Ofasa Abunomah
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Ofasa Abunomah has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Evans Ogoun
Robert Gordon University
3 shared publications - Priscilla Ogunlude
Robert Gordon University
3 shared publications - Edward Gobina
Robert Gordon University
2 shared publications - Florence Aisueni
Robert Gordon University
2 shared publications - Idris Hashim
Robert Gordon University
2 shared publications Muktar Ramalan
Robert Gordon University
2 shared publications
Latest Publications
- Open Access
- 17 January 2022
- Published by ISTES Organization in International Journal on Engineering, Science and Technology
- Vol. 4 (1) , 41-53
Effect of Reservoir Structural Rhythm on Carbon Capture and Sequestration (CCS) Performance
In addition to the evolution of green and nano energy, sequestration of CO2 is also an evolving method to control the global CO2 footprint and greenhouse effect. Carbon Capture and Sequestration (CCS) is an established technique to capture carbon from anthropogenic sources, such as power and chemical plants, and then inject the same in subsurface rock micropores, to permanently store the CO2. Besides its environmental credentials, CCS also offers economic opportunities in Gas Enhanced Oil Recovery and Methane displacement in coalbed reservoirs. CCS process incorporates various geological, geometrical and engineering understandings of porous media and fluid dynamics. Previous investigators have identified low permeability rock as a better site for CCS. However, little is known of the propagation and effectiveness of CCS in reservoirs that have multiple layers of sedimentation, vis-à-vis well topology and density, flow direction, storage site, and power optimisation. In reality, these layers altogether form a structural rhythm and gradient. In this study, we investigated the structural rhythms and gradients that optimise CCS by using two objective functions (Darcy and interstitial flowrates) and 15 structural criteria (such as pore size, porosity, tortuosity, and aspect ratio). An experimental method has been applied. Five analogous reservoir porous core samples with varying structural parameters have been tested. The results indicate that CCS optimisation is responsive to structural parameters. The rhythm analysis from this study suggests that the CCS gas flow requires a compound rhythm that has a positive porosity and negative pore gradients. That is, the CCS injection wells should be placed in the reservoir area with relatively low porosity (3%) and large pore size (6000nm), while the storage site should be at a relatively high porosity (20%) and smaller pore size (200nm). This study can be directly applied to CCS practice, such that, given a layered reservoir, engineers can predict the well placement or topology that would optimize some of the essential performance objectives of CCS.
- 17 January 2022
- Published by ISTES Organization in International Journal on Engineering, Science and Technology
- Vol. 4 (1) , 41-53
Open AccessEffect of Reservoir Structural Rhythm on Carbon Capture and Sequestration (CCS) Performance
In addition to the evolution of green and nano energy, sequestration of CO2 is also an evolving method to control the global CO2 footprint and greenhouse effect. Carbon Capture and Sequestration (CCS) is an established technique to capture carbon from anthropogenic sources, such as power and chemical plants, and then inject the same in subsurface rock micropores, to permanently store the CO2. Besides its environmental credentials, CCS also offers economic opportunities in Gas Enhanced Oil Recovery and Methane displacement in coalbed reservoirs. CCS process incorporates various geological, geometrical and engineering understandings of porous media and fluid dynamics. Previous investigators have identified low permeability rock as a better site for CCS. However, little is known of the propagation and effectiveness of CCS in reservoirs that have multiple layers of sedimentation, vis-à-vis well topology and density, flow direction, storage site, and power optimisation. In reality, these layers altogether form a structural rhythm and gradient. In this study, we investigated the structural rhythms and gradients that optimise CCS by using two objective functions (Darcy and interstitial flowrates) and 15 structural criteria (such as pore size, porosity, tortuosity, and aspect ratio). An experimental method has been applied. Five analogous reservoir porous core samples with varying structural parameters have been tested. The results indicate that CCS optimisation is responsive to structural parameters. The rhythm analysis from this study suggests that the CCS gas flow requires a compound rhythm that has a positive porosity and negative pore gradients. That is, the CCS injection wells should be placed in the reservoir area with relatively low porosity (3%) and large pore size (6000nm), while the storage site should be at a relatively high porosity (20%) and smaller pore size (200nm). This study can be directly applied to CCS practice, such that, given a layered reservoir, engineers can predict the well placement or topology that would optimize some of the essential performance objectives of CCS.
