Xuxia Shai
Current Organizations / Institutes
The organizations/institutes from the scholar's latest article
Xuxia Shai has a total of 34 co-authors. Here are the top co-authors by number of shared publications:
- Chunhua Zeng
Faculty of Science, Kunming University of Science and Technology, Kunming, China
2 shared publications Jie Li
Institute of Physical and Engineering Science/Faculty of Science, Kunming University of Science and Technology, Kunming 650500, China
2 shared publications- Lei Gao
Faculty of Science, Kunming University of Science and Technology 3 , Kunming 650500
2 shared publications Chunhua Zeng
Institute of Physical and Engineering Science/Faculty of Science, Kunming University of Science and Technology, Kunming 650500, China
1 shared publicationDeng Shu-Kang
1 shared publicationHua Wang
State Key Laboratory of Complex Nonferrous Metal Resources Clean Utilization, Kunming University of Science and Technology, Kunming 650093, China
1 shared publication
Latest Publications
- Open Access
- 24 April 2023
- Published by Wiley in Small Science
- Vol. 3 (7)
Origins, Impacts, and Mitigation Strategies of Strain in Efficient and Stable Perovskite Solar Cells
Because of their straightforward manufacture and exceptional photovoltaic efficiency, perovskite solar cells (PSCs) have quickly become appealing rivals in the photovoltaic sector. The residual strain, which prevents their practical use, keeps the efficiency and long‐term stability below practical bounds. Herein, the causes of strain in metal‐halide perovskites that are pertinent to photovoltaic applications, as well as how strain affects the materials’ physical characteristics and solar performance and how to control it, are discussed. Finally, a perspective on future strain engineering to support robust and effective PSCs is proposed. This review provides a comprehensive understanding of strain from origins, effects, to regulation, which would enhance the research enthusiasm on strain engineering to drive further improvements in performance especially stability of PSCs toward commercialization.
- 24 April 2023
- Published by Wiley in Small Science
- Vol. 3 (7)
Open AccessOrigins, Impacts, and Mitigation Strategies of Strain in Efficient and Stable Perovskite Solar Cells
Because of their straightforward manufacture and exceptional photovoltaic efficiency, perovskite solar cells (PSCs) have quickly become appealing rivals in the photovoltaic sector. The residual strain, which prevents their practical use, keeps the efficiency and long‐term stability below practical bounds. Herein, the causes of strain in metal‐halide perovskites that are pertinent to photovoltaic applications, as well as how strain affects the materials’ physical characteristics and solar performance and how to control it, are discussed. Finally, a perspective on future strain engineering to support robust and effective PSCs is proposed. This review provides a comprehensive understanding of strain from origins, effects, to regulation, which would enhance the research enthusiasm on strain engineering to drive further improvements in performance especially stability of PSCs toward commercialization.
- Open Access
Preparation of Heavily Doped P-Type PbSe with High Thermoelectric Performance by the NaCl Salt-Assisted Approach
Thermoelectric (TE) technology, which can convert scrap heat into electricity, has attracted considerable attention. However, broader applications of TE are hindered by lacking high-performance thermoelectric materials, which can be effectively progressed by regulating the carrier concentration. In this work, a series of PbSe(NaCl)x (x = 3, 3.5, 4, 4.5) samples were synthesized through the NaCl salt-assisted approach with Na+ and Cl− doped into their lattice. Both theoretical and experimental results demonstrate that manipulating the carrier concentration by adjusting the content of NaCl is conducive to upgrading the electrical transport properties of the materials. The carrier concentration elevated from 2.71 × 1019 cm−3 to 4.16 × 1019 cm−3, and the materials demonstrated a maximum power factor of 2.9 × 10−3 W m−1 K−2. Combined with an ultralow lattice thermal conductivity of 0.7 W m−1 K−1, a high thermoelectric figure of merit (ZT) with 1.26 at 690 K was attained in PbSe(NaCl)4.5. This study provides a guideline for chemical doping to improve the thermoelectric properties of PbSe further and promote its applications.
Open AccessPreparation of Heavily Doped P-Type PbSe with High Thermoelectric Performance by the NaCl Salt-Assisted Approach
Thermoelectric (TE) technology, which can convert scrap heat into electricity, has attracted considerable attention. However, broader applications of TE are hindered by lacking high-performance thermoelectric materials, which can be effectively progressed by regulating the carrier concentration. In this work, a series of PbSe(NaCl)x (x = 3, 3.5, 4, 4.5) samples were synthesized through the NaCl salt-assisted approach with Na+ and Cl− doped into their lattice. Both theoretical and experimental results demonstrate that manipulating the carrier concentration by adjusting the content of NaCl is conducive to upgrading the electrical transport properties of the materials. The carrier concentration elevated from 2.71 × 1019 cm−3 to 4.16 × 1019 cm−3, and the materials demonstrated a maximum power factor of 2.9 × 10−3 W m−1 K−2. Combined with an ultralow lattice thermal conductivity of 0.7 W m−1 K−1, a high thermoelectric figure of merit (ZT) with 1.26 at 690 K was attained in PbSe(NaCl)4.5. This study provides a guideline for chemical doping to improve the thermoelectric properties of PbSe further and promote its applications.
