AWArmin Wittneben

Armin Wittneben

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Armin Wittneben has a total of 42 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Load Modulation for Backscatter Communication: Channel Capacity and Near-Capacity Schemes

    by Gregor Dumphart, Johannes Sager, Armin Wittneben

    In backscatter communication (BC), a passive tag transmits information by just affecting an external electromagnetic field through load modulation. Thereby, the feed current of the excited tag antenna is modulated by adapting the passive termination load. This paper studies the achievable information rates with a freely adaptable passive load. As a prerequisite, we unify monostatic, bistatic, and ambient BC with circuit-based system modeling. We present the crucial insight that channel capacity is described by existing results on peak-power-limited quadrature Gaussian channels, because the steady-state tag current phasor lies on a disk. Consequently, we derive the channel capacity for the case of an unmodulated external field, for general passive, purely reactive, or purely resistive tag loads. We find that modulating both resistance and reactance is important for very high rates. We discuss the capacity-achieving load statistics, rate asymptotics, technical conclusions, and rate losses from value-range-constrained loads (which are found to be small for moderate constraints). We then demonstrate that near-capacity rates can be attained by more practical schemes: (i) amplitude-and-phase-shift keying on the reflection coefficient and (ii) simple load circuits of a few switched resistors and capacitors. Finally, we draw conclusions for the ambient BC channel capacity in important special cases.


  • Open Access

    Pairwise Node Localization From Differences in Their UWB Channels to Observer Nodes

    by Gregor Dumphart, Robin Kramer, Robert Heyn, Marc Kuhn, Armin Wittneben

    We consider the problem of localization and distance estimation between a pair of wireless nodes in a multipath propagation environment, but not the usual way of processing a channel measurement between them. We propose a novel paradigm which compares the two nodes' ultra-wideband (UWB) channels to other nodes, called observers. The main idea is that the dissimilarity between the channel impulse responses (CIRs) increases with d and allows for an estimate $\hat{d}$ . Our approach relies on extracting common multipath components (MPCs) from the CIRs. This is realistic in indoor or urban scenarios and if d is considerably smaller than the distances to the observers. We present distance estimators which utilize the rich location information contained in MPC delay differences. Likewise, we present estimators for the relative position vector which process both MPC delays and MPC directions. We do so for various important cases: with and without time synchronization, delay measurement errors, and knowledge of the MPC association between the two CIRs. The estimators exhibit great technological advantages: they do not require line-of-sight conditions or knowledge about the observer locations or the environment. We study the estimation accuracy with a numerical evaluation based on random sampling and, additionally, with an experimental evaluation based on measurements in an indoor environment. The proposal shows the potential for great accuracy in theory and practice. We describe how the paradigm could be incorporated into established cooperative localization frameworks to provide them with novel inter- and intra-node measurements for spatio-temporal tracking. This could enable low-cost localization of wireless users or networks in dynamic multipath settings.


  • Open Access

    The Channel Capacity of General Complex-Valued Load Modulation for Backscatter Communication

    by Gregor Dumphart, Johannes Sager, Armin Wittneben

    This paper studies achievable information rates of backscatter communication systems where the tag performs load modulation with a freely adaptable passive termination. We find that the complex phasor of the tag current is constrained to a disk and that the capacity problem can therefore be described with existing results on peak-power-limited quadrature channels. This allows us to state the channel capacity and the capacity-achieving distribution of the load impedance, which is described by non-concentric circles in the right half-plane. For the low-SNR case (SNR < 4.8 dB) we find that channel capacity is achieved by a purely reactive load with Cauchy-distributed reactance. The exposition is based on a system model that abstracts all relevant classes of backscatter communication systems, including RFID. To address practicality, we construct a symbol alphabet that allows for a near-capacity information rate of more than 6 bit per load-switching period at reasonably high SNR. We also find that the rate hardly decreases when typical value-range constraints are imposed on the load impedance.

  • Open Access

    Pairwise Distance and Position Estimators From Differences in UWB Channels to Observers

    by Gregor Dumphart, Robin Kramer, Armin Wittneben

    We consider the problem of obtaining relative location information between two wireless nodes from the differences in their ultra-wideband (UWB) channels to observer nodes. Our approach focuses on the delays of multipath components (MPCs) extracted from the observed channels. For the two different cases of known and unknown MPC association between these channels, we present estimators for the distance and for the relative position vector between the two nodes. The position estimators require both MPC directions and MPC delays as input. All presented estimators exhibit very desirable technological properties: they do not require line-of-sight conditions, precise synchronization, or knowledge about the observer locations or about the environment. These advantages could enable low-cost wireless network localization in dynamic multipath environments. The exposition is complemented by a numerical evaluation of the estimation accuracy using random sampling, where especially the position estimators show the potential for great accuracy.

  • Open Access

    Practical Accuracy Limits of Radiation-Aware Magneto-Inductive 3D Localization

    by Gregor Dumphart, Henry Schulten, Bharat Bhatia, Christoph Sulser, Armin Wittneben

    The key motivation for the low-frequency magnetic localization approach is that magnetic near-fields are well predictable by a free-space model, which should enable accurate localization. Yet, limited accuracy has been reported for practical systems and it is unclear whether the inaccuracies are caused by field distortion due to nearby conductors, unconsidered radiative propagation, or measurement noise. Hence, we investigate the practical performance limits by means of a calibrated magnetoinductive system which localizes an active single-coil agent with arbitrary orientation, using 4 mW transmit power at 500 kHz. The system uses eight single-coil anchors around a 3m x 3m area in an office room. We base the location estimation on a complex baseband model which comprises both reactive and radiative propagation. The link coefficients, which serve as input data for location estimation, are measured with a multiport network analyzer while the agent is moved with a positioner device. This establishes a reliable ground truth for calibration and evaluation. The system achieves a median position error of 3.2 cm and a 90th percentile of 8.3 cm. After investigating the model error we conjecture that field distortion due to conducting building structures is the main cause of the performance bottleneck. The results are complemented with predictions on the achievable accuracy in more suitable circumstances using the Cram\'er-Rao lower bound.

