Xin Qian
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Xin Qian has a total of 48 co-authors. Here are the top co-authors by number of shared publications:
- Yi Fang
College of Civil and Transportation Engineering, Hohai University, Nanjing, People’s Republic of China
7 shared publications - Jialai Wang
Department of Civil, Construction, and Environmental Engineering, The University of Alabama, Tuscaloosa, AL 35487, USA
4 shared publications Heng Yang
3 shared publicationsLiang Wang
3 shared publications- Liang Wang
School of Civil Engineering and Architecture, Anhui University of Science and Technology, Huainan, China
3 shared publications Mengxiao Li
3 shared publications
Latest Publications
- Open Access
- 4 June 2026
- Published by Elsevier in Developments in the Built Environment
- Vol. 27
Reconciling strength and alkalinity in cast-in-place ecological concrete via spray-induced phosphate mineralization
- 4 June 2026
- Published by Elsevier in Developments in the Built Environment
- Vol. 27
Open AccessReconciling strength and alkalinity in cast-in-place ecological concrete via spray-induced phosphate mineralization
- 20 August 2025
- Published by Elsevier in Construction and Building Materials
- Vol. 493
Improving the interfacial bonding between steel fiber and cement mortars using a bio-inspired functionalization
- 20 August 2025
- Published by Elsevier in Construction and Building Materials
- Vol. 493
Improving the interfacial bonding between steel fiber and cement mortars using a bio-inspired functionalization
- 26 July 2024
- Published by Elsevier in Journal of Building Engineering
- Vol. 95
Enhancing the hydration and micromechanical properties of C3A-gypsum systems with a plant-derived biomolecule
- 26 July 2024
- Published by Elsevier in Journal of Building Engineering
- Vol. 95
Enhancing the hydration and micromechanical properties of C3A-gypsum systems with a plant-derived biomolecule
- 13 December 2023
- Published by Elsevier in Cement and Concrete Composites
- Vol. 146
Ascorbic acid: A green admixture for eco-efficient metakaolin blended cement with enhanced properties and corrosion resistance
- 13 December 2023
- Published by Elsevier in Cement and Concrete Composites
- Vol. 146
Ascorbic acid: A green admixture for eco-efficient metakaolin blended cement with enhanced properties and corrosion resistance
- 30 July 2023
- Published by Elsevier in Journal of Cleaner Production
- Vol. 419
A bio-inspired mineral precipitation method to improve the freeze-thaw resistance of cement concrete pavement
- 30 July 2023
- Published by Elsevier in Journal of Cleaner Production
- Vol. 419
A bio-inspired mineral precipitation method to improve the freeze-thaw resistance of cement concrete pavement
- 28 June 2023
- Published by Elsevier in Cement and Concrete Composites
- Vol. 142
Nanosilica in-situ produced with sodium silicate as a performance enhancing additive for concretes
- 28 June 2023
- Published by Elsevier in Cement and Concrete Composites
- Vol. 142
Nanosilica in-situ produced with sodium silicate as a performance enhancing additive for concretes
- 21 August 2022
- Published by Elsevier in Journal of Cleaner Production
- Vol. 371
A clean dispersant for nano-silica to enhance the performance of cement mortars
- 21 August 2022
- Published by Elsevier in Journal of Cleaner Production
- Vol. 371
A clean dispersant for nano-silica to enhance the performance of cement mortars
- Open Access
- 1 August 2022
- Published by Elsevier in KSCE Journal of Civil Engineering
- Vol. 26 (9) , 4023-4037
Hydration, Compressive Strength and Durability of Eco-friendly Cement Mortars Containing Recycled Brick Powder and Metakaolin
- 1 August 2022
- Published by Elsevier in KSCE Journal of Civil Engineering
- Vol. 26 (9) , 4023-4037
Open AccessHydration, Compressive Strength and Durability of Eco-friendly Cement Mortars Containing Recycled Brick Powder and Metakaolin
- Open Access
Effect of Sulfur Content in Sulfate-Rich Copper Tailings on the Properties of MgO-Activated Slag Materials
The high-value utilization of sulfate-rich tailings (SRCTs) can accelerate their mass consumption, so the many problems caused by the massive accumulation of SRCTs can be alleviated, such as environmental pollution, land occupation, security risk, etc. This study proposes using SRCTs to replace fine natural aggregates in MgO-activated slag materials (MASMs) and investigate the influence of the sulfur content in SRCTs on the properties of MASMs. The experimental results showed that the 28 d compressive strength of MASM mortars was increased by up to 83% using SRCT composites. Two major mechanisms were discovered: additional hydration product formation and pore structure refinement. The results of XRD suggested that incorporating SRCT composite into MASMs increased the production of expansive sulfate-containing hydration products, such as ettringite, gypsum, and hydroxyl-Afm. The results of element mapping showed that the oxidation of pyrite in SRCTs could release sulfates into the surrounding area and participate in the hydration of MASM, indicating that SRCTs can work as an auxiliary activator for MASMs. Furthermore, the addition of SRCT significantly refined the pore structure of MASMs, leading to the reduction in porosity by up to 37.77%. These findings confirm a synergistic effect on activating the slag between SRCTs and MgO, promoting the mass utilization of SRCTs. As a result, the additional expansive hydration products contribute to the enhanced compressive strength and refined pore structure.
