Petra Peroutková
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Petra Peroutková has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Jiří Palarčík
Institute of Environmental and Chemical Engineering, Faculty of Chemical Technology, University of Pardubice, Studentská 573, 532 10 Pardubice, Czech Republic
3 shared publications - Dominika Josefová
Institute of Environmental and Chemical Engineering, University of Pardubice, Studentská 573, 532 10 Pardubice, Czech Republic
1 shared publication - Dušan Kacálek
The Forestry and Game Management Research Institute, Research Station at Opočno, Na Olivě 550, 517 73 Opočno, Czech Republic
1 shared publication - Jan Malaťák
Faculty of Engineering, Czech University of Life Sciences Prague, Kamýcká 129, 165 00 Prague, Czech Republic
1 shared publication - Jan Velebil
Faculty of Engineering, Czech University of Life Sciences Prague, Kamýcká 129, 165 00 Prague, Czech Republic
1 shared publication - Jaromíra Chýlková
Institute of Environmental and Chemical Engineering, Faculty of Chemical Technology, University of Pardubice, Studentská 573, 532 10 Pardubice, Czech Republic
1 shared publication
Latest Publications
- Open Access
The Impact of Clear-Cutting on the Volume and Chemistry of Water at a Sandy Nutrient-Poor Pine Site
Clear-cutting removes a stand cover suddenly, thus impacting soil-surface conditions by the expected increase in the humus breakdown rate, due to the addition of more precipitation and solar radiation. The impacts of removing a forest were studied at a site with deep sandy soils dominated by Scots pine, where three treatments, including a stand left on site, whole-tree harvesting treatment, and stem-only harvesting treatment, were established. Clear-cut precipitation and sub-canopy throughfall were measured. The non-replicated treatments were equipped with lysimeters at depths of −10 cm and −70 cm and in addition, three exploratory wells were drilled to sample groundwater in each of the treatments. The volume and chemistry of the water samples were periodically analyzed. The mean throughfall was 84% of open-area precipitation and the pH of the water penetrating the canopy was significantly lower overall, although the subcanopy samples were only slightly more acidic. Significant differences among the treatments were shown in throughfall (total organic carbon, TOC), shallow subsurface water (pH, TOC, NO3−), subsurface water at the 70-cm depth (NO3−) and also groundwater (pH, TOC, NO3−), where some of the differences had been observed before the stand parts were clear-cut. Limits for drinking water were exceeded in groundwater pH, as the values from both clear-cut sites fell below pH 6.5 following clear-cutting. TOC greater than 5 mg·L−1 was found in the Q1-2020 samples, whereas groundwater nitrate remained low, even though the three wells differed significantly from each other. Due to the non-replicated design of the experiment, generalization of the outcomes is a matter of further research.
Open AccessThe Impact of Clear-Cutting on the Volume and Chemistry of Water at a Sandy Nutrient-Poor Pine Site
Clear-cutting removes a stand cover suddenly, thus impacting soil-surface conditions by the expected increase in the humus breakdown rate, due to the addition of more precipitation and solar radiation. The impacts of removing a forest were studied at a site with deep sandy soils dominated by Scots pine, where three treatments, including a stand left on site, whole-tree harvesting treatment, and stem-only harvesting treatment, were established. Clear-cut precipitation and sub-canopy throughfall were measured. The non-replicated treatments were equipped with lysimeters at depths of −10 cm and −70 cm and in addition, three exploratory wells were drilled to sample groundwater in each of the treatments. The volume and chemistry of the water samples were periodically analyzed. The mean throughfall was 84% of open-area precipitation and the pH of the water penetrating the canopy was significantly lower overall, although the subcanopy samples were only slightly more acidic. Significant differences among the treatments were shown in throughfall (total organic carbon, TOC), shallow subsurface water (pH, TOC, NO3−), subsurface water at the 70-cm depth (NO3−) and also groundwater (pH, TOC, NO3−), where some of the differences had been observed before the stand parts were clear-cut. Limits for drinking water were exceeded in groundwater pH, as the values from both clear-cut sites fell below pH 6.5 following clear-cutting. TOC greater than 5 mg·L−1 was found in the Q1-2020 samples, whereas groundwater nitrate remained low, even though the three wells differed significantly from each other. Due to the non-replicated design of the experiment, generalization of the outcomes is a matter of further research.
