Heechang Moon
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Heechang Moon has a total of 38 co-authors. Here are the top co-authors by number of shared publications:
Bongsang Kim
3 shared publications- Bongsang Kim2 shared publications
- Heeseok Shin
Convergence Major for Intelligent Drone, Department of Aerospace Systems Engineering Sejong University, Seoul 05006, Republic of Korea
2 shared publications - Jeonghoon Kwak
AI+X Research Center, Advanced Institute of Convergence Technology (AICT), Suwon 16229, Republic of Korea
2 shared publications - Kyuho Lee
Autonomous Vehicle Intelligent Robotics, Industrial Convergence Interdepartmental Program, Hongik University, Seoul 04066, Republic of Korea
2 shared publications - Myeong-Jun Kim
Department of Electrical and Control Engineering, Cheongju University, Cheongju 28503, Republic of Korea
2 shared publications
Latest Publications
- Open Access
Mobile-Master-Vehicle-Based LiDAR Perception and Centralized Control of Sensor-Light Slave Vehicles
This study presents an asymmetric cooperative perception-and-control architecture in which a sensor-rich mobile master vehicle performs external perception, state estimation, motion planning, and path-tracking control for sensor-light slave vehicles. The proposed vehicle-model-aided LiDAR tracking (VMALT) method combines ego-motion-compensated LiDAR measurements with transmitted speed and steering commands through a kinematic bicycle model. In physical-vehicle experiments, VMALT reduced the slave-position RMSE from 0.36 m with a LiDAR-only constant-velocity Kalman filter to 0.32 m, corresponding to an 11.1% improvement. The estimated state was subsequently used for closed-loop speed and path-tracking control of the physical slave vehicle. Scalability was evaluated using a one-master–two-slave configuration over three separate runs comprising circular and linear paths and geometrically identified line-of-sight-overlap candidates. Concurrent two-target LiDAR availability ranged from 96.465% to 99.934%, with a maximum interior observation gap of 0.10 s. The VMALT trajectories expressed in the GPS coordinate frame followed the position and direction of both slave vehicles, with heading RMSEs ranging from to . In an LTE-tethering communication test, all 2400 UDP packets were returned, with median and 99th-percentile round-trip times of 4.654 and 8.220 ms, respectively. These results demonstrate the feasibility of centralized perception and control for multiple sensor-light vehicles under the evaluated low-speed operating conditions.Open AccessMobile-Master-Vehicle-Based LiDAR Perception and Centralized Control of Sensor-Light Slave Vehicles
This study presents an asymmetric cooperative perception-and-control architecture in which a sensor-rich mobile master vehicle performs external perception, state estimation, motion planning, and path-tracking control for sensor-light slave vehicles. The proposed vehicle-model-aided LiDAR tracking (VMALT) method combines ego-motion-compensated LiDAR measurements with transmitted speed and steering commands through a kinematic bicycle model. In physical-vehicle experiments, VMALT reduced the slave-position RMSE from 0.36 m with a LiDAR-only constant-velocity Kalman filter to 0.32 m, corresponding to an 11.1% improvement. The estimated state was subsequently used for closed-loop speed and path-tracking control of the physical slave vehicle. Scalability was evaluated using a one-master–two-slave configuration over three separate runs comprising circular and linear paths and geometrically identified line-of-sight-overlap candidates. Concurrent two-target LiDAR availability ranged from 96.465% to 99.934%, with a maximum interior observation gap of 0.10 s. The VMALT trajectories expressed in the GPS coordinate frame followed the position and direction of both slave vehicles, with heading RMSEs ranging from to . In an LTE-tethering communication test, all 2400 UDP packets were returned, with median and 99th-percentile round-trip times of 4.654 and 8.220 ms, respectively. These results demonstrate the feasibility of centralized perception and control for multiple sensor-light vehicles under the evaluated low-speed operating conditions. - Open Access
Backstepping-Based Recursive Virtual-Heading Path-Tracking Control for Reverse Driving of a Multi-Trailer System
Reverse path tracking of multi-trailer systems is challenging because tractor steering affects the following bodies only through passive hitch joints, causing tracking-error propagation and increasing the risk of jackknifing. This paper proposes a backstepping-based recursive virtual-heading (BS-RVH) controller that converts the path-tracking error of the final trailer into a desired heading rate and recursively generates the desired hitch angles, preceding-body heading rates, and tractor steering command. Desired hitch-angle saturation is included, and local boundedness and the effect of saturation residuals are analyzed. For a tractor–two-trailer system, BS-RVH achieves lateral root-mean-square errors of 0.015 m, 0.021 m, and 0.013 m on the S-curve, circular, and figure-eight paths, respectively. These values represent reductions of 93.0–93.4% compared with the curvature-based controller. The maximum absolute hitch angles remain below 12°, and all paths reach the predefined 99.5% completion threshold without jackknifing. An additional tractor–three-trailer evaluation completes the same paths without jackknifing, with lateral root-mean-square errors ranging from 0.073 m to 0.112 m. These results demonstrate the effectiveness and stage-wise extensibility of BS-RVH under low-speed kinematic conditions.
