BZBiao Zhou

Biao Zhou

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article

Previous Organizations / Institutes

The organizations / institutes from the scholar's other articles in the past ten years


Biao Zhou has a total of 25 co-authors. Here are the top co-authors by number of shared publications:


Latest Publications

  • A Nonisothermal Numerical Well Test Model for Multistage Fractured Horizontal Wells in Deep Shale Gas Reservoirs

    by Zekai Tang, Zhiming Chen, Biao Zhou, Zhigang Song, Hanhan Cai, Kamy Sepehrnoori

    Summary: Reliable pressure-transient interpretation for deep shale gas wells requires the thermal response of fractured reservoirs to be considered. This study develops a fully coupled nonisothermal numerical well test model for multistage fractured horizontal wells (MFHWs). The model is formulated within the analytically enhanced embedded discrete fracture model (EDFM) framework. It couples mass and energy conservation, matrix-fracture and fracture-fracture transfer, temperature-dependent adsorption/desorption with the associated energy exchange, and pressure- and temperature-sensitive permeability. Methane properties are obtained from pressure-temperature lookup tables generated using CoolProp. The model is verified against the thermal numerical model in commercial well test software. It reproduces the corresponding pressure-transient responses while requiring only 0.366% of the solution time required by the commercial software for the verification case. A pressure-derivative deviation coefficient is introduced to quantify the error caused by neglecting temperature variations. The pressure-transient response is divided into seven flow periods. Thermal effects are limited during wellbore storage and early fracture flow, but accumulate as pressure depletion propagates into the matrix and fracture network. The deviation coefficient increases to approximately 0.08 during desorption, 0.11 during interfracture interference, and 0.65 at the end of boundary-dominated flow. Sensitivity analyses show that effective matrix permeability and hydraulic fracture spacing control the spatial extent and timing of thermal disturbances. Adsorption density, isosteric heat of adsorption, and rock specific heat capacity strongly affect the deviation magnitude, whereas rock thermal conductivity has a smaller influence. Increasing adsorption density from 5 kg/m³ to 50 kg/m³ increases the terminal deviation coefficient from 0.34 to 0.85. Increasing rock specific heat capacity from 500 J/(kg·K) to 2,000 J/(kg·K) reduces it from 0.80 to 0.30. Application to a pressure-buildup test in the WY Block provides a good match to field data. The field-case deviation coefficient reaches 0.59 at the end of shut-in, confirming that thermal history can materially affect shale gas pressure-transient interpretation.


  • A hybrid dual-medium discrete fracture model for horizontal wells with complex fracture systems and waterflooding interference

    by Baoyun Zhang, Zhiming Chen, Jiapeng Han, Biao Zhou, Haifeng Zhu, Kamy Sepehrnoori

    Pressure transport in tight reservoirs is controlled by rapid flow through conductive fractures, delayed exchange between the matrix and fractures, and the interaction of pressure disturbances caused by injection and production. These coupled processes remain insufficiently understood. This study develops a hybrid model that combines a dual-medium representation with explicit fractures for oil–water flow in multistage fractured horizontal wells under waterflooding. Hydraulic fractures and major natural fractures are represented explicitly, whereas the stimulated reservoir volume is described as a dual-medium system. A shape factor derived from pressure diffusion tests on irregular matrix blocks is introduced to characterize matrix–fracture exchange, and a pressure support coefficient is defined to quantify injection support. The formulation reproduces the Lim–Aziz solution for a cubic block with a relative difference of 2.54%, and the implementation is verified against KAPPA. The pressure response exhibits eight flow regimes. The late time downward departure of the pressure and pressure derivative curves results from the overlap of pressurization caused by injection and depletion caused by production. A continuous fracture pathway between the injector and producer accelerates pressure communication and water migration, producing the strongest pressure support but the greatest risk of water breakthrough among the tested cases. Increasing the injection rate strengthens and advances the interference response, whereas reducing well spacing shortens its arrival time. A field case demonstrates the applicability of the model to pressure transient matching and fracture parameter interpretation.

  • A Numerical Well Test Model for Fractured Wells in Fractured Shale Gas Reservoirs Considering Multiple Flow Mechanisms

