GSGyörgy Sáfrán

György Sáfrán

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


György Sáfrán has a total of 22 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • Open Access

    Reductive Treatment of Pt Supported on Ti0.8Sn0.2O2-C Composite: A Route for Modulating the Sn–Pt Interactions

    by Cristina Silva, Khirdakhanim Salmanzade, Irina Borbáth, Erzsébet Dódony, Dániel Olasz, György Sáfrán, Andrei Kuncser, Erzsébet Pászti-Gere, András Tompos, Zoltán Pászti

    The composites of transition metal-doped titania and carbon have emerged as promising supports for Pt electrocatalysts in PEM fuel cells. In these multifunctional supports, the oxide component stabilizes the Pt particles, while the dopant provides a co-catalytic function. Among other elements, Sn is a valuable additive. Stong metal-support interaction (SMSI), i.e., the migration of a partially reduced oxide species from the support to the surface of Pt during reductive treatment is a general feature of TiO2-supported Pt catalysts. In order to explore the influence of SMSI on the stability and performance of Pt/Ti0.8Sn0.2O2-C catalysts, the structural and catalytic properties of the as prepared samples measured using XRD, TEM, XPS and electrochemical investigations were compared to those obtained from catalysts reduced in hydrogen at elevated temperatures. According to the observations, the uniform oxide coverage of the carbon backbone facilitated the formation of Pt–oxide–C triple junctions at a high density. The electrocatalytic behavior of the as prepared catalysts was determined by the atomic closeness of Sn to Pt, while even a low temperature reductive treatment resulted in Sn–Pt alloying. The segregation of tin oxide on the surface of the alloy particles, a characteristic material transport process in Sn–Pt alloys after oxygen exposure, contributed to a better stability of the reduced catalysts.


  • Open Access

    Review on High-Throughput Micro-Combinatorial Characterization of Binary and Ternary Layers towards Databases

    by György Sáfrán, Péter Petrik, Noémi Szász, Dániel Olasz, Nguyen Quang Chinh, Miklós Serényi

    The novel, single-sample concept combinatorial method, the so-called micro-combinatory technique, has been shown to be suitable for the high-throughput and complex characterization of multicomponent thin films over an entire composition range. This review focuses on recent results regarding the characteristics of different binary and ternary films prepared by direct current (DC) and radiofrequency (RF) sputtering using the micro-combinatorial technique. In addition to the 3 mm diameter TEM grid used for microstructural analysis, by scaling up the substrate size to 10 × 25 mm, this novel approach has allowed for a comprehensive study of the properties of the materials as a function of their composition, which has been determined via transmission electron microscopy (TEM), scanning electron microscopy (SEM), Rutherford backscattering spectrometry (RBS), X-ray diffraction analysis (XRD), atomic force microscopy (AFM), spectroscopic ellipsometry, and nanoindentation studies. Thanks to the micro-combinatory technique, the characterization of multicomponent layers can be studied in greater detail and efficiency than before, which is beneficial for both research and practical applications. In addition to new scientific advances, we will briefly explore the potential for innovation with respect to this new high-throughput concept, including the creation of two- and three-component thin film databases.


  • Open Access

    Investigation of the RF Sputtering Process and the Properties of Deposited Silicon Oxynitride Layers under Varying Reactive Gas Conditions

    by Nikolett Hegedüs, Csaba Balázsi, Tamás Kolonits, Dániel Olasz, György Sáfrán, Miklós Serényi, Katalin Balázsi

    In a single process run, an amorphous silicon oxynitride layer was grown, which includes the entire transition from oxide to nitride. The variation of the optical properties and the thickness of the layer was characterized by Spectroscopic Ellipsometry (SE) measurements, while the elemental composition was investigated by Energy Dispersive Spectroscopy (EDS). It was revealed that the refractive index of the layer at 632.8 nm is tunable in the 1.48–1.89 range by varying the oxygen partial pressure in the chamber. From the data of the composition of the layer, the typical physical parameters of the process were determined by applying the Berg model valid for reactive sputtering. In our modelling, a new approach was introduced, where the metallic Si target sputtered with a uniform nitrogen and variable oxygen gas flow was considered as an oxygen gas-sputtered SiN target. The layer growth method used in the present work and the revealed correlations between sputtering parameters, layer composition and refractive index, enable both the achievement of the desired optical properties of silicon oxynitride layers and the production of thin films with gradient refractive index for technology applications.


  • Open Access

    Poisoning and Reuse of Supported Precious Metal Catalysts in the Hydrogenation of N-Heterocycles, Part II: Hydrogenation of 1-Methylpyrrole over Rhodium

    by László Hegedűs, Tien Thuy Thanh Nguyen, Krisztina Lévay, Krisztina László, György Sáfrán, Andrea Beck

    Poisoning effect of nitrogen on heterogeneous, supported precious metal catalysts, along with their recycling, was further examined in the liquid-phase hydrogenation of 1-methylpyrrole (MP) to 1-methylpyrrolidine (MPD) over rhodium on carbon or γ-alumina, in methanol, under non-acidic conditions, at 25–50 °C and 10 bar. Reusing a spent, unregenerated 5% Rh/C or 5% Rh/γ-Al2O3 catalyst, it was found that the conversion of this model substrate and the activity of the catalyst were strongly dependent on the amount of catalyst, the type of support, the catalyst pre- or after-treatment, the temperature, and the number of recycling, respectively. An unexpected catalytic behaviour of rhodium was observed when it was used in a prehydrogenated form, because no complete conversion of MP was achieved over even the fresh Rh/C or Rh/γ-Al2O3, contrary to the untreated one. In addition, there was a significant difference in the reusability and activity of these rhodium catalysts, depending on their supports (activated carbon, γ-alumina). These diversions were elucidated by applying dispersion (O2- and H2-titration), temperature-programmed desorption of ammonia (NH3-TPD), and transmission electron microscopy (TEM) measurements.