Jianbao Liu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Jianbao Liu has a total of 15 co-authors. Here are the top co-authors by number of shared publications:
- Jiangang Ren
School of Environmental and Biological Engineering, Henan University of Engineering, Zhengzhou 451191, China
3 shared publications - Bing Li
School of Environmental and Biological Engineering, Henan University of Engineering, Zhengzhou 451191, China
2 shared publications - Chengtao Yang
Henan Energy Industry Group Research Institute Co., Ltd., Zhengzhou 450046, China
2 shared publications - Bing Li
School of Environment and Bioengineering, Henan University of Engineering, Zhengzhou 451191, China
1 shared publication - Fan Zhang
School of Resources and Safety Engineering, Henan University of Engineering, Zhengzhou 451191, China
1 shared publication - Feng Chen
School of Environmental and Biological Engineering, Henan University of Engineering, Zhengzhou 451191, China
1 shared publication
Latest Publications
- Open Access
- 1 April 2026
- Published by MDPI AG in Fractal and Fractional
- Vol. 10 (4) , 235
Multifractal Evolution Patterns of Microporous Structures with Coalification Degree
The dominant pores governing methane adsorption in coal are micropores (pore size < 2 nm). Their spatial heterogeneity can be quantitatively characterized using multifractal theory; however, the evolution patterns and mechanisms of microporous structures across different coalification degrees remain unclear. This research selected a series of coal samples from different ranks and identified the coalification degree using the maximum vitrinite reflectance (Rₒ,max). By comprehensively employing low-temperature CO2 adsorption experiments and multifractal analysis, the evolution patterns of the microporous structures and their multifractal spectral parameters were systematically revealed, and the underlying control mechanisms were explored. Results indicate that micropore volume (PV) and specific surface area (SSA) first exhibit a decrease and then increase as Rₒ,max increases, with the trough occurring during the second coalification jump at Rₒ,max = 1.2–1.4%. The pore sizes exhibit bimodal distributions, with the primary peak occurring in the range of 0.45–0.65 nm and the secondary peak occurring in the range of 0.8–0.9 nm. All microporous structures possess pronounced multifractal characteristics. The generalized dimension spectrum width (ΔD) and singularity spectrum width (Δα) exhibit an increasing–decreasing–increasing trend with Rₒ,max, whereas the Hurst exponent (H) follows an inverted parabolic curve, first increases then decreases. This contrasts with the trends in PV and SSA, indicating that the evolution of pore-space heterogeneity and connectivity is independent of and lags the changes in micropore quantity. These patterns are governed by a structural phase transition within the coal macromolecular network. Marked by the second coalification jump, the microporous system shifts from a flexible degradation–polycondensation paradigm to a rigid ordering–construction paradigm. This transition drives the asynchronous, synergistic evolutions of pore quantity, spatial heterogeneity (ΔD and Δα), and topological connectivity (H). This research provides a theoretical basis for quantitatively evaluating pore heterogeneity in coal reservoirs.
- 1 April 2026
- Published by MDPI AG in Fractal and Fractional
- Vol. 10 (4) , 235
Open AccessMultifractal Evolution Patterns of Microporous Structures with Coalification Degree
The dominant pores governing methane adsorption in coal are micropores (pore size < 2 nm). Their spatial heterogeneity can be quantitatively characterized using multifractal theory; however, the evolution patterns and mechanisms of microporous structures across different coalification degrees remain unclear. This research selected a series of coal samples from different ranks and identified the coalification degree using the maximum vitrinite reflectance (Rₒ,max). By comprehensively employing low-temperature CO2 adsorption experiments and multifractal analysis, the evolution patterns of the microporous structures and their multifractal spectral parameters were systematically revealed, and the underlying control mechanisms were explored. Results indicate that micropore volume (PV) and specific surface area (SSA) first exhibit a decrease and then increase as Rₒ,max increases, with the trough occurring during the second coalification jump at Rₒ,max = 1.2–1.4%. The pore sizes exhibit bimodal distributions, with the primary peak occurring in the range of 0.45–0.65 nm and the secondary peak occurring in the range of 0.8–0.9 nm. All microporous structures possess pronounced multifractal characteristics. The generalized dimension spectrum width (ΔD) and singularity spectrum width (Δα) exhibit an increasing–decreasing–increasing trend with Rₒ,max, whereas the Hurst exponent (H) follows an inverted parabolic curve, first increases then decreases. This contrasts with the trends in PV and SSA, indicating that the evolution of pore-space heterogeneity and connectivity is independent of and lags the changes in micropore quantity. These patterns are governed by a structural phase transition within the coal macromolecular network. Marked by the second coalification jump, the microporous system shifts from a flexible degradation–polycondensation paradigm to a rigid ordering–construction paradigm. This transition drives the asynchronous, synergistic evolutions of pore quantity, spatial heterogeneity (ΔD and Δα), and topological connectivity (H). This research provides a theoretical basis for quantitatively evaluating pore heterogeneity in coal reservoirs.
