Huaizhou Yang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Huaizhou Yang has a total of 36 co-authors. Here are the top co-authors by number of shared publications:
- Hero Jan Heeres
University of Groningen Nijenborgh 3
5 shared publications - Peter Joseph Deuss
University of Groningen Nijenborgh 3
3 shared publications Zhiwen Wang
Department of Chemical Engineering, ENTEG, University of Groningen, Nijenborgh 4, 9747 AG Groningen, The Netherlands
3 shared publicationsWang Yin
Fujian Universities Engineering Research Center of Reactive Distillation Technology, College of Chemical Engineering, Fuzhou University, Fuzhou 350116, Fujian, China
2 shared publications- Ali Mohamed Abdel-Mageed
Leibniz Institute for Catalysis (LIKAT) Rostock Germany
1 shared publication Anna Liutkova
Laboratory of Inorganic Materials and Catalysis, Department of Chemical Engineering and Chemistry, Eindhoven University of Technology, 5600 MB Eindhoven, The Netherlands
1 shared publication
Latest Publications
- Open Access
- 20 December 2024
- Published by Elsevier in Applied Catalysis B: Environment and Energy
- Vol. 365
One-pot synthesis of alanine from glycerol without additional H2 over a rutile-supported Ru catalyst
- 20 December 2024
- Published by Elsevier in Applied Catalysis B: Environment and Energy
- Vol. 365
Open AccessOne-pot synthesis of alanine from glycerol without additional H2 over a rutile-supported Ru catalyst
- Top Cited PapersOpen Access
- 17 September 2024
- Published by American Chemical Society (ACS) in Chemical Reviews
- Vol. 124 (19) , 10701-10876
Benzenoid Aromatics from Renewable Resources
In this Review, all known chemical methods for the conversion of renewable resources into benzenoid aromatics are summarized. The raw materials that were taken into consideration are CO2; lignocellulose and its constituents cellulose, hemicellulose, and lignin; carbohydrates, mostly glucose, fructose, and xylose; chitin; fats and oils; terpenes; and materials that are easily obtained via fermentation, such as biogas, bioethanol, acetone, and many more. There are roughly two directions. One much used method is catalytic fast pyrolysis carried out at high temperatures (between 300 and 700 °C depending on the raw material), which leads to the formation of biochar; gases, such as CO, CO2, H2, and CH4; and an oil which is a mixture of hydrocarbons, mostly aromatics. The carbon selectivities of this method can be reasonably high when defined small molecules such as methanol or hexane are used but are rather low when highly oxygenated compounds such as lignocellulose are used. The other direction is largely based on the multistep conversion of platform chemicals obtained from lignocellulose, cellulose, or sugars and a limited number of fats and terpenes. Much research has focused on furan compounds such as furfural, 5-hydroxymethylfurfural, and 5-chloromethylfurfural. The conversion of lignocellulose to xylene via 5-chloromethylfurfural and dimethylfuran has led to the construction of two large-scale plants, one of which has been operational since 2023.
- 17 September 2024
- Published by American Chemical Society (ACS) in Chemical Reviews
- Vol. 124 (19) , 10701-10876
Top Cited PapersOpen AccessBenzenoid Aromatics from Renewable Resources
In this Review, all known chemical methods for the conversion of renewable resources into benzenoid aromatics are summarized. The raw materials that were taken into consideration are CO2; lignocellulose and its constituents cellulose, hemicellulose, and lignin; carbohydrates, mostly glucose, fructose, and xylose; chitin; fats and oils; terpenes; and materials that are easily obtained via fermentation, such as biogas, bioethanol, acetone, and many more. There are roughly two directions. One much used method is catalytic fast pyrolysis carried out at high temperatures (between 300 and 700 °C depending on the raw material), which leads to the formation of biochar; gases, such as CO, CO2, H2, and CH4; and an oil which is a mixture of hydrocarbons, mostly aromatics. The carbon selectivities of this method can be reasonably high when defined small molecules such as methanol or hexane are used but are rather low when highly oxygenated compounds such as lignocellulose are used. The other direction is largely based on the multistep conversion of platform chemicals obtained from lignocellulose, cellulose, or sugars and a limited number of fats and terpenes. Much research has focused on furan compounds such as furfural, 5-hydroxymethylfurfural, and 5-chloromethylfurfural. The conversion of lignocellulose to xylene via 5-chloromethylfurfural and dimethylfuran has led to the construction of two large-scale plants, one of which has been operational since 2023.