    by Zhiming Chen, Biao Zhou, Wei Yu, Kamy Sepehrnoori

    Summary: The reservoirs of shale gas are typified by their low porosity and permeability, which generally necessitates the implementation of large-scale hydraulic fracturing for economic development, thereby resulting in highly complex flow mechanisms. Well test analysis is an effective method for reservoir parameter inversion, which aids in the efficient development of shale gas. However, there is currently a lack of an efficient and accurate well test model for shale gas reservoirs. To address this issue, this study proposes a numerical well test model for fractured shale gas reservoirs that incorporates various flow mechanisms, including adsorption/desorption, diffusion, stress sensitivity, fracture closure, and non-Darcy flow. First, a transient transmissibility correction factor is introduced to account for fracture geometries and early-time transient effects, thereby enhancing model accuracy. Subsequently, the model couples gas transport equations with geomechanical effects and Langmuir isothermal adsorption, which are solved using the finite volume method combined with Newton-Raphson iteration. The subsequent step involves the validation of the model’s accuracy. This is achieved by comparing the model’s results with those derived from a standard software package. Sensitivity analyses further reveal that natural fractures reduce pressure loss by enhancing fluid supply, while adsorption delays the pressure decline at later stages; additionally, stress sensitivity and fracture closure intensify the pressure drop, particularly in soft shales. Moreover, the model identifies eight flow stages, including wellbore storage and skin effect, bilinear flow, linear flow, fluid supply, desorption, interfracture interference, transitional flow, and boundary-dominated flow. Finally, a field case study of a shale gas well in the Longmaxi Formation successfully matches production data, yielding inverted parameters such as matrix permeability and fracture conductivity. Overall, this work provides a powerful tool for shale gas reservoirs. The tool is capable of evaluating fractures, optimizing gas reservoir development, and interpreting well test data.


  • Open Access

    Expression and clinical significance of LncRNA Kcnq1ot1 in type 2 diabetes mellitus patients with osteoarthritis

    by Hai Hu, Can Zhou, Binbin Jiang, Song Wu, Ting Cai, Jie Yu, Liguo Zhu, Biao Zhou

    We aimed to investigate the expression of lncRNA Kcnq1ot1 in T2DM patients with OA, as well as its correlation with serum inflammatory factors and clinical outcomes of the patients. This prospective observational cohort study included a total of 50 patients with type 2 diabetes mellitus (T2DM), 50 patients with osteoarthritis (OA), and 51 patients with both T2DM and OA between March 2020 and March 2023. The serum TNF-α, interleukin (IL)-6, IL-1β and C-reactive protein (CRP) levels were measured using enzyme-linked immunosorbent assay (ELISA). To determine the expression of LncRNA Kcnq1ot1, RT-qPCR was used. Demographic, clinical statistics, lipid metabolism and nutritional indicators were collected. All data used SPSS 26.0 to statistical analyses. The T2DM + OA group had significantly higher BMI and LDLC levels compared to the T2DM group (p < 0.05). The serum levels of LncRNA Kcnq1ot1 were significantly higher in the T2DM + OA group compared to the OA group and T2DM group (p < 0.05). Pearson’s analysis supported a positive correlation between LncRNA Kcnq1ot1 and IL-6 and IL-1β levels. In addition, LncRNA Kcnq1ot1 could be a potential biomarker for diagnosing the occurrence of T2DM patients with OA. Moreover, LncRNA Kcnq1ot1, BMI, IL-6, Low density lipoprotein cholesterol (LDLC) were the risk factors for T2DM patients with OA. This study showed that the serum LncRNA Kcnq1ot1 levels was remarkably elevated in T2DM patients with OA. This study might provide new targets and a comprehensive approach to treatment in T2DM patients with OA.


  • Transient Flow Analysis of Multistage Fractured Horizontal Wells with Varied Natural Fractures Connection Relationships

    by Jiapeng Han, Zhiming Chen, Biao Zhou

    Summary: In this paper, we introduce a semianalytical model for analyzing the transient pressure behavior of a multistage fractured horizontal well (MFHW) with varying fracture distributions, and the pressure distribution in matrix and fracture networks. The model focuses on both matrix and fracture network domains. Matrix flow is simulated using the line-source function, with 1D flow assumed for fractures. The block center grid analysis technique is used to simulate pressure within the fracture network, utilizing the principle of pressure superposition for matrix pressure calculations. First, the accuracy of the proposed model is confirmed by comparing its results with the numerical model. Then, we identify six flow stages in an MFHW with better-connected natural fractures (NFs): bilinear flow, NFs fluid supply, linear flow, early pseudoradial flow, elliptical flow, and latter pseudoradial flow. Furthermore, sensitivity analysis on operational factors [cluster spacing (CS), stage spacing, stage number, hydraulic fracture (HF) half-length, and fracture conductivity] and geological factors (NF distribution) evaluates their impact on dimensionless pressure and its derivative. The pressure distribution characteristics across different flow regimes were also analyzed using fracture and matrix pressure distribution maps. These analyses offer valuable insights into the development of MFHWs in reservoirs with NFs. A case study in the Lucaogou shale oil reservoir of the Junggar Basin demonstrates that varying connectivity of NFs significantly impacts the pressure transient behavior of an MFHW. Neglecting the influence of NFs resulted in higher errors compared with models with NFs, highlighting the critical role of NFs in accurately characterizing reservoir behavior.


