Shaopeng Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Research Interests
Shaopeng Li has a total of 23 co-authors. Here are the top co-authors by number of shared publications:
- Teng Wu
University at Buffalo
5 shared publications - Kurtis Gurley
Graduate student, University of Florida, Gainesville, Florida
4 shared publications - Ryan A. Catarelli
Univ. of Florida
4 shared publications John W. van de Lindt
Colorado State Univ
3 shared publicationsYanlin Guo
Colorado State Univ
3 shared publications- Brian M. Phillips
Department of Civil and Environmental Engineering, University of Maryland
2 shared publications
Latest Publications
- 1 September 2026
- Published by American Society of Civil Engineers (ASCE) in Journal of Structural Engineering
- Vol. 152 (9)
Experimental Investigation of Compact Debris Flight in Highly Turbulent Winds
The wind fields that drive debris flight are highly turbulent due to both the inherent turbulence of the approaching flow and the additional turbulence generated by nearby buildings. The significant size disparity between debris and buildings makes consistent scaling in wind tunnel experiments particularly difficult and often requires large-scale tests (e.g., 1 ∶ 20 ). At such large scales, conventional boundary layer wind tunnel techniques suffer from a well-known limitation, a deficit of low-frequency turbulence energy. Due to these challenges, the existing wind tunnel experiments on windborne debris flight failed to simultaneously scale down the approaching turbulent flow, neighboring buildings, and debris. Although these experimental findings reflect the most advanced work to date, they may not faithfully represent real-world scenarios such as the complex urban environment as a result of these challenges. This study leverages recent advancements in wind tunnel testing capabilities to systematically investigate the effects of highly turbulent wind fields on compact debris flight. The building and debris sizes are carefully selected to replicate real-world conditions at a 1 ∶ 20 scale, where actively controlled fans are employed to mitigate the low-frequency turbulence deficit associated with large geometric scale. High-speed cameras combined with computer vision are used to track the three-dimensional flight trajectories of spherical debris within this complex wind environment. The experimental results reveal that (1) incorporating low-frequency turbulence to address the typical low-frequency energy deficit in large-scale experiments and thereby achieve a full-scale representative spectrum significantly increases the variability of debris flight, and (2) the presence of a neighboring building effectively alters the local wind field (wind direction, mean wind speed, turbulence intensity, and spectra) and leads to debris flight characteristics that differ substantially from those observed in unobstructed flow. This study provides an archival data set for validating numerical models that simulates debris flight in complex wind conditions.
- 1 September 2026
- Published by American Society of Civil Engineers (ASCE) in Journal of Structural Engineering
- Vol. 152 (9)
Experimental Investigation of Compact Debris Flight in Highly Turbulent Winds
The wind fields that drive debris flight are highly turbulent due to both the inherent turbulence of the approaching flow and the additional turbulence generated by nearby buildings. The significant size disparity between debris and buildings makes consistent scaling in wind tunnel experiments particularly difficult and often requires large-scale tests (e.g., 1 ∶ 20 ). At such large scales, conventional boundary layer wind tunnel techniques suffer from a well-known limitation, a deficit of low-frequency turbulence energy. Due to these challenges, the existing wind tunnel experiments on windborne debris flight failed to simultaneously scale down the approaching turbulent flow, neighboring buildings, and debris. Although these experimental findings reflect the most advanced work to date, they may not faithfully represent real-world scenarios such as the complex urban environment as a result of these challenges. This study leverages recent advancements in wind tunnel testing capabilities to systematically investigate the effects of highly turbulent wind fields on compact debris flight. The building and debris sizes are carefully selected to replicate real-world conditions at a 1 ∶ 20 scale, where actively controlled fans are employed to mitigate the low-frequency turbulence deficit associated with large geometric scale. High-speed cameras combined with computer vision are used to track the three-dimensional flight trajectories of spherical debris within this complex wind environment. The experimental results reveal that (1) incorporating low-frequency turbulence to address the typical low-frequency energy deficit in large-scale experiments and thereby achieve a full-scale representative spectrum significantly increases the variability of debris flight, and (2) the presence of a neighboring building effectively alters the local wind field (wind direction, mean wind speed, turbulence intensity, and spectra) and leads to debris flight characteristics that differ substantially from those observed in unobstructed flow. This study provides an archival data set for validating numerical models that simulates debris flight in complex wind conditions.