- Open Access
- 21 July 2023
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry Letters
- Vol. 14 (30) , 6778-6783
Pt/CeO2 as Catalyst for Nonoxidative Coupling of Methane: Oxidative Regeneration
- 21 July 2023
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry Letters
- Vol. 14 (30) , 6778-6783
Open AccessPt/CeO2 as Catalyst for Nonoxidative Coupling of Methane: Oxidative Regeneration
- Open Access
- 15 February 2023
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 11 (8) , 3170-3181
Solvent-Free Catalytic Hydrotreatment of Alcell Lignin Using Mono- and Bimetallic Ni(Mo) Catalysts Supported on Mesoporous Alumina
- 15 February 2023
- Published by American Chemical Society (ACS) in ACS Sustainable Chemistry & Engineering
- Vol. 11 (8) , 3170-3181
Open AccessSolvent-Free Catalytic Hydrotreatment of Alcell Lignin Using Mono- and Bimetallic Ni(Mo) Catalysts Supported on Mesoporous Alumina
- Open Access
- 10 November 2022
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 36 (23) , 14281-14291
Catalytic Hydrotreatment of Biomass-Derived Fast Pyrolysis Liquids Using Ni and Cu-Based PRICAT Catalysts
- 10 November 2022
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 36 (23) , 14281-14291
Open AccessCatalytic Hydrotreatment of Biomass-Derived Fast Pyrolysis Liquids Using Ni and Cu-Based PRICAT Catalysts
- Open Access
- 8 November 2022
- Published by University of Groningen Press
Biobased Aromatic Chemicals by Lignin Depolymerization and Defunctionalization
- 8 November 2022
- Published by University of Groningen Press
Open AccessBiobased Aromatic Chemicals by Lignin Depolymerization and Defunctionalization
- Open Access
- 30 June 2022
- Published by Wiley in ChemCatChem
- Vol. 14 (16)
Selective Demethoxylation of Guaiacols to Phenols using Supported MoO3 Catalysts
Lignin‐derived monomers with methoxy substituents are abundantly present in bioliquids derived from lignocellulosic biomass. Examples are the products obtained from the reductive catalytic fractionation of lignin (RCF) and pyrolysis of lignocellulosic biomass and hydrotreated products thereof. An attractive valorization step for these liquids involves demethoxylation to obtain alkylated phenols through selective catalytic hydrodeoxygenation (HDO). Within the context of sustainable chemistry, there is a strong drive to use cheap, non‐precious metal catalysts for this purpose. In this study, the HDO of guaiacol (5 wt% in toluene) was investigated in a continuous fixed‐bed reactor at 380 °C, 20 bar over supported MoO3 catalysts. MoO3 (5 %) supported on TiO2 (P25) was shown to give superior performance compared with MoO3 supported on anatase TiO2, Al2O3, SiO2, Nb2O5, CeO2, and ZrO2. Additional studies involving variation of the Mo loading and process conditions were performed, and the highest selectivity to demethoxylated phenolics like phenol and methylated phenols was 82 % at 97 % conversion of guaiacol. Both 4‐n‐propylguaiacol and a realistic guaiacols‐rich feed isolated from a representative pyrolysis oil were also successfully demethoxylated with the 5 % MoO3/TiO2 catalyst.
- 30 June 2022
- Published by Wiley in ChemCatChem
- Vol. 14 (16)
Open AccessSelective Demethoxylation of Guaiacols to Phenols using Supported MoO3 Catalysts
Lignin‐derived monomers with methoxy substituents are abundantly present in bioliquids derived from lignocellulosic biomass. Examples are the products obtained from the reductive catalytic fractionation of lignin (RCF) and pyrolysis of lignocellulosic biomass and hydrotreated products thereof. An attractive valorization step for these liquids involves demethoxylation to obtain alkylated phenols through selective catalytic hydrodeoxygenation (HDO). Within the context of sustainable chemistry, there is a strong drive to use cheap, non‐precious metal catalysts for this purpose. In this study, the HDO of guaiacol (5 wt% in toluene) was investigated in a continuous fixed‐bed reactor at 380 °C, 20 bar over supported MoO3 catalysts. MoO3 (5 %) supported on TiO2 (P25) was shown to give superior performance compared with MoO3 supported on anatase TiO2, Al2O3, SiO2, Nb2O5, CeO2, and ZrO2. Additional studies involving variation of the Mo loading and process conditions were performed, and the highest selectivity to demethoxylated phenolics like phenol and methylated phenols was 82 % at 97 % conversion of guaiacol. Both 4‐n‐propylguaiacol and a realistic guaiacols‐rich feed isolated from a representative pyrolysis oil were also successfully demethoxylated with the 5 % MoO3/TiO2 catalyst.
- Open Access
- 2 June 2022
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 36 (12) , 6606-6610
Enhanced Catalytic Depolymerization of a Kraft Lignin by a Mechanochemical Approach
- 2 June 2022
- Published by American Chemical Society (ACS) in Energy & Fuels
- Vol. 36 (12) , 6606-6610
Open AccessEnhanced Catalytic Depolymerization of a Kraft Lignin by a Mechanochemical Approach