Dong-Yeol Yang
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Dong-Yeol Yang has a total of 22 co-authors. Here are the top co-authors by number of shared publications:
- Byung-Sung Kim
College of Information and Communication Engineering, Sungkyunkwan University, Suwon, South Korea
8 shared publications - Seuk-Won Kang
Department of Electrical and Computer Engineering, Sungkyunkwan University, Suwon, South Korea
6 shared publications - Jeong-Bae Yoon
Department of Electrical and Computer Engineering, Sungkyunkwan University, Suwon, South Korea
4 shared publications - Chan-Jong Lee2 shared publications
- Kyu-Jin Choi
Department of Electrical and Computer Engineering, Sungkyunkwan University, Suwon, South Korea
2 shared publications - Reem Song
College of Information and Communication Engineering, Sungkyunkwan University, Suwon, South Korea
2 shared publications
Latest Publications
- 1 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 74 (1) , 468-484
An 8 TX–16 RX W-Band 2-D Distributed Active Array TD-MIMO FMCW Radar in 28-nm CMOS
This article presents a 94-GHz time-domain multiple-input–multiple-output (TD-MIMO) frequency- modulated continuous-wave (FMCW) radar system with 8 transmitters (TXs) and 16 receivers (RXs). The system incorporates a single-channel TX chip and a four-channel RX chip, which are separately designed to enable flexible antenna array optimization. Both chips are implemented in 28-nm bulk CMOS technology and feature a $\times 24$ frequency multiplication scheme, along with a direct backside antenna-feeding architecture through the silicon substrate. This approach effectively reduces the complexity and cost of large-scale W-band array implementation by eliminating the need for low-yield, expensive millimeter-wave (mm-wave) packaging. A compact, center-fed antenna is directly integrated into the package, removing the external antenna feedlines and enabling efficient arrangement of a 2-D thinned active array, which is optimized using a genetic algorithm (GA) for enhanced angular resolution. Furthermore, a time-interleaved intermediate-frequency (IF) sampling architecture is adopted to realize 128 virtual channels with reduced back-end hardware and processing burden. The fabricated antenna-integrated TX and RX module achieve an equivalent isotropic radiated power (EIRP) of 27 dBm and a conversion gain of 34 dB, respectively. The radar system demonstrates high angular resolutions of 0.81° in azimuth and 1.5° in elevation direction.
- 1 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Microwave Theory and Techniques
- Vol. 74 (1) , 468-484
An 8 TX–16 RX W-Band 2-D Distributed Active Array TD-MIMO FMCW Radar in 28-nm CMOS
This article presents a 94-GHz time-domain multiple-input–multiple-output (TD-MIMO) frequency- modulated continuous-wave (FMCW) radar system with 8 transmitters (TXs) and 16 receivers (RXs). The system incorporates a single-channel TX chip and a four-channel RX chip, which are separately designed to enable flexible antenna array optimization. Both chips are implemented in 28-nm bulk CMOS technology and feature a $\times 24$ frequency multiplication scheme, along with a direct backside antenna-feeding architecture through the silicon substrate. This approach effectively reduces the complexity and cost of large-scale W-band array implementation by eliminating the need for low-yield, expensive millimeter-wave (mm-wave) packaging. A compact, center-fed antenna is directly integrated into the package, removing the external antenna feedlines and enabling efficient arrangement of a 2-D thinned active array, which is optimized using a genetic algorithm (GA) for enhanced angular resolution. Furthermore, a time-interleaved intermediate-frequency (IF) sampling architecture is adopted to realize 128 virtual channels with reduced back-end hardware and processing burden. The fabricated antenna-integrated TX and RX module achieve an equivalent isotropic radiated power (EIRP) of 27 dBm and a conversion gain of 34 dB, respectively. The radar system demonstrates high angular resolutions of 0.81° in azimuth and 1.5° in elevation direction.
