TYTsuyoshi Yaita

Tsuyoshi Yaita

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Tsuyoshi Yaita has a total of 70 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Synchrotron radiation analysis of microparticles from the Fukushima Daiichi nuclear power station

    by Tohru Kobayashi, Masaaki Kobata, Hajime Tanida, Yoshihiro Okamoto, Shin-Ichi Fujimori, Yukiharu Takeda, Takuya Tsuji, Tatsuo Fukuda, Goro Shibata, Ikuto Kawasaki, et al.

    In March 2011, the Fukushima Daiichi Nuclear Power Station (FDNPS) suffered reactor core overheating and fuel melting following the Great East Japan Earthquake and tsunami, producing complex microparticles from vaporized and rapidly solidified nuclear and structural materials. The chemical states and local structures of key elements in these particles, particularly uranium and plutonium, remain poorly constrained. Here, we present the synchrotron-based micro-focused X-ray absorption fine structure (XAFS) and X-ray diffraction (XRD) study of microparticles recovered from inside Unit 2 of FDNPS. The particles contain uranium, zirconium, and trace plutonium uniformly incorporated into chemically homogeneous oxide matrices. Two types were identified: uranium-rich particles with cubic UO2 and mixed U-Zr oxides with tetragonal ZrO2, the latter persisting at room temperature, indicating rapid cooling from a high-temperature metastable phase above 1650 °C. Both uranium and plutonium are mainly in the +4 state, with localized valence increases in zirconium-rich regions, suggesting redox-driven charge compensation during crystallization. These results provide direct evidence of melt evolution, actinide mixing, and oxidation-state preservation during severe reactor accidents, informing models of core degradation and strategies for safe decommissioning at FDNPS.


  • Open Access

    Desorption of cesium from Fukushima soils using a mechanochemical method

    by Yui Kaneta, Tohru Kobayashi, Takuya Tsuji, Mitsunori Honda, Keiichi Yokoyama, Yuzo Mampuku, Tsuyoshi Yaita

    The Fukushima Daiichi Nuclear Power Plant accident caused severe soil contamination by radioactive cesium (Cs). The large volume of removed soil from decontamination must be disposed of by 2045, requiring volume reduction. However, Cs is strongly adsorbed onto clay minerals in the soil, making removal difficult. Thus, the desorption behavior of stable Cs adsorbed onto weathered biotite (WB), a clay mineral abundant in Fukushima soils, was investigated using a mechanochemical (MC) method that combines physical grinding by ball impact and friction with a wet process promoting chemical reactions. The effectiveness of this method for desorbing radioactive Cs from Fukushima soil was also evaluated. The results are based on the scanning electron microscopy analysis and the results of the desorption experiment; oxalic acid desorbed Cs to some extent without affecting the layered structure of the clay minerals significantly, and ammonium chloride showed an exfoliation of the layer structure, resulting in a stable desorption of Cs independent of samples. Regarding the real soil samples collected in Fukushima, the MC method using ammonium chloride solution desorbed 80% of 137Cs, and the desorption behavior was reproduced reliably in actual soil samples. In contrast, oxalic acid did not always result in radioactive Cs made sufficiently desorbed for all the samples. Based on these findings, the MC method with ammonium chloride promotes radioactive Cs desorption effectively from interlayers due to synergistic effects from the layered structure’s exfoliation and chemical interaction. The MC method with ammonium chloride should reduce the volume of removed soil requiring final disposal, thereby reducing associated management costs.


  • Open Access

    A concise synthesis of multiply fused phenanthroline diamide (fused-PTDA) by palladium-catalyzed intramolecular C–H arylation. Highly efficient and selective extraction performance of fused-PTDA toward early lanthanides

    by Towa Asano, Yuki Nakanishi, Shoichi Sugita, Kentaro Okano, Hirokazu Narita, Tohru Kobayashi, Tsuyoshi Yaita, Atsunori Mori

    The reaction of phenanthroline diamide bearing a bromoaryl moiety on the amide substituent in the presence of palladium catalyst proceeded efficiently to afford multiply-fused phenanthroline derivatives through intramolecular C–H arylation. The obtained diamide derivatives was found to extract lanthanide remarkably highly efficiently with distribution ratio (D: up to ca. 500) and it was also found show the metal-selective extraction (separation factor SF = up to 4.4).