Open AccessBackstepping-Based Recursive Virtual-Heading Path-Tracking Control for Reverse Driving of a Multi-Trailer System
Reverse path tracking of multi-trailer systems is challenging because tractor steering affects the following bodies only through passive hitch joints, causing tracking-error propagation and increasing the risk of jackknifing. This paper proposes a backstepping-based recursive virtual-heading (BS-RVH) controller that converts the path-tracking error of the final trailer into a desired heading rate and recursively generates the desired hitch angles, preceding-body heading rates, and tractor steering command. Desired hitch-angle saturation is included, and local boundedness and the effect of saturation residuals are analyzed. For a tractor–two-trailer system, BS-RVH achieves lateral root-mean-square errors of 0.015 m, 0.021 m, and 0.013 m on the S-curve, circular, and figure-eight paths, respectively. These values represent reductions of 93.0–93.4% compared with the curvature-based controller. The maximum absolute hitch angles remain below 12°, and all paths reach the predefined 99.5% completion threshold without jackknifing. An additional tractor–three-trailer evaluation completes the same paths without jackknifing, with lateral root-mean-square errors ranging from 0.073 m to 0.112 m. These results demonstrate the effectiveness and stage-wise extensibility of BS-RVH under low-speed kinematic conditions.
- 31 August 2026
- Published by The Korea Robotics Society in Journal of Korea Robotics Society
- Vol. 21 (3) , 379-387
Experimental Study and Performance Analysis of RDDF-based Autonomous Navigation for Quadruped Robots in Unstructured Snow-covered Outdoor Environments
- 31 August 2026
- Published by The Korea Robotics Society in Journal of Korea Robotics Society
- Vol. 21 (3) , 379-387
Experimental Study and Performance Analysis of RDDF-based Autonomous Navigation for Quadruped Robots in Unstructured Snow-covered Outdoor Environments
- 31 May 2025
- Published by The Korea Robotics Society in Journal of Korea Robotics Society
- Vol. 20 (2) , 277-284
Performance Comparison of Low-Cost GPS Modules and Development of a Position Correction Algorithm Using Positional Relationships
- 31 May 2025
- Published by The Korea Robotics Society in Journal of Korea Robotics Society
- Vol. 20 (2) , 277-284
Performance Comparison of Low-Cost GPS Modules and Development of a Position Correction Algorithm Using Positional Relationships
- 1 May 2025
- Published by Institute of Control, Robotics and Systems in Journal of Institute of Control, Robotics and Systems
- Vol. 31 (5) , 502-509
Improvement of Localization Algorithm for Indoor and Outdoor Navigation of Autonomous Robots
Location estimation for waypoint-based autonomous driving robots primarily relies on SLAM (Simultaneous Localization and Mapping) and GNSS (Global Navigation Satellite System) technologies. GNSS performs well in open areas but struggles with signal issues, while SLAM offers high accuracy in feature-rich environments but faces challenges in open spaces. This study integrates SLAM and GNSS, enabling seamless switching between systems when one encounters difficulties. The combined system ensures consistency by aligning coordinate systems and directional data. Experiments in indoor, forest, and open environments demonstrate that the switching algorithm enables stable autonomous driving in diverse conditions, effectively leveraging the strengths of both systems.