  • Open Access

    Inter-Node Distance Estimation from Multipath Delay Differences of Channels to Observer Nodes

    by Gregor Dumphart, Marc Kuhn, Armin Wittneben, Florian Trösch

    We study the estimation of distance d between two wireless nodes by means of their wideband channels to a third node, called observer. The motivating principle is that the channel impulse responses are similar for small d and drift apart when d increases. Following this idea we propose specific distance estimators based on the differences of path delays of the extractable multipath components. In particular, we derive such estimators for rich multipath environments and various important cases: with and without clock synchronization as well as errors on the extracted path delays (e.g. due to limited bandwidth). The estimators readily support (and benefit from) the presence of multiple observers. We present an error analysis and, using ray tracing in an exemplary indoor environment, show that the estimators perform well in realistic conditions. We describe possible localization applications of the proposed scheme and highlight its major advantages: it requires neither precise synchronization nor line-of-sight connection. This could make wireless user tracking feasible in dynamic indoor settings.

  • Open Access

    Magneto-Inductive Powering and Uplink of In-Body Microsensors: Feasibility and High-Density Effects

    by Gregor Dumphart, Bertold Ian Bitachon, Armin Wittneben

    This paper studies magnetic induction for wireless powering and the data uplink of microsensors, in particular for future medical in-body applications. We consider an external massive coil array as power source (1 W) and data sink. For sensor devices at 12 cm distance from the array, e.g. beneath the human skin, we compute a minimum coil size of 150 um assuming 50 nW required chip activation power and operation at 750 MHz. A 275 um coil at the sensor allows for 1 Mbit/s uplink rate. Moreover, we study resonant sensor nodes in dense swarms, a key aspect of envisioned biomedical applications. In particular, we investigate the occurring passive relaying effect and cooperative transmit beamforming in the uplink. We show that the frequency- and location-dependent signal fluctuations in such swarms allow for significant performance gains when utilized with adaptive matching, spectrally-aware signaling and node cooperation. The work is based on a general magneto-inductive MIMO system model, which is introduced first.

  • Open Access

    Robust Near-Field 3D Localization of an Unaligned Single-Coil Agent Using Unobtrusive Anchors

    by Gregor Dumphart, Eric Slottke, Armin Wittneben

    The magnetic near-field provides a suitable means for indoor localization, due to its insensitivity to the environment and strong spatial gradients. We consider indoor localization setups consisting of flat coils, allowing for convenient integration of the agent coil into a mobile device (e.g., a smart phone or wristband) and flush mounting of the anchor coils to walls. In order to study such setups systematically, we first express the Cram\'er-Rao lower bound (CRLB) on the position error for unknown orientation and evaluate its distribution within a square room of variable size, using 15 x 10cm anchor coils and a commercial NFC antenna at the agent. Thereby, we find cm-accuracy being achievable in a room of 10 x 10 x 3 meters with 12 flat wall-mounted anchors and with 10mW used for the generation of magnetic fields. Practically achieving such estimation performance is, however, difficult because of the non-convex 5D likelihood function. To that end, we propose a fast and accurate weighted least squares (WLS) algorithm which is insensitive to initialization. This is enabled by effectively eliminating the orientation nuisance parameter in a rigorous fashion and scaling the individual anchor observations, leading to a smoothed 3D cost function. Using WLS estimates to initialize a maximum-likelihood (ML) solver yields accuracy near the theoretical limit in up to 98% of cases, thus enabling robust indoor localization with unobtrusive infrastructure, with a computational efficiency suitable for real-time processing.

  • Open Access

    Magneto-inductive Passive Relaying in Arbitrarily Arranged Networks

    by Gregor Dumphart, Eric Slottke, Armin Wittneben

    We consider a wireless sensor network that uses inductive near-field coupling for wireless powering or communication, or for both. The severely limited range of an inductively coupled source-destination pair can be improved using resonant relay devices, which are purely passive in nature. Utilization of such magneto-inductive relays has only been studied for regular network topologies, allowing simplified assumptions on the mutual antenna couplings. In this work we present an analysis of magneto-inductive passive relaying in arbitrarily arranged networks. We find that the resulting channel has characteristics similar to multipath fading: the channel power gain is governed by a non-coherent sum of phasors, resulting in increased frequency selectivity. We propose and study two strategies to increase the channel power gain of random relay networks: i) deactivation of individual relays by open-circuit switching and ii) frequency tuning. The presented results show that both methods improve the utilization of available passive relays, leading to reliable and significant performance gains.

  • Single-anchor localization in inductively coupled sensor networks using passive relays and load switching

    by Eric Slottke, Armin Wittneben

    Wireless physical layers based on inductive coupling are receiving attention in the context of RFID and, more recently, sensor networks. In this work we present the first method for localization in inductively coupled networks which only requires a single anchor. The utilization of passive relays with known positions resolves the associated problem of localization ambiguity. We demonstrate that a single impedance measurement can be sufficient to locate a node in two dimensions. Localization performance can further be increased by deterministic load switching. Numerical results indicate that a median localization error in the millimeter range is possible under realistic conditions.