Valeria Turfani has a total of 58 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Effect of Asparaginase on Neo-Formed Contaminants and Quality Attributes in Wholemeal Biscuits

    by Francesca Masciola, Irene Baiamonte, Emanuele Marconi, Francesca Melini, Valentina Melini, Sahara Melloni, Piera Moro, Nicoletta Nardo, Valentina Narducci, Jose Sanchez del Pulgar, et al.

    The effects of asparaginase treatment and conditions of its use (enzyme dose and dough resting time) on the formation of heat-induced contaminants, namely, acrylamide (ACR) and 5-hydroxymethylfurfural (HMF), were investigated in wholemeal wheat biscuits. In addition, potential impacts on sensory-related quality attributes were assessed through instrumental analysis of colour, texture, and volatile organic compounds (VOCs). Three levels of asparaginase addition (100, 300, and 500 ASNU kg−1 flour) were tested and compared with an untreated control, with and without the application of a 15 min dough resting step. Results confirmed the effectiveness of asparaginase in reducing ACR levels in the final biscuits, showing a dose-dependent response with reductions of up to 68% at 500 ASNU kg−1 flour. A dough resting step tend to further lower ACR content. In contrast, asparaginase treatment did not exert a consistent effect on HMF formation, whereas dough resting tended to decrease it. Moreover, asparaginase addition at the highest dose reduced the level of several Maillard reaction-derived VOCs by approximately 30%. Overall, asparaginase treatment markedly reduced ACR formation while causing changes in some odour-active compounds in biscuits. Further sensory evaluation will be necessary to determine whether these changes are perceptible and may influence consumer acceptance.

  • Open Access

    Recent Advances in Inks for 3D Food Printing: A Review

    by Mena Ritota, Sahara Melloni, Giulia Cianfrini, Valentina Narducci, Stefania Ruggeri, Valeria Turfani

    The integration of 3D printers into food production represents an unprecedented innovation, envisaging applications from the industry to missions in space to home cooking, with no geographical or sectoral limits. Extrusion food 3D printers are designed to use ‘food inks’ that must be produced from raw materials possessing a range of suitable characteristics (viscosity, elasticity, and others) that make them printable. Not all food matrices possess such characteristics, and additives are often needed to formulate food inks, which must also adapt to the complexity of the 3D model to be printed. Initially, mainly food matrices such as potatoes, chocolate, cereal, and legume flours and soluble-fiber-rich additives were tested with this new technology, with promising results. In recent years, alternative food matrices (e.g., based on insects, algae, cultured meat, and food waste) have begun to be experimented with, as 3D printing appears to be a suitable way to exploit their potential. This review aims to highlight recent studies that have investigated the development of innovative food ink formulations and trace a picture of the new food raw materials that are being tested for 3D food printing, the opportunities they represent, their nutritional properties, safety, and technological challenges. This review considered a total of 46 papers, selected from 330 papers published in the last 8 years (2018–2025) on the generic subject of 3D food printing.


  • Open Access

    Effect of Asparaginase Treatment on Biscuit Volatile Compounds

    by Francesca Masciola, Irene Baiamonte, Emanuele Marconi, Sahara Melloni, Nicoletta Nardo, Valentina Narducci, Jose Sanchez del Pulgar, Valeria Turfani, Antonio Raffo

    Among the strategies proposed to reduce the formation of acrylamide in bakery products, the use of asparaginase is considered one of the most promising, also due to its limited impact on the sensory quality of the final product. Asparagine, the key precursor of acrylamide that is selectively hydrolysed by the asparaginase treatment, is generally not considered a major contributor to the overall flavour and colour of baked foods. This study investigates the effect of three addition levels of the enzyme asparaginase (500, 750, 1000 ASNU compared to a not added control) and three different preparation conditions (without resting time and with 15 min resting time at 20 °C or 50 °C) on asparagine content in the dough and on the formation of Volatile Organic Compounds (VOCs) and colour of shortbread biscuits. Results showed that the addition of asparaginase, at all levels, markedly reduced the asparagine content in the dough, with limited effects on the VOC profile and colour. The examined preparation conditions significantly affected the VOC profile: the application of a resting time at 20 °C tended to promote the formation of VOCs through lipid oxidation while reducing the level of many MR-related VOCs. This last effect seemed to parallel the slight reduction of the browning index observed when the resting time was applied. Results suggest that the use of asparaginase does not markedly affect the VOC profile of shortbread biscuits, thus confirming its limited effects on sensory-related quality attributes of baked foods.