- 5 July 2022
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 126 (28) , 11751-11760
Anisotropic Chalcogenide Perovskite CaZrS3: A Promising Thermoelectric Material
- 5 July 2022
- Published by American Chemical Society (ACS) in The Journal of Physical Chemistry C
- Vol. 126 (28) , 11751-11760
Anisotropic Chalcogenide Perovskite CaZrS3: A Promising Thermoelectric Material
- 1 January 2022
- Published by Acta Physica Sinica, Chinese Physical Society and Institute of Physics, Chinese Academy of Sciences in Acta Physica Sinica
- Vol. 71 (1) , 017101-017101-8
Electronic and optical properties of inorganic lead-free perovskite Cs3Bi2I9
有机-无机卤化钙钛矿材料因具有优异的光电性质而被广泛应用于太阳电池中, 然而材料及器件的稳定性及含铅问题却严重制约其生产发展. 与杂化钙钛矿相比, 无机非铅钙钛矿Cs3Bi2I9因具有更强的稳定性和环境友好性受到人们的广泛关注. Cs3Bi2I9具有单斜、三角和六方3种晶型, 目前, 对Cs3Bi2I9的理论和实验研究主要集中在六方相. 本文基于密度泛函理论的第一性原理对Cs3Bi2I9单斜、三角和六方相的电子性质、载流子有效质量(\begin{document}$m^* $\end{document} )、稳定性和光学性质进行了理论研究. 结果表明, 3种晶相具有相近的稳定性, 三角相因具有较小的直接带隙(1.21 eV)性质成为最具研究潜力的对象. 3种晶相的\begin{document}$m^* $\end{document} 均具有沿a, b方向相同和沿c方向不同的特点, 三角相的电子有效质量最小、且沿a方向的电子有效质量小于c方向. 相比单斜和六方相, 三角相Cs3Bi2I9的光学性质均发生红移现象、具有更优异的光吸收性能. 此外, 3种晶相的光学性质也表现出沿a, b方向相同和沿c方向不同的性质, 且沿a方向的光吸收性能优于c方向. 因此, 对于Cs3Bi2I9钙钛矿, 期待三角晶相沿a方向在光电子器件方面有较好的贡献.- 1 January 2022
- Published by Acta Physica Sinica, Chinese Physical Society and Institute of Physics, Chinese Academy of Sciences in Acta Physica Sinica
- Vol. 71 (1) , 017101-017101-8
Electronic and optical properties of inorganic lead-free perovskite Cs3Bi2I9
有机-无机卤化钙钛矿材料因具有优异的光电性质而被广泛应用于太阳电池中, 然而材料及器件的稳定性及含铅问题却严重制约其生产发展. 与杂化钙钛矿相比, 无机非铅钙钛矿Cs3Bi2I9因具有更强的稳定性和环境友好性受到人们的广泛关注. Cs3Bi2I9具有单斜、三角和六方3种晶型, 目前, 对Cs3Bi2I9的理论和实验研究主要集中在六方相. 本文基于密度泛函理论的第一性原理对Cs3Bi2I9单斜、三角和六方相的电子性质、载流子有效质量(\begin{document}$m^* $\end{document} )、稳定性和光学性质进行了理论研究. 结果表明, 3种晶相具有相近的稳定性, 三角相因具有较小的直接带隙(1.21 eV)性质成为最具研究潜力的对象. 3种晶相的\begin{document}$m^* $\end{document} 均具有沿a, b方向相同和沿c方向不同的特点, 三角相的电子有效质量最小、且沿a方向的电子有效质量小于c方向. 相比单斜和六方相, 三角相Cs3Bi2I9的光学性质均发生红移现象、具有更优异的光吸收性能. 此外, 3种晶相的光学性质也表现出沿a, b方向相同和沿c方向不同的性质, 且沿a方向的光吸收性能优于c方向. 因此, 对于Cs3Bi2I9钙钛矿, 期待三角晶相沿a方向在光电子器件方面有较好的贡献.- Open Access
- 1 January 2014
- Published by Acta Physica Sinica, Chinese Physical Society and Institute of Physics, Chinese Academy of Sciences in Acta Physica Sinica
- Vol. 63 (17) , 177401
Structural and electrical transport properties of Mg-doped n-type Sn-based type Ⅷ single crystalline clathrate
本文采用Sn自熔剂法,制备Mg掺杂Sn基单晶笼合物Ba8Ga16-XMgXSn30 (0 X 1.5),并对其结构及电传输性能进行研究. 结果表明所制备化合物为具有空间群I43 m的Ⅷ型单晶笼合物,随Mg掺杂量的增加,对应化合物的熔点略有升高,晶格常数减小,掺杂样品中填充原子Ba的实际含量低于理想值8.0,其在十二面体空洞中的占有率约为0.93(Mg的名义含量X=1.5时). 所有样品均表现为n型传导,Mg的掺入对材料的能带结构有一定影响,Mg掺杂后,样品的载流子浓度降低,Seebeck系数的绝对值、电阻率增加,Mg的名义含量X=1.5时,样品的功率因子在430 K附近取得最大值1.2610-3 Wm-1K-2.
- 1 January 2014
- Published by Acta Physica Sinica, Chinese Physical Society and Institute of Physics, Chinese Academy of Sciences in Acta Physica Sinica
- Vol. 63 (17) , 177401
Open AccessStructural and electrical transport properties of Mg-doped n-type Sn-based type Ⅷ single crystalline clathrate
本文采用Sn自熔剂法,制备Mg掺杂Sn基单晶笼合物Ba8Ga16-XMgXSn30 (0 X 1.5),并对其结构及电传输性能进行研究. 结果表明所制备化合物为具有空间群I43 m的Ⅷ型单晶笼合物,随Mg掺杂量的增加,对应化合物的熔点略有升高,晶格常数减小,掺杂样品中填充原子Ba的实际含量低于理想值8.0,其在十二面体空洞中的占有率约为0.93(Mg的名义含量X=1.5时). 所有样品均表现为n型传导,Mg的掺入对材料的能带结构有一定影响,Mg掺杂后,样品的载流子浓度降低,Seebeck系数的绝对值、电阻率增加,Mg的名义含量X=1.5时,样品的功率因子在430 K附近取得最大值1.2610-3 Wm-1K-2.