MIMarija Ivaškienė

Marija Ivaškienė

*This is an algorithmically generated author record based on publicly available information.

Current Organizations / Institutes

The organizations/institutes from the scholar's latest article


Marija Ivaškienė has a total of 20 co-authors. Here are the top co-authors by number of shared publications:

  • Agne Mazurkeviciute

    Institute of Pharmaceutical Technologies, Faculty of Pharmacy, Medical Academy, Lithuanian University of Health Sciences, LT-50161 Kaunas, Lithuania

    2 shared publications
  • Gintaras Daunoras

    Dr. L. Kriaučeliūnas Small Animal Clinic, Faculty of Veterinary Medicine, Lithuanian University of Health Sciences, LT-47181 Kaunas, Lithuania

    2 shared publications
  • Inga Matulyte

    Department of Drug Technology and Social Pharmacy, Lithuanian University of Health Sciences, LT-50161 Kaunas, Lithuania

    2 shared publications
  • Modestas Žilius

    Department of Clinical Pharmacy, Faculty of Pharmacy, Academy of Medicine, Lithuanian University of Health Sciences, Sukilėlių av. 13, 50162 Kaunas, Lithuania

    2 shared publications
  • Aidas Grigonis

    Department of Dr. L. Kriauceliunas Small Animal Clinic, Faculty of Veterinary Medicine, Lithuanian University of Health Sciences, Tilzes Str. 18, LT-47181 Kaunas, Lithuania

    1 shared publication
  • Dalia Juodžentė

    Dr. L. Kriaučeliūnas Small Animal Clinic, Faculty of Veterinary, Veterinary Academy, Lithuanian University of Health Sciences, 47181 Kaunas, Lithuania

    1 shared publication

Latest Publications

  • Open Access

    Effect of In Vitro Ruminal pH on Zearalenone Degradation and Interaction with Other Mycotoxins in a Static Gastrointestinal Model

    by Rimvydas Falkauskas, Jurgita Jovaišienė, Gintarė Vaičiulienė, Sigita Kerzienė, Ingrida Jacevičienė, Eugenijus Jacevičius, Inga Jarmalaitė, Marija Ivaškienė, Gintaras Daunoras, Rasa Želvytė, et al.

    The degradation of zearalenone (ZEN) in the rumen of dairy cows is influenced by rumen pH, which is a key factor affecting this process. The aim of this study was to investigate the variation of ZEN in interaction with other mycotoxins at different ruminal pH environments (physiological (pH 6.5) and acidic (pH 5.5)) using an in vitro rumen model. Rumen fluid was collected from the caudoventral part of the rumen of cows using a pharyngeal–esophageal probe. To determine the changes in different mycotoxins (ZEN; AFLB1; DON; T-2) in the rumen of cows, a model rumen system was used, and mycotoxins concentrations were detected by HPLC. The study found that at pH 6.5, ZEN alone and in combination with other mycotoxins (DON; T-2; AFLB1) significantly (p < 0.05) reduced ZEN levels compared to the rumen environment at pH 5.5. It was observed that α-zearalenol (α-ZEL) and β-zearalenol (β-ZEL) concentrations were generally higher at a rumen pH of 6.5 compared to pH 5.5, averaging 47.09 µg/L and 35.23 µg/L, respectively. Additionally, the frequency of detection for both α-ZEL and β-ZEL was greater at pH 6.5 than at pH 5.5. A comparison of α-ZEL concentrations in rumen samples at pH 5.5 showed a 20% increase from the 6th to the 9th hour of the test, while β-ZEL levels remained unchanged over the same period.


  • Open Access

    Modeling, the Optimization of the Composition of Emulgels with Ciclopirox Olamine, and Quality Assessment

    by Agne Mazurkeviciute, Inga Matulyte, Marija Ivaskiene, Modestas Zilius

    The design and development of pharmaceutical products require specific knowledge, time, and investment. Response surface methodology (RSM) is a widely used technique in the design of experiments (DoE) to optimize various processes and products. The aim of this study was to model and produce experimental emulgels containing 1% ciclopirox olamine and to evaluate their physical, rheological, and mechanical properties and their ability to release ciclopirox olamine. The objective was to optimize the composition of the experimental emulgel containing 1% ciclopirox olamine by applying a central composite design based on selected criteria. The surfactant (polysorbate 80) had the greatest influence on the physical, rheological, and mechanical properties of the emulgels, as well as on the release of ciclopirox olamine from these systems. During the optimization process, an emulgel of optimal composition was generated containing 38.27% mineral oil, 6.56% polysorbate 80, and 55.17% hydrogel containing 1% ciclopirox olamine, meeting specified criteria (dependent variables) including the maximum flux of ciclopirox olamine, the minimum sol–gel transition temperature (Tsol/gel), and the minimum particle size of the oil phase. The oil phase particle size (D50) of this emulgel was determined to be 0.337 µm, the system Tsol/gel was 9.1 °C, and the flux of ciclopirox olamine from this gel matrix was calculated to be 1.44 mg/cm2. This emulgel of optimal composition could be used to treat fungal skin diseases.


