RWRudeger H. T. Wilke
Rudeger H. T. Wilke
*This is an algorithmically generated author record based on publicly available information.
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Research Interests
Rudeger H. T. Wilke has a total of 6 co-authors. Here are the top co-authors by number of shared publications:
Daniel A. Schwartz
Harvard–Smithsonian Center for Astrophysics, Cambridge, Massachusetts 02138, USA
1 shared publicationPaul B. Reid
Harvard–Smithsonian Center for Astrophysics, Cambridge, Massachusetts 02138, USA
1 shared publicationRaegan L. Johnson-Wilke
Materials Research Institute, Pennsylvania State University, University Park, Pennsylvania 16802, USA
1 shared publication- Susan Trolier-McKinstry
Pennsylvania State University
1 shared publication - Vincenzo Cotroneo
INAF - Osservatorio Astronomico di Brera (Italy)
1 shared publication William N. Davis
Harvard–Smithsonian Center for Astrophysics, Cambridge, Massachusetts 02138, USA
1 shared publication
Latest Publications
- 10 May 2013
- Published by Optica Publishing Group in Applied Optics
- Vol. 52 (14) , 3412-3419
Sputter deposition of PZT piezoelectric films on thin glass substrates for adjustable x-ray optics
Piezoelectric (PZT) thin films deposited on thin glass substrates have been proposed for adjustable optics in future x-ray telescopes. The light weight of these x-ray optics enables large collecting areas, while the capability to correct mirror figure errors with the PZT thin film will allow much higher imaging resolution than possible with conventional lightweight optics. However, the low strain temperature and flexible nature of the thin glass complicate the use of chemical-solution deposition due to warping of the substrate at typical crystallization temperatures for the PZT. RF magnetron sputtering enabled preparation of PZT films with thicknesses up to 3 μm on Schott D263 glass substrates with much less deformation. X-ray diffraction analysis indicated that the films crystallized with the perovskite phase and showed no indication of secondary phases. Films with electrodes exhibited relative permittivity values near 1100 and loss tangents below 0.05. In addition, the remanent polarization was with coercive fields of . The transverse piezoelectric coefficient was as high as . To assess influence functions for the x-ray optics application, the piezoelectrically induced deflection of individual cells was measured and compared with finite-element-analysis calculations. The good agreement between the results suggests that actuation of PZT thin films can control mirror figure errors to a precision of about 5 nm, allowing sub-arcsecond imaging.- 10 May 2013
- Published by Optica Publishing Group in Applied Optics
- Vol. 52 (14) , 3412-3419
Sputter deposition of PZT piezoelectric films on thin glass substrates for adjustable x-ray optics
Piezoelectric (PZT) thin films deposited on thin glass substrates have been proposed for adjustable optics in future x-ray telescopes. The light weight of these x-ray optics enables large collecting areas, while the capability to correct mirror figure errors with the PZT thin film will allow much higher imaging resolution than possible with conventional lightweight optics. However, the low strain temperature and flexible nature of the thin glass complicate the use of chemical-solution deposition due to warping of the substrate at typical crystallization temperatures for the PZT. RF magnetron sputtering enabled preparation of PZT films with thicknesses up to 3 μm on Schott D263 glass substrates with much less deformation. X-ray diffraction analysis indicated that the films crystallized with the perovskite phase and showed no indication of secondary phases. Films with electrodes exhibited relative permittivity values near 1100 and loss tangents below 0.05. In addition, the remanent polarization was with coercive fields of . The transverse piezoelectric coefficient was as high as . To assess influence functions for the x-ray optics application, the piezoelectrically induced deflection of individual cells was measured and compared with finite-element-analysis calculations. The good agreement between the results suggests that actuation of PZT thin films can control mirror figure errors to a precision of about 5 nm, allowing sub-arcsecond imaging.