Yadi Li
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Research Subjects
Yadi Li has a total of 7 co-authors. Here are the top co-authors by number of shared publications:
- Jie Zhang
School of Food Science and Technology, Jiangnan University, Wuxi 214122, China
2 shared publications - Peng Zhou
School of Food Science and Technology, Jiangnan University, Wuxi 214122, China
2 shared publications - Joe Mac Regenstein
Department of Food Science, Cornell University, Ithaca, USA
1 shared publication - Shitong Zhang
State Key Laboratory of Food Science and Technology, Jiangnan University, Wuxi 214122, China
1 shared publication - Yuan Xie
State Key Laboratory of Food Science and Technology, Jiangnan University, Wuxi 214122, China
1 shared publication - Yun He
State Key Laboratory of Food Science and Technology, Jiangnan University, Wuxi 214122, China
1 shared publication
Latest Publications
- Open Access
Effect of Coagulant and Treatment Conditions on the Gelation and Textural Properties of Acidic Whey Tofu
This study aimed to investigate the properties of acidic whey tofu gelatin generated from two acidic whey coagulants by pure fermentation of Lactiplantibacillus paracasei and L. plantarum, as well as the characteristics of acidic whey tofu. The optimal holding temperature and the amount of coagulants added were determined based on the pH, water-holding capacity, texture, microstructure, and rheological properties of tofu gelation. Then, the differences in quality between tofu produced by pure bacterial fermentation and by natural fermentation were investigated under optimal tofu gelatin preparation conditions. The tofu gelatin presented the best texture at 37 °C with a 10% addition of coagulants fermented by both L. paracasei and L. plantarum. Under these conditions, the coagulant produced by the fermentation of L. plantarum resulted in a shorter formation time and stronger tofu gelatin compared with that produced from L. paracasei. Tofu produced by the fermentation of L. paracasei had higher pH, less hardness, and a rougher network structure, whereas tofu produced by the fermentation of L. plantarum was closer to tofu produced by natural fermentation in terms of pH, texture, rheology, and microstructure.
Open AccessEffect of Coagulant and Treatment Conditions on the Gelation and Textural Properties of Acidic Whey Tofu
This study aimed to investigate the properties of acidic whey tofu gelatin generated from two acidic whey coagulants by pure fermentation of Lactiplantibacillus paracasei and L. plantarum, as well as the characteristics of acidic whey tofu. The optimal holding temperature and the amount of coagulants added were determined based on the pH, water-holding capacity, texture, microstructure, and rheological properties of tofu gelation. Then, the differences in quality between tofu produced by pure bacterial fermentation and by natural fermentation were investigated under optimal tofu gelatin preparation conditions. The tofu gelatin presented the best texture at 37 °C with a 10% addition of coagulants fermented by both L. paracasei and L. plantarum. Under these conditions, the coagulant produced by the fermentation of L. plantarum resulted in a shorter formation time and stronger tofu gelatin compared with that produced from L. paracasei. Tofu produced by the fermentation of L. paracasei had higher pH, less hardness, and a rougher network structure, whereas tofu produced by the fermentation of L. plantarum was closer to tofu produced by natural fermentation in terms of pH, texture, rheology, and microstructure.
- Open Access
Effects of Drying Methods on Serum Protein Powder Properties
This study investigated the effects of atmospheric spray drying (ASD), low-pressure spray drying (LPSD) and freeze drying (FD) on the properties of serum protein powder, including the basic characteristics of the powder, bioactive proteins and changes in protein profile, using a proteomics approach. The total solid and water activity of the powder obtained by FD was significantly higher than that obtained by ASD and LPSD. There was no significant difference in the content of fat, lactose or solubility between the three kinds of powders. The concentration and activity of the proteins/enzymes in the serum protein powder made from LPSD were not altered after drying, similar to FD, although both parameters decreased after ASD. The microstructure of the powder observed by scanning electron microscopy indicated that the powder manufactured by ASD and LPSD was spherical in structure, while that manufactured by FD was flake-like. In total, there were 245 proteins identified in the serum protein concentrate and powder from the three drying methods. These findings indicate that LPSD is an effective and cost-saving method for producing serum whey protein powder.
Open AccessEffects of Drying Methods on Serum Protein Powder Properties
This study investigated the effects of atmospheric spray drying (ASD), low-pressure spray drying (LPSD) and freeze drying (FD) on the properties of serum protein powder, including the basic characteristics of the powder, bioactive proteins and changes in protein profile, using a proteomics approach. The total solid and water activity of the powder obtained by FD was significantly higher than that obtained by ASD and LPSD. There was no significant difference in the content of fat, lactose or solubility between the three kinds of powders. The concentration and activity of the proteins/enzymes in the serum protein powder made from LPSD were not altered after drying, similar to FD, although both parameters decreased after ASD. The microstructure of the powder observed by scanning electron microscopy indicated that the powder manufactured by ASD and LPSD was spherical in structure, while that manufactured by FD was flake-like. In total, there were 245 proteins identified in the serum protein concentrate and powder from the three drying methods. These findings indicate that LPSD is an effective and cost-saving method for producing serum whey protein powder.