Mahek Mehta
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Mahek Mehta has a total of 14 co-authors. Here are the top co-authors by number of shared publications:
- Sushobhan Avasthi
Centre for Nanoscience and Engineering, Indian Institute of Science , Bangalore 560012
3 shared publications Ambresh Mallya
Center for Nano Science and Engineering, Indian Institute of Science, Bangalore, Karnataka 560012, India
1 shared publication- Anirudh Venugopalarao
Centre for Nanoscience and Engineering Indian Institute of Science Bangalore 560012 India
1 shared publication - Arvind Rajnarayan Singh
Centre for Nano Science and Engineering, Indian Institute of Science, Bengaluru, 560012, Karnataka, India
1 shared publication Avijit Chatterjee
GlobalFoundaries, Bengaluru, Karnataka, India
1 shared publication- Khushboo Kumari
Centre for Nano Science and Engineering, Indian Institute of Science, Bengaluru, Karnataka, India
1 shared publication
Latest Publications
- 13 March 2024
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 6 (3) , 2084-2092
Low Interface Resistance in Epitaxial β-Ga2O3 Vertical Power Diodes on Silicon (100) Using TiN Buffer
- 13 March 2024
- Published by American Chemical Society (ACS) in ACS Applied Electronic Materials
- Vol. 6 (3) , 2084-2092
Low Interface Resistance in Epitaxial β-Ga2O3 Vertical Power Diodes on Silicon (100) Using TiN Buffer
- 27 January 2023
- Published by IOP Publishing in Physica Scripta
- Vol. 98 (2) , 025013
The possibility of gallium oxide (β-Ga2O3) heterojunction bipolar transistors
Bipolar junction transistors have not been viable with β-Ga2O3 due to its poor hole mobility and unavailability of shallow acceptors. Many p-type oxides form high-quality heterojunction diodes (low ideality factor and high breakdown voltage) with β-Ga2O3. We propose using these heterojunctions to make a β-Ga2O3 heterojunction bipolar transistor (HBT). Cu2O/β-Ga2O3 heterojunction is especially promising because of the relatively high electron diffusion length (∼μ m) in Cu2O, a low electron injection barrier at the Cu2O-Ga2O3 interface, and breakdown voltages of >1000 V. Using Silvaco TCAD, we simulate a β-Ga2O3 heterojunction bipolar transistor with a Cu2O base and estimate the power figure of merit (PFOM). We find that the low bandgap of Cu2O severely limits the performance of these HBTs. Reports of Cu2O-Ga2O3 diodes with extremely high breakdown voltage are probably due to heavily doped Cu2O or interface defects, but these effects do not translate to the HBT. For HBTs with PFOM better than the state-of-the-art β-Ga2O3 unipolar transistors, we need alternative p-type oxides with a bandgap E g > 3.4 eV and electron diffusion length >0.4 μ m. We discuss the possible candidates. Using an empirical model for the critical avalanche breakdown field, we estimate the maximum PFOM for possible β-Ga2O3 HBTs.
- 27 January 2023
- Published by IOP Publishing in Physica Scripta
- Vol. 98 (2) , 025013
The possibility of gallium oxide (β-Ga2O3) heterojunction bipolar transistors
Bipolar junction transistors have not been viable with β-Ga2O3 due to its poor hole mobility and unavailability of shallow acceptors. Many p-type oxides form high-quality heterojunction diodes (low ideality factor and high breakdown voltage) with β-Ga2O3. We propose using these heterojunctions to make a β-Ga2O3 heterojunction bipolar transistor (HBT). Cu2O/β-Ga2O3 heterojunction is especially promising because of the relatively high electron diffusion length (∼μ m) in Cu2O, a low electron injection barrier at the Cu2O-Ga2O3 interface, and breakdown voltages of >1000 V. Using Silvaco TCAD, we simulate a β-Ga2O3 heterojunction bipolar transistor with a Cu2O base and estimate the power figure of merit (PFOM). We find that the low bandgap of Cu2O severely limits the performance of these HBTs. Reports of Cu2O-Ga2O3 diodes with extremely high breakdown voltage are probably due to heavily doped Cu2O or interface defects, but these effects do not translate to the HBT. For HBTs with PFOM better than the state-of-the-art β-Ga2O3 unipolar transistors, we need alternative p-type oxides with a bandgap E g > 3.4 eV and electron diffusion length >0.4 μ m. We discuss the possible candidates. Using an empirical model for the critical avalanche breakdown field, we estimate the maximum PFOM for possible β-Ga2O3 HBTs.
- 12 May 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 22 (12) , 11682-11689
Laser-Crystallized Epitaxial Germanium on Silicon-Based Near-Infrared Photodetector
This work reports the fabrication of near-infrared (NIR) photodetectors based on laser-crystallized epitaxial germanium (100 nm) on silicon (001). The laser crystallized epitaxial germanium has an extracted dislocation density of$\approx 10$ 9 cm −2 . Metal-Semiconductor-Metal photodetectors fabricated on these films using Cr/Au as contact showed remarkable responsivity values of 0.64 A/W at 1550 nm and 0.71 A/W at 1310 nm for a 1V bias. Au/Cr-Ge contact exhibited ohmic characteristics with a contact resistance of$\approx 340$ ±$13~\Omega $ . The devices showed a time response with a rise time (10%-90%) of 3 s and fall time (90%-10%) of 5.2 s. The obtained high value of dark current is reduced by one order after passivating the Ge layer below contact with TiO 2 (5 nm). TiO 2 based devices showed a contact resistance of 3400±$283\Omega $ . Kelvin probe force microscopy (KPFM) was employed to map the surface potential across the MSM photodiodes to understand the current transport mechanisms. KPFM yields an Ohmic and Schottky contact in MSM diodes without and with TiO 2 passivation layer, respectively. With further improvement in the device architecture; and optimization of the laser crystallization conditions of Ge film; these devices can be used as a potential candidate for various low-cost NIR applications, like on-chip integration of photonic circuits.- 12 May 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Sensors Journal
- Vol. 22 (12) , 11682-11689
Laser-Crystallized Epitaxial Germanium on Silicon-Based Near-Infrared Photodetector
This work reports the fabrication of near-infrared (NIR) photodetectors based on laser-crystallized epitaxial germanium (100 nm) on silicon (001). The laser crystallized epitaxial germanium has an extracted dislocation density of$\approx 10$ 9 cm −2 . Metal-Semiconductor-Metal photodetectors fabricated on these films using Cr/Au as contact showed remarkable responsivity values of 0.64 A/W at 1550 nm and 0.71 A/W at 1310 nm for a 1V bias. Au/Cr-Ge contact exhibited ohmic characteristics with a contact resistance of$\approx 340$ ±$13~\Omega $ . The devices showed a time response with a rise time (10%-90%) of 3 s and fall time (90%-10%) of 5.2 s. The obtained high value of dark current is reduced by one order after passivating the Ge layer below contact with TiO 2 (5 nm). TiO 2 based devices showed a contact resistance of 3400±$283\Omega $ . Kelvin probe force microscopy (KPFM) was employed to map the surface potential across the MSM photodiodes to understand the current transport mechanisms. KPFM yields an Ohmic and Schottky contact in MSM diodes without and with TiO 2 passivation layer, respectively. With further improvement in the device architecture; and optimization of the laser crystallization conditions of Ge film; these devices can be used as a potential candidate for various low-cost NIR applications, like on-chip integration of photonic circuits.