Nuria Navascues
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Nuria Navascues has a total of 97 co-authors. Here are the top co-authors by number of shared publications:
- Silvia Irusta
Instituto de Nanociencia y Materiales de Aragón (INMA), CSIC-Universidad de Zaragoza, Zaragoza 50009, Spain
8 shared publications - Reyes Mallada
Instituto de Nanociencia y Materiales de Aragón (INMA), CSIC-Universidad de Zaragoza, 50009 Zaragoza, Spain
7 shared publications - Carlos Téllez
Instituto de Nanociencia y Materiales de Aragón (INMA), CSIC-Universidad de Zaragoza, 50009 Zaragoza, Spain
4 shared publications - Manuel Arruebo
Departamento de Ingeniería Química y Tecnologías del Medio Ambiente, Universidad de Zaragoza, E-50018 Zaragoza, Spain
4 shared publications Silvia Irusta
4 shared publications- Joaquín Coronas
Instituto de Nanociencia y Materiales de Aragón (INMA), CSIC-Universidad de Zaragoza, Zaragoza 50018, Spain
3 shared publications
Latest Publications
- Open Access
- 27 March 2020
- Published by MDPI AG in Nanomaterials
- Vol. 10 (4) , 616
Antibacterial Effect of Thymol Loaded SBA-15 Nanorods Incorporated in PCL Electrospun Fibers
For the effective management of infected chronic wounds, the incorporation of antimicrobial drugs into wound dressings can increase their local availability at the infection site. Mesoporous silicon dioxide SBA-15 is an excellent drug carrier with tunable drug release kinetics. In this work, synthesized SBA-15 loaded with the natural antimicrobial compound thymol (THY) was incorporated into polycaprolactone (PCL) electrospun nanofibers to obtain an advanced wound dressing. Rod-shaped particles with internal parallel channels oriented along the longitudinal axis (diameter: 138 ± 30 nm, length: 563 ± 100 nm) were loaded with 70.8 wt.% of THY. Fiber mats were prepared using these particles as nanofillers within polycaprolactone (PCL) electrospun fibers. The resulting mats contained 5.6 wt.% of THY and more than half of this loading was released in the first 7 h. This release would prevent an initial bacterial colonization and also inhibit or eliminate bacterial growth as in vitro shown against Staphylococcus aureus ATCC 25923. Minimal inhibitory concentration (MIC: 0.07 mg/mL) and minimal bactericidal concentration (MBC: 0.11 mg/mL) of released THY were lower than the amount of free THY required, demonstrating the benefit of drug encapsulation for a more efficient bactericidal capacity due to the direct contact between mats and bacteria.
- 27 March 2020
- Published by MDPI AG in Nanomaterials
- Vol. 10 (4) , 616
Open AccessAntibacterial Effect of Thymol Loaded SBA-15 Nanorods Incorporated in PCL Electrospun Fibers
For the effective management of infected chronic wounds, the incorporation of antimicrobial drugs into wound dressings can increase their local availability at the infection site. Mesoporous silicon dioxide SBA-15 is an excellent drug carrier with tunable drug release kinetics. In this work, synthesized SBA-15 loaded with the natural antimicrobial compound thymol (THY) was incorporated into polycaprolactone (PCL) electrospun nanofibers to obtain an advanced wound dressing. Rod-shaped particles with internal parallel channels oriented along the longitudinal axis (diameter: 138 ± 30 nm, length: 563 ± 100 nm) were loaded with 70.8 wt.% of THY. Fiber mats were prepared using these particles as nanofillers within polycaprolactone (PCL) electrospun fibers. The resulting mats contained 5.6 wt.% of THY and more than half of this loading was released in the first 7 h. This release would prevent an initial bacterial colonization and also inhibit or eliminate bacterial growth as in vitro shown against Staphylococcus aureus ATCC 25923. Minimal inhibitory concentration (MIC: 0.07 mg/mL) and minimal bactericidal concentration (MBC: 0.11 mg/mL) of released THY were lower than the amount of free THY required, demonstrating the benefit of drug encapsulation for a more efficient bactericidal capacity due to the direct contact between mats and bacteria.
- 1 February 2020
- Published by Elsevier in Molecular Catalysis
- Vol. 481, 100636
Cobalt deposited on micro and nanometric structures of ceria and zirconia applied in diesel soot combustion
- 1 February 2020
- Published by Elsevier in Molecular Catalysis
- Vol. 481, 100636
Cobalt deposited on micro and nanometric structures of ceria and zirconia applied in diesel soot combustion
- 12 June 2017
- Published by Wiley in ChemistrySelect
- Vol. 2 (17) , 4667-4672
Manifestation of Concealed Defects in MoS 2 Nanospheres for Efficient and Durable Electrocatalytic Hydrogen Evolution Reaction
MoS 2 nanospheres were formed using a template free hydrothermal process, which exhibit high catalytic activity towards hydrogen evolution reaction (HER). The extend of defect sites are probed by extended X‐ray absorption fine structure which found decrease in co‐ordination number at Mo site rather than at S site. DFT calculations identified an uneven strain and defect distribution between two S planes of curved MoS 2 . Based on hydrogen adsorption on various sites, we identify a new pathway called “extended activity @ shielded defects”, for Volmer‐Tafel and Volmer‐Heyrovsky mechanisms, where H adsorption occurs at exposed S layer driven by defects in underneath S layer of nanosphere. Having higher defect concentration it exhibited excellent HER activity with overpotential of −0.12 V, Tafel slope of 90 mV/decade, and higher turnover frequency. Our findings provide an avenue to design and engineer advanced nanostructures for catalysis, electronic devices, and other potential applications.