- 1 May 2025
- Published by Institute of Control, Robotics and Systems in Journal of Institute of Control, Robotics and Systems
- Vol. 31 (5) , 502-509
Improvement of Localization Algorithm for Indoor and Outdoor Navigation of Autonomous Robots
Location estimation for waypoint-based autonomous driving robots primarily relies on SLAM (Simultaneous Localization and Mapping) and GNSS (Global Navigation Satellite System) technologies. GNSS performs well in open areas but struggles with signal issues, while SLAM offers high accuracy in feature-rich environments but faces challenges in open spaces. This study integrates SLAM and GNSS, enabling seamless switching between systems when one encounters difficulties. The combined system ensures consistency by aligning coordinate systems and directional data. Experiments in indoor, forest, and open environments demonstrate that the switching algorithm enables stable autonomous driving in diverse conditions, effectively leveraging the strengths of both systems.
- 18 March 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Robotics & Automation Magazine
- Vol. 31 (1) , 123-132
Autonomous Robot Racing Competitions: Truly Multivehicle Autonomous Racing Competitions [Competitions]
Autonomous car racing competitions have become widespread across many countries and events, taking inspiration from renowned motorsports like Formula 1 and IndyCar, among others. Similar to how traditional motorsports have fueled advancements in automotive technology, researchers and students are now anticipating similar contributions from autonomous car racing competitions. Betz et al. have provided a comprehensive review of the current landscape of autonomous car racing in [1] . These competitions feature a diverse range of robot cars, varying in scale from 1:10 to full-scale (refer to Table 1 for specifics). The size differences also extend to the sensory and computing systems employed. While many of these events are tailored for educational purposes, targeting students from high school to postgraduate programs, it is noted that smaller-scale hardware systems may not necessarily utilize the same sensory and computing systems as their real-scale counterparts. This, however, does not imply that the technical challenges in algorithm and program development are any less demanding than those encountered in full-scale or near full-scale cases. The variations in sensory, computing, and hardware resources due to the size differences may give rise to distinct technical problems not encountered by autonomous cars navigating real-world road environments. Nevertheless, fundamental issues, such as planning, motion control, and real-time recognition with onboard systems are common for both scales.
- 18 March 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Robotics & Automation Magazine
- Vol. 31 (1) , 123-132
Autonomous Robot Racing Competitions: Truly Multivehicle Autonomous Racing Competitions [Competitions]
Autonomous car racing competitions have become widespread across many countries and events, taking inspiration from renowned motorsports like Formula 1 and IndyCar, among others. Similar to how traditional motorsports have fueled advancements in automotive technology, researchers and students are now anticipating similar contributions from autonomous car racing competitions. Betz et al. have provided a comprehensive review of the current landscape of autonomous car racing in [1] . These competitions feature a diverse range of robot cars, varying in scale from 1:10 to full-scale (refer to Table 1 for specifics). The size differences also extend to the sensory and computing systems employed. While many of these events are tailored for educational purposes, targeting students from high school to postgraduate programs, it is noted that smaller-scale hardware systems may not necessarily utilize the same sensory and computing systems as their real-scale counterparts. This, however, does not imply that the technical challenges in algorithm and program development are any less demanding than those encountered in full-scale or near full-scale cases. The variations in sensory, computing, and hardware resources due to the size differences may give rise to distinct technical problems not encountered by autonomous cars navigating real-world road environments. Nevertheless, fundamental issues, such as planning, motion control, and real-time recognition with onboard systems are common for both scales.
- 1 September 2023
- Published by The Korea Robotics Society in Journal of Korea Robotics Society
- Vol. 18 (3) , 251-259
A Fusion Algorithm of Pure Pursuit and Velocity Planning to Improve the Path Following Performance of Differential Driven Robots in Unstructured Environments
- 1 September 2023
- Published by The Korea Robotics Society in Journal of Korea Robotics Society
- Vol. 18 (3) , 251-259
A Fusion Algorithm of Pure Pursuit and Velocity Planning to Improve the Path Following Performance of Differential Driven Robots in Unstructured Environments
- 30 July 2020
- Published by The Korea Robotics Society in Journal of Korea Robotics Society
- Vol. 15 (3) , 221-232
Slip Detection and Control Algorithm to Improve Path Tracking Performance of Four-Wheel Independently Actuated Farming Platform
- 30 July 2020
- Published by The Korea Robotics Society in Journal of Korea Robotics Society
- Vol. 15 (3) , 221-232
Slip Detection and Control Algorithm to Improve Path Tracking Performance of Four-Wheel Independently Actuated Farming Platform