  • A three-dimensional numerical well-test model for pressure transient analysis in fractured horizontal wells with secondary fractures

    by Biao Zhou, Zhiming Chen, Xurong Zhao, Bin Wang, Haizhu Wang, Kamy Sepehrnoori

    During oil and gas reservoir development, multi-stage horizontal wells (MFHWs) and hydraulic fracturing techniques can effectively increase estimated ultimate recovery. However, there still lacks an understanding of the three-dimensional (3D) pressure transient behaviors of multi-stage fractured horizontal wells with secondary fractures. To narrow this gap, a three-dimensional numerical well-test model based on a discrete fracture model and unstructured tetrahedral grids is developed to study the pressure transient behaviors of MFHWs with secondary fractures. The pressure transient solutions of MFHWs with secondary fractures have been demonstrated by model verifications. The results show that the proposed model can accurately capture the complex transient flow around fractures, including early radial flow that is not easily captured by two-dimensional numerical well test models. The proposed model classifies the flow regimes of a MFHW as: wellbore storage and skin effects, early radial flow, bilinear flow, linear flow, elliptical flow, pseudo radial flow, and pseudo-boundary dominated flow. It is found that the fracture geometry has a relatively large effect on the shape of the pressure derivative curve in this work. The hydraulic fracture half-length has the greatest impact on the pressure transient behaviors of the MFHW, followed by fracture height and secondary fracture half-length, as found in this study. Additionally, fracture parameters are evaluated, and actual well testing data are interpreted, taking into account the fracture height. This work is meaningful to understand the three-dimensional pressure transient behaviors of MFHWs with secondary fractures.


  • Unravelling the molecular and biochemical responses in cotton plants to biochar and biofertilizer amendments for Pb toxicity mitigation

    by Biao Zhou, Tiejian Zhang, Fei Wang

    Over the past few years, there has been a rising interest in employing biochar (BC) and biofertilizers (BF) as a means of restoring soils that have been polluted by heavy metals. The primary objective of this study was to examine how the application of BC and BF affects the ability of cotton plants to withstand Pb toxicity at varying concentrations (0, 500, and 1000 mg/kg soil). The findings revealed that exposure to Pb stress, particularly at the 1000 mg/kg level, led to a decline in the growth and biomass of cotton plants. Pb toxicity triggered oxidative damage, impaired the photosynthetic apparatus, and diminished the levels of photosynthetic pigments. By increasing the expression of Rubisco-S, Rubisco-L, P5CR, and PRP5 genes and regulating proline metabolism, BC and BF increased the levels of proline and photosynthetic pigments and protected the photosynthetic apparatus. The application of BC and BF resulted in an upregulation of genes such as CuZnSOD, FeSOD, and APX1, as well as an increase in the activity of the glyoxalase system and antioxidant enzymes. These changes enhanced the antioxidant capacity of the plants and provided protection to membrane lipids from oxidative stress caused by Pb. The inclusion of BC and BF offered protection to photosynthesis and other essential intracellular processes in leaves by minimizing the transfer of Pb to leaves and promoting the accumulation of thiol compounds. This protective effect helped mitigate the negative impact of the toxic metal Pb on leaf function. By improving plant tolerance, reducing metal transfer, strengthening the antioxidant defense system, and enhancing the level of protective substances, these amendments show promise as valuable tools in tackling heavy metal pollution.


  • Pressure Transient Behaviors of Discretely Fractured Reservoirs Using a Numerical Discrete Fracture Model

    by Zhiming Chen, Biao Zhou, Shaoqi Zhang, Wei Yu

    Summary: The conventional dual-porosity model (Warren and Root 1963) may not apply to naturally fractured reservoirs (NFRs), which have poorly connected fractures. To narrow this gap, a new discrete fracture model (DFM)-based numerical well-testing model is developed for pressure transient analysis in vertical wells interacting with natural fractures (NFs). The numerical model is based on a DFM and unstructured perpendicular bisector (PEBI) grid system. The accuracy and practicality of the proposed model have been demonstrated by model verifications with a commercial numerical software. The results show that the flow regimes of the vertical well interacting with NFs can be divided into wellbore storage and skin effects, bilinear flow, linear flow, radial flow, NF effect, and boundary-dominated flow. This is the radial flow of the formation before pressure propagates to NFs, which is virtually quite different from that in the conventional dual-porosity model. However, there are no bilinear and linear flow stages in the vertical well interacting with no NFs. It is found that the vertical well interacting with NFs has a lower pressure depletion. It is also found that the “V-shape” caused by the NF effect in the pressure derivative curve becomes deeper when there are more NFs, longer NFs, and higher fracture conductivity. Furthermore, the “V-shape” appears earlier, and the duration of the NF effect is longer as the number of NFs increases. Besides, with the decrease of the distance between the fracture and the well, the impacts of NFs on pressure transient behaviors of the vertical well are more significant. This work provides a meaningful way to understand the pressure transient behaviors of discrete NFs.