Julian Bohler
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Julian Bohler has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
- Johann Walter Kolar
Swiss Federal Institute of Technology (ETH) Zurich
1 shared publication Johann Wurz
EGSTON Power Electronics GmbH, Klosterneuburg, Austria
1 shared publication- Jonas Huber
Power Electronic Systems Laboratory (PES), ETH Zrich, Zrich, Switzerland
1 shared publication Martin Stransky
EGSTON Power Electronics GmbH, Klosterneuburg, Austria
1 shared publicationNissim Uvaidov
EGSTON Power Electronics GmbH, Klosterneuburg, Austria
1 shared publication- Srdjan Srdic
Department of Electrical and Computer Engineering, North Carolina State University, Raleigh, NC, USA
1 shared publication
Latest Publications
- Open Access
- 3 May 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 10, 54613-54633
Ultra-High-Bandwidth Power Amplifiers: A Technology Overview and Future Prospects
Testing of power electronic converters can advantageously be carried out in power-hardware-in-the-loop (P-HIL) environments that emulate the behavior of power grids, electric motors, etc. The interface between the model and the device under test requires a power amplifier whose bandwidth ultimately limits the accuracy of the emulation. Hence, there is a need for general-purpose AC power amplifiers with ultra-high power bandwidth. This paper first provides a comprehensive review of amplifier concepts proposed over the past decades, i.e., linear power amplifiers, switch-mode amplifiers, including advanced variants such as multilevel (parallel-interleaving) and multicell (series-interleaving) topologies, as well as hybrid approaches that, e.g., combine analog and switch-mode stages. Based on this review, the two key concepts (parallel-interleaving of bridge-legs and cascading of converter cells) that facilitate high efficiency and ultra-high power bandwidth are identified and discussed, covering also suitable isolated mains interfaces and control considerations. Finally, we present a three-phase amplifier system that uses six cascaded converter cells per phase to realize an effective switching frequency of 3.6 MHz. The prototype thus achieves a measured power bandwidth of 100 kHz at the nominal phase output voltage of 230Vrms, and an output power of up to 10 kW per phase.
- 3 May 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 10, 54613-54633
Open AccessUltra-High-Bandwidth Power Amplifiers: A Technology Overview and Future Prospects
Testing of power electronic converters can advantageously be carried out in power-hardware-in-the-loop (P-HIL) environments that emulate the behavior of power grids, electric motors, etc. The interface between the model and the device under test requires a power amplifier whose bandwidth ultimately limits the accuracy of the emulation. Hence, there is a need for general-purpose AC power amplifiers with ultra-high power bandwidth. This paper first provides a comprehensive review of amplifier concepts proposed over the past decades, i.e., linear power amplifiers, switch-mode amplifiers, including advanced variants such as multilevel (parallel-interleaving) and multicell (series-interleaving) topologies, as well as hybrid approaches that, e.g., combine analog and switch-mode stages. Based on this review, the two key concepts (parallel-interleaving of bridge-legs and cascading of converter cells) that facilitate high efficiency and ultra-high power bandwidth are identified and discussed, covering also suitable isolated mains interfaces and control considerations. Finally, we present a three-phase amplifier system that uses six cascaded converter cells per phase to realize an effective switching frequency of 3.6 MHz. The prototype thus achieves a measured power bandwidth of 100 kHz at the nominal phase output voltage of 230Vrms, and an output power of up to 10 kW per phase.