  • Open Access

    Wheat Germ Agglutinin (WGA): Its Nature, Biological Role, Significance in Human Nutrition, and Possibility to Be Used as Marker of Whole-Grain Status in Wheat-Based Foods

    by Marina Carcea, Sahara Melloni, Valentina Narducci, Valeria Turfani

    The growing scientific evidence on the health benefits of whole-grain food consumption has promoted the manufacturing of a great number of products differing in quality and content of whole-grain components. This is particularly true for commercial wheat-based products where it is not always clear how much whole wheat is present considering that in many cases, they are manufactured from reconstituted mill streams and that there is not a standardised globally accepted definition and metrics to objectively evaluate whole-grain status. Attempts have been made to assess the level of “wholegraininess” in wheat products by measuring specific constituents that correlate with different wheat tissues, especially those that are expected to be found in a true whole-grain wheat product. Wheat germ agglutinin (WGA), a small lectin protein present exclusively in the wheat-germ tissues, has been indicated by several scientists as one of these constituents and after founding that its level changes depending on the amount of germ found in a wheat flour, it has been indicated as a biomarker of whole-grain status for wheat products. In this review, the biochemistry of WGA, its methods of detection, and current knowledge on its possibility to be practically utilized as a reliable marker are critically discussed.


  • Open Access

    Stone Milling versus Roller Milling in Soft Wheat (Part 2): Influence on Nutritional and Technological Quality of Products

    by Marina Carcea, Valentina Narducci, Valeria Turfani, Enrico Finotti

    Wholegrain soft wheat flours can be obtained by either roller milling or stone milling. In this paper, we report on the continuation of a study aimed at analysing compositional and technological differences between differently milled wholegrain flours. Eight mixes of soft wheat grains were stone milled and roller milled and the milling products analysed for their phytic acid, lipids composition to determine the presence of trans-fatty acids and damaged starch. A wholegrain flour milled with a laboratory disk mill was also analysed as comparison, as well as seven wholegrain flours purchased on the market. For phytic acid we found that that there is no compositional difference between a stone milled or a roller milled flour if the milling streams are all recombined: the milling streams instead have different amounts of phytic acid which is mainly present in the fine bran and coarse bran. It was not possible to highlight differences in the milling technology due to the presence of trans-fatty acids in the stone milled wholegrain flour whereas it was possible to find that starch damage depended on the milling method with stone milled wholegrain flours having in all cases significantly higher values than the roller milled ones.


  • Open Access

    A Comprehensive Study on the Influence of Sodium Chloride on the Technological Quality Parameters of Soft Wheat Dough

    by Marina Carcea, Valentina Narducci, Valeria Turfani, Francesco Mellara

    This study aimed at understanding how the presence or absence of NaCl influences dough rheological performance of soft wheat cvs. currently used in the Italian bread manufacturing industry as a scientific support to national health strategies to reduce the use of NaCl in bread. For this reason 176 flour samples belonging to 41 soft wheat cvs. currently cultivated in Italy, were analyzed for their protein content, Zeleny sedimentation value, and by means of the Chopin Alveograph and Brabender Farinograph, with no salt and with 1.5% salt addition (average salt content in Italian bread). Three selected cvs. (Aubusson, Bolero, and Blasco) were additionally studied by means of the Rapid Visco Analyzer (RVA) at three levels of salt addition (0%, 1.5% and 3.0%). The fermentation behaviour of the cvs. Aubusson and Blasco was also studied by means of a Rheofermentometer under the same conditions. The results of our study confirmed the role of salt in strengthening the wheat gluten network (up to 86%), and thus the gas retention of dough and in affecting yeast activity. However, it also definitely proved that careful cultivar selection can help in overcoming technical challenges in reduced-salt bread manufacturing and eventually, it opens the path to wheat breeding for reduced-salt bread baking.


