Bruna de Araújo Braga
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Bruna de Araújo Braga has a total of 10 co-authors. Here are the top co-authors by number of shared publications:
- Alessandra Silva Batista
Universidade de São Paulo
1 shared publication - Bruno Monteiro Balboni
Stellenbosch University, Stellenbosch, South Africa
1 shared publication - Emeli Susane Costa Gomes
Universidade Federal de Santa Catarina
1 shared publication - Jobert Silva da Rocha
Universidade Federal do Paraná – UFPR, Curitiba, PR, Brasil
1 shared publication - José Nivaldo Garcia
Universidade de São Paulo
1 shared publication - Luciana Duque Silva
Universidade de São Paulo
1 shared publication
Latest Publications
- 1 September 2022
- Published by SAGE Publications in International Wood Products Journal
- Vol. 13 (4) , 255-262
Evaluation of the potential use of Amazonian palm species for the production of edge-glued panels
The potential of Attalea maripa and Attalea speciosa was evaluated for the production of edge-glued panels. The chemical and physical properties and the quality of the bonding of the species and mixed treatment between them, under different conditions, were evaluated. The length bonding was performed with polyvinyl acetate (PVA) adhesive and the side with PVA and emulsion polymer isocyanate (EPI) in two spreading rates. The species A. maripa has a lower content of extractives in cold and hot water, total extractives, ash and pH, and higher density compared to A. speciosa. The tangential, radial and volumetric shrinkage and shrinkage anisotropy of the species were statistically equal. On the length bonding, only in the tensile test after drying pre-treatment were the requirements of the technical standards not met. As regards side bonding, the treatments of A. maripa and mixed joints with EPI reached the standard for the pre-treatment in cold water.
- 1 September 2022
- Published by SAGE Publications in International Wood Products Journal
- Vol. 13 (4) , 255-262
Evaluation of the potential use of Amazonian palm species for the production of edge-glued panels
The potential of Attalea maripa and Attalea speciosa was evaluated for the production of edge-glued panels. The chemical and physical properties and the quality of the bonding of the species and mixed treatment between them, under different conditions, were evaluated. The length bonding was performed with polyvinyl acetate (PVA) adhesive and the side with PVA and emulsion polymer isocyanate (EPI) in two spreading rates. The species A. maripa has a lower content of extractives in cold and hot water, total extractives, ash and pH, and higher density compared to A. speciosa. The tangential, radial and volumetric shrinkage and shrinkage anisotropy of the species were statistically equal. On the length bonding, only in the tensile test after drying pre-treatment were the requirements of the technical standards not met. As regards side bonding, the treatments of A. maripa and mixed joints with EPI reached the standard for the pre-treatment in cold water.
- Open Access
- 31 July 2022
- Published by Editoriales Iberoamericanos in Revista Ibero-Americana de Ciências Ambientais
- Vol. 13 (7) , 1-9
Wood properties and growth of Cunninghamia lanceolata: a natural alternative for treated Pinus sp. timber
Cunninghamia lanceolata (Chinese fir) is the main timber species in China with desirable wood properties and silviculture characteristics and has a high potential to be planted in Brazil. We aimed to assess selected wood properties of C. lanceolata from an experimental plantation in São Paulo, Brazil, since there is no information about this timber grown in Brazil. We also assessed the growth and increment rate of this plantation. Despite its low density (434 kg m-3), C. lanceolata timber has good mechanical properties, as well as low shrinkage. The studied timber showed superior properties than most Pinus sp. planted in Brazil and Eucalyptus grandis, especially when considering the strength to weight ratio. Together with its known high durability, our results show that C. lanceolata has potential for many applications from furniture to engineered products for structural purposes. The increment rate of the stand was low, probably because of the lack of management practices. But the species has high growth potential, reaching 41 m-3 ha-1 year-1 in China. After genetic improvement and under proper management, Cunninghamia lanceolata can be an ally of the Timber Industry in Brazil and other countries with adequate climate for the species and be used as a substitute to treated Pinus sp. wood.
- 31 July 2022
- Published by Editoriales Iberoamericanos in Revista Ibero-Americana de Ciências Ambientais
- Vol. 13 (7) , 1-9
Open AccessWood properties and growth of Cunninghamia lanceolata: a natural alternative for treated Pinus sp. timber
Cunninghamia lanceolata (Chinese fir) is the main timber species in China with desirable wood properties and silviculture characteristics and has a high potential to be planted in Brazil. We aimed to assess selected wood properties of C. lanceolata from an experimental plantation in São Paulo, Brazil, since there is no information about this timber grown in Brazil. We also assessed the growth and increment rate of this plantation. Despite its low density (434 kg m-3), C. lanceolata timber has good mechanical properties, as well as low shrinkage. The studied timber showed superior properties than most Pinus sp. planted in Brazil and Eucalyptus grandis, especially when considering the strength to weight ratio. Together with its known high durability, our results show that C. lanceolata has potential for many applications from furniture to engineered products for structural purposes. The increment rate of the stand was low, probably because of the lack of management practices. But the species has high growth potential, reaching 41 m-3 ha-1 year-1 in China. After genetic improvement and under proper management, Cunninghamia lanceolata can be an ally of the Timber Industry in Brazil and other countries with adequate climate for the species and be used as a substitute to treated Pinus sp. wood.
