Jianghao Wu
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Previous Organizations / Institutes
The organizations / institutes from the scholar's other articles in the past ten years
Jianghao Wu has a total of 17 co-authors. Here are the top co-authors by number of shared publications:
Jingwei Zhu
College of Integrated Circuits and Micro-Nano Electronics, State Key Laboratory of Integrated Chips and Systems, Fudan University, Shanghai, China
2 shared publications- Yun Chen
Fudan University
2 shared publications Haoyu Wu
State Key Laboratory of Application Specific Integrated Circuit and System, Fudan University, Shanghai, China
1 shared publicationHuijun Cao
College of Integrated Circuits and Micro-Nano Electronics, State Key Laboratory of Integrated Chips and Systems, Fudan University, Shanghai, China
1 shared publication- Jun Han
Fudan University
1 shared publication Jun Yang
School of Electronic Engineering, Beijing University of Posts and Telecommunications 1 , Beijing 100876, China
1 shared publication
Latest Publications
- 1 September 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 73 (9) , 953-957
A 0.8-mm $^2$ 39.2-mW 37.6-kMats/J Eigenpair Solver for Sparsity-Aware Massive MIMO Systems- 1 September 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems II: Express Briefs
- Vol. 73 (9) , 953-957
A 0.8-mm $^2$ 39.2-mW 37.6-kMats/J Eigenpair Solver for Sparsity-Aware Massive MIMO Systems- 12 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Communications Letters
- Vol. PP (10897798) , 1
A Low-Complexity Carrier Phase Recovery Architecture using Prefix-Sum and CT-MLE for Coherent Receivers
Hardware-efficient carrier phase recovery (CPR) is critical for coherent optical systems employing high-order quadrature amplitude modulation. This letter proposes a low-parallelism and low-complexity CPR architecture. It introduces a parallel prefix-sum engine that exploits the sparsity of the symbol distribution, enabling the hardware parallelism to be significantly reduced without information loss. Furthermore, the architecture features a multiplication-free maximum likelihood estimation to reduce intrinsic computational complexity. Implemented in 28 nm CMOS for 32 GBaud system, the proposed CPR estimator reduces area by 51% and power by 39% compared to a conventional mVV-CT-VV baseline, achieving state-of-the-art efficiencies with only 0.37 dB signal-to-noise ratio penalty.
- 12 January 2026
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Communications Letters
- Vol. PP (10897798) , 1
A Low-Complexity Carrier Phase Recovery Architecture using Prefix-Sum and CT-MLE for Coherent Receivers
Hardware-efficient carrier phase recovery (CPR) is critical for coherent optical systems employing high-order quadrature amplitude modulation. This letter proposes a low-parallelism and low-complexity CPR architecture. It introduces a parallel prefix-sum engine that exploits the sparsity of the symbol distribution, enabling the hardware parallelism to be significantly reduced without information loss. Furthermore, the architecture features a multiplication-free maximum likelihood estimation to reduce intrinsic computational complexity. Implemented in 28 nm CMOS for 32 GBaud system, the proposed CPR estimator reduces area by 51% and power by 39% compared to a conventional mVV-CT-VV baseline, achieving state-of-the-art efficiencies with only 0.37 dB signal-to-noise ratio penalty.
- 24 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Communications Letters
- Vol. 28 (11) , 2478-2482
A Robust Physical Layer Key Generation Algorithm for Ultra-Wideband Ranging Process
Ultra-wideband (UWB) technology has been widely used for low-cost accurate ranging and positioning. To ensure communication security, a secret key must be derived before every ranging session. However, this process introduces significant latency and requires additional hardware. Therefore, this letter proposes a low-cost physical layer key generation algorithm that leverages the characteristics of multi-path channels for authentication and encryption. By effectively utilizing channel impulse response (CIR) and channel features, the proposed approach significantly reduces the key disagreement rate (KDR). Moreover, a scrambled timestamp sequence (STS) assisted error correction method is also proposed to further reduce the KDR. Simulation results demonstrate that, for a 128-bit physical key, the proposed scheme achieves a 0.5% KDR and over 83% STS matching rate at a 10 dB Signal to Noise Ratio (SNR). By utilizing several generation processes, the proposed algorithm can efficiently generate the physical layer key during the ranging session.
- 24 September 2024
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Communications Letters
- Vol. 28 (11) , 2478-2482
A Robust Physical Layer Key Generation Algorithm for Ultra-Wideband Ranging Process
Ultra-wideband (UWB) technology has been widely used for low-cost accurate ranging and positioning. To ensure communication security, a secret key must be derived before every ranging session. However, this process introduces significant latency and requires additional hardware. Therefore, this letter proposes a low-cost physical layer key generation algorithm that leverages the characteristics of multi-path channels for authentication and encryption. By effectively utilizing channel impulse response (CIR) and channel features, the proposed approach significantly reduces the key disagreement rate (KDR). Moreover, a scrambled timestamp sequence (STS) assisted error correction method is also proposed to further reduce the KDR. Simulation results demonstrate that, for a 128-bit physical key, the proposed scheme achieves a 0.5% KDR and over 83% STS matching rate at a 10 dB Signal to Noise Ratio (SNR). By utilizing several generation processes, the proposed algorithm can efficiently generate the physical layer key during the ranging session.
- 5 July 2022
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 132 (1) , 013103
A double-layer high-transmission terahertz linear-to-circular polarization converter
A double-layer broadband high-transmission terahertz linear-to-circular polarization metasurface is experimentally demonstrated in frequencies between 0.46 and 0.62 THz. The measured results show a good agreement with the simulations. The values of co-polarization transmission coefficients and remain above 0.82 in both simulation and experiment, and the simulated and measured axial ratio is 26.2% and 29.6%, respectively. Moreover, the experimental ellipticity remains above 0.98 in the region from 0.5 to 0.62 THz. The average measured polarization conversion ratio is 0.68. The multi-reflection and transmission interference model is used to explain the physical mechanism of polarization conversion. The proposed structure could be used in terahertz transmission and detection because of its stable, high ellipticity and transmittance.- 5 July 2022
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 132 (1) , 013103
A double-layer high-transmission terahertz linear-to-circular polarization converter
A double-layer broadband high-transmission terahertz linear-to-circular polarization metasurface is experimentally demonstrated in frequencies between 0.46 and 0.62 THz. The measured results show a good agreement with the simulations. The values of co-polarization transmission coefficients and remain above 0.82 in both simulation and experiment, and the simulated and measured axial ratio is 26.2% and 29.6%, respectively. Moreover, the experimental ellipticity remains above 0.98 in the region from 0.5 to 0.62 THz. The average measured polarization conversion ratio is 0.68. The multi-reflection and transmission interference model is used to explain the physical mechanism of polarization conversion. The proposed structure could be used in terahertz transmission and detection because of its stable, high ellipticity and transmittance.