SWShuangle Wu

Shuangle Wu

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Shuangle Wu has a total of 28 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Research on simultaneous measurement of 3D deformation distribution on opposite dual end faces

    by Shuangle Wu, Chuanxiang Li, Shuqi Guo, Qiu Hu, Lizhou Men, Lang Wang, Xiongwei Li

    Conventional optical detection methods typically permit the measurement of merely a single end-face per operation. However, in industrial fields such as aerospace, complex parts and structures often have structural surfaces, requiring simultaneous measurement of the relative deformation or mechanical response of multiple end faces. In response to this, we design a simultaneous measurement system for three-dimensional deformation distribution of dual-end faces based on digital speckle pattern interferometry. The opposite-end faces of the object are simultaneously imaged onto the camera target plane with orthogonal polarization states through different imaging systems, so as to realize simultaneous measurement of the dual-end faces without mutual interference of measurement information. Meanwhile, the imaging resolution of the dual-end faces is improved, and the measurement field of view is expanded. In addition, by adjusting the interference spectrum distribution of the two-end faces, synchronous and independent extraction of the measurement information from the dual-end faces is realized. Finally, three-dimensional deformation distribution of the dual-end faces is obtained by multilaser illumination from different angles. On this basis, the attitude change angle caused by end-face deformation is derived. Experiments verify that the measurement accuracy of the system for attitude angle change can reach 0.0015 deg.

  • Denoising method based on an improved convolutional neural network for laser speckle pattern interferometry phase maps with high noise levels

    by Shuangle Wu, Yufeng Xie, Lang Wang, Qiu Hu, Weiming Cai

    Denoising of speckle pattern interference phase maps is a complex but critical step in laser speckle pattern interferometry. This study proposes an algorithm to denoise high-noise phase fringe patterns on the basis of an improved convolutional neural network. The fundamental structure of the algorithm is a U-Net configuration with residual connections. These connections help solve the problem of gradient vanishing during the training of deep neural networks. During algorithm design, the model is trained by combining the simulated noise fringe patterns and the real noise fringe patterns to construct a training set with a certain proportion, which improves the generalization ability of the denoising algorithm. Different from the single-indicator loss function in the traditional neural network denoising model, the combined loss function proposed in this study merges the structured similarity indexing measure and mean square error as evaluation indices in the training process of the algorithm model. The combined loss function can accurately evaluate the similarity between the denoised image and the original image and reduce the errors that may result from a single index. The algorithm, with its excellent predictive analysis and feature extraction capabilities, efficiently removes noise from phase-stripe images and preserves the edge and detailed information of the stripes. Test results show that the proposed algorithm can achieve good denoising effects and retain the fringe detail information of interferometric fringe patterns when dealing with speckle pattern interference phase maps with sparse fringe density and low noise and those with dense and noisy fringes. This noise reduction effect is crucial for improving the quality of interferometric phase maps and lays a solid foundation for subsequent interferometric phase map processing and analysis, such as phase unwrapping.

  • A Synchronous Measurement System for the First Derivative of Out-of-Plane Deformation of Double Ends

    by Shuangle Wu, Yanfeng Yao, Biao Wang, Yonghong Wang, Fenglong Yang

    In current practical applications, synchronously obtaining the information about out-of-plane deformation of double ends is often necessary. However, traditional measurement systems cannot achieve the synchronous measurement of double ends, as two sets of measurement systems are often needed. This study solves the problem by designing a synchronous measurement system for the first derivative of the double-end deformation based on shearography. The first derivative distribution of the double-end deformation is measured synchronically by imaging the two end surfaces in different areas of the camera’s target plane through different shear structures. In addition, by placing apertures in each Michelson shear structure, the synchronous dynamic measurement of both ends and the independent adjustment of the shear and spectral distribution in the Michelson shearography system are realized. The principle of the measurement system is introduced in detail, and the feasibility and practicability of the proposed system are verified by experiments.


  • Elimination of overexposed area and its phase correction method in speckle pattern interferometry

    by Yonghong Wang, Shuangle Wu, Yanfeng Yao, Chen Li, Peizheng Yan

    The technology of optical interferometry1,2 can measure plenty of physical parameters which are proportional to the phase of light. Among them, digital speckle pattern interferometry (DSPI)3 – 5 and digital speckle shearing pattern interferometry (DSSPI, shearography)6,7 have been widely concerned and applied to the measurement of parameters such as object deformation and its first derivative due to their characteristics of full-field, non-contact, high sensitivity, and high precision.8,9 In the practical applications of DSPI and DSSPI, it is often necessary to measure the deformation or detect defects of some specimens placed in boxes such as temperature control box and pressure control box. The observation windows of these boxes are mostly made of quartz glass. When the DSPI or DSSPI is used to measure the object inside, the laser irradiates the surface of the object through the observation window. Meanwhile, part of the laser is reflected on the surface of the observation window glass, which makes the local area of the field of view overexposed during the imaging, resulting in the failure to measure the area normally.


  • A new multiplexed system for the simultaneous measurement of out-of-plane deformation and its first derivative

    by QiHan Zhao, Xiao Zhang, ShuangLe Wu, HuanQing Wang, PeiZheng Yan, YongHong Wang


  • Fast automatic multi-defects recognition based on the spatial characteristics of Freeman chain code

    by Xiao Zhang, Yonghong Wang, Qihan Zhao, Fengqing Bao, Shuangle Wu, Peizheng Yan

    Shearography is a very effective non-destructive testing method for detecting the internal defects of composite materials. How to improve the detection efficiency of this technique to help achieve the rapid and automatic recognition of multiple defects has always been a hot research topic for researchers. Based on the results of the shearography, we propose a method to identify multiple defects in the phase map using the spatial characteristics of Freeman chain code. First of all, we use Canny operator to binarize the phase map, then refine the fringe by morphological means, and finally identify the defects by the spatial characteristics chain code. In addition, Otsu is used to assist in judging the fracture or incomplete defects. For the fringes under vacuum loading or thermal loading, this method can detect the defects quickly and successfully. The theoretical description is given and the effectiveness and practicability of the method are verified by experiments.


  • Open Access

    Pixelated Carrier Phase-Shifting Shearography Using Spatiotemporal Low-Pass Filtering Algorithm

    by Peizheng Yan, Xiangwei Liu, Shuangle Wu, Fangyuan Sun, Qihan Zhao, Yonghong Wang

    Shearography has been widely used in non-destructive testing due to its advantages in providing full-field, high precision, real-time measurement. The study presents a pixelated carrier phase-shifting shearography using a pixelated micropolarizer array. Based on the shearography, a series of shearograms are captured and phase maps corresponding to deformation are measured dynamically and continuously. Using the proposed spatiotemporal filtering algorithm in the complex domain, the set of phase maps are simultaneously low-pass filtered in the spatial and temporal domains, resulting in better phase quality than spatial low-pass filtering. By accumulating the temporally adjacent phase, the phase corresponding to large deformation can be evaluated; thus, large deformations can be accurately measured and protected from speckle noise, allowing internal defects to be easily identified. The capability of the proposed shearography is described by theoretical discussions and experiments.