  • Open Access

    Stone Milling versus Roller Milling in Soft Wheat: Influence on Products Composition

    by Marina Carcea, Valeria Turfani, Valentina Narducci, Sahara Melloni, Vincenzo Galli, Valentina Tullio

    Wholegrain wheat flours are in great demand from consumers worldwide because they are considered healthier then refined flours. They can be obtained by either stone milling, which is experiencing a revival in Europe, or roller milling. In order to study compositional differences due to the milling technology and to explore the possibility of a better qualification of wholegrain flours by means of nutritionally oriented quality parameters, eight mixes of soft wheat grains were stone milled and roller milled and the milling products were analyzed for their protein, ash, lipids, total dietary fibre, total polyphenols and alkylresorcinols content. A wholegrain flour milled with a laboratory disk mill was used as a comparison and a set of seven wholegrain flours purchased on themarket were also analyzed and compared. The particle size distribution of stone milled and recombined roller milled flour was also studied. Considering the above mentioned parameters, we found that there is no compositional difference between a stone milled or a roller milled flour if, in this latter one, the milling streams are all recombined, but the particle size distribution was different. This might have an impact on the technological quality of flours and on the bioavailability of components.


  • Impact of sodium reduction strategies on volatile compounds, sensory properties and consumer perception in commercial wheat bread

    by Fiorella Sinesio, Antonio Raffo, Marina Peparaio, Elisabetta Moneta, Eleonora Saggia Civitelli, Valentina Narducci, Valeria Turfani, Stefano Ferrari Nicoli, Marina Carcea


  • Open Access

    Bread for the Aging Population: The Effect of a Functional Wheat–Lentil Bread on the Immune Function of Aged Mice

    by Marina Carcea, Valeria Turfani, Valentina Narducci, Alessandra Durazzo, Alberto Finamore, Marianna Roselli, Rita Rami

    A functional bread tailored for the needs of the aging population was baked by substituting 24% of wheat flour with red lentil flour and compared with wheat bread. Its nutritional profile was assessed by analysing proteins, amino acids, lipids, soluble and insoluble dietary fibre, resistant starch, total polyphenols, lignans and the antioxidant capacity (FRAP assay). The wheat–lentil bread had 30% more proteins than wheat bread (8.3%, as is), a more balanced amino acids composition, an almost double mineral (0.63%, as is) as well as total dietary fibre content (4.6%, as is), double the amount of polyphenols (939.1 mg GAE/100g on dry matter, d.m.), higher amounts and variety of lignans, and more than double the antioxidant capacity (71.6 µmoL/g d.m.). The in vivo effect of 60 days bread consumption on the immune response was studied by means of a murine model of elderly mice. Serum cytokines and intraepithelial lymphocyte immunophenotype from the mice intestine were analysed as markers of systemic and intestinal inflammatory status, respectively. Analysis of immune parameters in intraepithelial lymphocytes showed significant differences among the two types of bread indicating a positive effect of the wheat–lentil bread on the intestinal immune system, whereas both breads induced a reduction in serum IL-10.


  • Open Access

    A Survey of Sodium Chloride Content in Italian Artisanal and Industrial Bread

    by Marina Carcea, Valentina Narducci, Valeria Turfani, Altero Aguzzi

    A nationwide survey on salt content in both artisanal and industrial bread was undertaken in Italy to establish a baseline for salt reduction initiatives. Excess sodium intake in the diet is associated with high blood pressure and the risk of cardiovascular diseases. Bread has been identified as a major contributor to salt intake in the Italian diet. Most of the bread consumed in Italy comes from artisanal bakeries so 135 artisanal bread were sampled in 56 locations from Northern to Southern Italy together with 19 samples of industrial bread representative of the entire Italian production. Sodium chloride content was analysed according to the Volhardt’s method. A salt content between 0.7% and 2.3% g/100 g (as is basis) was found, with a mean value of 1.5% (Standard Deviation, 0.3). However, the majority of samples (58%) had a content below 1.5%, with 12% having a very low salt content (between 0.5% and 1.0%), whereas the remaining 42% had a salt content higher than the mean value with a very high salt content (>2.0%) recorded for 3% of samples. As regards the industrial bread, an average content of 1.6% was found (SD, 0.3). In this group, most of the samples (56%) had a very high content between 2.0% and 2.5%, whereas 5% only had a content between 1.1% and 1.5%. Statistics on salt content are also reported for the different categories of bread.