- Open Access
- 30 November 2025
- Published by Korean Institute of Electromagnetic Engineering and Science in The Journal of Korean Institute of Electromagnetic Engineering and Science
- Vol. 36 (11) , 1081-1089
D-Band FMCW Radar with Virtual Array Expansion for Point Cloud Imaging
- 30 November 2025
- Published by Korean Institute of Electromagnetic Engineering and Science in The Journal of Korean Institute of Electromagnetic Engineering and Science
- Vol. 36 (11) , 1081-1089
Open AccessD-Band FMCW Radar with Virtual Array Expansion for Point Cloud Imaging
- Open Access
- 30 September 2024
- Published by Korean Institute of Electromagnetic Engineering and Science in The Journal of Korean Institute of Electromagnetic Engineering and Science
- Vol. 35 (9) , 754-761
A W-Band Thinned Array FMCW Radar System
한국전자파학회논문지 (The Journal of Korean Institute of Electromagnetic Engineering and Science)
- 30 September 2024
- Published by Korean Institute of Electromagnetic Engineering and Science in The Journal of Korean Institute of Electromagnetic Engineering and Science
- Vol. 35 (9) , 754-761
Open AccessA W-Band Thinned Array FMCW Radar System
한국전자파학회논문지 (The Journal of Korean Institute of Electromagnetic Engineering and Science)
- Open Access
- 24 June 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 12, 94632-94642
A Ka-Band Beam-Steering Radar Transmitter Using Active Multiplier and Coupled Delay Line Phase Shifter
This paper presents a Ka-band beam steering transmitter exploiting a coupled varactor loaded transmission line (VLTL) phase shifter and a CMOS transmitter chip with an integrated frequency multiplier. The short-coupled line couplers placed along a single VLTL provides multi-phase outputs while minimizing the impedance mismatch and unequal power distribution along the VLTLs. The inherent phase-accumulating nature along the VLTL reduces the burden of wide phase control range required for using separate phase shifters for each channel. Additionally, the frequency multiplier with a multiplication ratio of 8 reduces the required amount of phase change at the reference frequency and therefore the tuning range of the varactor, which also minimize a change of line characteristic impedance to ensure the impedance matching of the VLTL. Hence, a 32 GHz phased array transmitter is implemented using a single VLTL phase shifter operating at a low reference frequency of about 4 GHz. The fabricated 1×4 phased array transmitter achieves a continuous beam steering range of ±20° in the E-plane using a single control voltage. The sidelobe level is below -10 dB at all scan angles and the peak effective isotropic radiated power (EIRP) is 38.1 dBm at 31.6 GHz and the 3-dB bandwidth of 2.4 GHz is achieved.
- 24 June 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 12, 94632-94642
Open AccessA Ka-Band Beam-Steering Radar Transmitter Using Active Multiplier and Coupled Delay Line Phase Shifter
This paper presents a Ka-band beam steering transmitter exploiting a coupled varactor loaded transmission line (VLTL) phase shifter and a CMOS transmitter chip with an integrated frequency multiplier. The short-coupled line couplers placed along a single VLTL provides multi-phase outputs while minimizing the impedance mismatch and unequal power distribution along the VLTLs. The inherent phase-accumulating nature along the VLTL reduces the burden of wide phase control range required for using separate phase shifters for each channel. Additionally, the frequency multiplier with a multiplication ratio of 8 reduces the required amount of phase change at the reference frequency and therefore the tuning range of the varactor, which also minimize a change of line characteristic impedance to ensure the impedance matching of the VLTL. Hence, a 32 GHz phased array transmitter is implemented using a single VLTL phase shifter operating at a low reference frequency of about 4 GHz. The fabricated 1×4 phased array transmitter achieves a continuous beam steering range of ±20° in the E-plane using a single control voltage. The sidelobe level is below -10 dB at all scan angles and the peak effective isotropic radiated power (EIRP) is 38.1 dBm at 31.6 GHz and the 3-dB bandwidth of 2.4 GHz is achieved.
