Pablo Gilberto Toledo Guizar
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Pablo Gilberto Toledo Guizar has a total of 9 co-authors. Here are the top co-authors by number of shared publications:
- Norberto Hernández Como
Instituto Politécnico Nacional
2 shared publications Arturo Torres Sánchez
Centro de Nanociencias y Micro y Nanotecnologas, Instituto Politcnico Nacional, Mexico City, Mexico
1 shared publicationFrancisco Hernandez-Cuevas
Centro de Nanociencias y Micro y Nanotecnologías, Instituto Politécnico Nacional, CDMX, Mexico
1 shared publication- Isai Salvador Hernandez Luna
Centro de Nanociencias y Micro y Nanotecnologías, Instituto Politécnico Nacional, Mexico City 07700, Mexico
1 shared publication - José Luis Hernández-López
Centro de Nanociencias y Micro y Nanotecnologías, Instituto Politécnico Nacional, CDMX, Mexico
1 shared publication Martha Leticia Hernandez-Pichardo
Escuela Superior de Ingeniería Química e Industrias Extractivas, Instituto Politécnico Nacional, CDMX, Mexico
1 shared publication
Latest Publications
- 31 May 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal on Flexible Electronics
- Vol. 3 (11) , 466-471
Basic Logic Gates and Digital Circuits Based on Flexible IGZO Enhancement-Mode nMOS TFTs
An increasing number of new applications beyond displays has been reported for the amorphous oxide semiconductors, especially Indium–gallium–zinc–oxide (IGZO), based flexible thin-film transistors (TFTs). The atomic composition of the IGZO target was In:Ga:Zn= 2:2:2. From sensors to microprocessors, the flexible IGZO TFTs aim to diversify the functionality of silicon legacy nodes. In this work, IGZO enhancement-mode NMOS TFTs, with a minimum channel length of 5 μm, were fabricated on flexible polyimide substrates at temperatures below 150 °C. We observed a small dependency of threshold voltage (2.23±0.06 V) and saturation mobility (3.74±0.57 cm 2 /V-s) with the channel width to length ratio. The IGZO TFTs were interconnected in the saturation load configuration for the successful demonstration of basic logic gates (inverter, NAND and NOR gates), a seven-stage ring oscillator, an XOR gate, and a half-adder. Due to this configuration, their output voltage was limited to V DD -V TH . Their electrical response was evaluated with direct and alternating voltages at a maximum input frequency of 500 Hz and a power supply of 5 V. Under ac analysis their fall/rise time were in the 3-43/148-212 μs range. The inverter, as the fundamental building block for digital circuits, was also tested at different bending radius from 10 to 2.5 mm. Our results are oriented to a better understanding of the flexible IGZO TFT technology to reach reliable integrated circuits.
- 31 May 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Journal on Flexible Electronics
- Vol. 3 (11) , 466-471
Basic Logic Gates and Digital Circuits Based on Flexible IGZO Enhancement-Mode nMOS TFTs
An increasing number of new applications beyond displays has been reported for the amorphous oxide semiconductors, especially Indium–gallium–zinc–oxide (IGZO), based flexible thin-film transistors (TFTs). The atomic composition of the IGZO target was In:Ga:Zn= 2:2:2. From sensors to microprocessors, the flexible IGZO TFTs aim to diversify the functionality of silicon legacy nodes. In this work, IGZO enhancement-mode NMOS TFTs, with a minimum channel length of 5 μm, were fabricated on flexible polyimide substrates at temperatures below 150 °C. We observed a small dependency of threshold voltage (2.23±0.06 V) and saturation mobility (3.74±0.57 cm 2 /V-s) with the channel width to length ratio. The IGZO TFTs were interconnected in the saturation load configuration for the successful demonstration of basic logic gates (inverter, NAND and NOR gates), a seven-stage ring oscillator, an XOR gate, and a half-adder. Due to this configuration, their output voltage was limited to V DD -V TH . Their electrical response was evaluated with direct and alternating voltages at a maximum input frequency of 500 Hz and a power supply of 5 V. Under ac analysis their fall/rise time were in the 3-43/148-212 μs range. The inverter, as the fundamental building block for digital circuits, was also tested at different bending radius from 10 to 2.5 mm. Our results are oriented to a better understanding of the flexible IGZO TFT technology to reach reliable integrated circuits.
- 1 June 2022
- Published by IOP Publishing in Flexible and Printed Electronics
- Vol. 7 (2) , 025015
Threshold voltage reliability in flexible amorphous In–Ga–ZnO TFTs under simultaneous electrical and mechanical stress
Flexible amorphous In–Ga–ZnO (a-IGZO) thin film transistors (TFTs) have been successfully demonstrated on 50 µ m thick freestanding polyimide (PI) with µ sat around 10 cm 2 V −1 s −1 . In the literature, common characterization of flexible TFTs consist of measuring their electrical response at different bending radius or under positive and negative gate bias stress (PBS and NBS). However, there are few studies where the flexible TFTs have been measured with a simultaneous mechanical and electrical stress. In this work, simultaneous testing under electrical and mechanical stress were carried out with a gate bias stress voltage of ±6 V during 3600 s, and with a tensile bending radius of 1, 2 and 4 mm. a-IGZO TFTs bottom gate-top contacts were fabricated on commercial Kapton HN PI by a complete photolithography process. All the PBS and NBS characteristics presented an abnormal threshold voltage left shift which was mainly explained by the adsorption/desorption of water molecules at the back channel. This V th shift was modeled with the stretched exponential equation. Analyzed TFTs were stable under simultaneous stress until a 4 mm bending radius with electrical parameters V th , subthreshold slope, µ sat and I on / I off in the order of 0.7 V, 340 mV dec −1 , 6 cm 2 V −1 s −1 and 5 × 10 8 , respectively.
- 1 June 2022
- Published by IOP Publishing in Flexible and Printed Electronics
- Vol. 7 (2) , 025015
Threshold voltage reliability in flexible amorphous In–Ga–ZnO TFTs under simultaneous electrical and mechanical stress
Flexible amorphous In–Ga–ZnO (a-IGZO) thin film transistors (TFTs) have been successfully demonstrated on 50 µ m thick freestanding polyimide (PI) with µ sat around 10 cm 2 V −1 s −1 . In the literature, common characterization of flexible TFTs consist of measuring their electrical response at different bending radius or under positive and negative gate bias stress (PBS and NBS). However, there are few studies where the flexible TFTs have been measured with a simultaneous mechanical and electrical stress. In this work, simultaneous testing under electrical and mechanical stress were carried out with a gate bias stress voltage of ±6 V during 3600 s, and with a tensile bending radius of 1, 2 and 4 mm. a-IGZO TFTs bottom gate-top contacts were fabricated on commercial Kapton HN PI by a complete photolithography process. All the PBS and NBS characteristics presented an abnormal threshold voltage left shift which was mainly explained by the adsorption/desorption of water molecules at the back channel. This V th shift was modeled with the stretched exponential equation. Analyzed TFTs were stable under simultaneous stress until a 4 mm bending radius with electrical parameters V th , subthreshold slope, µ sat and I on / I off in the order of 0.7 V, 340 mV dec −1 , 6 cm 2 V −1 s −1 and 5 × 10 8 , respectively.