PLParthiban Loganathan

Parthiban Loganathan

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Parthiban Loganathan has a total of 22 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    One-Part Alkali-Activated Concrete as a Sustainable Alternative to Cement: Performance Evaluation and Life Cycle Assessment

    by Yamini Venugopal, Arunasankar Chithambar Ganesh, Parthiban Loganathan

    One-part alkali activated concrete (OPAAC) has emerged as a viable alternative to conventional cementitious materials because of its reduced carbon footprint and simplified ”just add water” processing. The performance of OPAAC is strongly governed by the activator-binder(A/B) ratio, which significantly influences reaction kinetics, gel formation and microstructural development. This study explores the influence of varying A/B ratios on the fresh, mechanical, durability and microstructural properties of OPAAC using ground granulated blast furnace slag (GGBS) as the sole precursor and sodium metasilicate as the solid activator under ambient curing conditions. Life cycle assessment (LCA) was performed to quantify associated environmental impacts. Mixtures were prepared with A/B ratios between 0.20 to 0.35 and evaluated for workability, compressive strength, split-tensile strength, flexural strength, water absorption, porosity and sorptivity. microstructural characteristics was performed through scanning electron microscopy (SEM) coupled with energy-dispersive X-ray spectroscopy (EDX). workability improved with increasing A/B ratio due to enhanced activator availability. Mechanical performance peaked at an optimum A/B ratio of 0.30, achieving a compressive strength of 46.45 Mpa, split -tensile strength of 4.22 Mpa and flexural strength of 6.08 Mpa. with reduced water absorption (3.8%), minimum porosity (9.12%) and the lowest sorptivity value of 0.72mm at 64 minutes. SEM-EDX confirmed a dense, homogeneous gel matrix with reduced porosity. LCA showed that OPAAC has low environmental impact than conventional concrete, due to usage of GGBS. Though higher activator dosages increase certain impacts. Overall A/B ratio 0.30 delivers optimum performance, whereas the lower ratio 0.20 shows superior environmental sustainability.

  • Open Access

    Development of Sustainable Paver Block to Suit Very Heavy Traffic Conditions Using Cassava Peel Ash

    by A. Chithambar Ganesh, Kandukuri Anitha, Ragavan Veeraiah, Parthiban Loganathan, J. Ram Prashath

    This investigation explores the synergistic use of cassava peel ash (CPA), an agricultural waste and silane treated glass fibers (GF) as sustainable components in concrete and paver blocks. CPA was utilized as a partial substitute for cement at 0%–20% by weight of cement and silane‐treated GF was incorporated in proportions ranging from 0.5% to 2.5% by volume of concrete. Experimental tests evaluated workability, compressive, tensile, and flexural strengths, pozzolanic activity index (PAI), ductility, and impact resistance of concrete. Microstructural evaluations using SEM and EDS confirmed enhanced C–S–H gel formation and decreased porosity. Results exhibited that 15% CPA enhanced strength properties significantly, with CA15G2 achieving optimal mechanical performance. Compressive, tensile, and flexural strengths improved by 22.75%, 25.5%, and 43.58% respectively, while workability decreased with 2% utilization of treated fiber content. Paver blocks cast with the optimized mix (CA15G2PB) exceeded the requirements of IS 15658:2006 for heavy traffic applications. Overall, the incorporation of CPA and GF significantly improved the mechanical characteristics, and microstructural investigation of concrete, highlighting their potential as eco‐friendly alternatives in modern construction.


  • Time series SAR interferometry approach for landslide identification in mountainous areas of Western Ghats, India

    by Suresh Devaraj, Kiran Yarrakula, Tapas Ranjan Martha, Geetha Priya Murugesan, Divya Sekhar Vaka, Samvedya Surampudi, Abhinav Wadhwa, Parthiban Loganathan, Venkatesh Budamala


  • Optimization of hybrid fibre reinforced geopolymer concrete using hardened and durability properties

    by Kadarkarai Arunkumar, Arunachalam Sureshkumar, Arunasankar Chithambar Ganesh, Loganathan Parthiban, Premkumar V


  • Open Access

    Effect of serpentine rock and its acidulated products as magnesium fertilisers for pasture, compared with magnesium oxide and Epsom salts, on a Pumice Soil. 1. Dry matter yield and magnesium uptake

    by J. A. Hanly, P. Loganathan, L. D. Currie

    Low pasture magnesium (Mg) intakes by grazing dairy and beef cows is a main cause of hypomagnesaemia in these animals soon after calving. Magnesium fertiliser application to pasture can increase pasture mixed‐herbage (hereafter “herbage”) Mg concentration and reduce the risk of this disorder. However, the effectiveness of Mg fertilisers is variable depending on fertiliser type and soil properties. A 32‐month Mg fertiliser field trial was conducted on dairy pasture on an Immature Orthic Pumice Soil (near Taupo, New Zealand; exchangeable Mg 0.4 cmol c kg –1 , pasture Mg 0.13%) to compare the effectiveness of a range of Mg fertilisers in elevating herbage Mg concentration. The fertilisers used were ground serpentine rock, three acidulated serpentine rock products, Epsom salts, and E‐mag (magnesium oxide). All fertilisers were applied at 100 kg Mg ha –1 at the start of the trial. The trial also had two treatments where Epsom salts was applied at 25 and 50 kg Mg ha –1 and a treatment where serpentine rock was reapplied during the second and third year at 100 kg Mg ha –1 . Magnesium fertiliser treatments did not affect pasture dry matter yield significantly at any harvest, however, the effect of treatments on herbage Mg concentration was highly significant ( P < 0.001) at all harvests. The single application of serpentine significantly increased herbage Mg concentration at 10 harvests, with five of these harvests having Mg concentrations ≥ 0.20%, which is generally considered to be the minimum “threshold level” for stock health. In comparison, the Mg concentration in pasture not receiving Mg fertiliser remained below the minimum threshold level throughout the trial. Application of serpentine rock annually further increased herbage Mg concentration and accumulation. The herbage Mg concentrations for this treatment were similar to those of the Epsom salts (50 kg Mg ha –1 ) treatment at the majority of the harvests. These results indicate that the annual application of serpentine rock may have potential as an alternative strategy to the application of more soluble Mg sources for raising herbage Mg concentration to levels considered adequate to meet stock health requirements. The more soluble Mg fertilisers—Epsom salts, the two serpentine‐superphosphate products, and an acidulated serpentine rock plus reactive phosphate rock product—had the greatest effect on increasing herbage Mg concentration and accumulation. These treatments increased herbage Mg concentration to ≥0.20% within 3–6 months after application and for the majority of harvests over the rest of the trial period. The effect of E‐mag on herbage Mg concentration was similar to that of serpentine rock during the first year, but the subsequent performance of E‐mag was similar to the more soluble Mg fertilisers.