  • Open Access

    In situ XAFS–XRD study of the Zr–Y2O3 interaction at extra-high temperatures

    by Ayumi Itoh, Satoru Matsuo, Kenta Yoshida, Kenji Konashi, Rikuto Ikuta, Keisuke Niino, Yuji Arita, Masaaki Kobata, Tatsuo Fukuda, Tohru Kobayashi, et al.

    The in situ measurement technique for a metal/metal-oxide mixture at extra-high temperature above 2000 K has been desired in the field of nuclear safety engineering. In the present study, we succeeded in simultaneous XAFS–XRD measurements of the Zr oxidation [Zr + O → Zr(O) + ZrO2] up to 1952 K and ZrO2–Y2O3 reaction from 1952 to 2519 K. The chemical shift during Zr oxidation was observed in the absorption spectra around the Zr K-edge, and the interatomic cation–cation and cation–oxygen distances obtained by the fitting analysis of EXAFS during the Y2O3–ZrO2 reaction are explained. Also, the temperature dependency of the anharmonic effect was investigated by comparing the fitted second- and third-order cumulants with the theoretical ones in which the Morse potential was applied as an interatomic potential, giving a good explanation about the local structure dynamics. Finally, the applicability of the developed system to investigation of nuclear fuel materials, such as UO2–Zr, is discussed.


  • Open Access

    EXAFS investigation of strontium adsorption onto weathered biotite

    by Mitsunori Honda, Yui Kaneta, Tsuyoshi Yaita

    The efficiency of the sorption of Sr2+ on weathered biotite (WB), a type of clay mineral, was investigated. Removal of Sr2+ and Cs+ is important in the treatment of contaminated water from the 1F accident, which is one of the radionuclide waste treatment problems. We focused on developing an adsorption method for Sr ions using WB, which is abundant in Fukushima. Applying a molten salt treatment, the amount of sorbed Sr2+ simply increased as the added mass ratio of strontium chloride (SrCl2) increased from 1:1, 1:5, and 1:10 for the onefold, fivefold, and tenfold additions of SrCl2, respectively. Then, the crystal structure of WB as an adsorbent was evaluated by x-ray diffraction (XRD) analysis. Thus, it was observed that the WB retained its original crystal structure even after the sorption of Sr2+. Extended x-ray absorption fine structure (EXAFS) analysis was performed to investigate the local sorption structure of Sr2+ in the WB. The results revealed that Sr2+ was preferentially sorbed into the SiO4 and Al2O3 layers when Sr2+ was in the low mass ratio, whereas it was mainly sorbed into the SiO4 layer when the ratio was high.


  • Direct energy conversion using Ni/SiC Schottky junction in 237Np and 241Am gamma ray regions

    by Tatsuo Fukuda, Masaaki Kobata, Takahisa Shobu, Kenji Yoshii, Junichiro Kamiya, Yosuke Iwamoto, Takahiro Makino, Yuichi Yamazaki, Takeshi Ohshima, Yasuhiro Shirai, et al.

    Direct energy conversion has been investigated using Ni/SiC Schottky junctions with the irradiation of monochromatized synchrotron x rays mimicking the gamma rays of 237Np (30 keV) and 241Am (60 keV). Through current–voltage measurements, electrical energies were obtained for both types of gamma rays. The energy conversion efficiencies based on absorbed energy were found to be ∼1.6%, which is comparable to other previously described semiconducting systems. This result raises the prospect of energy recovery from nuclear wastes utilizing the present system, judging from the radiation tolerant nature of SiC. Additionally, we found different conversion efficiencies between the two samples during the same process. This could be explained using hard x-ray photoelectron spectroscopy and secondary ion mass spectroscopy measurements, suggesting the creation of Ni–Si compounds at the interface in the sample with poor performance. Hence, such combined measurements are useful to provide data that electrical measurements cannot provide us.

  • Open Access

    Marking actinides for separation: Resonance-enhanced multiphoton charge transfer in actinide complexes

    by Shohei Matsuda, Keiichi Yokoyama, Tsuyoshi Yaita, Tohru Kobayashi, Yui Kaneta, Marie Simonnet, Tetsuhiro Sekiguchi, Mitsunori Honda, Kojiro Shimojo, Reisuke Doi, et al.