- Open Access
Changing Law of Permeability of Coal Reservoirs under Variable Pressure Conditions and Its Influence on Extraction Efficiency of Coalbed Methane
Coal permeability data are critical in the prevention and control of coal and gas outbursts in mines and are an important reservoir parameter for the development of coalbed methane. The mechanism by which permeability is affected by gas pressure is complex. We used a self-developed true triaxial seepage experimental device that collects lignite and anthracite coal samples, sets fixed axial pressure and confining pressure, and changes gas pressure by changing the orientation of the coal seam to study the influence of the gas pressure on the permeability of the coal seam under the conditions of different coal types and different bedding orientations. Coal permeability decreased rapidly and then decreased slowly and tended to be stable with the increase in gas pressure. This conformed to the power exponential fitting relationship, and the fitting degree reached more than 99%. The comparison of the two anthracite coal samples showed that the sample’s permeability with a bedding plane vertical to the seepage direction was significantly lower than that of the bedding plane parallel to the seepage direction, indicating that gas seeped more easily along the bedding. The sensitivity coefficient of permeability with the change in gas pressure was calculated. The analysis showed that coal permeability was sensitive to changes in gas pressure during the low-pressure stage. When the gas pressure was greater than 0.8 MPa, the sensitivity coefficient was significantly reduced, which may have been related to the slow increase in the amount of gas absorbed by the coal seam in the high-pressure stage. A theoretical calculation model of coal seam permeability considering adsorption/desorption and seepage effects was proposed and then verified with experimental results showing that the theoretical model better reflected the permeability characteristics of coal and predicted its permeability. Using the finite element simulation software COMSOL, the extraction efficiency of the coal seam gas under different gas pressure conditions was simulated. The results showed that coal permeability and extraction efficiency decreased with an increase in gas pressure. In the low-pressure stage, the reduction in the extraction efficiency was more evident than that in the high-pressure stage.
Open AccessChanging Law of Permeability of Coal Reservoirs under Variable Pressure Conditions and Its Influence on Extraction Efficiency of Coalbed Methane
Coal permeability data are critical in the prevention and control of coal and gas outbursts in mines and are an important reservoir parameter for the development of coalbed methane. The mechanism by which permeability is affected by gas pressure is complex. We used a self-developed true triaxial seepage experimental device that collects lignite and anthracite coal samples, sets fixed axial pressure and confining pressure, and changes gas pressure by changing the orientation of the coal seam to study the influence of the gas pressure on the permeability of the coal seam under the conditions of different coal types and different bedding orientations. Coal permeability decreased rapidly and then decreased slowly and tended to be stable with the increase in gas pressure. This conformed to the power exponential fitting relationship, and the fitting degree reached more than 99%. The comparison of the two anthracite coal samples showed that the sample’s permeability with a bedding plane vertical to the seepage direction was significantly lower than that of the bedding plane parallel to the seepage direction, indicating that gas seeped more easily along the bedding. The sensitivity coefficient of permeability with the change in gas pressure was calculated. The analysis showed that coal permeability was sensitive to changes in gas pressure during the low-pressure stage. When the gas pressure was greater than 0.8 MPa, the sensitivity coefficient was significantly reduced, which may have been related to the slow increase in the amount of gas absorbed by the coal seam in the high-pressure stage. A theoretical calculation model of coal seam permeability considering adsorption/desorption and seepage effects was proposed and then verified with experimental results showing that the theoretical model better reflected the permeability characteristics of coal and predicted its permeability. Using the finite element simulation software COMSOL, the extraction efficiency of the coal seam gas under different gas pressure conditions was simulated. The results showed that coal permeability and extraction efficiency decreased with an increase in gas pressure. In the low-pressure stage, the reduction in the extraction efficiency was more evident than that in the high-pressure stage.
- Open Access
Experimental Study on the Microstructure of Coal with Different Particle Sizes
In the study of coal pore structure, the traditional test method does not consider the influence of coal particle size. During the crushing process, coal samples are affected by crushing stress. While the particle size changes, the change characteristics of pore structure and macromolecular structure are a matter for which systematic research is still lacking. In this paper, mercury injection and liquid nitrogen were used to characterize the pore structure of coal. It was found that the porosity, total pore volume and total specific surface area of the coal increased with the decrease of particle size. However, during this process, the pore volume of macropores and mesopores decreases, while the micropores and transition pores increase significantly, indicating that while the particle size decreases, macropores and mesopores are broken into micropores and transition pores. In addition, the pore structure of samples with a particle size less than 200 mesh changes significantly. With the decrease of coal particle size, the areas of the D peak and G peak of the Raman spectrum increase, indicating that the ordering degree of coal increases. Finally, the statistical results of the peak area of the Fourier infrared spectrum show that alcohol, phenol, ammonia hydroxyl and fatty hydrocarbon CH2 and CH3 are greatly reduced, while the out-of-plane deformation vibration of alkyl ether and aromatic structure C–H are significantly increased, which also indicates the transformation of the coal macromolecular structure to an aromatic structure with strong stability.
Open AccessExperimental Study on the Microstructure of Coal with Different Particle Sizes
In the study of coal pore structure, the traditional test method does not consider the influence of coal particle size. During the crushing process, coal samples are affected by crushing stress. While the particle size changes, the change characteristics of pore structure and macromolecular structure are a matter for which systematic research is still lacking. In this paper, mercury injection and liquid nitrogen were used to characterize the pore structure of coal. It was found that the porosity, total pore volume and total specific surface area of the coal increased with the decrease of particle size. However, during this process, the pore volume of macropores and mesopores decreases, while the micropores and transition pores increase significantly, indicating that while the particle size decreases, macropores and mesopores are broken into micropores and transition pores. In addition, the pore structure of samples with a particle size less than 200 mesh changes significantly. With the decrease of coal particle size, the areas of the D peak and G peak of the Raman spectrum increase, indicating that the ordering degree of coal increases. Finally, the statistical results of the peak area of the Fourier infrared spectrum show that alcohol, phenol, ammonia hydroxyl and fatty hydrocarbon CH2 and CH3 are greatly reduced, while the out-of-plane deformation vibration of alkyl ether and aromatic structure C–H are significantly increased, which also indicates the transformation of the coal macromolecular structure to an aromatic structure with strong stability.