- Open Access
- 20 October 2021
- Published by Editoriales Iberoamericanos in Revista Ibero-Americana de Ciências Ambientais
- Vol. 12 (10) , 25-34
Comportamento cronológico do fator de forma artificial do Pinus caribaea var. hondurensis em sítios Amazônicos
Atualmente, as atividades de reflorestamento estão cada vez mais consolidadas e difundidas no Brasil, especialmente por conta de seus benefícios ambientais, sociais e econômicos. Dessa forma, em um contexto associado ao uso do solo na Amazônia Central brasileira, a prática de reflorestamento torna-se ainda mais atrativa, pois além de importantes ganhos ecológicos relacionados a conservação florestal e restauração de áreas degradadas, incluem vantagens financeiras com programas de restauração e estoque de carbono atmosférico. No entanto, para implementação de reflorestamentos em larga escala nessa região necessita-se de pesquisas sobre a seleção de espécies promissoras que sejam adaptáveis as condições ambientais locais. Diante disso, o presente trabalho teve como objetivo avaliar a evolução do fator de forma artificial para a espécie Pinus caribaea var. hondurensis em diferentes classes de idades e sítios em plantios experimentais instalados na Amazônia Central. Com isso, busca-se acessar novas informações a respeito do potencial silvicultural da espécie para região, tendo em vista que o conhecimento da variável fator de forma é fundamental para determinar padrões de crescimento de árvores e rendimentos de povoamentos florestais. Nesse sentido, foram amostrados oito indivíduos pertencentes a dois povoamentos experimentais, de modo que os fatores de formas artificiais foram obtidos a partir das reconstituições das variáveis dendrométricas pela técnica de análise de tronco completa. Os povoamentos avaliados localizam-se na Reserva Florestal do Palhão (RFP) e Estação Experimental de Curuá-Una (EECU), apresentando 46 e 50 anos, respectivamente. A evolução cronológica do fator de forma das árvores apresentou um padrão decrescente, destacando que nas idades iniciais apresentaram tendência a menor conicidade. A análise de variância fatorial demonstrou que o fator de forma da espécie não é influenciado pela interação entre as áreas estudadas (RFP e EECU) e as classes de idade (1, 2, 3 e 4), no entanto, quando avaliadas separadamente, a variável classe de idade mostrou diferença significativa. Portanto, os fatores de forma observados entre os 5 e 15 anos (0,73 para a EECU e 0,69 para a RFP) apresentaram-se estatisticamente superiores aos observados às demais classes de idade. Estes resultados em comparação aos obtidos pela mesma espécie em outras regiões do Brasil demonstram que, em sítios amazônicos, o fator de forma do Pinus caribaea var. hondurensis mostra-se promissor para atividades silviculturais.
- 20 October 2021
- Published by Editoriales Iberoamericanos in Revista Ibero-Americana de Ciências Ambientais
- Vol. 12 (10) , 25-34
Open AccessComportamento cronológico do fator de forma artificial do Pinus caribaea var. hondurensis em sítios Amazônicos
Atualmente, as atividades de reflorestamento estão cada vez mais consolidadas e difundidas no Brasil, especialmente por conta de seus benefícios ambientais, sociais e econômicos. Dessa forma, em um contexto associado ao uso do solo na Amazônia Central brasileira, a prática de reflorestamento torna-se ainda mais atrativa, pois além de importantes ganhos ecológicos relacionados a conservação florestal e restauração de áreas degradadas, incluem vantagens financeiras com programas de restauração e estoque de carbono atmosférico. No entanto, para implementação de reflorestamentos em larga escala nessa região necessita-se de pesquisas sobre a seleção de espécies promissoras que sejam adaptáveis as condições ambientais locais. Diante disso, o presente trabalho teve como objetivo avaliar a evolução do fator de forma artificial para a espécie Pinus caribaea var. hondurensis em diferentes classes de idades e sítios em plantios experimentais instalados na Amazônia Central. Com isso, busca-se acessar novas informações a respeito do potencial silvicultural da espécie para região, tendo em vista que o conhecimento da variável fator de forma é fundamental para determinar padrões de crescimento de árvores e rendimentos de povoamentos florestais. Nesse sentido, foram amostrados oito indivíduos pertencentes a dois povoamentos experimentais, de modo que os fatores de formas artificiais foram obtidos a partir das reconstituições das variáveis dendrométricas pela técnica de análise de tronco completa. Os povoamentos avaliados localizam-se na Reserva Florestal do Palhão (RFP) e Estação Experimental de Curuá-Una (EECU), apresentando 46 e 50 anos, respectivamente. A evolução cronológica do fator de forma das árvores apresentou um padrão decrescente, destacando que nas idades iniciais apresentaram tendência a menor conicidade. A análise de variância fatorial demonstrou que o fator de forma da espécie não é influenciado pela interação entre as áreas estudadas (RFP e EECU) e as classes de idade (1, 2, 3 e 4), no entanto, quando avaliadas separadamente, a variável classe de idade mostrou diferença significativa. Portanto, os fatores de forma observados entre os 5 e 15 anos (0,73 para a EECU e 0,69 para a RFP) apresentaram-se estatisticamente superiores aos observados às demais classes de idade. Estes resultados em comparação aos obtidos pela mesma espécie em outras regiões do Brasil demonstram que, em sítios amazônicos, o fator de forma do Pinus caribaea var. hondurensis mostra-se promissor para atividades silviculturais.