Avner Shultzman
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Avner Shultzman has a total of 30 co-authors. Here are the top co-authors by number of shared publications:
- Ido Kaminer
Solid State Institute, Technion – Israel Institute of Technology, Haifa, Israel
5 shared publications - Yaniv Kurman
Quantum Machines Inc., Tel Aviv, Israel
4 shared publications - Ohad Segal
Technion—Israel Institute of Technology
3 shared publications - Charles Roques-Carmes
Edward L. Ginzton Laboratory, Stanford University, Stanford, USA
2 shared publications - Yonina Chana Eldar
Faculty of Electrical and Computer Engineering, Northeastern University, Boston, MA, USA
2 shared publications - Alon Lifshits
Department of Electrical and Computer Engineering, Technion - Israel Institute of Technology, 32000 Haifa, Israel
1 shared publication
Latest Publications
- Open Access
- 1 November 2024
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 10 (44) , eadq6325
Purcell-enhanced x-ray scintillation
Scintillation materials convert high-energy radiation to optical light through a complex multistage process. The last stage of the process is spontaneous light emission, which usually governs and limits the scintillator emission rate and light yield. For decades, scintillator research focused on developing faster-emitting materials or external photonic coatings for improving light yields. Here, we experimentally demonstrate a fundamentally different approach: enhancing the scintillation rate and yield via the Purcell effect, utilizing optical environment engineering to boost spontaneous emission. This enhancement is universally applicable to any scintillating material and dopant when the material’s nanoscale geometry is engineered. We design a thin multilayer nanophotonic scintillator, demonstrating Purcell-enhanced scintillation with 50% enhancement in emission rate and 80% enhancement in light yield. The emission is robust to fabrication disorder, further highlighting its potential for x-ray applications. Our results show prospects for bridging nanophotonics and scintillator science toward reduced radiation dosage and increased resolution for high-energy particle detection.
- 1 November 2024
- Published by American Association for the Advancement of Science (AAAS) in Science Advances
- Vol. 10 (44) , eadq6325
Open AccessPurcell-enhanced x-ray scintillation
Scintillation materials convert high-energy radiation to optical light through a complex multistage process. The last stage of the process is spontaneous light emission, which usually governs and limits the scintillator emission rate and light yield. For decades, scintillator research focused on developing faster-emitting materials or external photonic coatings for improving light yields. Here, we experimentally demonstrate a fundamentally different approach: enhancing the scintillation rate and yield via the Purcell effect, utilizing optical environment engineering to boost spontaneous emission. This enhancement is universally applicable to any scintillating material and dopant when the material’s nanoscale geometry is engineered. We design a thin multilayer nanophotonic scintillator, demonstrating Purcell-enhanced scintillation with 50% enhancement in emission rate and 80% enhancement in light yield. The emission is robust to fabrication disorder, further highlighting its potential for x-ray applications. Our results show prospects for bridging nanophotonics and scintillator science toward reduced radiation dosage and increased resolution for high-energy particle detection.
- 3 October 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Radiation and Plasma Medical Sciences
- Vol. 9 (2) , 141-147
Toward a Second Generation of Metascintillators Using the Purcell Effect
- 3 October 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Radiation and Plasma Medical Sciences
- Vol. 9 (2) , 141-147
Toward a Second Generation of Metascintillators Using the Purcell Effect
- Top Cited Papers
- 13 February 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Communications
- Vol. 71 (4) , 2441-2456
Channel Estimation With Hybrid Reconfigurable Intelligent Metasurfaces
Reconfigurable Intelligent Surfaces (RISs) are envisioned to play a key role in future wireless communications, enabling programmable radio propagation environments. They are usually considered as almost passive planar structures that operate as adjustable reflectors, giving rise to a multitude of implementation challenges, including the inherent difficulty in estimating the underlying wireless channels. In this paper, we focus on the recently conceived concept of Hybrid Reconfigurable Intelligent Surfaces (HRISs), which do not solely reflect the impinging waveform in a controllable fashion, but are also capable of sensing and processing an adjustable portion of it. We first present implementation details for this metasurface architecture and propose a convenient mathematical model for characterizing its dual operation. As an indicative application of HRISs in wireless communications, we formulate the individual channel estimation problem for the uplink of a multi-user HRIS-empowered communication system. Considering first a noise-free setting, we theoretically quantify the advantage of HRISs in notably reducing the amount of pilots needed for channel estimation, as compared to the case of purely reflective RISs. We then present closed-form expressions for the Mean-Squared Error (MSE) performance in estimating the individual channels at the HRISs and the base station for the noisy model. Based on these derivations, we propose an automatic differentiation-based first-order optimization approach to efficiently determine the HRIS phase and power splitting configurations for minimizing the weighted sum-MSE performance. Our numerical evaluations demonstrate that HRISs do not only enable the estimation of the individual channels in HRIS-empowered communication systems, but also improve the ability to recover the cascaded channel, as compared to existing methods using passive and reflective RISs.