- 12 June 2017
- Published by Wiley in ChemistrySelect
- Vol. 2 (17) , 4667-4672
Manifestation of Concealed Defects in MoS 2 Nanospheres for Efficient and Durable Electrocatalytic Hydrogen Evolution Reaction
MoS 2 nanospheres were formed using a template free hydrothermal process, which exhibit high catalytic activity towards hydrogen evolution reaction (HER). The extend of defect sites are probed by extended X‐ray absorption fine structure which found decrease in co‐ordination number at Mo site rather than at S site. DFT calculations identified an uneven strain and defect distribution between two S planes of curved MoS 2 . Based on hydrogen adsorption on various sites, we identify a new pathway called “extended activity @ shielded defects”, for Volmer‐Tafel and Volmer‐Heyrovsky mechanisms, where H adsorption occurs at exposed S layer driven by defects in underneath S layer of nanosphere. Having higher defect concentration it exhibited excellent HER activity with overpotential of −0.12 V, Tafel slope of 90 mV/decade, and higher turnover frequency. Our findings provide an avenue to design and engineer advanced nanostructures for catalysis, electronic devices, and other potential applications.
- Open Access
- 1 June 2017
- Published by Elsevier in International Journal of Pharmaceutics
- Vol. 525 (1) , 112-122
Laser-treated electrospun fibers loaded with nano-hydroxyapatite for bone tissue engineering
- 1 June 2017
- Published by Elsevier in International Journal of Pharmaceutics
- Vol. 525 (1) , 112-122
Open AccessLaser-treated electrospun fibers loaded with nano-hydroxyapatite for bone tissue engineering
- 1 February 2017
- Published by Elsevier in Particuology
- Vol. 30, 135-143
Polycaprolactone/mesoporous silica MCM-41 composites prepared by in situ polymerization
- 1 February 2017
- Published by Elsevier in Particuology
- Vol. 30, 135-143
Polycaprolactone/mesoporous silica MCM-41 composites prepared by in situ polymerization
- Open Access
- 1 November 2016
- Published by Elsevier in Applied Catalysis A: General
- Vol. 528, 86-92
Pt-CoOx nanoparticles supported on ETS-10 for preferential oxidation of CO reaction
- 1 November 2016
- Published by Elsevier in Applied Catalysis A: General
- Vol. 528, 86-92
Open AccessPt-CoOx nanoparticles supported on ETS-10 for preferential oxidation of CO reaction
- 5 August 2016
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 6 (81) , 78036-78042
Modulation of bactericidal action in polymer nanocomposites: light-tuned Ag+ release from electrospun PMMA fibers
While silver is widely regarded as a potent antibacterial material, controlling the rate of release of the bactericidal agents (silver ions) remains a challenge. When silver nanoparticles are used as precursors, the release process involves oxidation and dissolution in the surrounding environment. Here we show that it is possible to tune the rate of silver release from polymer matrices containing silver precursors by a simple UV irradiation step. To demonstrate this, silver-containing polymer (PMMA) fibers have been produced by electrospinning, then subjected to different levels of exposure to UV radiation and fully characterized in terms of silver state, presence of nanoparticles, Ag+ release rates and bactericidal power. The as-spun fibers contained mainly silver as Ag+, while samples exposed to UV radiation displayed progressively higher proportions of Ag0 (XPS analysis). Nanoparticles consisting of metallic silver were present in UV-exposed samples, and their size increased with irradiation time. The Ag+ release rates (and the bactericidal action of the nanofibers) were found to directly depend on the degree of UV exposure: a fast Ag+ release was observed for non-irradiated samples, which during the release experiment delivered roughly three times as much silver than samples subjected to 24 h UV exposure.
- 5 August 2016
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 6 (81) , 78036-78042
Modulation of bactericidal action in polymer nanocomposites: light-tuned Ag+ release from electrospun PMMA fibers
While silver is widely regarded as a potent antibacterial material, controlling the rate of release of the bactericidal agents (silver ions) remains a challenge. When silver nanoparticles are used as precursors, the release process involves oxidation and dissolution in the surrounding environment. Here we show that it is possible to tune the rate of silver release from polymer matrices containing silver precursors by a simple UV irradiation step. To demonstrate this, silver-containing polymer (PMMA) fibers have been produced by electrospinning, then subjected to different levels of exposure to UV radiation and fully characterized in terms of silver state, presence of nanoparticles, Ag+ release rates and bactericidal power. The as-spun fibers contained mainly silver as Ag+, while samples exposed to UV radiation displayed progressively higher proportions of Ag0 (XPS analysis). Nanoparticles consisting of metallic silver were present in UV-exposed samples, and their size increased with irradiation time. The Ag+ release rates (and the bactericidal action of the nanofibers) were found to directly depend on the degree of UV exposure: a fast Ag+ release was observed for non-irradiated samples, which during the release experiment delivered roughly three times as much silver than samples subjected to 24 h UV exposure.
- Open Access
- 1 August 2016
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 41 (31) , 13331-13340
Hydrothermal assisted morphology designed MoS 2 material as alternative cathode catalyst for PEM electrolyser application
- 1 August 2016
- Published by Elsevier in International Journal of Hydrogen Energy
- Vol. 41 (31) , 13331-13340
Open AccessHydrothermal assisted morphology designed MoS 2 material as alternative cathode catalyst for PEM electrolyser application
- 1 July 2016
- Published by IOP Publishing in Materials Research Express
- Vol. 3 (7) , 075402
Comparative study of sol–gel methods for the facile synthesis of tailored magnetic silica spheres
- 1 July 2016
- Published by IOP Publishing in Materials Research Express
- Vol. 3 (7) , 075402
Comparative study of sol–gel methods for the facile synthesis of tailored magnetic silica spheres