Anastassiya A. Khamlenko
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Research Subjects
Anastassiya A. Khamlenko has a total of 13 co-authors. Here are the top co-authors by number of shared publications:
- Albina R. Sassykova
Almaty College of Finance and Economics, 39a, Ryskulbekov Street, Almaty 050042, Kazakhstan
2 shared publications - Larissa R. Sassykova
Al-Farabi Kazakh National University
2 shared publications - Tatyana V. Shakiyeva
Al-Farabi Kazakh National University
2 shared publications - Aigul A. Batyrbayeva
Faculty of Chemistry and Chemical Technology, al-Farabi Kazakh National University, Almaty 050040, Kazakhstan
1 shared publication - Akmaral Gazizovna Ismailova
Faculty of Chemistry and Chemical Technology, Al-Farabi Kazakh National University, 71 Al-Farabi Avenue, 050040 Almaty, Kazakhstan
1 shared publication Albina Muratova
Al-Farabi Kazakh National University, 050040 Almaty, Kazakhstan
1 shared publication
Latest Publications
- Open Access
- 4 July 2022
- Published by Ural Federal University in Chimica Techno Acta
- Vol. 9 (3) , 20229301
Catalytic cracking of M-100 fuel oil: relationships between origin process parameters and conversion products
The development of technologies for processing oil residues is relevant and promising for Kazakhstan, since the main oil reserves of hydrocarbons in the country are in heavy oils. This paper describes the study of the influence of technological modes on the yield and hydrocarbon composition of products formed because of cracking of commercial fuel oil and fuel oil M-100 in the presence of air in the reactor. For catalysts preparation, natural Taizhuzgen zeolite and Narynkol clay were used. It was found that the introduction of air into the reaction zone, in which oxygen is the initiator of the cracking process, significantly increases the yield of the middle distillate fractions. In the presence of air, the yield of diene and cyclodiene hydrocarbons significantly increases compared to cracking in an inert atmosphere. According to the data of IR spectral analysis of M-100 grade oil fractions, in addition to normal alkanes, the final sample contains a significant amount of olefinic and aromatic hydrocarbons. On the optimal catalyst, owing to oxidative cracking of fuel oil, the following product compositions (in %) were established: Fuel oil M-100: gas – 0.8, gasoline – 1.1, light gas oil – 85.7, heavy residue – 11.9, loss – 0.5 and total – 100.0%; commodity Fuel oil (M-100): gas – 3.3, gasoline – 8.4, light gas oil – 84.3, heavy residue – 4.0, loss – 0 and total – 100.0%.
- 4 July 2022
- Published by Ural Federal University in Chimica Techno Acta
- Vol. 9 (3) , 20229301
Open AccessCatalytic cracking of M-100 fuel oil: relationships between origin process parameters and conversion products
The development of technologies for processing oil residues is relevant and promising for Kazakhstan, since the main oil reserves of hydrocarbons in the country are in heavy oils. This paper describes the study of the influence of technological modes on the yield and hydrocarbon composition of products formed because of cracking of commercial fuel oil and fuel oil M-100 in the presence of air in the reactor. For catalysts preparation, natural Taizhuzgen zeolite and Narynkol clay were used. It was found that the introduction of air into the reaction zone, in which oxygen is the initiator of the cracking process, significantly increases the yield of the middle distillate fractions. In the presence of air, the yield of diene and cyclodiene hydrocarbons significantly increases compared to cracking in an inert atmosphere. According to the data of IR spectral analysis of M-100 grade oil fractions, in addition to normal alkanes, the final sample contains a significant amount of olefinic and aromatic hydrocarbons. On the optimal catalyst, owing to oxidative cracking of fuel oil, the following product compositions (in %) were established: Fuel oil M-100: gas – 0.8, gasoline – 1.1, light gas oil – 85.7, heavy residue – 11.9, loss – 0.5 and total – 100.0%; commodity Fuel oil (M-100): gas – 3.3, gasoline – 8.4, light gas oil – 84.3, heavy residue – 4.0, loss – 0 and total – 100.0%.
- Open Access
- 8 July 2021
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 340, 01017
Composite catalysts for the catalytic processing of fuel oil
The paper describes the catalytic cracking of heavy petroleum feedstock on catalysts based natural Taizhuzgen zeolite and Narynkol clay (Kazakhstan). Catalytic cracking was studied on fuel oil of the M-100 brand taken from the LLP Pavlodar Oil Chemistry Refinery (Kazakhstan). Air was added into the reaction medium. It was found that under optimal conditions, the conversion of the heavy residue of M-100 fuel oil reaches 46.2%, when cracking the initial fuel oil, the yield of the middle distillate fraction is 85.7 wt. % due to the content of 41.1 wt. % residual light gas oil in the resulting products. The optimal composite catalyst allows carry out the cracking of heavy oil residues without preliminary purification and with a high degree ofconversion to diesel fraction.
- 8 July 2021
- Published by EDP Sciences in MATEC Web of Conferences
- Vol. 340, 01017
Open AccessComposite catalysts for the catalytic processing of fuel oil
The paper describes the catalytic cracking of heavy petroleum feedstock on catalysts based natural Taizhuzgen zeolite and Narynkol clay (Kazakhstan). Catalytic cracking was studied on fuel oil of the M-100 brand taken from the LLP Pavlodar Oil Chemistry Refinery (Kazakhstan). Air was added into the reaction medium. It was found that under optimal conditions, the conversion of the heavy residue of M-100 fuel oil reaches 46.2%, when cracking the initial fuel oil, the yield of the middle distillate fraction is 85.7 wt. % due to the content of 41.1 wt. % residual light gas oil in the resulting products. The optimal composite catalyst allows carry out the cracking of heavy oil residues without preliminary purification and with a high degree ofconversion to diesel fraction.