- 13 February 2023
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Communications
- Vol. 71 (4) , 2441-2456
Top Cited PapersChannel Estimation With Hybrid Reconfigurable Intelligent Metasurfaces
Reconfigurable Intelligent Surfaces (RISs) are envisioned to play a key role in future wireless communications, enabling programmable radio propagation environments. They are usually considered as almost passive planar structures that operate as adjustable reflectors, giving rise to a multitude of implementation challenges, including the inherent difficulty in estimating the underlying wireless channels. In this paper, we focus on the recently conceived concept of Hybrid Reconfigurable Intelligent Surfaces (HRISs), which do not solely reflect the impinging waveform in a controllable fashion, but are also capable of sensing and processing an adjustable portion of it. We first present implementation details for this metasurface architecture and propose a convenient mathematical model for characterizing its dual operation. As an indicative application of HRISs in wireless communications, we formulate the individual channel estimation problem for the uplink of a multi-user HRIS-empowered communication system. Considering first a noise-free setting, we theoretically quantify the advantage of HRISs in notably reducing the amount of pilots needed for channel estimation, as compared to the case of purely reflective RISs. We then present closed-form expressions for the Mean-Squared Error (MSE) performance in estimating the individual channels at the HRISs and the base station for the noisy model. Based on these derivations, we propose an automatic differentiation-based first-order optimization approach to efficiently determine the HRIS phase and power splitting configurations for minimizing the weighted sum-MSE performance. Our numerical evaluations demonstrate that HRISs do not only enable the estimation of the individual channels in HRIS-empowered communication systems, but also improve the ability to recover the cascaded channel, as compared to existing methods using passive and reflective RISs.
- 21 September 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Computational Imaging
- Vol. 8 (25730436) , 893-904
Nonlinear Waveform Inversion for Quantitative Ultrasound
Due to its non-invasive and non-radiating nature, along with its low cost, ultrasound (US) imaging is widely used in medical applications. Typical B-mode US images have limited resolution and contrast and weak physical interpretation. Inverse US methods were developed to reconstruct the media's speed-of-sound (SoS) based on a linear acoustic model. However, the wave propagation in medical US is governed by nonlinear acoustics, which introduces more complex behaviors neglected in the linear model. In this work we propose a nonlinear waveform inversion (NWI) approach for quantitative US, that considers a nonlinear acoustics model to simultaneously reconstruct multiple material properties, including the medium's SoS, density, attenuation, and nonlinearity parameter. We thus broaden current inverse US approaches, such as the full waveform inversion (FWI) algorithm, by considering nonlinear media, and additional physical parameters. We represent the nonlinear acoustic model by means of a recurrent neural network, which enables us to apply advanced optimization algorithms borrowed from the deep learning toolbox and achieve more efficient reconstructions compared to the FWI method. We evaluate the performance of our approach on in-silico data and show that neglecting nonlinear effects may result in substantial degradation in the reconstruction, paving the way of NWI into clinical applications.