- Open Access
Decolorization and Oxidation of Acid Blue 80 in Homogeneous and Heterogeneous Phases by Selected AOP Processes
This paper is a kinetic study that compares the rate of decolorization and subsequently the mineralization of Acid Blue 80 in model dyeworks wastewater, both in the homogeneous phase using the Fenton and photo-Fenton reactions, UV-C and UVC/H2O2 processes, and in the heterogeneous phase, where the proven commercial photocatalysts P25, P90, and AV01 based on TiO2 were used. The influence of pH of the environment was studied and in the case of the Fenton reaction, the influence of the concentration of catalyzing Fe2+ ions on the rate of decolorization of the model wastewater was also studied. The optimal molar ratio of H2O2/Fe2+ was 10:1. For describing the reaction kinetics, first-order speed constants were best-suited. In all applied processes, the dye chromophore degraded, which was accompanied by a quantitative decolorization of the model wastewater. Subsequently, the mineralization of colorless intermediate products was studied through a decrease in COD or, more precisely, TOC. The mineralization efficiency in the homogeneous phase ranged between 18.6 and 97.1% after 24 h. In the case of heterogeneous photocatalysis, it ranged between 79.6 and 97.3% after 24 h, with efficiency declining in the order P90 > P25 > AV01.
Open AccessDecolorization and Oxidation of Acid Blue 80 in Homogeneous and Heterogeneous Phases by Selected AOP Processes
This paper is a kinetic study that compares the rate of decolorization and subsequently the mineralization of Acid Blue 80 in model dyeworks wastewater, both in the homogeneous phase using the Fenton and photo-Fenton reactions, UV-C and UVC/H2O2 processes, and in the heterogeneous phase, where the proven commercial photocatalysts P25, P90, and AV01 based on TiO2 were used. The influence of pH of the environment was studied and in the case of the Fenton reaction, the influence of the concentration of catalyzing Fe2+ ions on the rate of decolorization of the model wastewater was also studied. The optimal molar ratio of H2O2/Fe2+ was 10:1. For describing the reaction kinetics, first-order speed constants were best-suited. In all applied processes, the dye chromophore degraded, which was accompanied by a quantitative decolorization of the model wastewater. Subsequently, the mineralization of colorless intermediate products was studied through a decrease in COD or, more precisely, TOC. The mineralization efficiency in the homogeneous phase ranged between 18.6 and 97.1% after 24 h. In the case of heterogeneous photocatalysis, it ranged between 79.6 and 97.3% after 24 h, with efficiency declining in the order P90 > P25 > AV01.
- Open Access
Removal of Chloroacetanilide Herbicides from Water Using Heterogeneous Photocatalysis with TiO2/UV-A
Chloroacetanilide herbicides are widely used in the agricultural sector throughout the world. Because of their poor biodegradability, high water solubility, and long persistence, chloroacetanilide herbicides have a high potential to contaminate water, and conventional water treatment processes do not ensure sufficient removal. Therefore, heterogeneous photocatalysis using TiO2/UV-A was investigated for the degradation of alachlor, acetochlor, and metolachlor from water. Two commercially available TiO2 (P25 and AV-01) were used as photocatalysts. Different experimental setups were also tested. In addition, the toxicity of single herbicides and mixtures of their photocatalytic degradation products to the freshwater alga Chlorella kessleri was investigated via a growth inhibition test. The maximum removal efficiency for alachlor, acetochlor, and metolachlor was 97.5%, 93.1%, and 98.2%, respectively. No significant differences in the removal efficiency of chloroacetanilide herbicides were observed for the photocatalysts used. Although the concentrations of all herbicides during photocatalysis decreased, the toxicity of the resulting mixtures of degradation products increased or remained the same, indicating the formation of toxic degradation products.
Open AccessRemoval of Chloroacetanilide Herbicides from Water Using Heterogeneous Photocatalysis with TiO2/UV-A
Chloroacetanilide herbicides are widely used in the agricultural sector throughout the world. Because of their poor biodegradability, high water solubility, and long persistence, chloroacetanilide herbicides have a high potential to contaminate water, and conventional water treatment processes do not ensure sufficient removal. Therefore, heterogeneous photocatalysis using TiO2/UV-A was investigated for the degradation of alachlor, acetochlor, and metolachlor from water. Two commercially available TiO2 (P25 and AV-01) were used as photocatalysts. Different experimental setups were also tested. In addition, the toxicity of single herbicides and mixtures of their photocatalytic degradation products to the freshwater alga Chlorella kessleri was investigated via a growth inhibition test. The maximum removal efficiency for alachlor, acetochlor, and metolachlor was 97.5%, 93.1%, and 98.2%, respectively. No significant differences in the removal efficiency of chloroacetanilide herbicides were observed for the photocatalysts used. Although the concentrations of all herbicides during photocatalysis decreased, the toxicity of the resulting mixtures of degradation products increased or remained the same, indicating the formation of toxic degradation products.