparticles’ size and the cytotoxic activity, while a direct relationship between the silver nanoparticles’ size and the apoptotic cell death was noticed.
Open AccessCytotoxic Potential of Bio-Silica Conjugate with Different Sizes of Silver Nanoparticles for Cancer Cell Death
Well-defined silver nanoparticles were doped into bio-based amorphous silica (Ag-b-SiO2) with different silver contents (from 2 to 20 wt%) by a solvent-free procedure. The four as-synthetized samples were hydrogenated at 300 °C to ensure the formation of zero-valent Ag nanoparticles. The prepared samples were characterized by X-ray powder diffraction (XRD), elemental analysis, N2 sorption measurements, scanning electron microscopy (SEM), X-ray photoelectron spectroscopy (XPS), and high-resolution transmission electron microscopy (HR-TEM). The characterization data confirmed the formation of well-defined zero-valent silver nanoparticles in the range of 3–10 nm in the low-loading samples, while in high-loading samples, bulky particles of silver in the range of 200–500 nm were formed. The in vitro cytotoxic activities of the Ag-b-SiO2 samples were tested against the tumor cell lines of breast (MCF-7), liver (HepG2), and colon (HCT 116) over a concentration range of 0.01 to 1000 g. The prepared samples exhibited a wide range of cytotoxic activities against cancer cells. An inverse relationship was observed between the silver nanoparticles’ size and the cytotoxic activity, while a direct relationship between the silver nanoparticles’ size and the apoptotic cell death was noticed.
- Open Access
Valorization of Rice Husk and Straw Agriculture Wastes of Eastern Saudi Arabia: Production of Bio-Based Silica, Lignocellulose, and Activated Carbon
Bio-based silica, lignocellulose, and activated carbon were simply produced via the recycling of Hassawi rice biomass waste of Al-Ahsa governorate in the eastern Saudi Arabia region using a fast chemical treatment procedure. Rice husk and rice straw wastes were collected, ground, and chemically treated with sodium hydroxide to extract silica/silicate from the dried plant tissues. The liquid extract is then treated with acid solutions in order to precipitate silica/silicate at neutral medium. Lowering the pH of the supernatant to 2 resulted in the precipitation of lignocellulose. Thermal treatment of the biomass residue under N2 gas stream resulted in activated carbon production. Separated products were dried/treated and characterized using several physical examination techniques, such as FT-IR, SEM/EDX, XRD, and Raman spectroscopy in order to study their structure and morphology. Silica and lignocelluloses products were then preliminarily used in the treatment of wastewaters and water-desalination processes.
Open AccessValorization of Rice Husk and Straw Agriculture Wastes of Eastern Saudi Arabia: Production of Bio-Based Silica, Lignocellulose, and Activated Carbon
Bio-based silica, lignocellulose, and activated carbon were simply produced via the recycling of Hassawi rice biomass waste of Al-Ahsa governorate in the eastern Saudi Arabia region using a fast chemical treatment procedure. Rice husk and rice straw wastes were collected, ground, and chemically treated with sodium hydroxide to extract silica/silicate from the dried plant tissues. The liquid extract is then treated with acid solutions in order to precipitate silica/silicate at neutral medium. Lowering the pH of the supernatant to 2 resulted in the precipitation of lignocellulose. Thermal treatment of the biomass residue under N2 gas stream resulted in activated carbon production. Separated products were dried/treated and characterized using several physical examination techniques, such as FT-IR, SEM/EDX, XRD, and Raman spectroscopy in order to study their structure and morphology. Silica and lignocelluloses products were then preliminarily used in the treatment of wastewaters and water-desalination processes.