- Top Cited PapersOpen Access
- 11 February 2026
- Published by Elsevier in Building and Environment
- Vol. 294
A hierarchical deep learning model for predicting pedestrian-level urban winds
- 11 February 2026
- Published by Elsevier in Building and Environment
- Vol. 294
Top Cited PapersOpen AccessA hierarchical deep learning model for predicting pedestrian-level urban winds
- Open Access
- 1 September 2025
- Published by KEAI Publishing in Advances in Wind Engineering
- Vol. 2 (3)
Validating debris flight model in highly turbulent boundary layer flows using wind tunnel testing
- 1 September 2025
- Published by KEAI Publishing in Advances in Wind Engineering
- Vol. 2 (3)
Open AccessValidating debris flight model in highly turbulent boundary layer flows using wind tunnel testing
- 22 July 2025
- Published by Elsevier in Journal of Wind Engineering and Industrial Aerodynamics
- Vol. 265
A novel wind tunnel testing method for debris flight in turbulent winds
- 22 July 2025
- Published by Elsevier in Journal of Wind Engineering and Industrial Aerodynamics
- Vol. 265
A novel wind tunnel testing method for debris flight in turbulent winds
- Open Access
- 1 March 2025
- Published by KEAI Publishing in Advances in Wind Engineering
- Vol. 2 (1)
Optimizing post-hurricane recovery of interdependent infrastructure systems via knowledge-enhanced deep reinforcement learning
- 1 March 2025
- Published by KEAI Publishing in Advances in Wind Engineering
- Vol. 2 (1)
Open AccessOptimizing post-hurricane recovery of interdependent infrastructure systems via knowledge-enhanced deep reinforcement learning
- 25 September 2024
- Published by Elsevier in Journal of Wind Engineering and Industrial Aerodynamics
- Vol. 254
Physical simulation of downburst winds for civil structures: A review
- 25 September 2024
- Published by Elsevier in Journal of Wind Engineering and Industrial Aerodynamics
- Vol. 254
Physical simulation of downburst winds for civil structures: A review
- 11 September 2024
- Published by Elsevier in Energy and Buildings
- Vol. 323
Flow characteristics over flat building roof with different edge configurations for wind energy harvesting: A wind tunnel study
- 11 September 2024
- Published by Elsevier in Energy and Buildings
- Vol. 323
Flow characteristics over flat building roof with different edge configurations for wind energy harvesting: A wind tunnel study
- Open Access
- 11 October 2023
- Published by MDPI AG in Atmosphere
- Vol. 14 (10) , 1550
Hurricane Wave Loads on Spar-Type Floating Wind Turbines: A Comparison of Simulation Schemes
Floating wind turbines are sensitive to hurricane events. Since the turbine rotors are parked and the blades are feathered during hurricanes, the aerodynamic loads due to boundary-layer winds are relatively small compared to the hydrodynamic loads due to sea surface elevations. Hence, accurate modeling of the hurricane wave loads is crucial to ensure the safety of floating wind turbines. During a hurricane, large wave heights with severe flow separation make it inaccurate to use either linear panel method-based models (without nonlinear consideration associated with fluid viscosity) or Morison equation-based models (without unsteady consideration associated with fluid memory). Efforts have been made to advance simulation schemes of hurricane wave loads on spar-type floating wind turbines. This study systematically compares and assesses the efficacy of six hydrodynamic models available in the literature along with a newly proposed model. The ability of these seven hydrodynamic models to capture nonlinear and/or unsteady effects is investigated. As a demonstration example, the wave loads on a spar-type wind turbine are calculated using these seven models to highlight the underlying role of each simulation scheme in accurately acquiring the dynamic responses of this type of offshore floating structure in severe hurricane seas. It is found that the nonlinear viscous term in the Morison equation and hybrid model serves as an important nonlinear damping mechanism. The reduction of the low-frequency wave load and added mass in the modified hybrid model collectively leads to larger displacements compared to those based on the hybrid model. While the displacements based on the stretching method and Rainey’s equation are similarly larger than those based on the Morison equation, their nonlinear wave loads are much smaller than those in FNV theory.