- Open Access
- 30 April 2023
- Published by Korean Institute of Electromagnetic Engineering and Science in The Journal of Korean Institute of Electromagnetic Engineering and Science
- Vol. 34 (4) , 326-329
A Ka-Band Radar Receiver with Built-in X8 Multiplier
한국전자파학회논문지 (The Journal of Korean Institute of Electromagnetic Engineering and Science)
- 30 April 2023
- Published by Korean Institute of Electromagnetic Engineering and Science in The Journal of Korean Institute of Electromagnetic Engineering and Science
- Vol. 34 (4) , 326-329
Open AccessA Ka-Band Radar Receiver with Built-in X8 Multiplier
한국전자파학회논문지 (The Journal of Korean Institute of Electromagnetic Engineering and Science)
- Open Access
- 30 April 2023
- Published by Korean Institute of Electromagnetic Engineering and Science in The Journal of Korean Institute of Electromagnetic Engineering and Science
- Vol. 34 (4) , 326-329
A Ka-Band Radar Receiver with Built-in X8 Multiplier
한국전자파학회논문지 (The Journal of Korean Institute of Electromagnetic Engineering and Science)
- 30 April 2023
- Published by Korean Institute of Electromagnetic Engineering and Science in The Journal of Korean Institute of Electromagnetic Engineering and Science
- Vol. 34 (4) , 326-329
Open AccessA Ka-Band Radar Receiver with Built-in X8 Multiplier
한국전자파학회논문지 (The Journal of Korean Institute of Electromagnetic Engineering and Science)
- 3 November 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 33 (3) , 311-314
D-Band × 8 Frequency Multiplier Using Complementary Differential Frequency Doubler
A D-band $\times$ 8 frequency multiplier is presented in this letter. The $\times$ 8 frequency multiplier consists of two stages of the newly proposed common load complementary push-push doublers (CL-CPPDs) and one stage of NMOS push-push doubler. The proposed CL-CPPD uses a single load to generate a balanced output with high harmonic rejection (HR) and can be easily cascaded using transformers for a high multiplication ratio with low dc power consumption. The chip is fabricated by using a 40-nm CMOS technology, and it achieves a maximum output power of $-$ 2.48 dBm with an input power of $0$ dBm in the frequency range of 131.2–144.8 GHz. All HRs are over 34 dBc in the frequency range of 131.2–144.8 GHz. The total dc power dissipation is 41.4 mW when supplied from a single voltage of 0.9 V and occupies 0.37 ${\mathrm{mm}}^{2}$ of the chip area.
- 3 November 2022
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Microwave and Wireless Technology Letters
- Vol. 33 (3) , 311-314
D-Band × 8 Frequency Multiplier Using Complementary Differential Frequency Doubler
A D-band $\times$ 8 frequency multiplier is presented in this letter. The $\times$ 8 frequency multiplier consists of two stages of the newly proposed common load complementary push-push doublers (CL-CPPDs) and one stage of NMOS push-push doubler. The proposed CL-CPPD uses a single load to generate a balanced output with high harmonic rejection (HR) and can be easily cascaded using transformers for a high multiplication ratio with low dc power consumption. The chip is fabricated by using a 40-nm CMOS technology, and it achieves a maximum output power of $-$ 2.48 dBm with an input power of $0$ dBm in the frequency range of 131.2–144.8 GHz. All HRs are over 34 dBc in the frequency range of 131.2–144.8 GHz. The total dc power dissipation is 41.4 mW when supplied from a single voltage of 0.9 V and occupies 0.37 ${\mathrm{mm}}^{2}$ of the chip area.
- Open Access
- 31 May 2022
- Published by Korean Institute of Electromagnetic Engineering and Science in The Journal of Korean Institute of Electromagnetic Engineering and Science
- Vol. 33 (5) , 410-413
Design of a Ka-Band Receiver Using 28-nm CMOS Process
한국전자파학회논문지 (The Journal of Korean Institute of Electromagnetic Engineering and Science)
- 31 May 2022
- Published by Korean Institute of Electromagnetic Engineering and Science in The Journal of Korean Institute of Electromagnetic Engineering and Science
- Vol. 33 (5) , 410-413
Open AccessDesign of a Ka-Band Receiver Using 28-nm CMOS Process
한국전자파학회논문지 (The Journal of Korean Institute of Electromagnetic Engineering and Science)