    Precise separation and purification of f-block elements are important and challenging especially for the reduction of nuclear waste and the recycling of rare metals but are practically difficult mainly because of their chemical similarity. A promising way to overcome this difficulty is controlling their oxidation state by nonchemical processes. Here, we show resonance-enhanced multiphoton charge transfer in actinide complexes, which leads to element-specific control of their oxidation states owing to the distinct electronic spectra arising from resonant transitions between f orbitals. We observed oxidation of trivalent americium in nitric acid. In addition, we found that the coordination of nitrates is essential for promoting the oxidation reaction, which is the first finding ever relevant to the primary process of photoexcitation via resonant transitions of f-block elements. The resonance-enhanced photochemical process could be used in the nuclear waste management, as it would facilitate the mutual separation of actinides, such as americium and curium.


  • Open Access

    Extended X-ray absorption fine structure study on gel/liquid extraction of f-block elements

    by Masahiko Nakase, Toru Kobayashi, Hideaki Shiwaku, Takuya Kawamura, Kenji Takeshita, Tomoo Yamamura, Tsuyoshi Yaita


  • Open Access

    Speciation of Ruthenium(III) Chloro Complexes in Hydrochloric Acid Solutions and Their Extraction Characteristics with an Amide-Containing Amine Compound

    by Tomoya Suzuki, Takeshi Ogata, Mikiya Tanaka, Tohru Kobayashi, Hideaki Shiwaku, Tsuyoshi Yaita, Hirokazu Narita

    The refining of platinum group metals is based mainly on solvent extraction methods, whereas Ru is selectively recovered by distillation as RuO4. Replacement of distillation by extraction is expected to simplify the purification process. To develop an effective extraction system for Ru, we analyzed the Ru species in HCl with ultraviolet-visible (UV-Vis) and Ru K-edge extended X-ray absorption fine structure (EXAFS) spectroscopies, and we examined the properties of Ru extracted with N-2-ethylhexyl-bis(N-di-2-ethylhexyl-ethylamide) amine (EHBAA) and trioctylamine (TOA). EXAFS and UV-Vis spectra of Ru in HCl solutions revealed that the predominant Ru species in 0.5–10 M HCl solutions changed from [RuCl4(H2O)2]− to [RuCl6]3− with the HCl concentration. The extraction percentages (E%) of Ru in the EHBAA system increased with increasing HCl concentration, reached 80% at [HCl] = 5 M, and decreased at higher HCl concentrations; the corresponding E% for TOA were low. EXAFS analysis of the extracted complex indicated that the Ru3+ had 5 Cl− and 1 H2O in its inner coordination sphere. The similarity of the dependence on HCl concentrations of the E% in the EHBAA system and the distribution profile of [RuCl5(H2O)]2− on [RuCln(H2O)6−n]3−n suggested that the EHBAA extracted the pentachlorido species.


  • Open Access

    Comparison of the Extractabilities of Tetrachloro- and Tetrabromopalladate(II) Ions with a Thiodiglycolamide Compound

    by Hirokazu Narita, Motoki Maeda, Chiharu Tokoro, Tomoya Suzuki, Mikiya Tanaka, Ryuhei Motokawa, Hideaki Shiwaku, Tsuyoshi Yaita

    Using N,N,N',N'-tetra-2-ethylhexyl-thiodiglycolamide (TEHTDGA) in n-dodecane as the extractant, we compared the percentages of Pd(II) extracted from HCl and HBr solutions, and analyzed the structures of the Pd(II)-extractant complexes. For comparison, similar experiments were performed with di-n-hexyl sulfide (DHS), a well-known sulfide-type extractant. TEHTDGA extracted Pd(II) from both HCl and HBr solutions much faster than DHS. The Pd(II)/(TEHTDGA or DHS) stoichiometry in the organic phase was 1:2. For TEHTDGA, the extractability of Pd(II) from HBr solution was inferior to that from HCl solution, whereas the opposite was true for DHS. However, FT-IR spectroscopy and EXAFS measurements indicated that the inner-sphere structure of Pd(II) in the TEHTDGA complex was almost the same as that in the DHS system: in both cases, two of the halide ions in the tetrachloro- or tetrabromopalladate(II) ion were replaced by the sulfur atoms of two extractant molecules.