VMVitaly Mikhailov

Vitaly Mikhailov

*This is an algorithmically generated author record based on publicly available information.

Vitaly Mikhailov has a total of 78 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Continuous 16.4-THz Bandwidth Coherent DWDM Transmission in O-Band Using a Single Fibre Amplifier System

    by Daniel J. Elson, Mindaugas Jarmolovičius, Vitaly Mikhailov, Jiawei Luo, Daryl Inniss, Shohei Beppu, Glenn Baxter, Ralf Stolte, Luke Stewart, Shigehiro Takasaka, et al.

    A record continuous transmission bandwidth of 16.4 THz is demonstrated in O-band fibre transmission over an 80-km single-mode ultra low-loss fibre span. Bismuth-doped fibre amplifiers with an output power of 25 dBm and a low noise figure of 3.6 dB compensate a loss of 80-km fibre span. An O-band wavelength selective switch with a 16.4 THz bandwidth maximises the transmission capability and enabled optimisation of the input spectrum shape to reduce nonlinear interference near zero dispersion, resulting in a potential achievable information rate of over 100 Tb/s to be reached.


  • 115.2-THz Aggregate Bandwidth O-band Coherent DWDM Transmission Over a High-Density 250-$\mu$m Coating Multicore Fibre

    by Daniel J. Elson, Shohei Beppu, Ayumi Inoue, Daiki Soma, Takuji Nagashima, Vitaly Mikhailov, Jiawei Luo, Shigehiro Takasaka, Daryl Inniss, Noboru Yoshikane, et al.

    The rising demand for high transmission bandwidths in optical fibres for short-distance applications can be addressed by increasing the number of cores. Higher core densities in the fibres can be paired with the bandwidth enhancements provided by a bismuth-doped fibre amplifier (BDFA) operating in the O-band due to the lower intercore-crosstalk. In this study, we showcase an ultrawide O-band coherent transmission using a 12-core fibre with a standard 250-μm coating diameter. By using bidirectional transmission, inter-core crosstalk was effectively reduced to below −45 dB across a distance of 31.7 km (including multi-core connectors). The total aggregate bandwidth achieved was 115.2 THz, while retaining the conventional coating diameter, confirming the fibre's suitability for space-constrained environments


  • 9.6-THz Single Fibre Amplifier O-Band Coherent DWDM Transmission

    by Daniel J. Elson, Yuta Wakayama, Vitaly Mikhailov, Jiawei Luo, Noboru Yoshikane, Daryl Inniss, Takehiro Tsuritani

    We experimentally demonstrate greater than C-band coherent transmission over a bandwidth of 9.6-THz using simple back-ward-pumped bismuth-doped fibre amplifiers in the O-band. The signal-to-noise ratio (SNR) of coherent dense wavelength-division-multiplexed signals is evaluated after one and three 45-km spans of installed fibre at 30 and 40 GBd as a function of wavelength. The penalty at the zero-dispersion wavelength from nonlinear noise is measured and in the broadband transmission regime, the penalty is insignificant. The measured SNR is converted to achievable information rate, and the impact of the number of equaliser taps is evaluated, showing that chromatic dispersion compensation is not needed, demonstrating the potential for energy savings in receiver-side signal processing.


  • 1255–1355 nm (17.6 THz) Bandwidth O-Band BDFA Pumped Using Uncooled Multimode 915 nm Laser Diode via YDF Conversion Stage

    by Vitaly Mikhailov, Yingzhi Sun, Jiawei Luo, Farooq Khan, Daryl Inniss, Yuriy Dulashko, Mark Lee, Joel Mann, Robert S. Windeler, Paul S. Westbrook, et al.

    Bismuth doped fiber amplifiers (BDFA) have been pumped with single mode 1190–1260 nm lasers to amplify signals over the O-band. We report here a BDFA using 915 nm multimode laser via an ytterbium fiber conversation stage. The conversion stage transforms 915 nm pump to single mode 1150 nm light used to pump BDF. This pump provides up to 3W of 1150 nm power over 20–70 °C with 0.25–0.2 electrical to optical conversion (wall-plug) efficiency. Compared to directly pumped BDFAs with 1195 nm single mode semiconductor laser(s) the 915/1150 nm pumping has superior optical performance and lower power consumption. The resultant BDFA provides >20 dB gain over 1255 to 1355 nm (17.6 THz) with a maximum gain of 29.3 dB and corresponding noise figure (NF) of 4.6 dB (λ = 1300 nm, Pin = −20 dBm). The BDFA has electrical power consumption of 8.1–9.6 W over 20–70 °C respectively. We also show the amplifier is suitable for high-speed data transmission by amplification of 50 Gbaud/s PAM-4 WDM signals over 30 km of G.652 fiber.


  • BDFA Supported Transmission of 400GBASE-LR8 Signals Over Deployed Multimanufacturer 4-Core Fibre

    by Daniel J. Elson, Yuta Wakayama, Vitaly Mikhailov, Daryl Inniss, Jiawei Luo, Noboru Yoshikane

    We demonstrate reach extension for 400GBASE-LR8 signals in an installed multimanufacturer multicore fibre link with the use of bismuth-doped fibre amplifier as a preamplifier. The reach is extended to 28 km and we show that the accumulated intercore-crosstalk does not cause any frame loss over 24 hours. This connectorised multimanufacturer multicore fibre configuration with off-the-shelf transceivers can support a single fibre throughput of 1.6 Tb/s.


