Petra Manshanden
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Petra Manshanden has a total of 33 co-authors. Here are the top co-authors by number of shared publications:
Gianluca Coletti
2 shared publicationsHenri Fledderus
TNO Energy Transition, High Tech Campus 21, 5656 AE Eindhoven, The Netherlands
2 shared publicationsLukas Simurka
TNO Energy Transition, High Tech Campus 21, 5656 AE Eindhoven, The Netherlands
2 shared publicationsAlexandra Schmid
Solar Energy Systems Fraunhofer Institute for Solar Energy Systems Freiburg Germany
1 shared publication- Alison Ciesla
UNSW Sydney
1 shared publication - Andrea E. A. Bracesco
Plasma & Materials Processing, Department of Applied Physics and Science Education
1 shared publication
Latest Publications
- Open Access
One Year of Outdoor Performance of Perovskite/Perovskite/Silicon Triple‐Junction Solar Cell
Outdoor performance indicates the end use performance of solar modules and is therefore essential to monitor for emerging technologies, preferably at an early stage to elucidate optimal improvement paths. We study the performance of triple‐junction perovskite–perovskite–silicon sample during 1 year outdoor by monitoring the performance in situ by performing I – V curves. It is shown that the temperature step necessary for encapsulation degraded the performance significantly; however, this power loss could be reclaimed after a few weeks outdoors. The degradation to a performance of 80% of original takes 4 months. Further degradation until 50% of original performance was reached after 6 months. This degradation is for a significant part due to degradation of the top and middle perovskite and transport layers. Although the voltage, current, and resistances degraded significantly, all three subcells remained operational until the end of the measurement period after a full year, although the sample changed from middle cell limited to top cell limited. During that year, the energy yield was 0.75 kWh/Wp, or 10% of available solar energy, which was caused by degradation of the perovskite and transport layers, decrease of shunt resistance and the suboptimal low‐light performance during the entire runtime.
Open AccessOne Year of Outdoor Performance of Perovskite/Perovskite/Silicon Triple‐Junction Solar Cell
Outdoor performance indicates the end use performance of solar modules and is therefore essential to monitor for emerging technologies, preferably at an early stage to elucidate optimal improvement paths. We study the performance of triple‐junction perovskite–perovskite–silicon sample during 1 year outdoor by monitoring the performance in situ by performing I – V curves. It is shown that the temperature step necessary for encapsulation degraded the performance significantly; however, this power loss could be reclaimed after a few weeks outdoors. The degradation to a performance of 80% of original takes 4 months. Further degradation until 50% of original performance was reached after 6 months. This degradation is for a significant part due to degradation of the top and middle perovskite and transport layers. Although the voltage, current, and resistances degraded significantly, all three subcells remained operational until the end of the measurement period after a full year, although the sample changed from middle cell limited to top cell limited. During that year, the energy yield was 0.75 kWh/Wp, or 10% of available solar energy, which was caused by degradation of the perovskite and transport layers, decrease of shunt resistance and the suboptimal low‐light performance during the entire runtime.
- 16 February 2026
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 300
Variability of LID regeneration at lower temperatures: case maritime climate
- 16 February 2026
- Published by Elsevier in Solar Energy Materials and Solar Cells
- Vol. 300
Variability of LID regeneration at lower temperatures: case maritime climate
- Open Access
- 25 May 2022
- Published by EDP Sciences in EPJ Photovoltaics
- Vol. 13, 11
Quantifying the performance gain of 100 cm2 bifacial four terminal perovskite-Si tandem modules
Improving the performance of solar modules requires the implementation of both spectral and directional irradiance optimization. The performance of bifacial four-terminal tandem minimodules with a 100 cm2 area is reported, both indoor and outdoor measurements. We demonstrate a 24.5 mW/cm2 (bifacial irradiance 200 W/m2) bifacial tandem power density, measured according to a tandem adapted IEC60904-1-2 protocol, which constitutes a 3 mW/cm2 gain with respect to monofacial use. In addition, we show that in outdoor measurements bifacial four terminal tandems outperform identical monofacial four terminal tandems by 26% on average, depending on incident angle, injection level and temperature, in a 10% albedo environment. The average gain is higher for outdoor performance than for indoor performance, due to variations in relative rear irradiance.
- 25 May 2022
- Published by EDP Sciences in EPJ Photovoltaics
- Vol. 13, 11
Open AccessQuantifying the performance gain of 100 cm2 bifacial four terminal perovskite-Si tandem modules
Improving the performance of solar modules requires the implementation of both spectral and directional irradiance optimization. The performance of bifacial four-terminal tandem minimodules with a 100 cm2 area is reported, both indoor and outdoor measurements. We demonstrate a 24.5 mW/cm2 (bifacial irradiance 200 W/m2) bifacial tandem power density, measured according to a tandem adapted IEC60904-1-2 protocol, which constitutes a 3 mW/cm2 gain with respect to monofacial use. In addition, we show that in outdoor measurements bifacial four terminal tandems outperform identical monofacial four terminal tandems by 26% on average, depending on incident angle, injection level and temperature, in a 10% albedo environment. The average gain is higher for outdoor performance than for indoor performance, due to variations in relative rear irradiance.