  • Open Access

    A Comparative Study of the Chemical Properties and Antibacterial Activity of Four Different Ozonated Oils for Veterinary Purposes

    by Gabrielė Slavinskienė, Aidas Grigonis, Marija Ivaškienė, Ingrida Sinkevičienė, Vaida Andrulevičiūtė, Liudas Ivanauskas, Dalia Juodžentė, Kristina Ramanauskienė, Gintaras Daunoras

    Infectious skin diseases are quite common in veterinary medicine. These diseases can be caused by both bacteria and pathogenic fungi. Antimicrobial drugs are usually used for treatment. An alternative to these drugs could be ozonated oils with antibacterial and antifungal properties. Four different ozonated oils (linseed, hemp seed, sunflower, and olive) were tested in order to develop an optimal pharmaceutical form for the treatment of skin infections in animals. Chemical parameters such as acid and acidity value, iodine and peroxide value, viscosity, and infrared spectres were analysed. The ozonation of oils resulted in changes in their chemical composition. The antimicrobial activity of the tested oils was evaluated by determining the minimum inhibitory concentrations and zones of inhibition in agar. After ozonation, the acid content increased in all the tested oils. The highest acidity was found in linseed oil (13.00 ± 0.11 mg KOH/g; 6.1%). Hemp oil, whose acidity was also significant (second only to linseed oil), was the least acidified by ozonation (11.45 ± 0.09 mg KOH/g; 5.75%). After ozonation, the iodine value in oils was significantly reduced (45–93%), and the highest amounts of iodine value remained in linseed (47.50 ± 11.94 g Iodine/100 g oil) and hemp (44.77 ± 1.41 Iodine/100 g oil) oils. The highest number of peroxides after the ozonation of oils was found in sunflower oil (382 ± 9.8 meqO2/kg). It was found that ozonated hemp and linseed oils do not solidify and remain in liquid form when the temperature drops. The results showed a tendency for the reference strains of S. aureus, E. faecalis, and E. coli to have broader zones of inhibition (p < 0.001) than clinical strains. Overall, ozonated linseed oil had the highest antibacterial activity, and ozonated olive oil had the lowest, as determined by both methods. It was found that ozonated linseed oil was the most effective on bacteria, while the most sensitive were S. aureus ATCC 25923, MRSA, and S. pseudointermedius (MIC 13.5 mg/mL, 4.6 mg/mL, and 13.5 mg/mL, respectively, and sterile zones 20.67 ± 0.98 mm, 20.25 ± 0.45 mm, and 18.25 ± 0.45 mm, respectively). The aim and new aspect of this work is the characterisation of selected ozonated vegetable oils, especially hemp oil, according to chemical and antibacterial parameters, in order to select suitable candidates for preclinical and clinical animal studies in the treatment of bacterial or fungal skin infections in terms of safety and efficacy.


  • Open Access

    Assessment of Physical, Mechanical, Biopharmaceutical Properties of Emulgels and Bigel Containing Ciclopirox Olamine

    by Agnė Mazurkevičiūtė, Inga Matulytė, Marija Ivaškienė, Modestas Žilius

    Emulsions are thermodynamically unstable systems and it is difficult to produce biphasic formulations with large amounts of oil. The aim of our study was to prepare biphasic formulations containing 1% ciclopirox olamine and to determine the influence of the method of oil incorporation (without and with emulsifier and gelifier) on the physical (pH, particle size, rheological properties), mechanical, and biopharmaceutical properties of the formulations. It was found that the use of a poloxamer 407 gel as the hydrophase could result in a stable formulation when an oil with (EPG) or without an emulsifier (APG) or oleogel (OPG) was used as the oily phase. The results of the studies showed that the addition of an emulsifier (polysorbate 80) led to a decrease in the sol-gel temperature, a slower release of ciclopirox olamine, and a higher stability in the freeze–thaw test. However, regardless of the way the oil is incorporated, the particles are distributed in the same range and the antifungal activity against T. rubrum is the same. It is possible to create a biphasic formulation with a large amount of oil and poloxamer gel, but for greater stability, it is recommended to include an emulsifier in the composition.