William H. Doniger
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
William H. Doniger has a total of 16 co-authors. Here are the top co-authors by number of shared publications:
Kumar Sridharan
University of Wisconsin-Madison, Department of Material Science & Engineering, Madison, Wisconsin 53706, United States of America
2 shared publicationsAdrien Couet
University of Wisconsin-Madison, Department of Material Science & Engineering, Madison, Wisconsin 53706, United States of America
1 shared publication- Adrien Couet
University of Wisconsin-Madison
1 shared publication - Brian C. Kelleher
Independent Researcher
1 shared publication - Cody Falconer
University of Wisconsin-Madison, Department of Materials Science and Engineering, United States
1 shared publication - Guoping Cao
Idaho National Laboratory, Idaho Falls, USA
1 shared publication
Latest Publications
- Open Access
- 1 October 2025
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 172 (10) , 106504
Quantitative Voltammetry Measurements of High-Concentration Actinides in Molten Chloride Fuel Salts
Molten chloride mixtures containing high concentrations of UCl3 (i.e., >70 wt%) are candidates for next-generation molten salt reactor (MSR) fuel salts that enable new plant optimization and fuel cycle strategies. MSR licensing, however, is contingent on the development of effective material control and accounting (MC&A) practices for these salts. To close this gap, we have developed an electroanalytical approach that enables accurate in situ measurements of uranium concentrations in these highly loaded fuel salts. This methodology uses a multielectrode array voltammetry sensor combined with digital simulations that account for non-idealities such as uncompensated resistance effects. The theory-based numerical simulations of voltammetry responses yielded correction factors that are agnostic of electrochemical cell geometry and produced consistent voltammetry peak current results when correcting for varying amounts of ohmic resistance. In doing so, we have demonstrated accurate concentration measurements for UCl3 in LiCl-KCl-UCl3 across a range of mass fractions between 55 and 72.3 wt% at 550 °C.
- 1 October 2025
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 172 (10) , 106504
Open AccessQuantitative Voltammetry Measurements of High-Concentration Actinides in Molten Chloride Fuel Salts
Molten chloride mixtures containing high concentrations of UCl3 (i.e., >70 wt%) are candidates for next-generation molten salt reactor (MSR) fuel salts that enable new plant optimization and fuel cycle strategies. MSR licensing, however, is contingent on the development of effective material control and accounting (MC&A) practices for these salts. To close this gap, we have developed an electroanalytical approach that enables accurate in situ measurements of uranium concentrations in these highly loaded fuel salts. This methodology uses a multielectrode array voltammetry sensor combined with digital simulations that account for non-idealities such as uncompensated resistance effects. The theory-based numerical simulations of voltammetry responses yielded correction factors that are agnostic of electrochemical cell geometry and produced consistent voltammetry peak current results when correcting for varying amounts of ohmic resistance. In doing so, we have demonstrated accurate concentration measurements for UCl3 in LiCl-KCl-UCl3 across a range of mass fractions between 55 and 72.3 wt% at 550 °C.
- 1 July 2022
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 169 (7) , 071502
Potentiodynamic Polarization of Pure Metals and Alloys in Molten LiF-NaF-KF (FLiNaK) Using the K/K + Dynamic Reference Electrode
The potentiodynamic polarization method using the K/K + dynamic reference electrode was used to understand the corrosion behavior of Ni, Fe, Cr, the Ni-20Cr binary alloy, and 316L stainless steel in molten 46.5LiF-11.5NaF-42KF (FLiNaK, composition in mol %) salt at 700 °C. Exposure of the materials without an applied potential revealed that Ni and Fe were stable in FLiNaK, but Cr was dissolved rapidly. The apparent redox potentials of each material with respect to the K/K + redox couple are compared to gain insight into how the applied potential relates to the dominant corrosion mechanism for each alloy. The polarized pure metals experienced uniform surface recession while corrosion in the alloys resulted in preferential elemental dissolution depending on the applied potential with respect to the K/K + reference reaction.
- 1 July 2022
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 169 (7) , 071502
Potentiodynamic Polarization of Pure Metals and Alloys in Molten LiF-NaF-KF (FLiNaK) Using the K/K + Dynamic Reference Electrode
The potentiodynamic polarization method using the K/K + dynamic reference electrode was used to understand the corrosion behavior of Ni, Fe, Cr, the Ni-20Cr binary alloy, and 316L stainless steel in molten 46.5LiF-11.5NaF-42KF (FLiNaK, composition in mol %) salt at 700 °C. Exposure of the materials without an applied potential revealed that Ni and Fe were stable in FLiNaK, but Cr was dissolved rapidly. The apparent redox potentials of each material with respect to the K/K + redox couple are compared to gain insight into how the applied potential relates to the dominant corrosion mechanism for each alloy. The polarized pure metals experienced uniform surface recession while corrosion in the alloys resulted in preferential elemental dissolution depending on the applied potential with respect to the K/K + reference reaction.
- 1 October 2021
- Published by Elsevier in Corrosion Science
- Vol. 191, 109735
Environmental degradation of electroplated nickel and copper coated SS316H in molten FLiNaK salt
- 1 October 2021
- Published by Elsevier in Corrosion Science
- Vol. 191, 109735
Environmental degradation of electroplated nickel and copper coated SS316H in molten FLiNaK salt
- 21 February 2017
- Published by Springer Nature
- p. 617-628
Electrochemistry in Molten LiF-BeF2 Salt for Fluoride Salt-Cooled High Temperature Reactor Applications
- 21 February 2017
- Published by Springer Nature
- p. 617-628
Electrochemistry in Molten LiF-BeF2 Salt for Fluoride Salt-Cooled High Temperature Reactor Applications