- 21 September 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Computational Imaging
- Vol. 8 (25730436) , 893-904
Nonlinear Waveform Inversion for Quantitative Ultrasound
Due to its non-invasive and non-radiating nature, along with its low cost, ultrasound (US) imaging is widely used in medical applications. Typical B-mode US images have limited resolution and contrast and weak physical interpretation. Inverse US methods were developed to reconstruct the media's speed-of-sound (SoS) based on a linear acoustic model. However, the wave propagation in medical US is governed by nonlinear acoustics, which introduces more complex behaviors neglected in the linear model. In this work we propose a nonlinear waveform inversion (NWI) approach for quantitative US, that considers a nonlinear acoustics model to simultaneously reconstruct multiple material properties, including the medium's SoS, density, attenuation, and nonlinearity parameter. We thus broaden current inverse US approaches, such as the full waveform inversion (FWI) algorithm, by considering nonlinear media, and additional physical parameters. We represent the nonlinear acoustic model by means of a recurrent neural network, which enables us to apply advanced optimization algorithms borrowed from the deep learning toolbox and achieve more efficient reconstructions compared to the FWI method. We evaluate the performance of our approach on in-silico data and show that neglecting nonlinear effects may result in substantial degradation in the reconstruction, paving the way of NWI into clinical applications.
- Open Access
- 6 June 2022
- Published by AIP Publishing in Applied Physics Letters
- Vol. 120 (23)
Optimizing the spontaneous-emission of far-UVC phosphors
Far-UVC light can enable virus-deactivation while remaining harmless to human tissues. This triggered great efforts to create far-UVC light sources with sufficient emission power and efficiency. However, current sources, such as mercury lamps, KrCl excimer lamps, and LEDs, are made from hazardous chemicals or are limited by low efficiency. Consequently, an alternative approach for reaching the far-UVC is now receiving renewed interest: using phosphors for converting higher frequencies to the desired range of far-UVC. However, this concept is limited by the phosphor's conversion efficiency. In this paper, we propose to utilize principles of nanophotonics to create far-UVC sources. Specifically, we design a phosphor-dielectric multilayer that increases the efficiency of far-UVC light conversion and controls the intrinsic emission properties, including the angular spectrum and emission rate, by shaping the local density of photonic states. To exemplify our approach, we design an aperiodic multilayer nanostructure made of the phosphor material YPO4:Pr3+, showing an increase in light extraction by a factor of 3 compared to naïve bulk structures. Our approach can be applied to any phosphor material and any emitter geometry, opening avenues for engineering nanophotonic light sources in the far-UVC and other spectral regimes.
- 6 June 2022
- Published by AIP Publishing in Applied Physics Letters
- Vol. 120 (23)
Open AccessOptimizing the spontaneous-emission of far-UVC phosphors
Far-UVC light can enable virus-deactivation while remaining harmless to human tissues. This triggered great efforts to create far-UVC light sources with sufficient emission power and efficiency. However, current sources, such as mercury lamps, KrCl excimer lamps, and LEDs, are made from hazardous chemicals or are limited by low efficiency. Consequently, an alternative approach for reaching the far-UVC is now receiving renewed interest: using phosphors for converting higher frequencies to the desired range of far-UVC. However, this concept is limited by the phosphor's conversion efficiency. In this paper, we propose to utilize principles of nanophotonics to create far-UVC sources. Specifically, we design a phosphor-dielectric multilayer that increases the efficiency of far-UVC light conversion and controls the intrinsic emission properties, including the angular spectrum and emission rate, by shaping the local density of photonic states. To exemplify our approach, we design an aperiodic multilayer nanostructure made of the phosphor material YPO4:Pr3+, showing an increase in light extraction by a factor of 3 compared to naïve bulk structures. Our approach can be applied to any phosphor material and any emitter geometry, opening avenues for engineering nanophotonic light sources in the far-UVC and other spectral regimes.
- 1 January 2021
- Published by Optica Publishing Group
- Vol. 3, JTu2R.3
Purcell-Enhanced UV Sources
UV lamps are of increasing importance for safe virus disinfection. Here we propose a novel concept for UV sources based on a stack of phosphor-nanolayers, designed to maximize the output emission through photonic local-density-of-states engineering.
- 1 January 2021
- Published by Optica Publishing Group
- Vol. 3, JTu2R.3
Purcell-Enhanced UV Sources
UV lamps are of increasing importance for safe virus disinfection. Here we propose a novel concept for UV sources based on a stack of phosphor-nanolayers, designed to maximize the output emission through photonic local-density-of-states engineering.
- Open Access
- 1 January 2020
- Published by AIP Publishing
- Vol. 2304, 020110
Optimizing optical nanostructures for X-ray detection
- 1 January 2020
- Published by AIP Publishing
- Vol. 2304, 020110
Open AccessOptimizing optical nanostructures for X-ray detection