Open AccessEffect of Sulfur Content in Sulfate-Rich Copper Tailings on the Properties of MgO-Activated Slag Materials
The high-value utilization of sulfate-rich tailings (SRCTs) can accelerate their mass consumption, so the many problems caused by the massive accumulation of SRCTs can be alleviated, such as environmental pollution, land occupation, security risk, etc. This study proposes using SRCTs to replace fine natural aggregates in MgO-activated slag materials (MASMs) and investigate the influence of the sulfur content in SRCTs on the properties of MASMs. The experimental results showed that the 28 d compressive strength of MASM mortars was increased by up to 83% using SRCT composites. Two major mechanisms were discovered: additional hydration product formation and pore structure refinement. The results of XRD suggested that incorporating SRCT composite into MASMs increased the production of expansive sulfate-containing hydration products, such as ettringite, gypsum, and hydroxyl-Afm. The results of element mapping showed that the oxidation of pyrite in SRCTs could release sulfates into the surrounding area and participate in the hydration of MASM, indicating that SRCTs can work as an auxiliary activator for MASMs. Furthermore, the addition of SRCT significantly refined the pore structure of MASMs, leading to the reduction in porosity by up to 37.77%. These findings confirm a synergistic effect on activating the slag between SRCTs and MgO, promoting the mass utilization of SRCTs. As a result, the additional expansive hydration products contribute to the enhanced compressive strength and refined pore structure.
- Open Access
Bio-Based Admixture (Black Tea Extraction) for Better Performance of Metakaolin Blended Cement Mortars
With high pozzolanic reactivity, metakaolin (MK) is a popular supplementary cementitious material (SCM), which can be used to partially replace Portland cement in concretes. Due to its small particle size, however, MK can agglomerate, resulting in a nonuniform matrix and underperformance of the produced concrete. To address this issue, this paper exploits a low-cost, bio-based admixture—black tea extract (BTE)—to replace the traditional petroleum-based chemical admixture to enhance the dispersion and workability of MK blended cement mortars. Major biomolecules in the BTE such as caffeine, catechin, theanine, and theaflavin are rich in polyphenol, hydroxyl, and carboxylic acid groups, which can interact with cement particles and have profound effects on the hydration process and microstructure of the hydration products. Experimental studies showed that BTE does improve the workability of the MK blended cement mortar. More importantly, the BTE introduces significant change on the microstructure of the hardened pastes. Both the pores with size less than 50 nm and the total porosity of the hardened paste were significantly reduced, leading to a significant improvement in the micro- and macro-mechanical properties of the hardened paste. Experimental results suggest that up to 35% greater improvement in the compressive strength at 28 days was achieved using the proposed bio-admixture. Economic and environmental advantages of using the BTE as a renewable admixture were also illustrated through analyzing the cost–benefit, embodied carbon, and eco-efficiency of the MK blended mortars.
Open AccessBio-Based Admixture (Black Tea Extraction) for Better Performance of Metakaolin Blended Cement Mortars
With high pozzolanic reactivity, metakaolin (MK) is a popular supplementary cementitious material (SCM), which can be used to partially replace Portland cement in concretes. Due to its small particle size, however, MK can agglomerate, resulting in a nonuniform matrix and underperformance of the produced concrete. To address this issue, this paper exploits a low-cost, bio-based admixture—black tea extract (BTE)—to replace the traditional petroleum-based chemical admixture to enhance the dispersion and workability of MK blended cement mortars. Major biomolecules in the BTE such as caffeine, catechin, theanine, and theaflavin are rich in polyphenol, hydroxyl, and carboxylic acid groups, which can interact with cement particles and have profound effects on the hydration process and microstructure of the hydration products. Experimental studies showed that BTE does improve the workability of the MK blended cement mortar. More importantly, the BTE introduces significant change on the microstructure of the hardened pastes. Both the pores with size less than 50 nm and the total porosity of the hardened paste were significantly reduced, leading to a significant improvement in the micro- and macro-mechanical properties of the hardened paste. Experimental results suggest that up to 35% greater improvement in the compressive strength at 28 days was achieved using the proposed bio-admixture. Economic and environmental advantages of using the BTE as a renewable admixture were also illustrated through analyzing the cost–benefit, embodied carbon, and eco-efficiency of the MK blended mortars.