- Open Access
- 17 January 2022
- Published by ISTES Organization in International Journal on Engineering, Science and Technology
- Vol. 4 (1) , 99-123
Mass Transfer Characteristics through Alumina Membranes with Different Pores Sizes and Porosity
Different membranes covering the macroporous to nano-pororous range and having different porosities have been used to study the mass transfer of methane and carbon dioxide single gases. The effect of flow parameters on the transport mechanisms through porous membranes were reviewed in detail. The characteristics of gas transport through the macroporous, microporous, and nano-porous membranes were investigated with several gas diffusion models in the range of 20–100 ◦C and at pressure differences ranging from 0.2 to 3 bar. The experimental gas permeation data of the membranes were analyzed using the Darcy flow model. The results clearly showed good agreement between the model analysis and the experimental data. The experimental data showed that the permeation followed a parallel flow model in which the behavior of gases was governed by viscous and Knudsen diffusion, although to varied degrees. Permeation of the gases through each membrane varies considering the viscosity of the gases at the same temperature. Furthermore, the membranes followed the configurational diffusion model in which the permeance increased with increasing pressure and decreasing temperature. For the gas flow measurements through macroporous and nano-porous membranes with diameters ranging from 6000nm to 15nm, the results indicate that the experimental flux agrees well with the calculated (model) flux through which gas flows from the bulk stream in the shell side to the membrane outer surface where viscous flow and Knudsen diffusion coexist. The study shows that experimental flux is larger than Knudsen diffusion, and the contribution of Knudsen diffusion to the experimental flux increases with the decrease in the diameter. On the other hand, the effects of gas slippage are considerable as gas velocity near the wall is higher than zero. The slip length effects are inversely proportional to pore size and with driving pressure.
- 17 January 2022
- Published by ISTES Organization in International Journal on Engineering, Science and Technology
- Vol. 4 (1) , 99-123
Open AccessMass Transfer Characteristics through Alumina Membranes with Different Pores Sizes and Porosity
Different membranes covering the macroporous to nano-pororous range and having different porosities have been used to study the mass transfer of methane and carbon dioxide single gases. The effect of flow parameters on the transport mechanisms through porous membranes were reviewed in detail. The characteristics of gas transport through the macroporous, microporous, and nano-porous membranes were investigated with several gas diffusion models in the range of 20–100 ◦C and at pressure differences ranging from 0.2 to 3 bar. The experimental gas permeation data of the membranes were analyzed using the Darcy flow model. The results clearly showed good agreement between the model analysis and the experimental data. The experimental data showed that the permeation followed a parallel flow model in which the behavior of gases was governed by viscous and Knudsen diffusion, although to varied degrees. Permeation of the gases through each membrane varies considering the viscosity of the gases at the same temperature. Furthermore, the membranes followed the configurational diffusion model in which the permeance increased with increasing pressure and decreasing temperature. For the gas flow measurements through macroporous and nano-porous membranes with diameters ranging from 6000nm to 15nm, the results indicate that the experimental flux agrees well with the calculated (model) flux through which gas flows from the bulk stream in the shell side to the membrane outer surface where viscous flow and Knudsen diffusion coexist. The study shows that experimental flux is larger than Knudsen diffusion, and the contribution of Knudsen diffusion to the experimental flux increases with the decrease in the diameter. On the other hand, the effects of gas slippage are considerable as gas velocity near the wall is higher than zero. The slip length effects are inversely proportional to pore size and with driving pressure.
- Open Access
- 17 January 2022
- Published by ISTES Organization in International Journal on Engineering, Science and Technology
- Vol. 4 (1) , 73-84
Nanoporous Gas Transport in Shale Gas Reservoirs
In more conventional gas reservoirs, gas flow is simple, uncomplicated, and described by simple flux pressure drop expressions. In shale reservoirs however, this relationship takes the form of a more complex and multiscale flow process involving special flow mechanisms. Shale gas reservoirs often contain a significant number of nanopores leading to an apparent permeability that depends on pore fluid type, pore structure and pressure differentials. The complex geometry of shale reservoirs has drastically stimulated basic research on the transport mechanisms involved in the extraction of gas from shale formations. This study is aimed at studying the gas flow in nano pores. In this paper, permeation experiments for methane flow through nanoporous membranes were conducted and the effect of the pore size and pressure on the behaviour of the gas was analysed. The results obeyed the criteria to divide the flow stage into Darcy and Non-Darcy flow. As the pressure increases, the reservoir permeability also increases, and the gas tends to move faster thereby increasing the rate at which it flows per unit area in the system regardless of the temperature difference which means pressure gradient establishes the direction and rate of flow of gas in a reservoir.
- 17 January 2022
- Published by ISTES Organization in International Journal on Engineering, Science and Technology
- Vol. 4 (1) , 73-84
Open AccessNanoporous Gas Transport in Shale Gas Reservoirs
In more conventional gas reservoirs, gas flow is simple, uncomplicated, and described by simple flux pressure drop expressions. In shale reservoirs however, this relationship takes the form of a more complex and multiscale flow process involving special flow mechanisms. Shale gas reservoirs often contain a significant number of nanopores leading to an apparent permeability that depends on pore fluid type, pore structure and pressure differentials. The complex geometry of shale reservoirs has drastically stimulated basic research on the transport mechanisms involved in the extraction of gas from shale formations. This study is aimed at studying the gas flow in nano pores. In this paper, permeation experiments for methane flow through nanoporous membranes were conducted and the effect of the pore size and pressure on the behaviour of the gas was analysed. The results obeyed the criteria to divide the flow stage into Darcy and Non-Darcy flow. As the pressure increases, the reservoir permeability also increases, and the gas tends to move faster thereby increasing the rate at which it flows per unit area in the system regardless of the temperature difference which means pressure gradient establishes the direction and rate of flow of gas in a reservoir.