  • 400GBASE-LR4 and 400GBASE-LR8 Transmission Reach Maximization Using Bismuth-Doped Fiber Amplifiers

    by Yuta Wakayama, Daniel J. Elson, Vitaly Mikhailov, Rachata Maneekut, Jiawei Luo, Noboru Yoshikane, Daryl Inniss, Takehiro Tsuritani

    We extend the transmission distance of 400GBASE-LR4 and 400GBASE-LR8 systems by introducing simple and ultrawideband single-stage bismuth-doped fiber amplifiers (BDFAs). The transmission reach of emerging 400GBASE-LR4 and 400GBASE-LR8 transceivers was successfully extended from 10 km to 20 and 90 km, respectively. The transmission links were stable over seven days for both systems. Furthermore, we demonstrate that the transmission reach was maximized up to the chromatic dispersion limit and show the applicability of BDFAs for upgrading the transmission reach of cost-effective transceivers to meet the requirements of 400ZR applications. This offers a reasonable solution for improving the power budget and extending the reach of existing data center interconnections with 400GBASE-LR4/LR8 transceivers.


  • 1255-1355 nm (17.6 THz) Bandwidth O-band Bismuth Doped Fiber Amplifier Pumped Using Uncooled Multimode (MM) 915 nm Laser Diode

    by V. Mikhailov, Y. Sun, J. Luo, F. Khan, D. Inniss, Y. Dulashko, M. Lee, J. Mann, R.S. Windeler, P.S. Westbrook, et al.

    We report BDFA with >20 dB gain over 1255-1355 nm bandwidth (17.6 THz) with maximum gain of 29.3 dB and corresponding NF of 4.6 dB (λ=1300 nm, Pin=-20 dBm). The BDFA has electrical power consumption of 8.1-9.6 W over 20-70 ºC.


  • Real-Time 50Gb/s Upstream Transmission in TDM-PON with Class E1 Power Budget Using Ge/Si Avalanche Photodiode and Bismuth-Doped Fiber as Preamplifier

    by Ning Wang, Junwei Li, Dechao Zhang, Han Li, Jin Cheng, Wang Chen, Vitaly Mikhailov, Daryl Inniss, Yan Chen, Xiaodong Duan, et al.

    We experimentally demonstrate a real-time 20km transmission of 50Gb/s NRZ upstream signal in TDM-PON using a BDFA preamplifier and a Ge/Si APD receiver. The sensitivity of -27.8dBm is achieved due to the low noise figure of the BDFA.


  • Devices and Fibers for Ultrawideband Optical Communications

    by Jeremie Renaudier, Antonio Napoli, Maria Ionescu, Cosimo Calo, Gerrit Fiol, Vitaly Mikhailov, Wladek Forysiak, Nicolas Fontaine, Francesco Poletti, Pierluigi Poggiolini

    Wavelength-division multiplexing (WDM) has historically enabled the increase in the capacity of optical systems by progressively populating the existing optical bandwidth of erbium-doped fiber amplifiers (EDFAs) in the $C$ -band. Nowadays, the number of channels—needed in optical systems—is approaching the maximum capacity of standard $C$ -band EDFAs. As a result, the industry worked on novel approaches, such as the use of multicore fibers, the extension of the available spectrum of the $C$ -band EDFAs, and the development of transmission systems covering $C$ -and $L$ -bands and beyond. In the context of continuous traffic growth, ultrawideband (UWB) WDM transmission systems appear as a promising technology to leverage the bandwidth of already deployed optical fiber infrastructure and sustain the traffic demand for the years to come. Since the pioneering demonstrations of UWB transmission a few years ago, long strides have been taken toward UWB technologies. In this review article, we discuss how the most recent advances in the design and fabrication of enabling devices, such as lasers, amplifiers, optical switches, and modulators, have improved the performance of UWB systems, paving the way to turn research demonstrations into future products. In addition, we also report on the advances in UWB optical fibers, such as the recently introduced nested antiresonant nodeless fibers (NANFs), whose future implementations could potentially provide up to 300-nm-wide bandwidth at less than 0.2 dB/km loss.


  • Amplified Transmission Beyond C- and L- Bands: Bismuth Doped Fiber Amplifier for O-Band Transmission

    by Vitaly Mikhailov, Jiawei Luo, Daryl Inniss, Man F. Yan, Yingzhi Sun, Gabriel S. Puc, Robert S. Windeler, Paul S. Westbrook, Yuriy Dulashko, David J. DiGiovanni

    Optical amplification beyond C- and L-bands may be a promising solution to increase the capacity of transmission systems. In this paper we reviewed different amplification technologies, including semiconductor optical amplifiers (SOA), Raman amplifiers and doped fiber amplifiers briefly discussing their advantages and disadvantages. We found that while a variety of amplification solutions are available, they have not been implemented in practical systems because, until recently, C- and L- bands EDFA amplified systems provided sufficient capacity, and the lack of a complete optical components ecosystem. The O-band (1260-1360 nm) may be a notable exception since it has been used for decades for unamplified point-to-point transmission near fiber zero dispersion wavelength. Overall capacity demand and power budget reduction caused by the bit rate increase of pluggable modules promises to make O-band amplification an attractive solution. We present simple broadband O-band bismuth doped fiber amplifier (BDFA) with characteristics similar to, or above commercially available EDFAs. We demonstrated that BDFAs can amplify the entire O-band and a single stage amplifier can deliver 20 dB gain, 18 dBm output power and 5.5 dB noise figure over the 3-dB bandwidth greater than 60 nm. We illustrated the application of BDFAs by transmitting signals from a commercial 400 Gb/s 8-channel LAN-WDM transponder, operating within the IEEE standardized band, over 50 km of legacy G.652 fiber. We also demonstrated high power BDFA capable of delivering more than 700 mW of optical power without inducing measurable nonlinear distortion to intensity modulated signal propagating over a dispersive fiber waveguide.