- 11 October 2023
- Published by MDPI AG in Atmosphere
- Vol. 14 (10) , 1550
Open AccessHurricane Wave Loads on Spar-Type Floating Wind Turbines: A Comparison of Simulation Schemes
Floating wind turbines are sensitive to hurricane events. Since the turbine rotors are parked and the blades are feathered during hurricanes, the aerodynamic loads due to boundary-layer winds are relatively small compared to the hydrodynamic loads due to sea surface elevations. Hence, accurate modeling of the hurricane wave loads is crucial to ensure the safety of floating wind turbines. During a hurricane, large wave heights with severe flow separation make it inaccurate to use either linear panel method-based models (without nonlinear consideration associated with fluid viscosity) or Morison equation-based models (without unsteady consideration associated with fluid memory). Efforts have been made to advance simulation schemes of hurricane wave loads on spar-type floating wind turbines. This study systematically compares and assesses the efficacy of six hydrodynamic models available in the literature along with a newly proposed model. The ability of these seven hydrodynamic models to capture nonlinear and/or unsteady effects is investigated. As a demonstration example, the wave loads on a spar-type wind turbine are calculated using these seven models to highlight the underlying role of each simulation scheme in accurately acquiring the dynamic responses of this type of offshore floating structure in severe hurricane seas. It is found that the nonlinear viscous term in the Morison equation and hybrid model serves as an important nonlinear damping mechanism. The reduction of the low-frequency wave load and added mass in the modified hybrid model collectively leads to larger displacements compared to those based on the hybrid model. While the displacements based on the stretching method and Rainey’s equation are similarly larger than those based on the Morison equation, their nonlinear wave loads are much smaller than those in FNV theory.
- Open Access
Fast Prediction of Solitary Wave Forces on Box-Girder Bridges Using Artificial Neural Networks
The extreme shallow-water waves during a tropical cyclone are often simplified to solitary waves. Considering the lack of simulation tools to effectively and efficiently forecast wave forces on coastal box-girder bridges during tropical cyclones, this study investigates the impacts of solitary waves on box girders and accordingly develops a fast prediction model for solitary wave forces. Computational fluid dynamics (CFD) simulations are used to simulate the hydrodynamic forces on the bridge deck. A total of 368 cases are calculated for the parametric study by varying the submergence coefficients (Cs), relative wave heights (H/h) and deck aspect ratios (W/h). With the CFD simulation results as the training datasets, an artificial neural network (ANN) is trained utilizing the back-propagation algorithm. The maximum wave forces first increase and then decrease with the Cs, while they monotonically increase with H/h. For relatively large H/h and small Cs values, the relationship between the maximum wave forces and W/h presents strong nonlinearities. The observed correlation coefficients between the ANN predictions and the CFD results for the vertical and horizontal wave forces are 98.6% and 98.1%, respectively. The trained ANN-based model shows good prediction accuracy and could be used as an efficient model for the tropical cyclone risk analysis of coastal bridges.
Open AccessFast Prediction of Solitary Wave Forces on Box-Girder Bridges Using Artificial Neural Networks
The extreme shallow-water waves during a tropical cyclone are often simplified to solitary waves. Considering the lack of simulation tools to effectively and efficiently forecast wave forces on coastal box-girder bridges during tropical cyclones, this study investigates the impacts of solitary waves on box girders and accordingly develops a fast prediction model for solitary wave forces. Computational fluid dynamics (CFD) simulations are used to simulate the hydrodynamic forces on the bridge deck. A total of 368 cases are calculated for the parametric study by varying the submergence coefficients (Cs), relative wave heights (H/h) and deck aspect ratios (W/h). With the CFD simulation results as the training datasets, an artificial neural network (ANN) is trained utilizing the back-propagation algorithm. The maximum wave forces first increase and then decrease with the Cs, while they monotonically increase with H/h. For relatively large H/h and small Cs values, the relationship between the maximum wave forces and W/h presents strong nonlinearities. The observed correlation coefficients between the ANN predictions and the CFD results for the vertical and horizontal wave forces are 98.6% and 98.1%, respectively. The trained ANN-based model shows good prediction accuracy and could be used as an efficient model for the tropical cyclone risk analysis of coastal bridges.